Recently, cold atoms in lattices blossomed as good candidates to mimic the prop- erties of electrons in solid state systems and to simulate other quantum systems. However, experimental techniques currently use optical lattices in the far-field. This limit the lattice spacing to λ/2, thus the relevant energy scale (tunneling and interaction), making it difficult to enter deeply into the proper quantum regimes to observe magnetic quantum correlations or strongly correlated phases. Our project aims at reducing the lattice period to bridge the gap between solid state ( ̊A) and far field lattice (500nm) by developing an hybrid quantum system of Bose and Fermi quantum gas in close proximity of a nano-structured surface generating sub-wavelength lattice potentials. To push toward this goal, we first developed a novel method to transport and then trap an ultracold atomic cloud in close vicinity of a surface. We will discuss about the early stage atom-chip produced, and report on some tests about the transport sequence. By measuring the power spectral density of the trap parameters, we can predict the noise- induce heating of the trapped cloud. In order to work with such system, one need to be able to address individually each sites with a resolution under the standard PSF limit. We implemented a tunable sub-wavelength imaging system with a theoretical resolution of 30nm that we used to resolve the wave-packet of a cloud in a single lattice site. This scheme involves two superimposed optical lattices, one at 1064nm and one at 1529nm, whose interfringe can be tuned. We present hereafter the experimental setup in detail and show interesting results we obtained.
Recently, cold atoms in lattices blossomed as good candidates to mimic the prop- erties of electrons in solid state systems and to simulate other quantum systems. However, experimental techniques currently use optical lattices in the far-field. This limit the lattice spacing to λ/2, thus the relevant energy scale (tunneling and interaction), making it difficult to enter deeply into the proper quantum regimes to observe magnetic quantum correlations or strongly correlated phases. Our project aims at reducing the lattice period to bridge the gap between solid state ( ̊A) and far field lattice (500nm) by developing an hybrid quantum system of Bose and Fermi quantum gas in close proximity of a nano-structured surface generating sub-wavelength lattice potentials. To push toward this goal, we first developed a novel method to transport and then trap an ultracold atomic cloud in close vicinity of a surface. We will discuss about the early stage atom-chip produced, and report on some tests about the transport sequence. By measuring the power spectral density of the trap parameters, we can predict the noise- induce heating of the trapped cloud. In order to work with such system, one need to be able to address individually each sites with a resolution under the standard PSF limit. We implemented a tunable sub-wavelength imaging system with a theoretical resolution of 30nm that we used to resolve the wave-packet of a cloud in a single lattice site. This scheme involves two superimposed optical lattices, one at 1064nm and one at 1529nm, whose interfringe can be tuned. We present hereafter the experimental setup in detail and show interesting results we obtained.
Quantum gas microscopes have become a major element for quantum simulations using ultra-cold atoms in optical lattices. They are for example used to observe long-range order such as anti-ferromagnetic correlations in far field optical lattices using density and spin resolved microscopy. Decreasing the period of such lattice offer interesting perspective to increase atom-atom interaction energies and engineer atom-light coupling that our group tackles via the hybridization of cold atoms and nano-structured surfaces.In this poster, we will present how such type of sub-wavelength lattice potentials can be generated by trapping atoms in proximity (tens to hundreds of nanometers) of a nano-structured surface. At such atom to surface distance, the attractive Casimir-Polder force can be compensated by a doubly dressed state trapping method that I will discuss. Such method additionally offers solutions to overcome the diffraction limit of conventional imaging that become critical for sub-wavelength lattices. In this work, I will present the experimental characterization of a sub-wavelength resolution absorption imaging applicable to quantum gas detection. This method requires a quantitative determination of the atom number of dense clouds which has been characterized in this work and demonstrate that the scattering cross section reduces linearly with the optical density. Modelling the propagation of light in dense cloud we show that this reduction can be attributed to re-scattering of the incoherent part of the resonant fluorescence spectrum.The poster will additionally present an update on our recent work on the spectroscopy of Acetylene in sealed hollow core fibers.
Ultracold atomic gases can be utilised as extremely sensitive probes of their surrounding environment. In particular, samples of ultracold atoms confined using chip-based microtraps are an ideal tool for mapping electric and magnetic field landscapes. Over the course of this thesis, a new experiment capable of performing surface microscopy using magnetically trapped clouds of cold rubidium-87 atoms has been built. The focus of the work is on the design and construction of the experimental system, which must incorporate many different aspects for manipulating thermal atomic gases, with a view to positioning them at sub-micron distances from special surfaces. This reduced atom-surface separation is necessary for implementing a high resolution, high sensitivity magnetic field sensor with cold atoms. Although current microfabrication techniques easily enable trapping at distances on the order of micrometres, several distance-dependent surface effects - such as the Casimir-Polder force, Johnson-Nyquist noise, and stray potentials - eventually impede magnetic trapping at the sub-micron level. These surface effects can greatly modify the confining potentials, which reduces the trap depth and consequently leads to an additional loss rate of atoms from the trap. We have explored the possibility of using special surfaces such as nano-membranes of silicon nitride and graphene, which have reduced atom- surface interactions, to enable trapping distances at the sub-micron level. A multilayer printed circuit board chip has been designed to form an initial magnetic trap and then transport the cloud of atoms to a desired location over the samples. This chip, along with various samples, is mounted on a custom-made electrical feedthrough designed to make connections to all conductor that are inside the vacuum chamber. The initial cloud of cold atoms can then be prepared in the central region of the chip and delivered to the location of the samples on either side. The experimental system is able to routinely capture over 10^8 rubidium-87 atoms at a temperature of 80 micro-Kelvin in a magneto-optical trap using a novel scheme of five laser beams. A method is demonstrated for enhancing the atom number in the magneto-optical traps by a factor of two by using laser beams with two slightly different frequencies. Atoms from the magneto-optical trap are then transferred to a purely magnetic trap formed by the wires on the printed circuit board chip. Time-dependent currents in the chip wires then create a dynamic potential, which is shown to successfully transport the atomic sample over a distance of 12 millimetre with minimal atom loss. This thesis describes the development of the apparatus in detail, along with careful characterisation of the cold cloud at various stages of the experimental sequence. Initial results on the long distance atom transport are presented. Finally, the experimental results of the two frequency magneto-optical trap for atom number improvement are discussed.
Ultra-cold atoms systems used as quantum simulators offer an alternative way to simulate many-body systemsbehaviour in condensed matter. Indeed, we can create artificial matter with optical lattices : the stationnarywave reproduces the potential wells in the crystalline structure. Moreover, the big advantage of using cold atomsis that the parameters of the simulated crystal can be well controlled so that we can understand the electricaland magnetism properties of the condensed matter such as conductivity, ferromagnetism ...The commonapproach for generating optical lattices is interfering two laser beams in one dimension. The lattice spacing islimited by the interfringe, which is half the wavelength. However, the more the lattice spacing decreases, themore the interaction energies increase [3].In the new ongoing project, we are going to produce subwavelengthlattices by irradiating a nanostructure gold layer. The subwavelength potential is got thanks to the control ofthe interactions between the beams, the atomic cloud, and the nanostructured surface. This system will be ableto study new interaction regimes with very high tunability (different lattice geometries, impurities...).
Abstract Ultracold atoms in optical lattices are a very promising quantum simulation platform, as they provide a very clean system (almost defect free) and allow control over many parameters such as tunneling coupling or interaction strength. Because the typical lattice spacing lies in the sub-micron range, it is technically demanding to resolve exactly the position of the atoms in the lattice using high-resolution optics such as quantum gas microscopy. Here we review the matter-wave protocol of quantum gas magnification that we developed for magnifying the atomic density distribution in the lattice (Asteria et al 2021 Nature 599 571). The atomic cloud, thus magnified by a factor of up to ∼ 90 , can then be imaged in a single-shot even with sub-lattice resolution with standard absorption imaging techniques. Furthermore, the protocol was demonstrated for 3D systems with high filling factors, which are typically impossible to measure with high-resolution imaging. In this tutorial, we will review how this technique can be used for high-resolution imaging of the density distribution and present the results obtained using it as a method to access new observables. We conclude with an outlook focusing on how this technique could be beneficial for a wide variety of physical systems which can be realized using cold atoms. This tutorial expands on the topic of my presentation for the SAMOP 2023 PhD Prize finalist symposium.
This thesis reports the construction of a novel apparatus for experiments with ultracold atoms in optical lattices: the Fermi gas microscope.Improving upon similar designs for bosonic atoms, our Fermi gas microscope has the novel feature of being able to achieve single-site resolved imaging of fermionic atoms in an optical lattice; specifically, we use fermionic potassium-40, sympathetically cooled by bosonic sodium-23.In this thesis, several milestones on the way to achieving single-site resolution are described and documented.First, we have tested and mounted in place the imaging optics necessary for achieving single-site resolution.We set up separate 3D magnetooptical traps for capturing and cooling both 2 3 Na and 40 K.These species are then trapped simultaneously in a plugged quadrupole magnetic trap and evaporated to degeneracy; we obtain a sodium Bose-Einstein condensate with about a million atoms and a degenerate potassium cloud cooled to colder than 1 puK.Using magnetic transport over a distance of 1 cm, we move the cold cloud of atoms into place under the high-resolution imaging system and capture it in a hybrid magnetic and optical-dipole trap.Further evaporation in this hybrid trap performed by lowering the optical trap depth, and the cooled atoms are immersed in an optical lattice, the setup and calibration of which is also described here.Finally, we cool the atoms with optical molasses beams while in the lattice, with the imaging optics collecting the fluoresence light for high-resolution imaging.With molasses cooling set up, single-site fluoresence imaging of bosons and fermions in the same experimental apparatus is within reach.
Since the achievement of Bose-Einstein condensation (BEC), the progress in matterwave \nphysics has been immense. Among the many recent achievements there is \nthe miniaturization of atom traps, demonstration of the superfluid-Mott insulator \nquantum-phase transition in optical lattices and the experimental demonstration of \nthe BEC-BCS crossover in ultra-cold gases. \nMiniaturization of atom traps using micro-structured wires on a chip is one important \nstep towards an on-chip cold-atom device. These so-called \\atom chips" provide \nhigh control and versatility for trapping and guiding the ultra-cold atomic clouds. \nParticularly interesting is the use of these microchips to build mesoscopic devices \nfor cold atomic clouds as, for instance, in the case of an atom-cloud interferometer. \nHowever, these mesoscopic devices require coherent transport of the atom cloud. A \ngeneral method to treat decoherence due to current fluctuations in multi-wire atomchip \ntraps is presented in the rst part of this thesis. The decoherence rate Γ shows a \nstrong dependence on the distance between the wire and the atom cloud, r0, scaling \nas Γ ~ r-4 0 for a single atom waveguide. Considering an interferometer device, a \nstrong dependence of the decoherence rate on the trap geometry is found. \n \nStudying many-body eects in ultra-cold quantum gases is another important \nresearch eld. Experiments using ultra-cold quantum gases in optical lattices have \ndemonstrated the superuid-Mott insulator quantum phase transition and manybody \nentanglement. Optical lattices are based on a periodic modulation of the light \nintensity, generated by retro-reected laser beams. Correlations of the atomic cloud \nbetween dierent lattice sites of the optical lattice play a central role in these manybody \nexperiments. The dierent phases of the superuid-Mott insulator system can \nbe characterized by the dierent behavior of the inter-lattice site correlations. There \nare several numerical methods such as Quantum Monte Carlo (QMC) simulations, \nDensity Matrix Renormalization Group (DMRG) simulations, exact-diagonalization, \nor the Gutzwiller ansatz, to investigate the dynamics of an ultra-cold gas in an optical \nlattice theoretically. The Gutzwiller method, corresponding to the mean-eld solution, \nallows for the treatment of large lattice sizes. Mean-eld approaches have proven \nto be very useful to describe many-body physics. However, diculties arise in the correct \ndescription of the behavior of the decay of inter-lattice site correlations. Based on \nthe Gutzwiller approach, we have developed a method which allows the successive inclusion \nof inter-lattice site correlations. Comparing the results for the particle-number \nuctuations and the correlation function obtained from pure Gutzwiller calculations, \nto calculations which perturbatively include short-range correlations and calculations \n \nusing \\quasi-exact methods", showed a considerable improvement relative to the pure \nGutzwiller results due to the inclusion of short-range correlations. \nMany-body eects do not only arise in periodic potentials, but become increasingly \nimportant at ultra-low temperatures. The formation of Bose-Einstein condensates \nrequires an overlap of the atom wavefunctions and, hence, the formation of \na single condensate wavefunction. Another example of a many-body state is the \nsuperuid-BCS state, commonly used as a description of superconductivity. Here, \nfermions in dierent hyperne states form Cooper pairs. Experiments with ultracold \nquantum gases enable a variation of the interparticle interaction, e.g. , by using \na Feshbach resonance. Using Feshbach resonances to tune the interaction strength \nhas enabled the experimental observation of the crossover from a superuid-BCS \nstate to a Bose-Einstein condensate of molecules. A useful way to characterize the \ndierent states of ultra-cold quantum gases is to investigate the particle-number uctuations. \nIn this thesis we suggest to divide the atomic cloud into bins and consider \nthe atom-number uctuations in these bins. We calculate the full counting statistics \nfor dierent physical systems of ultra-cold gases (e.g. bosonic gases, fermionic gases, \nand spin mixtures). In particular, we consider the BCS-state as a rst trial example \nto show that there is a strong variation in the particle-number statistics at the \ncrossover from a superuid-BCS state to a Bose-Einstein condensate of molecules.