Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Progress of Theoretical and Experimental Physics

Reconstructing quantum states via unambiguous state discrimination

Naser Karimi, Hadi Z. Olyaei, Marziyeh Yahyavi, M. A. Jafarizadeh

Published Nov 21, 2022• 4 citations
Publisher

Abstract

Abstract In this paper, we introduce an analytical framework for the reconstruction of quantum states. The reconstruction of an unknown quantum state requires the information of a complete set of observables, obtained through experimental measurements of Hermitian operators usually defined as positive-operator-valued measures (POVMs). The scheme involves a single-qubit unambiguous state discrimination POVM, which can be generalized to perform n-qubit measurements. We also use maximum likelihood estimation as a method in the reconstruction of the density matrix from experimental data and show that the expected value of the cleaner is independent of the parameter of the density operator.

DOI
10.1093/ptep/ptac153

Related papers

Quantum tomography via unambiguous state discrimination

Roberto Salazar, A. Delgado

We study the determination of an unknown mixed state of a $d$-dimensional quantum system by means of unambiguous state discrimination. We show that optimal and nonoptimal unambiguous state discrimination can be used to reconstruct unknown states of a qubit. This result is extended to the case of a qudit by a sequence of reconstructions in two-dimensional subspaces. The total number of projections scales approximately as $2{d}^{2}$ for $d$ large; this is twice as much as in the case of tomography based on mutually unbiased bases or symmetric informationally complete positive-operator-valued measures, and less than the ${d}^{3}$ projections required by standard tomography.

Physical Review A•Jul 25, 2012•15 citations

Self-consistent state and measurement tomography with fewer measurements

A. Stephens, Jacob Cutshall, T. McPhee +1 more

We describe a technique for self-consistently characterizing both the quantum state of a single-qubit system, and the positive-operator-valued measure (POVM) that describes measurements on the system. The method works with only 10 measurements. We assume that a series of unitary transformations performed on the quantum state are fully known, while making minimal assumptions about both the density operator of the state and the POVM. The technique returns maximum-likely estimates of both the density operator and the POVM. To experimentally demonstrate the method, we perform reconstructions of over 300 state-measurement pairs, and we compare them to their expected density operators and POVMs. We find that 95% of the reconstructed POVMs have fidelities of 0.98 or greater, and 92% of the density operators have fidelities that are 0.98 or greater.

arXiv:2107.00121•Physical Review A•Jul 19, 2021•5 citations

Process positive-operator-valued measure: A mathematical framework for the description of process tomography experiments

Mário Ziman

We introduce a mathematical framework for the description of measurements of quantum processes. Using this framework, process estimation problems can be treated in a similar way as state estimation problems, only replacing the concept of positive-operator-valued measure (POVM) by the concept of process POVM (PPOVM). In particular, we will show that any measurement of qudit channels can be described by a collection of effects (positive operators) defined on a two-qudit system. However, the effects forming a PPOVM are not normalized in the usual sense. We will demonstrate the use of this formalism in discrimination problems by showing that perfect channel discrimination is equivalent to a specific unambiguous state discrimination.

arXiv:0802.3862•Physical Review A•Jun 24, 2008•89 citations

Quantum state tomography with noninstantaneous measurements, imperfections, and decoherence

Pierre Six, Philippe Campagne-Ibarcq, I. Dotsenko +3 more

Tomography of a quantum state is usually based on a positive-operator-valued measure (POVM) and on their experimental statistics. Among the available reconstructions, the maximum-likelihood (MaxLike) technique is an efficient one. We propose an extension of this technique when the measurement process cannot be simply described by an instantaneous POVM. Instead, the tomography relies on a set of quantum trajectories and their measurement records. This model includes the fact that, in practice, each measurement could be corrupted by imperfections and decoherence, and could also be associated with the record of continuous-time signals over a finite amount of time. The goal is then to retrieve the quantum state that was present at the start of this measurement process. The proposed extension relies on an explicit expression of the likelihood function via the effective matrices appearing in quantum smoothing and solutions of the adjoint quantum filter. It allows us to retrieve the initial quantum state as in standard MaxLike tomography, but where the traditional POVM operators are replaced by more general ones that depend on the measurement record of each trajectory. It also provides, aside from the MaxLike estimate of the quantum state, confidence intervals for any observable. Such confidence intervals are derived, as the MaxLike estimate, from an asymptotic expansion of multidimensional Laplace integrals appearing in Bayesian mean estimation. A validation is performed on two sets of experimental data: photon(s) trapped in a microwave cavity subject to quantum nondemolition measurements relying on Rydberg atoms, and heterodyne fluorescence measurements of a superconducting qubit.

arXiv:1510.01726•Physical Review A•Jan 12, 2016•30 citations

Quantum state reconstruction: a comparison of maximum likelihood and tomographic schemes

Daniel F. V. James, Paul G. Kwiat, Z. Hradil +2 more

Summary form only given. Experimental techniques for measurement of the quantum state of light have been the subject of intensive investigation for some time. Tomographic techniques have been applied to experiments such as the homodyne measurement of the Wigner function of a single mode of light and of the density matrix of the polarization degrees of freedom of a pair of entangled photons. In this technique, the density matrix (or Wigner function) which characterizes the quantum state of the system being measured is found from a linear transformation of experimental data. There are a number of drawbacks to the method, principally in that the recovered state might not, because of experimental noise, correspond to a physical state. For example, density matrices for any quantum state must be Hermitian, positive semi-definite matrices with unit trace. The tomographically measured matrices often fail to be positive semi-definite. To avoid this problem, the maximum likelihood approach to the estimation of quantum states has been developed. We evaluate two different approaches to the maximum likelihood technique, namely defining the likelihood function f as a weighted sum of squared variances from measured data, and defining it in terms of information content. These are compared with results of standard tomographical schemes.

Quantum Electronics and Laser Science Conference•Nov 13, 2002•2 citations

Quantum state reconstruction and optimal manipulations with quantum information (1996 IOC Prize Winner)

Vladimír Bužek

The concept of a quantum state represents one of the most fundamental pillars of the paradigm of quantum theory.'3 Contrary to its mathematical elegance and convenience in calculations, the physical interpretation of a quantum state is not so transparent. The problem is that the quantum state (described either by a state vector, or density operator or a phase-space probability density distribution) does not have a well defined objective status, i.e. a state vector is not an objective property of a particle. According to Peres (see,1 p. 374): "There is no physical evidence whatsoever that every physical system has at every instant a well defined state. .. In strict interpretation of quantum theory these mathematical symbols [i.e., state vectorsi represent statistical information enabling us to compute the probabilities of occurrence of specific events." Once this point of view is adopted then it becomes clear that any "measurement" or a reconstruction of a density operator (or its mathematical equivalent) can be understood exclusively as an expression of our knowledge about the quantum mechanical state based on a certain set of measured data. To be more specific, any quantum-mechanical reconstruction scheme is nothing more than an a posteriori estimation of the density operator of a quantum-mechanical (microscopic) system based on data obtained with the help of a macroscopic measurement apparatus.3 The quality of the reconstruction depends on the "quality" of the measured data and the efficiency of the reconstruction procedure with the help of which the data analysis is performed. In particular, we can specify three different situations. Firstly, when all system observables are precisely measured. In this case the complete reconstruction of an initially unknown state can be performed (we will call this the reconstruction on the complete observation level) . Secondly, when just part of the system observables is precisely measured then one cannot perform a complete reconstruction of the measured state. Nevertheless, the reconstructed density operator still uniquely determines mean values of the measured observables (we will denote this scheme as reconstruction on incomplete observation levels) . Finally, when measurement does not provide us with sufficient information to specify the exact mean values (or probability distributions) but only the frequencies of appearances of eigenstates of the measured observables, then one can perform an estimation (e.g. reconstruction based on quantum Bayesian inference) which is the "best" with respect to the given measured data and the a priori knowledge about the state of the measured system.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 19, 1999•0 citations
Abstract In this paper, we introduce an analytical framework for the reconstruction of quantum states. The reconstruction of an unknown quantum state requires the information of a complete set of observables, obtained through experimental measurements of Hermitian operators usually defined as positive-operator-valued measures (POVMs). The scheme involves a single-qubit unambiguous state discrimination POVM, which can be generalized to perform n-qubit measurements. We also use maximum likelihood estimation as a method in the reconstruction of the density matrix from experimental data and show that the expected value of the cleaner is independent of the parameter of the density operator.
We study the determination of an unknown mixed state of a ddd-dimensional quantum system by means of unambiguous state discrimination. We show that optimal and nonoptimal unambiguous state discrimination can be used to reconstruct unknown states of a qubit. This result is extended to the case of a qudit by a sequence of reconstructions in two-dimensional subspaces. The total number of projections scales approximately as 2d22{d}^{2}2d2 for ddd large; this is twice as much as in the case of tomography based on mutually unbiased bases or symmetric informationally complete positive-operator-valued measures, and less than the d3{d}^{3}d3 projections required by standard tomography.
We describe a technique for self-consistently characterizing both the quantum state of a single-qubit system, and the positive-operator-valued measure (POVM) that describes measurements on the system. The method works with only 10 measurements. We assume that a series of unitary transformations performed on the quantum state are fully known, while making minimal assumptions about both the density operator of the state and the POVM. The technique returns maximum-likely estimates of both the density operator and the POVM. To experimentally demonstrate the method, we perform reconstructions of over 300 state-measurement pairs, and we compare them to their expected density operators and POVMs. We find that 95% of the reconstructed POVMs have fidelities of 0.98 or greater, and 92% of the density operators have fidelities that are 0.98 or greater.
We introduce a mathematical framework for the description of measurements of quantum processes. Using this framework, process estimation problems can be treated in a similar way as state estimation problems, only replacing the concept of positive-operator-valued measure (POVM) by the concept of process POVM (PPOVM). In particular, we will show that any measurement of qudit channels can be described by a collection of effects (positive operators) defined on a two-qudit system. However, the effects forming a PPOVM are not normalized in the usual sense. We will demonstrate the use of this formalism in discrimination problems by showing that perfect channel discrimination is equivalent to a specific unambiguous state discrimination.
Tomography of a quantum state is usually based on a positive-operator-valued measure (POVM) and on their experimental statistics. Among the available reconstructions, the maximum-likelihood (MaxLike) technique is an efficient one. We propose an extension of this technique when the measurement process cannot be simply described by an instantaneous POVM. Instead, the tomography relies on a set of quantum trajectories and their measurement records. This model includes the fact that, in practice, each measurement could be corrupted by imperfections and decoherence, and could also be associated with the record of continuous-time signals over a finite amount of time. The goal is then to retrieve the quantum state that was present at the start of this measurement process. The proposed extension relies on an explicit expression of the likelihood function via the effective matrices appearing in quantum smoothing and solutions of the adjoint quantum filter. It allows us to retrieve the initial quantum state as in standard MaxLike tomography, but where the traditional POVM operators are replaced by more general ones that depend on the measurement record of each trajectory. It also provides, aside from the MaxLike estimate of the quantum state, confidence intervals for any observable. Such confidence intervals are derived, as the MaxLike estimate, from an asymptotic expansion of multidimensional Laplace integrals appearing in Bayesian mean estimation. A validation is performed on two sets of experimental data: photon(s) trapped in a microwave cavity subject to quantum nondemolition measurements relying on Rydberg atoms, and heterodyne fluorescence measurements of a superconducting qubit.
Summary form only given. Experimental techniques for measurement of the quantum state of light have been the subject of intensive investigation for some time. Tomographic techniques have been applied to experiments such as the homodyne measurement of the Wigner function of a single mode of light and of the density matrix of the polarization degrees of freedom of a pair of entangled photons. In this technique, the density matrix (or Wigner function) which characterizes the quantum state of the system being measured is found from a linear transformation of experimental data. There are a number of drawbacks to the method, principally in that the recovered state might not, because of experimental noise, correspond to a physical state. For example, density matrices for any quantum state must be Hermitian, positive semi-definite matrices with unit trace. The tomographically measured matrices often fail to be positive semi-definite. To avoid this problem, the maximum likelihood approach to the estimation of quantum states has been developed. We evaluate two different approaches to the maximum likelihood technique, namely defining the likelihood function f as a weighted sum of squared variances from measured data, and defining it in terms of information content. These are compared with results of standard tomographical schemes.
The concept of a quantum state represents one of the most fundamental pillars of the paradigm of quantum theory.'3 Contrary to its mathematical elegance and convenience in calculations, the physical interpretation of a quantum state is not so transparent. The problem is that the quantum state (described either by a state vector, or density operator or a phase-space probability density distribution) does not have a well defined objective status, i.e. a state vector is not an objective property of a particle. According to Peres (see,1 p. 374): "There is no physical evidence whatsoever that every physical system has at every instant a well defined state. .. In strict interpretation of quantum theory these mathematical symbols [i.e., state vectorsi represent statistical information enabling us to compute the probabilities of occurrence of specific events." Once this point of view is adopted then it becomes clear that any "measurement" or a reconstruction of a density operator (or its mathematical equivalent) can be understood exclusively as an expression of our knowledge about the quantum mechanical state based on a certain set of measured data. To be more specific, any quantum-mechanical reconstruction scheme is nothing more than an a posteriori estimation of the density operator of a quantum-mechanical (microscopic) system based on data obtained with the help of a macroscopic measurement apparatus.3 The quality of the reconstruction depends on the "quality" of the measured data and the efficiency of the reconstruction procedure with the help of which the data analysis is performed. In particular, we can specify three different situations. Firstly, when all system observables are precisely measured. In this case the complete reconstruction of an initially unknown state can be performed (we will call this the reconstruction on the complete observation level) . Secondly, when just part of the system observables is precisely measured then one cannot perform a complete reconstruction of the measured state. Nevertheless, the reconstructed density operator still uniquely determines mean values of the measured observables (we will denote this scheme as reconstruction on incomplete observation levels) . Finally, when measurement does not provide us with sufficient information to specify the exact mean values (or probability distributions) but only the frequencies of appearances of eigenstates of the measured observables, then one can perform an estimation (e.g. reconstruction based on quantum Bayesian inference) which is the "best" with respect to the given measured data and the a priori knowledge about the state of the measured system.