Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum 2.0 Conference and Exhibition

Proof-of-Principle Laboratory Demonstration of Long-Baseline Interferometric Imaging Using Distributed Single-Photons

Matthew Brown, Valérian Thiel, Markus Allgaier, Michael G. Raymer, Brian J. Smith, Paul G. Kwiat, John D. Monnier

Published Jan 1, 2022• 1 citation
Publisher

Abstract

We report results of very-long-baseline interferometric imaging using distributed single photons. We demonstrate source autocorrelation reconstruction, and increased signal-to-noise ratio per detected coincidence compared to using classical states as phase reference.
DOI
10.1364/quantum.2022.qm3c.1

Related papers

Comparing Weak References For Quantum Long-Baseline Telescopy

Matthew Brown, Markus Allgaier, Michael G. Raymer +1 more

We compare the signal-to-noise ratio for different measurements that could be used for stellar interferometry. We find that single-photon sources with number-resolved detection outperform other weak local oscillator states.

Quantum 2.0 Conference and Exhibition•Jan 1, 2024•0 citations

Long-baseline interferometry using single photon states as a non-local oscillator

Matthew Brown, Valérian Thiel, Markus Allgaier +4 more

Recent proposals suggest that distributed single photons serving as a ‘non-local oscillator’ can outperform coherent states as a phase reference for long-baseline interferometric imaging of weak sources [1,2]. Such nonlocal quantum states distributed between telescopes can, in-principle, surpass the limitations of conventional interferometric-based astronomical imaging approaches for very-long baselines such as: signal-to-noise, shot noise, signal loss, and faintness of the imaged objects. Here we demonstrate in a table-top experiment, interference between a nonlocal oscillator generated by equal-path splitting of an idler photon from a pulsed, separable, parametric down conversion process and a spectrally single-mode, quasi-thermal source. We compare the single-photon nonlocal oscillator to a more conventional local oscillator with uncertain photon number. Both methods enabled reconstruction of the source’s Gaussian spatial distribution by measurement of the interference visibility as a function of baseline separation and then applying the van Cittert-Zernike theorem [3,4]. In both cases, good qualitative agreement was found with the reconstructed source width and the known source width as measured using a camera. We also report an increase of signal-to-noise per ‘faux’ stellar photon detected when heralding the idler photon. 1593 heralded (non-local oscillator) detection events led to a maximum visibility of ~17% compared to the 10412 unheralded (classical local oscillator) detection events, which gave rise to a maximum visibility of ~10% – the first instance of quantum-enhanced sensing in this context.

Quantum Computing, Communication, and Simulation•Mar 2, 2022•6 citations

Interferometry-Based Astronomical Imaging Using Nonlocal Interference with Single-Photon States

Matthew Brown, Valérian Thiel, Markus Allgaier +4 more

Recent proposals suggest that a distributed single-photon would outperform weak coherent or thermal states as a phase reference for long-baseline interferometry of dim sources. We demonstrate experimental results toward confirming this prediction.

Frontiers in Optics•Jan 1, 2021•3 citations

Enhanced Photon-Pair Detection Using Phase-Sensitive Pre-amplification

James M. Dailey, Anjali Agarwal, P. Toliver +1 more

We describe an experimental demonstration of fiber-based optical phase-sensitive amplification for improved detection of correlated single-photon pairs. A measured coincidence gain of 4.5dB provides 3dB improvement in the detection system signal-to-noise ratio.

Conference on Lasers and Electro-Optics•Jan 1, 2015•0 citations

Long baseline optical interferometric imaging with active phase stabilization

Joshua J. Collier, Leuca Patmore, John S. Wallis +3 more

Astronomical observations allow us to better our understanding of the universe. As we observe smaller and more distance features, we run into the diffraction limit of our observation system. This limit is a function of the wavelength observed and the size of the primary aperture used. We can synthesize a larger primary aperture by implementing interferometry. Long baseline optical interferometry would lead to significant improvements in astronomical imaging resolution. Building optical interferometers with free space baselines becomes significantly more difficult as the baseline increases. A promising alternative is to use optical fiber to connect telescopes. Fiber-based interferometers are much more susceptible to phase noise than their free-space counterparts due to inhomogeneities in the fiber medium. This leads to significant degradation of interferometric signals used for astronomical measurements. We implement phase stabilization techniques used in quantum communications to stabilize an optical interferometer with a 170km pseudo-baseline. We use a quantum optimal measurement technique with this interferometer to resolve the extent of a source four times smaller than the diffraction limit of the system within 1.5% error. These results bring the potential for a full-scale on-sky long baseline interferometer significantly closer. A 350km baseline optical interferometer at 1550nm would allow us to resolve sub microarcsecond features in the universe.

physics.opticsCross-listedarXiv:2607.12167•Jul 15, 2026•1 citation

Enhanced Photon-Pair Detection Using Phase-Sensitive Pre-amplification

James M. Dailey

We describe an experimental demonstration of fiber-based optical phase-sensitive amplification for improved detection of correlated single-photon pairs.A measured coincidence gain of 4.5dB provides 3dB improvement in the detection system signal-to-noise ratio.

•Jul 25, 2016•0 citations
Recent proposals suggest that distributed single photons serving as a ‘non-local oscillator’ can outperform coherent states as a phase reference for long-baseline interferometric imaging of weak sources [1,2]. Such nonlocal quantum states distributed between telescopes can, in-principle, surpass the limitations of conventional interferometric-based astronomical imaging approaches for very-long baselines such as: signal-to-noise, shot noise, signal loss, and faintness of the imaged objects. Here we demonstrate in a table-top experiment, interference between a nonlocal oscillator generated by equal-path splitting of an idler photon from a pulsed, separable, parametric down conversion process and a spectrally single-mode, quasi-thermal source. We compare the single-photon nonlocal oscillator to a more conventional local oscillator with uncertain photon number. Both methods enabled reconstruction of the source’s Gaussian spatial distribution by measurement of the interference visibility as a function of baseline separation and then applying the van Cittert-Zernike theorem [3,4]. In both cases, good qualitative agreement was found with the reconstructed source width and the known source width as measured using a camera. We also report an increase of signal-to-noise per ‘faux’ stellar photon detected when heralding the idler photon. 1593 heralded (non-local oscillator) detection events led to a maximum visibility of ~17% compared to the 10412 unheralded (classical local oscillator) detection events, which gave rise to a maximum visibility of ~10% – the first instance of quantum-enhanced sensing in this context.
Astronomical observations allow us to better our understanding of the universe. As we observe smaller and more distance features, we run into the diffraction limit of our observation system. This limit is a function of the wavelength observed and the size of the primary aperture used. We can synthesize a larger primary aperture by implementing interferometry. Long baseline optical interferometry would lead to significant improvements in astronomical imaging resolution. Building optical interferometers with free space baselines becomes significantly more difficult as the baseline increases. A promising alternative is to use optical fiber to connect telescopes. Fiber-based interferometers are much more susceptible to phase noise than their free-space counterparts due to inhomogeneities in the fiber medium. This leads to significant degradation of interferometric signals used for astronomical measurements. We implement phase stabilization techniques used in quantum communications to stabilize an optical interferometer with a 170km pseudo-baseline. We use a quantum optimal measurement technique with this interferometer to resolve the extent of a source four times smaller than the diffraction limit of the system within 1.5% error. These results bring the potential for a full-scale on-sky long baseline interferometer significantly closer. A 350km baseline optical interferometer at 1550nm would allow us to resolve sub microarcsecond features in the universe.