Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)

Cavity build-up and transient fluctuations in optical-fibre-loop memories

M. Calzavara

Published Jan 1, 1994• 0 citations
Publisher

Abstract

The use of fibre-loop memories is being experimented for solving routing contention of data cells in photonic high bit rate ATM switching fabrics.1 The simplest fiber-loop memory looks like a ring laser consisting of a semiconductor laser amplifier (SOA), a span of fibre introducing a delay of the order of an ATM cell duration (10–6-sec) and a 50/50 directional coupler (Fig. 1). To compensate for the power tapping at the directional coupler while avoiding the onset of laser oscillations, the SOA is biased above the ring laser threshold only for a limited number of round trips, then the bias current is switched off. The memory is thus driven through the transition from a state ruled by spontaneous emission toward a state above lasing threshold, in which stimulated emission is predominant. Far enough from the beginning of the transition the intensity fluctuations display a maximum.2,3 The transition is completed after a time depending on the final state intensity.2 These features significantly affect the maximum storage time and noise behavior of the memory.

DOI
10.1364/cleo_europe.1994.cwj2

Related papers

SOA Fiber Ring Laser-Based Three-State Optical Memory

Jing Wang, Yuancheng Zhang, Antonio Malacarne +3 more

By exploiting three coupled semiconductor optical amplifier (SOA) fiber ring lasers, a compact, integratable, and polarization-independent three-state all-optical memory is demonstrated, with 40-dB extinction ratio for each state. Dynamic flip-flop operation between states is also demonstrated with switching pulse energy of 13.6 nJ. Due to the broad bandwidth of SOA gain spectrum, the wavelength range of set pulses is large. Finally, the transition behavior of state switching is investigated.

IEEE Photonics Technology Letters•Aug 28, 2008•10 citations

Polarization-based data storage in fibre ring lasers

Jordi García‐Ojalvo, Rajarshi Roy

The possibility of storing information in an amplifying optical fibre loop operating in a laser regime is discussed. Numerical simulations show that storage is possible and optimal when data are encoded in one of the polarization eigenstates of the fibre, provided the polarization direction of the light propagating inside the loop is switched between two orthogonal states every round trip.

Quantum and Semiclassical Optics Journal of the European Optical Society Part B•Dec 1, 1998•0 citations

Passive fiber ring flip-flop memory based on polarization dynamics

Jorge García-Mateos, Fernando Canal, Marc Haelterman

Optical storage devices are essential elements of future ultra-high bit-rate fiber communications systems in which they will find applications to various vital functions. Pulse pattern storage has been demonstrated in various fiber loop devices [1] that involve pulse control techniques in order to provide timing stability of the bit patterns. Most of these stabilization techniques are based on electrooptic modulation which limits the bit rates to a tenth of Gb/s. Moreover, erasing the data in these storage fiber loops requires switching off the system elect rooptically. Individual bit addressing is therefore impossible, which considerably restricts the functionality of the devices. We investigate here the possibility of developing a new type of all-optical fiber loop storage device. This device consists of a simple nonlinear passive fiber ring resonator synchronously and coherently pumped by a cw mode-locked train of ultrashort pulses. It is well known that this system exhibits rich nonlinear dynamics, in particular, optical bistability which is a feature naturally suited for applications to optical storage. However, erasing the data in an optical bistable element requires to switch off the holding beam and is therefore not practical. Recently, Haelterman et al. [2] have studied the polarization dynamics of nonlinear dispersive ring cavities with cw pump and have shown that these devices exhibit a polarization symmetry breaking characterized by a pitchfork bifurcation. This feature can be applied to the development of a set-reset flip-flop all-optical fiber loop pulsed memory. This work aims at presenting the results of a preliminary investigation of such a storage device.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jan 1, 1996•0 citations

Fiber-integrated quantum memory for telecom light

Kent Bonsma-Fisher, Cyril Hnatovsky, Dan M. Grobnic +4 more

We demonstrate the storage and on-demand retrieval of single-photon-level telecom pulses in a fiber cavity. The cavity is formed by fiber Bragg gratings at either end of a single-mode fiber. Photons are mapped into and out of the cavity using quantum frequency conversion driven by intense control pulses. In a first spliced-fiber cavity, we demonstrate storage up to $0.55\phantom{\rule{0.16em}{0ex}}\ensuremath{\mu}\mathrm{s}$ (11 cavity round trips), with $11.3%\ifmmode\pm\else\textpm\fi{}0.1$% total memory efficiency and a signal-to-noise ratio (SNR) of 12.8 after one round trip. In a second, monolithic cavity, we increase this lifetime to $1.75\phantom{\rule{0.16em}{0ex}}\ensuremath{\mu}\mathrm{s}$ (35 round trips) with a memory efficiency of $12.7%\ifmmode\pm\else\textpm\fi{}0.2%$ (SNR of $7.0\ifmmode\pm\else\textpm\fi{}0.2$) after one round trip. Fiber-based cavities for quantum storage at telecom wavelengths offer a promising route to synchronizing spontaneous-photon-generation events and building scalable quantum networks.

arXiv:2303.12794•Physical Review A•Jul 7, 2023•9 citations

Temporal evolution of amplitude restoration and thresholding in an all-optical regenerative memory

Alistair J. Poustie, K. J. Blow, Anthony E. Kelly +1 more

In this paper, we experimentally measure the temporal evolution of amplitude restoration and thresholding in an all-optical regenerative memory. The memory architecture comprises two coupled all-optical switching gates and different wavelength optical pulses are used for clock and data sources. The all-optical gates are nonlinear interferometers incorporating semiconductor optical amplifiers as the nonlinear optical material. The concatenated response of these nonlinear interferometers provides the required square top transmission function that allows the stored optical pulses to be equalized in amplitude. The edge of the transmission function forms the threshold for pulse storage in the memory. We input a variable amplitude data packet into the memory and record the temporal evolution of the pulses with a fast real-time digitizing oscilloscope. Complete amplitude restoration of the pulses occurs after ∼5 circulations of the optical fibre memory loop. This measurement is in good agreement with the theoretical prediction and indicates that the square top transmission response could also be achieved for data ‚on the fly‘ with a linear concatenation of only a few all-optical switching gates.

Journal of Modern Optics•Jul 1, 1999•5 citations

Ultra-Fast All-Optical Memory based on Quantum Dot Semiconductor Optical Amplifiers (QD-SOA)

Yossef Ben Ezra, Boris I. Lembrikov

All-optical signal processing is characterized by high bit-rate, power efficiency, high bandwidth, and transparency. All-optical logic gates are basic logic units for the all-optical signal processing implementation. Typically, all-optical gates are based on strong optical nonlinearities related in particular to semiconductor optical amplifiers (SOA). We briefly review the state of art in the field of all-optical logic gates and all-optical memory. In the original part, we discuss the ultrafast all-optical memory loop based on the Mach-Zehnder interferometer (MZI) with quantum dot (QD) semiconductor optical amplifier (SOA) in each arm.

InTech eBooks•Jun 21, 2017•3 citations
The use of fibre-loop memories is being experimented for solving routing contention of data cells in photonic high bit rate ATM switching fabrics.1 The simplest fiber-loop memory looks like a ring laser consisting of a semiconductor laser amplifier (SOA), a span of fibre introducing a delay of the order of an ATM cell duration (10–6-sec) and a 50/50 directional coupler (Fig. 1). To compensate for the power tapping at the directional coupler while avoiding the onset of laser oscillations, the SOA is biased above the ring laser threshold only for a limited number of round trips, then the bias current is switched off. The memory is thus driven through the transition from a state ruled by spontaneous emission toward a state above lasing threshold, in which stimulated emission is predominant. Far enough from the beginning of the transition the intensity fluctuations display a maximum.2,3 The transition is completed after a time depending on the final state intensity.2 These features significantly affect the maximum storage time and noise behavior of the memory.
Optical storage devices are essential elements of future ultra-high bit-rate fiber communications systems in which they will find applications to various vital functions. Pulse pattern storage has been demonstrated in various fiber loop devices [1] that involve pulse control techniques in order to provide timing stability of the bit patterns. Most of these stabilization techniques are based on electrooptic modulation which limits the bit rates to a tenth of Gb/s. Moreover, erasing the data in these storage fiber loops requires switching off the system elect rooptically. Individual bit addressing is therefore impossible, which considerably restricts the functionality of the devices. We investigate here the possibility of developing a new type of all-optical fiber loop storage device. This device consists of a simple nonlinear passive fiber ring resonator synchronously and coherently pumped by a cw mode-locked train of ultrashort pulses. It is well known that this system exhibits rich nonlinear dynamics, in particular, optical bistability which is a feature naturally suited for applications to optical storage. However, erasing the data in an optical bistable element requires to switch off the holding beam and is therefore not practical. Recently, Haelterman et al. [2] have studied the polarization dynamics of nonlinear dispersive ring cavities with cw pump and have shown that these devices exhibit a polarization symmetry breaking characterized by a pitchfork bifurcation. This feature can be applied to the development of a set-reset flip-flop all-optical fiber loop pulsed memory. This work aims at presenting the results of a preliminary investigation of such a storage device.
We demonstrate the storage and on-demand retrieval of single-photon-level telecom pulses in a fiber cavity. The cavity is formed by fiber Bragg gratings at either end of a single-mode fiber. Photons are mapped into and out of the cavity using quantum frequency conversion driven by intense control pulses. In a first spliced-fiber cavity, we demonstrate storage up to $0.55\phantom{\rule{0.16em}{0ex}}\ensuremath{\mu}\mathrm{s}$ (11 cavity round trips), with 11.311.3%\ifmmode\pm\else\textpm\fi{}0.111.3% total memory efficiency and a signal-to-noise ratio (SNR) of 12.8 after one round trip. In a second, monolithic cavity, we increase this lifetime to $1.75\phantom{\rule{0.16em}{0ex}}\ensuremath{\mu}\mathrm{s}$ (35 round trips) with a memory efficiency of 12.712.7%\ifmmode\pm\else\textpm\fi{}0.2%12.7 (SNR of $7.0\ifmmode\pm\else\textpm\fi{}0.2$) after one round trip. Fiber-based cavities for quantum storage at telecom wavelengths offer a promising route to synchronizing spontaneous-photon-generation events and building scalable quantum networks.
In this paper, we experimentally measure the temporal evolution of amplitude restoration and thresholding in an all-optical regenerative memory. The memory architecture comprises two coupled all-optical switching gates and different wavelength optical pulses are used for clock and data sources. The all-optical gates are nonlinear interferometers incorporating semiconductor optical amplifiers as the nonlinear optical material. The concatenated response of these nonlinear interferometers provides the required square top transmission function that allows the stored optical pulses to be equalized in amplitude. The edge of the transmission function forms the threshold for pulse storage in the memory. We input a variable amplitude data packet into the memory and record the temporal evolution of the pulses with a fast real-time digitizing oscilloscope. Complete amplitude restoration of the pulses occurs after ∼5 circulations of the optical fibre memory loop. This measurement is in good agreement with the theoretical prediction and indicates that the square top transmission response could also be achieved for data ‚on the fly‘ with a linear concatenation of only a few all-optical switching gates.
All-optical signal processing is characterized by high bit-rate, power efficiency, high bandwidth, and transparency. All-optical logic gates are basic logic units for the all-optical signal processing implementation. Typically, all-optical gates are based on strong optical nonlinearities related in particular to semiconductor optical amplifiers (SOA). We briefly review the state of art in the field of all-optical logic gates and all-optical memory. In the original part, we discuss the ultrafast all-optical memory loop based on the Mach-Zehnder interferometer (MZI) with quantum dot (QD) semiconductor optical amplifier (SOA) in each arm.