Abstract There are three principal mathematical approaches to describing trapping: the Holstein equation, the method of combining the equation of radiative transfer with the rate equation for the excited state atoms, and the multiple-scattering representation. Ultimately, these three descriptions are equivalent-as they should be, since they describe the same physical process. Their different formulations stem from different views of the trapping problem. Each method has its specific advantages and disadvantages for the evaluation, hence it is very helpful to fully understand all three formulations.
Abstract There are three principal mathematical approaches to describing trapping: the Holstein equation, the method of combining the equation of radiative transfer with the rate equation for the excited state atoms, and the multiple-scattering representation. Ultimately, these three descriptions are equivalent-as they should be, since they describe the same physical process. Their different formulations stem from different views of the trapping problem. Each method has its specific advantages and disadvantages for the evaluation, hence it is very helpful to fully understand all three formulations.
A simple stochastic formulation of the multiple scattering representation solution of the classical linear incoherent trapping problem is presented for a broad audience. A clear connection with the alternative Holstein's solution ansatz is emphasized by the (re)interpretation of the fundamental mode as the one associated with a relaxed nonchanging spatial distribution of excitation. Expressions for overall relaxation parameters (ensemble emission yield and lifetime) as well as time-resolved (decay and spatial distribution) and steady-state quantities (spectra and spatial distribution) are given with the fundamental mode contribution singled out. The multiple scattering representation is advocated for final undergraduate and beginning graduate physics instruction based on physical insight and computation feasibility. This will be illustrated in the following instalment of this contribution.
Abstract Radiation from spectral lines can be absorbed and re- emitted many times in atomic vapours before it reaches the boundaries of the container encasing the vapour. This effect is known as radiation trapping. It plays an important role practically everywhere where atomic vapours occur, e.g. in spectroscopy, in gas lasers, in atomic line filters, in the determination of atomic lifetimes, in measurements of atomic interaction potentials, and in electric discharge lamps. This book for the first time assembles all the information necessary for a treatment of practical problems, emphasizing both physical insights and mathematical methods. After an introduction that reviews resonance radiation and collisional processes in atomic vapours, physical effects and mathematical methods for various types of problems (e.g. with or without saturation, particle diffusion, reflecting cell walls, etc.) are explained in detail. The last part of the book describes the applications of these methods to a variety of practical problems like cross-section measurements or the design of discharge lamps.Atoms can both absorb and emit electromagnetic radiation like visible light In an assembly of many atoms, e.g., in a vapour or in a gas, radiation emitted by one atom may be reabsorbed by one of its neighbours, just to be reemitted a little later. The game can go on for quite some time—until the photon manages somehow to escape from this prison. At first glance, quite easy to understand. On the other hand, there must be some reason for this voluminous book full of sums, integrals and matrices. Our interest in this subject originally stemmed from investigations on atomic line filters we did for the European Space Agency, ESA. We believed that radiation trapping would have some influence on the performance of these filters and were looking for a simple means to take it into account We started out the same way as probably anyone new to the field would have done when faced with the problem of trapping. We read the classical paper of Holstein, and thought that was all there was to it. We soon had to realize, however, that the assumptions made by Holstein were not fulfilled in our problem, and decided to give the whole matter a closer look. That ‘closer look’ obtained a momentum of its own, and trapping became the centre of our own research in the following years. As our overview of the subject increased. we found that trapping plays a role in a staggering variety of situations. Trapping appears to be important in most experimental setups and in most engineering applications where atomic vapours are involved.
The purpose of this paper is to propose a theoretical treatment of radiation trapping in a multiple lines coupled system in which coupling includes collisional energy transfer and cross absorption between the excited states. First, to describe the coupled system, the Holstein equation of radiation trapping is extended to an integral differential master equation group in which the vector and matrix form is adopted. Then by use of operator manipulations, the asymptotic solution in the form of a series expansion in terms of operators is presented. Finally, the asymptotic solution is reduced, leading to a result which can not only give the system a complete description, but also has far more advantages than the simple cut off solution. A numeral illustration of a two excited states system is also presented.
Abstract In theory, all radiation trapping problems must be treated under consideration of the polarization state of the radiation. Even with an unpolarized excitation source, the geometry of the problem can introduce some degree of polarization to the fluorescence radiation. Of course, when the excitation source itself is polarized, as is usually the case for a laser, polarization can become even more important. One should not forget, however, that incorporation of polarization makes for a very complicated problem. The Holstein equation will become a Fredholm integral equation for a four-component vector instead of the usual scalar function (the excited-state density). Having seen the difficulties in solving the comparatively simple ‘usual’ trapping problem, we see that polarization should only be included when it is not to be avoided.
We introduce an analytical method to investigate radiation trapping problems with Doppler frequency redistribution. The problem is formulated within the framework of the Holstein-Biberman-Payne equation. We interpret the basic integro-differential trapping equation as a generalized wave equation for a four-dimensional (4D) classical system (an associated quasiparticle). We then construct its analytical solution by a semiclassical approach, called the geometrical quantization technique (GQT). Within the GQT, it is shown that the spatial and frequency variables can be separated and that the frequency part of the excited atom distribution function obeys a stationary Schr\"odinger equation for a perturbed oscillator. We demonstrate that there is a noticeable deviation of the actual spectral emission profile from the Doppler line in the region of small opacities. The problem of calculating the spatial mode structure and the effective radiation trapping factors is reduced to the evaluation of wave functions and quantized energy values of the quasiparticle confined in the vapor cell. We formulate the quantization rules and derive the phase factors, which allow us to obtain analytically the complete spectrum of the trapping factors in 1D geometries (layer, cylinder, sphere) and other (2D and 3D) geometries when the separation of space variables is possible. Finally, we outline a possible extension of our method to treat radiation trapping effects for more general experimental situations including, for instance, a system of cold atoms.
Modeling lasers may be realized with different levels of sophistication. Rigorously it requires a full quantum treatment but many laser dynamical properties may be captured by semiclassical or even purely classical approaches. In this book we deliberately chose the simplest point of view, i.e. purely classical equations, and try to extract analytically as much information as possible. The basic framework of our approach is provided by the rate equations . In their simplest version, they apply to an idealized active system consisting of only two energy levels coupled to a reservoir. They were introduced as soon as the laser was discovered to explain (regular or irregular, damped or undamped) intensity spikes commonly seen with solid state lasers (for a historical review, see the introduction in). These rate equations are discussed and sometimes derived from a semiclassical theory in textbooks on lasers. They capture the essential features of the response of a single-mode laser and they may be modified to account for specific effects such as the modulation of a parameter or optical feedback. The most basic processes involved in laser operation are schematically represented in Figure 1.1. N 1 and N 2 denote the number of atoms in the ground and excited levels, respectively. The process of light–matter interaction is restricted to stimulated emission and absorption.