Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Radioengineering

Further Improvements in Decoding Performance for 5G LDPC Codes Based on Modified Check-Node Unit

Bich Ngoc Tran-Thi, Truong Nguyen, Trang Hoang

Published May 11, 2023• 2 citations
Publisher

Abstract

One of the most important units of Low-Density Parity-Check (LDPC) decoders is the Check-Node Unit.Its main task is to find the first two minimum values among incoming variable-to-check messages and return check-tovariable messages.This block significantly affects the decoding performance, as well as the hardware implementation complexity.In this paper, we first propose a modification to the check-node update rule by introducing two optimal offset factors applied to the check-to-variable messages.Then, we present the Check-Node Unit hardware architecture which performs the proposed algorithm.The main objective of this work aims to improve further the decoding performance for 5 th Generation (5G) LDPC codes.The simulation results show that the proposed algorithm achieves essential improvements in terms of error correction performance.More precisely, the error-floor does not appear within Bit-Error-Rate (BER) of 10 -8 , while the decoding gain increases up to 0.21 dB compared to the baseline Normalized Min-Sum, as well as several state-ofthe-art LDPC-based Min-Sum decoders.

DOI
10.13164/re.2023.0226

Related papers

High-Performance and Low-Complexity Decoding Algorithms for 5G Low-Density Parity-Check Codes

Bich Ngoc Tran-Thi, Truong Nguyen, Trang Hoang

The development of the Fifth Generation (5G) New Radio (NR) provides several significant advantages when compared to the fourth generation (4G) Long Term Evolution (LTE) in mobile communications. Due to the outstanding characteristics of Low-Density Parity-Check (LDPC) codes such as high decoding performance, high throughput, low complexity, they have been accepted as the standard codes for the 5G NR. In this paper, we propose two LDPC decoding algorithms: Hybrid Offset Min-Sum (HOMS) and Variable Offset Min-Sum (VOMS), which are aimed at improving the error correction performance. The main idea of the HOMS/VOMS algorithm is to apply modified factors to both variable-nodes and check-nodes updated processing in order to compensate the extrinsic messages overestimation of the MS-based algorithms and increase the protection ability for degree-1 variable-nodes. The simulation results show that at the Bit-Error-Rate (BER) of 10-5, the proposed HOMS/VOMS algorithm achieves the decoding gain up to 0.2 dB compared to the Offset Min-Sum (OMS) algorithm, with a slight increase in decoding complexity.

Journal of Communications•Jan 1, 2022•3 citations

An Improved Offset Min-Sum LDPC Decoding Algorithm for 5G New Radio

Bich Ngoc Tran-Thi, Truong Nguyen, Hoa Nguyen Hong +1 more

This paper presents an Improved Offset Min-Sum (IOMS) algorithm for Low-Density Parity-Check (LDPC) decoders, used in 5thgeneration (5G) mobile communication. The proposed algorithm IOMS applies a multiplication factor to check-node update information messages. The simulation results show that the proposed IOMS algorithm offers a better error correction performance than the existing Min-Sum-based algorithms at the expense of a slight increase in complexity. At the BER of 10–5, the IOMS achieves a decoding gain of 0.1dB with respect to the OMS algorithm.

IEEE International Symposium on Electronics and the Environment (ISEE)•Apr 15, 2021•13 citations

An Enhanced Offset Min-Sum decoder for 5G LDPC Codes

Hangxuan Cui, Khoa Le, Fakhreddine Ghaffari +3 more

This paper presents an Enhanced Offset Min-Sum (EOMS) decoder for Low-Density Parity-Check (LDPC) codes used in the 5th generation (5G) mobile communications. It is observed that a significant part of Variable Nodes (VNs) in the 5G LDPC codes are with degree-1 and are very sensitive to be erroneous, leading to the fact that the decoding performance is generally reduced. In the EOMS decoding, the core check nodes (CN) and extension CNs are processed with different update rules. A new CN -update criterion is also proposed by making use of the third minimum value. As a result, the offset factors are adaptively selected and the error probability of degree-1 VNs is significantly reduced. Simulation results show that the proposed EOMS decoder offers a much better error-correction performance than the state-of-the-art benchmarks for several 5G LDPC codes with a negligible complexity overhead.

Asia-Pacific Conference on Communications (APCC)•Nov 1, 2019•1 citation

Generalized Two-Magnitude Check Node Updating with Self Correction for 5G LDPC Codes Decoding

Wei Zhou, Michael Lentmaier

The min-sum (MS) and approximate-min* (a-min*) algorithms are alternatives of the belief propagation (BP) algorithm for decoding low-density parity-check (LDPC) codes. To lower the BP decoding complexity, both algorithms compute two magnitudes at each check node (CN) and pass them to the neighboring variable nodes (VNs).In this work we propose a new algorithm, ga-min*, that generalizes the MS and a-min* in terms of number of incoming messages to a CN.We analyze and demonstrate a condition to improve the performance when applying self-correction to the ga-min*. Simulations on 5G LDPC codes show that the proposed decoding algorithm yields comparable performance to the a-min* with a significant reduction in complexity, and it is robust against LLR mismatch.

Systems Communications•Jan 1, 2019•7 citations

Modified min-sum decoding algorithm for LDPC codes based on classified correction

Zhong Zhou, Yunzhou Li, Xiang Chen +2 more

In this paper, a modified min-sum decoding algorithm based on classified correction is proposed for low density parity check (LDPC) codes. Different from the single correction in the normalized belief propagation (BP)-based and offset BP-based algorithms [4], the proposed algorithm utilizes two corrections for both minimum and sub-minimum magnitudes of input messages in check nodes. These two correction factors can be obtained by analyzing the offset of updated messages in check nodes between the BP and the min-sum algorithms associated with check node degree. Simulation results show that the proposed algorithm can achieve performance very close to that of the BP algorithm. Furthermore, the FPGA implementation of this algorithm can reach a throughput of 200 Mbps at BER=10-6with lower complexity and fewer resources than the BP algorithm.

International Conference on Communications and Networking in China (ChinaCom)•Aug 1, 2008•9 citations

Check node degree-based modified min-sum decoding algorithm with classification for LDPC codes

Jing Wang

A check node degree-based modified min-sum algorithm which classifies the codes was developed to reduce the complexity and improve the performance of decoding algorithm for low-density parity-check(LDPC) codes.The algorithm corrects both the minimum and sub-minimum absolute values of incoming messages in the check nodes.Two correction factors are obtained by calculating the offset between the belief propagation(BP) algorithm and the min-sum algorithm based on the check node degree.Simulations show that the algorithm achieves better performance than the BP algorithm at high signal noise ratio.The algorithm is also less complex than the BP algorithm and provides a good tradeoff between performance and complexity for any check node degree distribution in the LDPC codes.

Journal of Tsinghua University(Science and Technology)•Jan 1, 2009•0 citations
One of the most important units of Low-Density Parity-Check (LDPC) decoders is the Check-Node Unit.Its main task is to find the first two minimum values among incoming variable-to-check messages and return check-tovariable messages.This block significantly affects the decoding performance, as well as the hardware implementation complexity.In this paper, we first propose a modification to the check-node update rule by introducing two optimal offset factors applied to the check-to-variable messages.Then, we present the Check-Node Unit hardware architecture which performs the proposed algorithm.The main objective of this work aims to improve further the decoding performance for 5 th Generation (5G) LDPC codes.The simulation results show that the proposed algorithm achieves essential improvements in terms of error correction performance.More precisely, the error-floor does not appear within Bit-Error-Rate (BER) of 10 -8 , while the decoding gain increases up to 0.21 dB compared to the baseline Normalized Min-Sum, as well as several state-ofthe-art LDPC-based Min-Sum decoders.
The development of the Fifth Generation (5G) New Radio (NR) provides several significant advantages when compared to the fourth generation (4G) Long Term Evolution (LTE) in mobile communications. Due to the outstanding characteristics of Low-Density Parity-Check (LDPC) codes such as high decoding performance, high throughput, low complexity, they have been accepted as the standard codes for the 5G NR. In this paper, we propose two LDPC decoding algorithms: Hybrid Offset Min-Sum (HOMS) and Variable Offset Min-Sum (VOMS), which are aimed at improving the error correction performance. The main idea of the HOMS/VOMS algorithm is to apply modified factors to both variable-nodes and check-nodes updated processing in order to compensate the extrinsic messages overestimation of the MS-based algorithms and increase the protection ability for degree-1 variable-nodes. The simulation results show that at the Bit-Error-Rate (BER) of 10-5, the proposed HOMS/VOMS algorithm achieves the decoding gain up to 0.2 dB compared to the Offset Min-Sum (OMS) algorithm, with a slight increase in decoding complexity.
This paper presents an Improved Offset Min-Sum (IOMS) algorithm for Low-Density Parity-Check (LDPC) decoders, used in 5thgeneration (5G) mobile communication. The proposed algorithm IOMS applies a multiplication factor to check-node update information messages. The simulation results show that the proposed IOMS algorithm offers a better error correction performance than the existing Min-Sum-based algorithms at the expense of a slight increase in complexity. At the BER of 10–5, the IOMS achieves a decoding gain of 0.1dB with respect to the OMS algorithm.
This paper presents an Enhanced Offset Min-Sum (EOMS) decoder for Low-Density Parity-Check (LDPC) codes used in the 5th generation (5G) mobile communications. It is observed that a significant part of Variable Nodes (VNs) in the 5G LDPC codes are with degree-1 and are very sensitive to be erroneous, leading to the fact that the decoding performance is generally reduced. In the EOMS decoding, the core check nodes (CN) and extension CNs are processed with different update rules. A new CN -update criterion is also proposed by making use of the third minimum value. As a result, the offset factors are adaptively selected and the error probability of degree-1 VNs is significantly reduced. Simulation results show that the proposed EOMS decoder offers a much better error-correction performance than the state-of-the-art benchmarks for several 5G LDPC codes with a negligible complexity overhead.
The min-sum (MS) and approximate-min* (a-min*) algorithms are alternatives of the belief propagation (BP) algorithm for decoding low-density parity-check (LDPC) codes. To lower the BP decoding complexity, both algorithms compute two magnitudes at each check node (CN) and pass them to the neighboring variable nodes (VNs).In this work we propose a new algorithm, ga-min*, that generalizes the MS and a-min* in terms of number of incoming messages to a CN.We analyze and demonstrate a condition to improve the performance when applying self-correction to the ga-min*. Simulations on 5G LDPC codes show that the proposed decoding algorithm yields comparable performance to the a-min* with a significant reduction in complexity, and it is robust against LLR mismatch.
In this paper, a modified min-sum decoding algorithm based on classified correction is proposed for low density parity check (LDPC) codes. Different from the single correction in the normalized belief propagation (BP)-based and offset BP-based algorithms [4], the proposed algorithm utilizes two corrections for both minimum and sub-minimum magnitudes of input messages in check nodes. These two correction factors can be obtained by analyzing the offset of updated messages in check nodes between the BP and the min-sum algorithms associated with check node degree. Simulation results show that the proposed algorithm can achieve performance very close to that of the BP algorithm. Furthermore, the FPGA implementation of this algorithm can reach a throughput of 200 Mbps at BER=10-6with lower complexity and fewer resources than the BP algorithm.
A check node degree-based modified min-sum algorithm which classifies the codes was developed to reduce the complexity and improve the performance of decoding algorithm for low-density parity-check(LDPC) codes.The algorithm corrects both the minimum and sub-minimum absolute values of incoming messages in the check nodes.Two correction factors are obtained by calculating the offset between the belief propagation(BP) algorithm and the min-sum algorithm based on the check node degree.Simulations show that the algorithm achieves better performance than the BP algorithm at high signal noise ratio.The algorithm is also less complex than the BP algorithm and provides a good tradeoff between performance and complexity for any check node degree distribution in the LDPC codes.