Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Experimental methods in the physical sciences

Detectors Based on Superconductors

Karl K. Berggren, Eric A. Dauler, Andrew J. Kerman, Sae Woo Nam, Danna Rosenberg

Published Jan 1, 2013• 7 citations
Publisher
DOI
10.1016/b978-0-12-387695-9.00006-8

Related papers

Saturation of the superconductor quasiparticle direct radiation detector

M. J. Feldman

The saturation properties of the superconductor-insulator-superconductor (SIS) direct detector are calculated. It is shown that this device begins to saturate only at powers far larger than one would expect from a simple analogy with the SIS mixer. Since the SIS direct detector is known to have very low noise, this result should lead to its immediate practical exploitation for direct detection of millimeter wavelength radiation.

Journal of Applied Physics•Oct 1, 1986•4 citations

Superconducting Detectors

George H. Rieke

Cambridge University Press eBooks•Apr 30, 2021•1 citation

SFQ Parallel Encoders Promising for Video Imaging With Superconductor Stripline Detectors

Masamitsu Tanaka, Misaki Kozaka, Kyohei Kamiya +5 more

We report demonstration of a readout circuit with high-throughput single flux quantum (SFQ) based encoders for a large-scale video imaging system with a conventional frame rate. The encoders are fully parallel and integrated on the same chip as linear arrays of serially connected superconductor stripline detectors (SSLDs), superconducting quantum interference device (SQUID) based comparators, and SFQ synchronizers. Mutual coupling of parallel SSLDs and SQUID-based comparators allows the use of only one dc bias line; it is possible to use thousands of SSLDs without increasing the bias current or number of bias ports. To achieve crosstalk-free readout, the serially connected SSLDs are separated by low-pass filters or large inductors. We experimentally demonstrated crosstalk-free readout including SFQ parallel encoders from 1-D or 2-D serially connected SSLD arrays.

IEEE Transactions on Applied Superconductivity•Jul 31, 2020•6 citations

SUPERCONDUCTING PHOTON DETECTORS

Daiji Fukuda

•Jan 1, 2017•0 citations

Microwave SINIS Detectors

Michael A. Tarasov, Aleksandra A. Gunbina, Artem M. Chekushkin +3 more

This review presents the main characteristics and mechanisms of operation of superconductor–insulator–normal metal–insulator–superconductor (SINIS) microwave detectors. An analysis of the detectors’ performance against a quantum detector and a photon counter is given. Methods for cooling a superconductor using normal metal traps and the role of electron cooling in optimizing the current response to terahertz radiation are discussed. Fabrication methods using shadow evaporation as well as magnetron sputtering are described.

Applied Sciences•Oct 18, 2022•11 citations

Superconducting X-ray detectors

Can Hui Yang, Mengting Si, Lixing You

Science China Information Sciences•Jul 15, 2020•13 citations
We report demonstration of a readout circuit with high-throughput single flux quantum (SFQ) based encoders for a large-scale video imaging system with a conventional frame rate. The encoders are fully parallel and integrated on the same chip as linear arrays of serially connected superconductor stripline detectors (SSLDs), superconducting quantum interference device (SQUID) based comparators, and SFQ synchronizers. Mutual coupling of parallel SSLDs and SQUID-based comparators allows the use of only one dc bias line; it is possible to use thousands of SSLDs without increasing the bias current or number of bias ports. To achieve crosstalk-free readout, the serially connected SSLDs are separated by low-pass filters or large inductors. We experimentally demonstrated crosstalk-free readout including SFQ parallel encoders from 1-D or 2-D serially connected SSLD arrays.
This review presents the main characteristics and mechanisms of operation of superconductor–insulator–normal metal–insulator–superconductor (SINIS) microwave detectors. An analysis of the detectors’ performance against a quantum detector and a photon counter is given. Methods for cooling a superconductor using normal metal traps and the role of electron cooling in optimizing the current response to terahertz radiation are discussed. Fabrication methods using shadow evaporation as well as magnetron sputtering are described.