Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Annual Meeting Optical Society of America

Response of a self-pumped phase-conjugate mirror for two mutually coherent inputs

Tokuyuki Honda, Hirokazu Matsumoto

Published Jan 1, 1990• 0 citations
Publisher

Abstract

Photorefractive self-pumped phase conjugation is attractive for its simplicity and high reflectivity with low-power light sources. In order to realize its potential applications, it is important to study its response. So far the response of a phase-conjugate wave has been described with its rise time. It has not studied how the phase-conjugate wave responds when the spatial structure of an input probe wave is changed dynamically. We investigated the response of the phase conjugate wave by using two mutually coherent input beams, which can be regarded as components of a probe wave, and by introducing sinusoidal phase changes into one of them with varied frequencies. Each input beam has a power of 6 mW at the wavelength of 515 nm. A BaTiO3 crystal was employed as a self-pumped phase-conjugate mirror.1 By measuring relative phase between the two output beams, which can be regarded as components of a phase-conjugate wave, we found the response characteristic represented by a time-lag of first order, which is similar to RC circuit. The response time thus determined was 0.32 s, which was much shorter than the rise time of 30 s obtained with the same condition.

DOI
10.1364/oam.1990.thy18

Related papers

Controlling the frequency shift of a self-pumped phase conjugator

J. P. Jiang, Jack Feinberg

When the phase-conjugate replica of an optical beam is generated by traditional four-wave mixing with external pumping beams, the frequency of the phase-conjugate beam is fixed by the frequencies of the three input beams. In self-pumped phase conjugation, there is only one input beam, and the frequency of the output beam is free to roam. In photorefractive materials, this frequency difference between the incident and output beams is typically a few hertz. We present a method for controlling this frequency shift in the self-pumped phase-conjugate mirror that uses a ring configuration1 in photorefractive barium titanate. We show that two-beam coupling of an additional control beam with either of the optical beams already present in the ring cavity can alter the frequency of the phase-conjugate beam. We show that the control beam can alter the nonreciprocal phase shift2 of light propagating around the ring and thereby alter the frequency of the phase-conjugate beam. We also calculate the magnitude and the sign of the expected frequency shift as a function of the intensity, direction, and frequency of this control beam.

Annual Meeting Optical Society of America•Jan 1, 1986•0 citations

Mechanism for photorefractive phase conjugation using incoherent beams

M. D. Ewbank

Two mutually incoherent extraordinary laser beams, incident upon opposite a faces of a BaTiO 3 crystal, generate a get of photorefractive holograms that channel both beams toward the +c face of the crystal, where they are internally reflected into the opposite channel. The resultant cross coupling of the two incident beams produces a pair of phase-conjugate (ø * ) beams. This new photorefractive interaction is characterized by reasonable ø * reflectivities (~10–25%). good ø * fidelity, and no image cross talk. The variations in ø * reflectivity with crystal orientation, angles of incidence, and intensity ratio are presented. The formation times of the photorefractive gratings responsible for the phase conjugation are significantly shorter than those of other self-pumped phase conjugators.

WORLD SCIENTIFIC eBooks•Jul 1, 1995•0 citations

Mutually pumped phase conjugation in Kerr media

Ragini Saxena, Pochi Yeh

Several mutually pumped phase conjugation configurations have been experimentally demonstrated and theoretically studied in photorefractive media.1 Although these materials are very efficient at low operating power, the process is inherently slow due to the need to generate a large number of photo-induced charge carriers.2 This paper examines the possibility of the same process occurring in a transparent Kerr medium which offers the advantage of faster response times. Due to an electrostrictive nonlinearity in the medium, a photon from either of the two input beams can be spontaneously converted into a frequency downshifted Stokes photon and an acoustic phonon, a process better known as Brillouin scattering.3 The presence of phonons due to noise will also help in Stokes scattering the incident photons. Each pair of incident beam and its coherently generated scattered beam will then write a grating that is moving at the phonon velocity. Reading of this moving hologram by the other incoherent input beam may generate the cross-readout phase conjugated beam that is frequency shifted from the read beam by the frequency of the acoustic field. The nonlinear medium thus acts like a phase conjugate mirror to both of the incident beams. Since the read-write processes occur simultaneously, the dynamics of the beam coupling are described by NFWM equations in the nonlinear medium with appropriate boundary conditions. Our calculations show that it is indeed possible to phase conjugate the two mutually incoherent input beams simultaneously when the coupling strength is above a threshold value. If one of the input beams is very weak compared to the other input beam, it is phase conjugated with a very high reflection coefficient. We have also examined the effects of seeding the phase conjugated beams.

Annual Meeting Optical Society of America•Jan 1, 1989•0 citations

Self-oscillation in a photorefractive phase-conjugate mirror with linear absorption II Anisotropic four-wave mixing

Nitin C. Kothari

The effects of linear absorption on the degenerate and nondegenerate self-oscillation of a photorefractive phase-conjugate mirror under condition of anisotropic four-wave mixing are considered. The phase conjugation results from nonlinear mixing of two strong undepleted orthogonally polarized counterpropagating pump waves with a probe wave. We consider two types of situation for orthogonally polarized pump beams corresponding to two crystal families: one such as the Bi12SiO20 crystal family (sillenite family) and the other such as the BaTiO3 and strontium barium niobate crystal family. In both of these crystal families the degenerate and nondegenerate self-oscillations are shown to occur in the presence of linear absorption, which tends to increase the value of the coupling coefficient required for self-oscillation. Numerical results are presented that exhibit various features of degenerate and nondegenerate self-oscillation in both crystal families for different values of the phase ϕb of the backward grating.

Journal of the Optical Society of America B•Oct 1, 1996•2 citations

Nonlinear response of the photorefractive phase conjugator: a perturbation analysis

G. Li, Bahaa E. A. Saleh

Using perturbation theory, an examination is made of the fidelity of the photorefractive degenerate four-wave mixing phase conjugator. The general case is considered in which the probe is spatially varying (a beam) and temporally varying (a pulse), and the pumps are allowed to deplete. The probe wave is expanded as a sum of monochromatic plane-wave components. Carrying out the perturbation procedure up to the third order, the authors found that the components of the probe interact in pairs, so that the reflectance of each component of the conjugate wave is a combination of a linear term, a self-nonlinear term, and a term representing crosstalk with all other components of the probe. The crosstalk effect as a function of the frequency difference exhibits resonance behavior.>

IEEE Journal of Quantum Electronics•Apr 1, 1990•2 citations

Optical phase conjugation with a sodium Raman laser

Joanne DiFrancisco‐Donoghue, Jonathan S. Kane, Philip Hemmer

Recently, there has been increased interest in the use of resonant atomic systems for performing optical-wavefront conjugation. This interest has arisen because resonant systems are inherently fast, with response times in the nanosecond range. However, resonant systems tend to have lower efficiencies and greater optical power requirements than do photorefractive crystals, such as BaTiO3. In this paper, we explore the possibility of using a highly efficient Raman laser1 in a sodium-vapor cell to obtain efficient phase conjugation at greatly reduced optical power densities. In this demonstration we use a self-pumped (linear-cavity) conjugator for simplicity. With this setup, we have achieved phase- conjugate reflectivities of 2% with input powers of only 20 W/cm2. This is only 2% of the optical power density previously reported2 to obtain comparable reflectivity with a self-pumped scheme in sodium vapor.

Quantum Electronics and Laser Science Conference•May 12, 1991•0 citations
Photorefractive self-pumped phase conjugation is attractive for its simplicity and high reflectivity with low-power light sources. In order to realize its potential applications, it is important to study its response. So far the response of a phase-conjugate wave has been described with its rise time. It has not studied how the phase-conjugate wave responds when the spatial structure of an input probe wave is changed dynamically. We investigated the response of the phase conjugate wave by using two mutually coherent input beams, which can be regarded as components of a probe wave, and by introducing sinusoidal phase changes into one of them with varied frequencies. Each input beam has a power of 6 mW at the wavelength of 515 nm. A BaTiO3 crystal was employed as a self-pumped phase-conjugate mirror.1 By measuring relative phase between the two output beams, which can be regarded as components of a phase-conjugate wave, we found the response characteristic represented by a time-lag of first order, which is similar to RC circuit. The response time thus determined was 0.32 s, which was much shorter than the rise time of 30 s obtained with the same condition.
When the phase-conjugate replica of an optical beam is generated by traditional four-wave mixing with external pumping beams, the frequency of the phase-conjugate beam is fixed by the frequencies of the three input beams. In self-pumped phase conjugation, there is only one input beam, and the frequency of the output beam is free to roam. In photorefractive materials, this frequency difference between the incident and output beams is typically a few hertz. We present a method for controlling this frequency shift in the self-pumped phase-conjugate mirror that uses a ring configuration1 in photorefractive barium titanate. We show that two-beam coupling of an additional control beam with either of the optical beams already present in the ring cavity can alter the frequency of the phase-conjugate beam. We show that the control beam can alter the nonreciprocal phase shift2 of light propagating around the ring and thereby alter the frequency of the phase-conjugate beam. We also calculate the magnitude and the sign of the expected frequency shift as a function of the intensity, direction, and frequency of this control beam.
Two mutually incoherent extraordinary laser beams, incident upon opposite a faces of a BaTiO 3 crystal, generate a get of photorefractive holograms that channel both beams toward the +c face of the crystal, where they are internally reflected into the opposite channel. The resultant cross coupling of the two incident beams produces a pair of phase-conjugate (ø * ) beams. This new photorefractive interaction is characterized by reasonable ø * reflectivities (~10–25%). good ø * fidelity, and no image cross talk. The variations in ø * reflectivity with crystal orientation, angles of incidence, and intensity ratio are presented. The formation times of the photorefractive gratings responsible for the phase conjugation are significantly shorter than those of other self-pumped phase conjugators.
Several mutually pumped phase conjugation configurations have been experimentally demonstrated and theoretically studied in photorefractive media.1 Although these materials are very efficient at low operating power, the process is inherently slow due to the need to generate a large number of photo-induced charge carriers.2 This paper examines the possibility of the same process occurring in a transparent Kerr medium which offers the advantage of faster response times. Due to an electrostrictive nonlinearity in the medium, a photon from either of the two input beams can be spontaneously converted into a frequency downshifted Stokes photon and an acoustic phonon, a process better known as Brillouin scattering.3 The presence of phonons due to noise will also help in Stokes scattering the incident photons. Each pair of incident beam and its coherently generated scattered beam will then write a grating that is moving at the phonon velocity. Reading of this moving hologram by the other incoherent input beam may generate the cross-readout phase conjugated beam that is frequency shifted from the read beam by the frequency of the acoustic field. The nonlinear medium thus acts like a phase conjugate mirror to both of the incident beams. Since the read-write processes occur simultaneously, the dynamics of the beam coupling are described by NFWM equations in the nonlinear medium with appropriate boundary conditions. Our calculations show that it is indeed possible to phase conjugate the two mutually incoherent input beams simultaneously when the coupling strength is above a threshold value. If one of the input beams is very weak compared to the other input beam, it is phase conjugated with a very high reflection coefficient. We have also examined the effects of seeding the phase conjugated beams.
The effects of linear absorption on the degenerate and nondegenerate self-oscillation of a photorefractive phase-conjugate mirror under condition of anisotropic four-wave mixing are considered. The phase conjugation results from nonlinear mixing of two strong undepleted orthogonally polarized counterpropagating pump waves with a probe wave. We consider two types of situation for orthogonally polarized pump beams corresponding to two crystal families: one such as the Bi12SiO20 crystal family (sillenite family) and the other such as the BaTiO3 and strontium barium niobate crystal family. In both of these crystal families the degenerate and nondegenerate self-oscillations are shown to occur in the presence of linear absorption, which tends to increase the value of the coupling coefficient required for self-oscillation. Numerical results are presented that exhibit various features of degenerate and nondegenerate self-oscillation in both crystal families for different values of the phase ϕb of the backward grating.
Using perturbation theory, an examination is made of the fidelity of the photorefractive degenerate four-wave mixing phase conjugator. The general case is considered in which the probe is spatially varying (a beam) and temporally varying (a pulse), and the pumps are allowed to deplete. The probe wave is expanded as a sum of monochromatic plane-wave components. Carrying out the perturbation procedure up to the third order, the authors found that the components of the probe interact in pairs, so that the reflectance of each component of the conjugate wave is a combination of a linear term, a self-nonlinear term, and a term representing crosstalk with all other components of the probe. The crosstalk effect as a function of the frequency difference exhibits resonance behavior.>
Recently, there has been increased interest in the use of resonant atomic systems for performing optical-wavefront conjugation. This interest has arisen because resonant systems are inherently fast, with response times in the nanosecond range. However, resonant systems tend to have lower efficiencies and greater optical power requirements than do photorefractive crystals, such as BaTiO3. In this paper, we explore the possibility of using a highly efficient Raman laser1 in a sodium-vapor cell to obtain efficient phase conjugation at greatly reduced optical power densities. In this demonstration we use a self-pumped (linear-cavity) conjugator for simplicity. With this setup, we have achieved phase- conjugate reflectivities of 2% with input powers of only 20 W/cm2. This is only 2% of the optical power density previously reported2 to obtain comparable reflectivity with a self-pumped scheme in sodium vapor.