Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Optics

Photonics generation of broadband millimeter wave noise signals with high excess noise ratios

HUANG Hai-bi, 广东工业大学 信息工程学院 广东省信息光子技术重点实验室,广东 广州 510006, Wenjie Liu, SUN Yue-hui, WANG An-bang, QIN Yu-wen, WANG Yun-cai, 太原理工大学 新型传感器与智能控制教育部重点实验室,山西 太原 030024

Published Dec 17, 2021• 0 citations
Publisher
DOI
10.37188/co.2021-0158

Related papers

Low-noise millimeter- and submillimeter-wave receivers

Vyacheslav F. Vdovin, И. И. Зинченко

Radiophysics and Quantum Electronics•Nov 1, 1998•7 citations

Photon noise from chaotic and coherent millimeter-wave sources measured with horn-coupled, aluminum lumped-element kinetic inductance detectors

D. Flanigan, Heather McCarrick, G. Jones +18 more

We report photon-noise limited performance of horn-coupled, aluminum lumped-element kinetic inductance detectors at millimeter wavelengths. The detectors are illuminated by a millimeter-wave source that uses an active multiplier chain to produce radiation between 140 and 160 GHz. We feed the multiplier with either amplified broadband noise or a continuous-wave tone from a microwave signal generator. We demonstrate that the detector response over a 40 dB range of source power is well-described by a simple model that considers the number of quasiparticles. The detector noise-equivalent power (NEP) is dominated by photon noise when the absorbed power is greater than approximately 1 pW, which corresponds to NEP≈2×10−17 W Hz−1/2, referenced to absorbed power. At higher source power levels, we observe the relationships between noise and power expected from the photon statistics of the source signal: NEP∝P for broadband (chaotic) illumination and NEP∝P1/2 for continuous-wave (coherent) illumination.

arXiv:1510.06609•Applied Physics Letters•Feb 22, 2016•30 citations

Noise Analysis for Millimeter-Wave Driving of High-Temperature Superconductor Josephson Junction Arrays

Changhao Zhao, Yafang Lian, Da Xu +6 more

High-temperature superconductor Josephson junction arrays were irradiated with millimeter-wave of approximately 70 GHz. The junction arrays were composed of 15 bicrystal YBCO junctions in series and produced DC voltage output of up to 2 mV, which was sampled by a commercial nanovoltmeter. The measured Vppof voltage fluctuations was on the order of 0.6 μV, exceeding the intrinsic fluctuation of the nanovoltmeter itself. To identify the origin of the excessive fluctuations, the phase noise and harmonic distortion of the millimeter-wave signal were analyzed and finally excluded from the major cause of the performance degradation. While millimeter-wave filtering and DC wiring of the apparatus can be improved, the results showed the feasibility of the millimeter-wave driving architecture and the noise analysis framework can be applied to development of even higher frequency drives into THz range.

Conference on Precision Electromagnetic Measurements•Sep 1, 2026•0 citations

Phase noise in coherent optical communications

Murat Azizoá ̧¡lu

Massachusetts Institute of Technology eBooks•Jan 1, 1991•6 citations

Photonic Millimeter-wave generation and transmission system applicable to the high-frequency radio interferometers

Hitoshi Kiuchi, Tetsuya Kawanishi

In the field of high-frequency radio interferometer, Atacama Large Millimeter/sub-millimeter Array (ALMA), its highest receiving frequency reaches 950 GHz. To receive such high frequencies, a higher reference frequency is required (as much as over 100 GHz). To maintain signal coherency, this reference signal has to be highly stable. To address these issues, we have developed a new method to generate and transmit a reference signal in the form of frequency difference between two coherent light waves. The two transmitted optical signals require phase stability better than 10-13(1 sec) in white phase noise in the Allan standard deviation.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Apr 1, 2009•3 citations

Optical Frequency Division for Low Noise RF to W Band Signal Generation

Franklyn Quinlan

Bulletin of the American Physical Society•Mar 13, 2017•0 citations
We report photon-noise limited performance of horn-coupled, aluminum lumped-element kinetic inductance detectors at millimeter wavelengths. The detectors are illuminated by a millimeter-wave source that uses an active multiplier chain to produce radiation between 140 and 160 GHz. We feed the multiplier with either amplified broadband noise or a continuous-wave tone from a microwave signal generator. We demonstrate that the detector response over a 40 dB range of source power is well-described by a simple model that considers the number of quasiparticles. The detector noise-equivalent power (NEP) is dominated by photon noise when the absorbed power is greater than approximately 1 pW, which corresponds to NEP≈2×10−17 W Hz−1/2, referenced to absorbed power. At higher source power levels, we observe the relationships between noise and power expected from the photon statistics of the source signal: NEP∝P for broadband (chaotic) illumination and NEP∝P1/2 for continuous-wave (coherent) illumination.
High-temperature superconductor Josephson junction arrays were irradiated with millimeter-wave of approximately 70 GHz. The junction arrays were composed of 15 bicrystal YBCO junctions in series and produced DC voltage output of up to 2 mV, which was sampled by a commercial nanovoltmeter. The measured Vppof voltage fluctuations was on the order of 0.6 μV, exceeding the intrinsic fluctuation of the nanovoltmeter itself. To identify the origin of the excessive fluctuations, the phase noise and harmonic distortion of the millimeter-wave signal were analyzed and finally excluded from the major cause of the performance degradation. While millimeter-wave filtering and DC wiring of the apparatus can be improved, the results showed the feasibility of the millimeter-wave driving architecture and the noise analysis framework can be applied to development of even higher frequency drives into THz range.
In the field of high-frequency radio interferometer, Atacama Large Millimeter/sub-millimeter Array (ALMA), its highest receiving frequency reaches 950 GHz. To receive such high frequencies, a higher reference frequency is required (as much as over 100 GHz). To maintain signal coherency, this reference signal has to be highly stable. To address these issues, we have developed a new method to generate and transmit a reference signal in the form of frequency difference between two coherent light waves. The two transmitted optical signals require phase stability better than 10-13(1 sec) in white phase noise in the Allan standard deviation.