Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

電子技術総合研究所彙報

High Sensitivity Double Relaxation Oscillation SQUIDs with Large Transfer from Flux to Voltage

Derk Jan Adelerhof

Published Feb 1, 1995• 0 citations
OpenAlex

Related papers

Next generation dc-SQUIDs: relaxation oscillation SQUIDs

van Duuren, M.J., Derk Jan Adelerhof, G.C.S. Brons +3 more

•Dec 20, 1994•0 citations

High sensitivity double relaxation oscillation superconducting quantum interference devices with large transfer from flux to voltage

Derk Jan Adelerhof, Jun Kawai, Gen Uehara +1 more

Double relaxation oscillation superconducting quantum interference devices (SQUIDs) (DROSs) based on Nb/AlOx tunnel junctions have been fabricated and characterized. The estimated relaxation frequencies range from 400 MHz up to 14 GHz. Transfer coefficients from flux to voltage of 2 up to 7 mV/φ0 have been obtained. Both the intrinsic flux noise and the performance in a flux-locked loop with direct-voltage readout have been determined. Special attention is paid to the effect of damping resistors on the sensitivity of DROSs. The intrinsic sensitivity improves with increasing relaxation frequency, leveling off to a value of 13h at relaxation frequencies above 2–3 GHz for SQUID inductances of about 30 pH. This sensitivity is very close to the theoretical maximum sensitivity of 6h of a comparable standard type dc SQUID. In a flux-locked loop based on direct-voltage readout, a noise level of 0.55 μφ0/√Hz corresponding to an energy sensitivity of 34h has been obtained for a DROS with a SQUID inductance of 29 pH.

Review of Scientific Instruments•Mar 1, 1995•18 citations

Smart SQUID based on double relaxation oscillation SQUIDs

Michiel J. van Duuren, G.C.S. Brons, H.E. Kattouw +2 more

•Dec 19, 1997•0 citations

(Double) relaxation oscillation SQUIDs with high flux-to-voltage transfer: Simulations and experiments

Derk Jan Adelerhof, H. Nijstad, J. Flokstra +1 more

Relaxation oscillation superconducting quantum interference devices (SQUIDs) (ROSs) and double relaxation oscillation SQUIDs (DROSs) have been fabricated and characterized. The SQUIDs are based on hysteretic Nb/Al,AlOx/Al/Nb Josephson tunnel junctions. The relaxation oscillations were simulated by computer. By these simulations the minimum and maximum values of the shunt inductance at which the relaxation oscillations persist have been determined for different values of the shunt resistance and of the critical current and capacitance of the junctions. The transfer from flux to dc voltage in ROSs increases linearly with the shunt resistance. The operation range of the shunt inductance, however, becomes smaller with increasing shunt resistance. In ROSs with a SQUID inductance of 20 pH, a maximum voltage modulation width of 400 μV and a flux-to-voltage transfer δV/δφ of 4 mV/φ0 have been obtained. Two ROSs have been operated in a simple flux-locked loop with direct voltage readout. The experimental white flux noise spectral density of about 3μφ0/√Hz is in good agreement with the theoretical model. The sensitivity of these SQUIDs is limited by so-called switching noise, which is noise due to the interaction between the relaxation oscillations and the Josephson frequency. In DROSs typical flux-to-voltage transfer values of 10–30 mV/φ0 and maximum values up to 80 mV/φ0 have been obtained. This transfer is determined by thermal noise on the critical currents of the SQUIDs. The effective flux noise density of DROSs in flux-locked-loop operation with direct voltage readout is in good agreement with the theoretical noise level which is mainly determined by thermal noise on the critical currents. In one of the DROSs with a SQUID inductance of 20 pH, a white flux noise of 1μφ0/√Hz has been obtained at an estimated relaxation frequency of about 80 MHz. This corresponds to an energy sensitivity of about 160 h.

Journal of Applied Physics•Sep 15, 1994•56 citations

Theory of the voltage–current characteristics of high TC asymmetric DC SQUIDs

Ya. S. Greenberg

Physica C Superconductivity•Dec 27, 2002•16 citations

Low-noise SQUIDs with large transfer - two stage SQUIDs based on DROSs

M. Podt, Jakob Flokstra, Horst Rogalla

We have realized a two-stage integrated superconducting quantum interference device (SQUID) system with a closed loop bandwidth of 2.5 MHz, operated in a direct voltage readout mode. The corresponding flux slew rate was 1.3×105 Φ0/s and the measured white flux noise was 1.3 μΦ0/√Hz at 4.2 K. The system is based on a conventional dc SQUID with a double relaxation oscillation SQUID (DROS) as the second stage. Because of the large flux-to-voltage transfer, the sensitivity of the system is completely determined by the sensor SQUID and not by the DROS or the room-temperature preamplifier. Decreasing the Josephson junction area enables a further improvement of the sensitivity of the two-stage SQUID systems.

•Aug 26, 2001•0 citations
Double relaxation oscillation superconducting quantum interference devices (SQUIDs) (DROSs) based on Nb/AlOx tunnel junctions have been fabricated and characterized. The estimated relaxation frequencies range from 400 MHz up to 14 GHz. Transfer coefficients from flux to voltage of 2 up to 7 mV/φ0 have been obtained. Both the intrinsic flux noise and the performance in a flux-locked loop with direct-voltage readout have been determined. Special attention is paid to the effect of damping resistors on the sensitivity of DROSs. The intrinsic sensitivity improves with increasing relaxation frequency, leveling off to a value of 13h at relaxation frequencies above 2–3 GHz for SQUID inductances of about 30 pH. This sensitivity is very close to the theoretical maximum sensitivity of 6h of a comparable standard type dc SQUID. In a flux-locked loop based on direct-voltage readout, a noise level of 0.55 μφ0/√Hz corresponding to an energy sensitivity of 34h has been obtained for a DROS with a SQUID inductance of 29 pH.
Relaxation oscillation superconducting quantum interference devices (SQUIDs) (ROSs) and double relaxation oscillation SQUIDs (DROSs) have been fabricated and characterized. The SQUIDs are based on hysteretic Nb/Al,AlOx/Al/Nb Josephson tunnel junctions. The relaxation oscillations were simulated by computer. By these simulations the minimum and maximum values of the shunt inductance at which the relaxation oscillations persist have been determined for different values of the shunt resistance and of the critical current and capacitance of the junctions. The transfer from flux to dc voltage in ROSs increases linearly with the shunt resistance. The operation range of the shunt inductance, however, becomes smaller with increasing shunt resistance. In ROSs with a SQUID inductance of 20 pH, a maximum voltage modulation width of 400 μV and a flux-to-voltage transfer δV/δφ of 4 mV/φ0 have been obtained. Two ROSs have been operated in a simple flux-locked loop with direct voltage readout. The experimental white flux noise spectral density of about 3μφ0/√Hz is in good agreement with the theoretical model. The sensitivity of these SQUIDs is limited by so-called switching noise, which is noise due to the interaction between the relaxation oscillations and the Josephson frequency. In DROSs typical flux-to-voltage transfer values of 10–30 mV/φ0 and maximum values up to 80 mV/φ0 have been obtained. This transfer is determined by thermal noise on the critical currents of the SQUIDs. The effective flux noise density of DROSs in flux-locked-loop operation with direct voltage readout is in good agreement with the theoretical noise level which is mainly determined by thermal noise on the critical currents. In one of the DROSs with a SQUID inductance of 20 pH, a white flux noise of 1μφ0/√Hz has been obtained at an estimated relaxation frequency of about 80 MHz. This corresponds to an energy sensitivity of about 160 h.
We have realized a two-stage integrated superconducting quantum interference device (SQUID) system with a closed loop bandwidth of 2.5 MHz, operated in a direct voltage readout mode. The corresponding flux slew rate was 1.3×105 Φ0/s and the measured white flux noise was 1.3 μΦ0/√Hz at 4.2 K. The system is based on a conventional dc SQUID with a double relaxation oscillation SQUID (DROS) as the second stage. Because of the large flux-to-voltage transfer, the sensitivity of the system is completely determined by the sensor SQUID and not by the DROS or the room-temperature preamplifier. Decreasing the Josephson junction area enables a further improvement of the sensitivity of the two-stage SQUID systems.