Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Institute of Physics eBooks

Population inversion with moderate pumping

Prem Ballabh Bisht

Published Aug 1, 2022• 0 citations
Publisher
DOI
10.1088/978-0-7503-5226-0ch6

Related papers

Population Inversion without Pumping: Supradegeneracy

Daniel P. Sheehan

Bulletin of the American Physical Society•Mar 9, 2018•0 citations

Transient Population Inversion Induced and Probed by a Signal Pulse in a Continuous-Wave-Pumped Erbium-Doped Fiber Amplifier

K. Kuroda, Yuzo Yoshikuni

We report on the transient population inversion in a continuous-wave (CW)-pumped erbium-doped fiber amplifier. The temporal profile of the population inversion of the erbium-doped fiber amplifier is probed by a signal pulse that induces a decrease in the population inversion. The pump and signal power dependences of the profile are measured. We analyze the dependences by applying an analytical formula describing the temporal evolution of the population inversion at the input end of the fiber.

Japanese Journal of Applied Physics•Nov 8, 2012•9 citations

Studies of Ruby Superfluorescence and Population Inversion

P. V. Avizonis, William R. Willoughby

It was found that by observing the fluorescent intensity of ruby along its longitudinal axis during pumping, an appreciable amount of information may be obtained. It was observed that the time at which population inversion occurs during a pump cycle is directly observable from the time-resolved fluorescent intensity. A method for establishing the actual population in the metastable state from the fluorescent intensity is demonstrated and cross correlated with two other methods for measuring population inversion. The rate equation describing population inversion has been solved including the nonlinear stimulated emission loss term, and complete agreement with experiment is demonstrated. For the particular pumping geometry used, maximum energy available, and ruby quality and size, maximum metastable population of 1.21×1019 ions/cm3 was achieved, representing 75% inversion.

Journal of Applied Physics•Feb 1, 1966•18 citations

Population Inversion

Galina Nemova

SPIE eBooks•Mar 23, 2022•0 citations

Lasing without inversion in a closed three-level system

Yifu Zhu

It is shown that a closed V-type, three-level system, which is incoherently pumped on the transition at which lasing occurs and coherently pumped on the other transition, exhibits lasing without population inversion in any atomic state basis. The same system can be also made to exhibit lasing without population inversion in the bare atomic state basis but with population inversion in the dressed-state basis.

Physical Review A•May 1, 1992•125 citations

Population inversion in a three-level system

V. B. Krasovit︠s︡kiĭ, A.R. Linetskii

Radiophysics and Quantum Electronics•Feb 1, 1968•0 citations
It was found that by observing the fluorescent intensity of ruby along its longitudinal axis during pumping, an appreciable amount of information may be obtained. It was observed that the time at which population inversion occurs during a pump cycle is directly observable from the time-resolved fluorescent intensity. A method for establishing the actual population in the metastable state from the fluorescent intensity is demonstrated and cross correlated with two other methods for measuring population inversion. The rate equation describing population inversion has been solved including the nonlinear stimulated emission loss term, and complete agreement with experiment is demonstrated. For the particular pumping geometry used, maximum energy available, and ruby quality and size, maximum metastable population of 1.21×1019 ions/cm3 was achieved, representing 75% inversion.