Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Wiley eBooks

Optimization of Segmented Linear Paul Traps and Transport of Stored Particles

Stephan Schulz, Ulrich Poschinger, Kilian Singer, Ferdinand Schmidt‐Kaler

Published Jan 26, 2007• 7 citations
Publisher

Abstract

This chapter contains sections titled: Introduction Optimization of a Two-layer Microstructured Ion Trap Design Objectives Operating Mode and Modeling of the Segmented Linear Paul Trap Optimization of the Radial Potential Optimization of the Axial Potential Open Loop Control of Ion Transport Non-adiabatic Heating Sources Overview of the Applied Optimization Strategies The Optimal Control Method Optimization Results Ion Heating due to Anharmonic Dispersion Quantum Mechanical Estimate of Non-adiabatic Parametric Heating Improved Initial Guess Function and Ultra-fast Transport Discussion of the Open-loop Result Outlook Appendix References

DOI
10.1002/9783527611065.ch2

Related papers

Optimization of segmented linear Paul traps and transport of stored particles

S. Schulz, Ulrich Poschinger, Kilian Singer +1 more

Abstract Single ions held in linear Paul traps are promising candidates for a future quantum computer. Here, we discuss a two‐layer microstructured segmented linear ion trap. The radial and axial potentials are obtained from numeric field simulations and the geometry of the trap is optimized. As the trap electrodes are segmented in the axial direction, the trap allows the transport of ions between different spatial regions. Starting with realistic numerically obtained axial potentials, we optimize the transport of an ion such that the motional degrees of freedom are not excited, even though the transport speed far exceeds the adiabatic regime. In our optimization we achieve a transport within roughly two oscillation periods in the axial trap potential compared to typical adiabatic transports that take of the order 102 oscillations. Furthermore heating due to quantum mechanical effects is estimated and suppression strategies are proposed.

arXiv:quant-ph/0607217•Fortschritte der Physik•Aug 1, 2006•74 citations

Transport Dynamics of Single Ions in Segmented Microstructured Paul Trap Arrays

R. Reichle, Dietrich G. Leibfried, R. B. Blakestad +7 more

This chapter contains sections titled: Introduction Classical Equations of Motion Classical Dynamics of Ion Transport Homogeneous Solution Green's Function and General Solution Adiabatic Limit Quantum and Classical, Dragged Harmonic Oscillators with Constant Frequency The Dragged Quantum Harmonic Oscillator Transport Dynamics in a Well-controlled Regime Two Analytical Examples Near-optimum Transport Functions High-frequency Limit, Adiabatic Transport, and Approximate Trajectories Please supply a short title Determination of Waveforms Potential Fluctuations and Aspect-ratio Rule Conclusions Appendix References

Wiley eBooks•Jan 26, 2007•8 citations

Transport dynamics of single ions in segmented microstructured Paul trap arrays

R. Reichle, Dietrich G. Leibfried, R. B. Blakestad +7 more

Abstract It was recently proposed to use small groups of trapped ions as qubit carriers in miniaturized electrode arrays that comprise a large number of individual trapping zones, between which ions could be moved [1,2] This approach might be scalable for quantum information processing with a large numbers of qubits. Processing of quantum information is achieved by transporting ions to and from separate memory and qubit manipulation zones in between quantum logic operations. The transport of ion groups in this scheme plays a major role and requires precise experimental control and fast transport times. In this paper we introduce a theoretical framework to study ion transport in external potentials that might be created by typical miniaturized Paul trap electrode arrays. In particular we discuss the relationship between classical and quantum descriptions of the transport and study the energy transfer to the oscillatory motion during near‐adiabatic transport. Based on our findings we suggest a numerical method to find electrode potentials as a function of time to optimize the local potential an ion experiences during transport. We demonstrate this method for one specific electrode geometry that should closely represent the situation encountered in realistic trap arrays.

arXiv:quant-ph/0606237•Fortschritte der Physik•Aug 1, 2006•91 citations

Controlling Fast Transport of Cold Trapped Ions

Andreas Walther, Frank Ziesel, Thomas Ruster +6 more

We realize fast transport of ions in a segmented microstructured Paul trap. The ion is shuttled over a distance of more than 10(4) times its ground state wave function size during only five motional cycles of the trap (280 μm in 3.6 μs). Starting from a ground-state-cooled ion, we find an optimized transport such that the energy increase is as low as 0.10±0.01 motional quanta. In addition, we demonstrate that quantum information stored in a spin-motion entangled state is preserved throughout the transport. Shuttling operations are concatenated, as a proof-of-principle for the shuttling-based architecture to scalable ion trap quantum computing.

arXiv:1206.0364•Physical Review Letters•Aug 20, 2012•255 citations

Transport of ions in a segmented linear Paul trap in printed-circuit-board technology

G Huber, T. Deuschle, Wolfgang Schnitzler +3 more

We describe the construction and operation of a segmented linear Paul trap, fabricated in printed-circuit-board technology with an electrode segment width of 500 μm. We prove the applicability of this technology to reliable ion trapping and report the observation of Doppler-cooled ion crystals of 40 Ca + with this kind of trap. Measured trap frequencies agree with numerical simulations at the level of a few percent from which we infer a high fabrication accuracy of the segmented trap. To demonstrate its usefulness and versatility for trapped ion experiments we study the fast transport of a single ion. Our experimental results show a success rate of 99.0(1)% for a transport distance of 2 × 2 mm in a round-trip time of T = 20 μs, which corresponds to 4 axial oscillations only. We theoretically and experimentally investigate the excitation of oscillations caused by fast ion transports with error-function voltage ramps: for a slightly slower transport (a round-trip shuttle within T = 30 μs) we observe non-adiabatic motional excitation of 0.89(15) meV.

arXiv:0711.2947•New Journal of Physics•Jan 14, 2008•73 citations

Quantum Computing Experiments with Cold Trapped Ions

Ferdinand Schmidt‐Kaler

This chapter contains sections titled: Introduction Paul Traps Ion crystals and their normal modes Ion—;light interaction Levels and Transitions for Typical Qubit Candidates Various Two-Qubit Gates Teleportation Segmented Trapsand Future Directions

Wiley eBooks•Nov 6, 2006•1 citation
This chapter contains sections titled: Introduction Optimization of a Two-layer Microstructured Ion Trap Design Objectives Operating Mode and Modeling of the Segmented Linear Paul Trap Optimization of the Radial Potential Optimization of the Axial Potential Open Loop Control of Ion Transport Non-adiabatic Heating Sources Overview of the Applied Optimization Strategies The Optimal Control Method Optimization Results Ion Heating due to Anharmonic Dispersion Quantum Mechanical Estimate of Non-adiabatic Parametric Heating Improved Initial Guess Function and Ultra-fast Transport Discussion of the Open-loop Result Outlook Appendix References
Abstract Single ions held in linear Paul traps are promising candidates for a future quantum computer. Here, we discuss a two‐layer microstructured segmented linear ion trap. The radial and axial potentials are obtained from numeric field simulations and the geometry of the trap is optimized. As the trap electrodes are segmented in the axial direction, the trap allows the transport of ions between different spatial regions. Starting with realistic numerically obtained axial potentials, we optimize the transport of an ion such that the motional degrees of freedom are not excited, even though the transport speed far exceeds the adiabatic regime. In our optimization we achieve a transport within roughly two oscillation periods in the axial trap potential compared to typical adiabatic transports that take of the order 102 oscillations. Furthermore heating due to quantum mechanical effects is estimated and suppression strategies are proposed.
This chapter contains sections titled: Introduction Classical Equations of Motion Classical Dynamics of Ion Transport Homogeneous Solution Green's Function and General Solution Adiabatic Limit Quantum and Classical, Dragged Harmonic Oscillators with Constant Frequency The Dragged Quantum Harmonic Oscillator Transport Dynamics in a Well-controlled Regime Two Analytical Examples Near-optimum Transport Functions High-frequency Limit, Adiabatic Transport, and Approximate Trajectories Please supply a short title Determination of Waveforms Potential Fluctuations and Aspect-ratio Rule Conclusions Appendix References
Abstract It was recently proposed to use small groups of trapped ions as qubit carriers in miniaturized electrode arrays that comprise a large number of individual trapping zones, between which ions could be moved [1,2] This approach might be scalable for quantum information processing with a large numbers of qubits. Processing of quantum information is achieved by transporting ions to and from separate memory and qubit manipulation zones in between quantum logic operations. The transport of ion groups in this scheme plays a major role and requires precise experimental control and fast transport times. In this paper we introduce a theoretical framework to study ion transport in external potentials that might be created by typical miniaturized Paul trap electrode arrays. In particular we discuss the relationship between classical and quantum descriptions of the transport and study the energy transfer to the oscillatory motion during near‐adiabatic transport. Based on our findings we suggest a numerical method to find electrode potentials as a function of time to optimize the local potential an ion experiences during transport. We demonstrate this method for one specific electrode geometry that should closely represent the situation encountered in realistic trap arrays.
We realize fast transport of ions in a segmented microstructured Paul trap. The ion is shuttled over a distance of more than 10(4) times its ground state wave function size during only five motional cycles of the trap (280 μm in 3.6 μs). Starting from a ground-state-cooled ion, we find an optimized transport such that the energy increase is as low as 0.10±0.01 motional quanta. In addition, we demonstrate that quantum information stored in a spin-motion entangled state is preserved throughout the transport. Shuttling operations are concatenated, as a proof-of-principle for the shuttling-based architecture to scalable ion trap quantum computing.
We describe the construction and operation of a segmented linear Paul trap, fabricated in printed-circuit-board technology with an electrode segment width of 500 μm. We prove the applicability of this technology to reliable ion trapping and report the observation of Doppler-cooled ion crystals of 40 Ca + with this kind of trap. Measured trap frequencies agree with numerical simulations at the level of a few percent from which we infer a high fabrication accuracy of the segmented trap. To demonstrate its usefulness and versatility for trapped ion experiments we study the fast transport of a single ion. Our experimental results show a success rate of 99.0(1)% for a transport distance of 2 × 2 mm in a round-trip time of T = 20 μs, which corresponds to 4 axial oscillations only. We theoretically and experimentally investigate the excitation of oscillations caused by fast ion transports with error-function voltage ramps: for a slightly slower transport (a round-trip shuttle within T = 30 μs) we observe non-adiabatic motional excitation of 0.89(15) meV.