Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Annual Meeting Optical Society of America

Brillouin-enhanced four-wave mixing in CS2 for a frequency-recovered phase-conjugation mirror of an iodine laser

Byoung Choi, Min Sik Jo, Eung Cheol Kang, Chang Hee Nam

Published Jan 1, 1993• 0 citations
Publisher

Abstract

The Brillouin-enhanced four-wave mixing (BEFWM) has been investigated using CS2 as a nonlinear medium to develope a phase conjugation mirror for an iodine laser.
DOI
10.1364/oam.1993.wr.39

Related papers

Single cell Brillouin enhanced four-wave mixing with focusing geometry

Y. S. Kuo, Y. Fong, C. Wu +2 more

Brillouin enhanced four-wave mixing (BEFWM) is a judicious combination of SBS and FWM processes. In the traditional BEFWM experiments, two cells are used: one generates SBS, the other provides four-wave mixing. We demonstrated the generation of a phase conjugate signal by single cell BEFWM with focusing geometry. A single cell containing the optical nonlinear medium was used simultaneously for conventional SBS and FWM. Experiments were performed by using either CS2 or TiCl4 as the nonlinear medium; both have large Brillouin gain but differ greatly in their nonlinear indices of refraction. Thus the mechanism for four-wave mixing is shown to be Brillouin nonlinearity. In this experiment, the phase matching condition was satisfied and the frequency of the phase conjugate signal was not shifted from that of the master input beam. The operating regime of the experiment was far below the threshold of instability, which accounts for the low reflectivity that we observed. This single cell configuration is more compact and the optical alignment is easier than in the conventional BEFWM, in which two nonlinear cells are used.

Annual Meeting Optical Society of America•Jan 1, 1992•0 citations

Bandwidth effects on Brillouin enhanced four-wave mixing

Y. S. Kuo, J. K. McIver

Brillouin enhanced four-wave mixing (BEFWM) is a judicious combination of SBS and FWM processes. Very high phase conjugate reflectivity (>106) has been reported. Various conditions have been presented that lead to these high reflectivities, but all those discussions are based on a single mode laser. Here we report the experimental results of BEFWM with a multimode laser. The laser mode spacing is 0.15 GHz, which is larger than the linewidth of the acoustic phonon (0.1 GHz), so we can neglect the gratings that are not resonant with the acoustic frequency. We observed that the phase conjugate reflectivity is smaller for the multimode pump. Assume there is no coupling between modes through BEFWM and each mode interacts with the nonlinear medium independently. It has been shown that the reflectivity will decrease as the input pump power decreases. Thus the reflectivity of a single mode pump is higher than the resultant reflectivity from a multimode pump. Further examination of the temporal profiles of the probe and phase conjugate pulses in the multimode case shows that the pulse modulation depth is decreased in the phase conjugate pulse.

Annual Meeting Optical Society of America•Jan 1, 1992•0 citations

Experimental investigation of high resolution imaging using Brillouin-enhanced four-wave mixing

Anca Mocofanescu, L. Corner, R. Ramos-Garcia +1 more

We present the results of an experimental investigation of a polarization-decoupled Brillouin-enhanced four-wave mixing (BEFWM) configuration used for short-pulse high-resolution imaging. In this geometry, the four-wave mixing medium is carbon disulphide (CS2) and the counterpropagating pump is generated from the forward pump by stimulated Brillouin scattering in a second CS2 cell. This configuration produced a good quality, high resolution (∼9 μm) phase conjugate image of a United States Air Force test chart, correcting for aberrations in the system.

Journal of Modern Optics•Apr 1, 1997•2 citations

Self-phase conjugation technique via four wave mixing of middle infrared radiation in a laser active medium

Alexander A. Ageichik, Oleg G. Kotyaev, Yu. A. Rezunkov +2 more

As it is known, self-conjugation of the IR laser beam via Brillouin radiation stimulated scattering phenomenon is not realised because of some physical limits on radiation intensity which are the principal limitations, to the present time. That is why, one of the promising technique of phase conjugation of infrared radiation is a self-conjugation of a laser beam wavefront via four wave interaction in a nonlinear medium with feed-back loop (FWMF) [1]. Unlike conventional our wave mixing schemes, the FWMF self-conjugation is supposed to be realised without any additional beams pumping a phase conjugation mirror.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jan 1, 1996•0 citations

Optical Phase Conjugation Enhanced by the Brillouin Interaction.

Mark D. Skeldon

This thesis provides an in-depth study of the Brillouin interaction and how it can be exploited to enhance other nonlinear optical processes. The work begins with a detailed derivation of the equations of motion describing the stimulated Brillouin scattering (SBS) process. The derivation applies the principles of conservation of momentum and energy to a fluid particle in the medium, and evolves into a complete mathematical description of the SBS process including optical absorption and thermal effects. Predictions of the important parameters for this process, such as the SBS gain and reflectivity are given for the cases of a single and multimode laser. When using a multimode laser it is shown under what conditions the SBS gain and reflectivity are unaffected by the number of modes in the pump laser. Experiments carried out in this limit confirm the theoretical predictions. A novel scheme for combining SBS and conventional four-wave mixing into what is called Brillouin-enhanced four-wave mixing is discussed both theoretically and experimentally. This new geometry for producing a phase-conjugate signal is capable of combining the good features of both the SBS and four-wave mixing processes, while eliminating the undesirable features of these processes. This Brillouin-enhanced four-wave mixing process produces a phase-conjugate mirror with reflectivities greater than 100%, with no frequency shift on reflection, and produces a high-fidelity phase-conjugate signal even when using aberrated pump waves. Experimental verification of all these features is demonstrated. A phase-conjugate oscillator consisting of a conventional mirror and a phase-conjugate mirror based on Brillouin-enhanced four-wave mixing has been constructed. The beam divergence and near-field spot size of this oscillator has been measured for various cavity lengths and radii of curvature of the conventional mirror. A theoretical analysis of the mode structure of this oscillator has been performed assuming a Gaussian reflectivity profile for the phase-conjugate mirror. The beam-parameter measurements made on the experimental phase-conjugate oscillators are in good agreement with our theoretical analysis

•Jan 1, 1988•0 citations

Non-frequency-shifted, high-fidelity phase conjugation with aberrated pump waves by Brillouin-enhanced four-wave mixing

Mark D. Skeldon, Paul Narum, Robert W. Boyd

The results of an experimental investigation of a new geometry for producing phase conjugation by Brillouin-enhanced four-wave mixing are presented. In this geometry, the four-wave mixing medium is carbon disulfide, and the backward-going pump wave is created from the transmitted forward-going pump wave by stimulated Brillouin scattering (SBS) in glycerol. The two pump waves are hence phase conjugates of each other, and the quality of the phase-conjugation process is not degraded even by the use of an aberrated pump wave. The probe wave is created by SBS in carbon disulfide, which has a Brillouin frequency half that of glycerol, and the conjugate wave is therefore generated at the same frequency as the probe. Since the pump and signal waves differ in frequency by the Brillouin frequency of the carbon disulfide four-wave mixing medium, high reflectivities (approximately 2000%) are obtained as a result of Brillouin resonance enhancement.

Optics Letters•May 1, 1987•34 citations
Brillouin enhanced four-wave mixing (BEFWM) is a judicious combination of SBS and FWM processes. In the traditional BEFWM experiments, two cells are used: one generates SBS, the other provides four-wave mixing. We demonstrated the generation of a phase conjugate signal by single cell BEFWM with focusing geometry. A single cell containing the optical nonlinear medium was used simultaneously for conventional SBS and FWM. Experiments were performed by using either CS2 or TiCl4 as the nonlinear medium; both have large Brillouin gain but differ greatly in their nonlinear indices of refraction. Thus the mechanism for four-wave mixing is shown to be Brillouin nonlinearity. In this experiment, the phase matching condition was satisfied and the frequency of the phase conjugate signal was not shifted from that of the master input beam. The operating regime of the experiment was far below the threshold of instability, which accounts for the low reflectivity that we observed. This single cell configuration is more compact and the optical alignment is easier than in the conventional BEFWM, in which two nonlinear cells are used.
Brillouin enhanced four-wave mixing (BEFWM) is a judicious combination of SBS and FWM processes. Very high phase conjugate reflectivity (>106) has been reported. Various conditions have been presented that lead to these high reflectivities, but all those discussions are based on a single mode laser. Here we report the experimental results of BEFWM with a multimode laser. The laser mode spacing is 0.15 GHz, which is larger than the linewidth of the acoustic phonon (0.1 GHz), so we can neglect the gratings that are not resonant with the acoustic frequency. We observed that the phase conjugate reflectivity is smaller for the multimode pump. Assume there is no coupling between modes through BEFWM and each mode interacts with the nonlinear medium independently. It has been shown that the reflectivity will decrease as the input pump power decreases. Thus the reflectivity of a single mode pump is higher than the resultant reflectivity from a multimode pump. Further examination of the temporal profiles of the probe and phase conjugate pulses in the multimode case shows that the pulse modulation depth is decreased in the phase conjugate pulse.
We present the results of an experimental investigation of a polarization-decoupled Brillouin-enhanced four-wave mixing (BEFWM) configuration used for short-pulse high-resolution imaging. In this geometry, the four-wave mixing medium is carbon disulphide (CS2) and the counterpropagating pump is generated from the forward pump by stimulated Brillouin scattering in a second CS2 cell. This configuration produced a good quality, high resolution (∼9 μm) phase conjugate image of a United States Air Force test chart, correcting for aberrations in the system.
As it is known, self-conjugation of the IR laser beam via Brillouin radiation stimulated scattering phenomenon is not realised because of some physical limits on radiation intensity which are the principal limitations, to the present time. That is why, one of the promising technique of phase conjugation of infrared radiation is a self-conjugation of a laser beam wavefront via four wave interaction in a nonlinear medium with feed-back loop (FWMF) [1]. Unlike conventional our wave mixing schemes, the FWMF self-conjugation is supposed to be realised without any additional beams pumping a phase conjugation mirror.
This thesis provides an in-depth study of the Brillouin interaction and how it can be exploited to enhance other nonlinear optical processes. The work begins with a detailed derivation of the equations of motion describing the stimulated Brillouin scattering (SBS) process. The derivation applies the principles of conservation of momentum and energy to a fluid particle in the medium, and evolves into a complete mathematical description of the SBS process including optical absorption and thermal effects. Predictions of the important parameters for this process, such as the SBS gain and reflectivity are given for the cases of a single and multimode laser. When using a multimode laser it is shown under what conditions the SBS gain and reflectivity are unaffected by the number of modes in the pump laser. Experiments carried out in this limit confirm the theoretical predictions. A novel scheme for combining SBS and conventional four-wave mixing into what is called Brillouin-enhanced four-wave mixing is discussed both theoretically and experimentally. This new geometry for producing a phase-conjugate signal is capable of combining the good features of both the SBS and four-wave mixing processes, while eliminating the undesirable features of these processes. This Brillouin-enhanced four-wave mixing process produces a phase-conjugate mirror with reflectivities greater than 100%, with no frequency shift on reflection, and produces a high-fidelity phase-conjugate signal even when using aberrated pump waves. Experimental verification of all these features is demonstrated. A phase-conjugate oscillator consisting of a conventional mirror and a phase-conjugate mirror based on Brillouin-enhanced four-wave mixing has been constructed. The beam divergence and near-field spot size of this oscillator has been measured for various cavity lengths and radii of curvature of the conventional mirror. A theoretical analysis of the mode structure of this oscillator has been performed assuming a Gaussian reflectivity profile for the phase-conjugate mirror. The beam-parameter measurements made on the experimental phase-conjugate oscillators are in good agreement with our theoretical analysis
The results of an experimental investigation of a new geometry for producing phase conjugation by Brillouin-enhanced four-wave mixing are presented. In this geometry, the four-wave mixing medium is carbon disulfide, and the backward-going pump wave is created from the transmitted forward-going pump wave by stimulated Brillouin scattering (SBS) in glycerol. The two pump waves are hence phase conjugates of each other, and the quality of the phase-conjugation process is not degraded even by the use of an aberrated pump wave. The probe wave is created by SBS in carbon disulfide, which has a Brillouin frequency half that of glycerol, and the conjugate wave is therefore generated at the same frequency as the probe. Since the pump and signal waves differ in frequency by the Brillouin frequency of the carbon disulfide four-wave mixing medium, high reflectivities (approximately 2000%) are obtained as a result of Brillouin resonance enhancement.