Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

A direct-current pumped Josephson travelling-wave amplifier

P. Russer

Published Jan 1, 1977• 1 citation
OpenAlex

Related papers

Driving a Josephson Traveling Wave Parametric Amplifier into Chaos: Effects of a Non-Sinusoidal Current-Phase Relation

Claudio Guarcello, C. Barone, Giovanni Carapella +4 more

•Jan 1, 2024•0 citations

Progress towards a broadband traveling wave Josephson parametric amplifier

D. H. Slichter, Lafe Spietz, Ofer Naaman +2 more

Bulletin of the American Physical Society•Mar 17, 2010•1 citation

Characterisation of a travelling-wave parametric amplifier for improved qubit measurements

Hampus Renberg Nilsson

In order to build a large-scale quantum computer, one of the requirements is high-fidelity multiplexed qubit readout, which in turn relies on the use of ultralow-noise amplifiers. While Josephson Parametric Amplifiers (JPAs), using a cavity with few Josephson junctions, have shown promising results for single qubit readout, they have limitations such as low saturation power and a gain-bandwidth product restriction. This makes them less suited for frequency multiplexed qubit readout. A current-pumped Josephson Travelling-Wave Parametric Amplifier (JTWPA), using 4-wave mixing in a lumped-element transmission line, features both high saturation power as well as no restriction on large bandwidth and high gain. This is possible due to multiple junctions and the lack of a cavity. However, also this current pumped JTWPA has an inherent problem, namely phase mismatch between the pump and the signal. This prevents exponential gain. In this thesis, a current pumped JTWPA using the resonant phase matching (RPM) technique to reduce the phase mismatch problem is studied and characterised. The JTWPA shows high gain, high saturation power and a large signal-to-noise ratio improvement. The JTWPA is also used for qubit readout, for which it clearly improves the readout fidelity.

•Jan 1, 2019•0 citations

A Multi-Channel Josephson Parametric Amplifier

Michael Selvanayagam, Alexander T. Papageorge, Damon S. Russell +6 more

Bulletin of the American Physical Society•Mar 14, 2017•0 citations

Development of Josephson Traveling-Wave Parametric Amplifier Based on Aluminum SIS Junctions

Michael A. Tarasov, Aleksandra A. Gunbina, S. A. Lemzyakov +6 more

Abstract Prototypes of the design of Josephson traveling-wave parametric amplifier based on aluminum superconductor–insulator–superconductor junctions in the form of direct-current SQUIDs included in central conductor of coplanar line are developed, fabricated, and investigated. Three manufacturing methods for the fabrication of such devices are tested: two of them using shadow evaporation and one using magnetron sputtering and direct electron-beam lithography. Current–voltage characteristics of the junctions are measured at 0.3 K. A cryogenic setup for the measurement of spectral characteristics of such amplifier containing cold semiconductor amplifier with circulator and cooled attenuators of the channels of input signal and pump is developed. The absorption spectrum of coplanar directional coupler with a quarter-wave resonator dedicated for measurements of short chains from one to 27 SQUIDs is measured.

Physics of the Solid State•Oct 1, 2021•3 citations

Flux-driven Josephson parametric amplifier

Tsuyoshi Yamamoto

Bulletin of the American Physical Society•Mar 17, 2009•0 citations
In order to build a large-scale quantum computer, one of the requirements is high-fidelity multiplexed qubit readout, which in turn relies on the use of ultralow-noise amplifiers. While Josephson Parametric Amplifiers (JPAs), using a cavity with few Josephson junctions, have shown promising results for single qubit readout, they have limitations such as low saturation power and a gain-bandwidth product restriction. This makes them less suited for frequency multiplexed qubit readout. A current-pumped Josephson Travelling-Wave Parametric Amplifier (JTWPA), using 4-wave mixing in a lumped-element transmission line, features both high saturation power as well as no restriction on large bandwidth and high gain. This is possible due to multiple junctions and the lack of a cavity. However, also this current pumped JTWPA has an inherent problem, namely phase mismatch between the pump and the signal. This prevents exponential gain. In this thesis, a current pumped JTWPA using the resonant phase matching (RPM) technique to reduce the phase mismatch problem is studied and characterised. The JTWPA shows high gain, high saturation power and a large signal-to-noise ratio improvement. The JTWPA is also used for qubit readout, for which it clearly improves the readout fidelity.
Abstract Prototypes of the design of Josephson traveling-wave parametric amplifier based on aluminum superconductor–insulator–superconductor junctions in the form of direct-current SQUIDs included in central conductor of coplanar line are developed, fabricated, and investigated. Three manufacturing methods for the fabrication of such devices are tested: two of them using shadow evaporation and one using magnetron sputtering and direct electron-beam lithography. Current–voltage characteristics of the junctions are measured at 0.3 K. A cryogenic setup for the measurement of spectral characteristics of such amplifier containing cold semiconductor amplifier with circulator and cooled attenuators of the channels of input signal and pump is developed. The absorption spectrum of coplanar directional coupler with a quarter-wave resonator dedicated for measurements of short chains from one to 27 SQUIDs is measured.