Summary There has been growing attention in physical layer security (PLS) techniques for wireless networks. PLS techniques are based on physical layer characteristics and are less computationally complex than traditional cryptographic approaches, which work on higher layers of networks. Physical layer key generation (PLKG) is one of the prominent key based PLS techniques that exploits reciprocity and randomness of wireless fading channel to establish secure communication between two transceivers. PLKG system consists of five stages as RSS measurement, its preprocessing, quantization and encoding, key reconciliation, and privacy amplification. Each stage has a substantial role in deciding the performance of PLKG system, but RSS preprocessing offers wide scope in performance improvement for the system. In this work, we propose PLKG system using a new class of preprocessing technique first time, which is nonlinear. We formulated the problem uniquely and considered two nonlinear techniques: nonlinear preprocessing using expander (NLPE) and nonlinear preprocessing using compressor (NLPC). We analyzed the performance of system using NLPE and NLPC and found NLPE is most suitable. Performance of the system is evaluated in terms of bit disagreement rate (BDR) and randomness of keys. Results show that NLPE performs extremely well, as compared with linear approach and without preprocessing approach, especially at low signal to noise ratio (SNR) range. Emerging wireless networks such as internet of things (IoT), centralized radio access network (CRAN), wireless sensor network (WSN), and so forth are being operated at lower transmission power with lightweight hardware. Hence, for such type of power constraint networks, proposed PLKG system with NLPE can be proven a perfect security solution.
Summary There has been growing attention in physical layer security (PLS) techniques for wireless networks. PLS techniques are based on physical layer characteristics and are less computationally complex than traditional cryptographic approaches, which work on higher layers of networks. Physical layer key generation (PLKG) is one of the prominent key based PLS techniques that exploits reciprocity and randomness of wireless fading channel to establish secure communication between two transceivers. PLKG system consists of five stages as RSS measurement, its preprocessing, quantization and encoding, key reconciliation, and privacy amplification. Each stage has a substantial role in deciding the performance of PLKG system, but RSS preprocessing offers wide scope in performance improvement for the system. In this work, we propose PLKG system using a new class of preprocessing technique first time, which is nonlinear. We formulated the problem uniquely and considered two nonlinear techniques: nonlinear preprocessing using expander (NLPE) and nonlinear preprocessing using compressor (NLPC). We analyzed the performance of system using NLPE and NLPC and found NLPE is most suitable. Performance of the system is evaluated in terms of bit disagreement rate (BDR) and randomness of keys. Results show that NLPE performs extremely well, as compared with linear approach and without preprocessing approach, especially at low signal to noise ratio (SNR) range. Emerging wireless networks such as internet of things (IoT), centralized radio access network (CRAN), wireless sensor network (WSN), and so forth are being operated at lower transmission power with lightweight hardware. Hence, for such type of power constraint networks, proposed PLKG system with NLPE can be proven a perfect security solution.
Modern networking technologies involve the interconnection of smart and intelligent physical objects to provide advanced services. These physical objects may be part of various network technologies like WLAN, wireless sensor network (WSN), Internet of Things (IoT), etc., and share data in wireless mode, which should be secured from threats. These physical devices possess many constraints like power, computational complexity and storage, and are required to have lightweight security algorithms. Traditionally, security is achieved by the higher layers of the communication model, which has high computational complexity and consumes more power. In this chapter, a secure-key-generation scheme from physical layer characteristics is introduced as a possible lightweight security alternative to traditional upper-layer security approaches. The proposed scheme is based on the wiretap-channel model and security is achieved by generating keys at both communicating ends independently, based on inherent common-channel characteristics like randomness. It is mainly based on the principle of spatial decorrelation and channel reciprocity for identical carrier frequency. There is no provision for sharing keys as in public-key cryptography, so physical-layer key generation is not vulnerable to threats like key leakage. The generated key at the transmitter encrypts plain text; the generated cipher is transmitted on the common channel and is decrypted at the receiver end using the key generated by the receiver. Key generation consists of fundamental blocks like channel probing and quantization followed by information reconciliation and privacy amplification. The physical-layer key generation is already a power-efficient security solution; this chapter aims to enhance this capacity further. This is done by introducing low-end signal conditioning in the channel-probing step using moving-window averaging. This solution not only improves system performance but also makes it suitable for limited- power applications. The performance of the key-generation system is characterised in terms of the bit-disagreement rate between the generated key sequences of communicating parties and the key randomness by means of the NIST statistical test suite.
Wireless communication systems are becoming increasingly important in our daily lives, especially with the rapid expansion of the Internet of Things (IoT). Secure and reliable communication is essential for the correct functioning of critical applications and use cases such as healthcare, finance, transportation, and industrial automation. However, the growing number of connected devices introduces significant challenges to data security and privacy due to the open nature of wireless networks. While traditional encryption methods are effective, they can be resource-intensive and impractical for resource-constrained IoT environments. Physical layer security (PLS) provides a lightweight alternative by leveraging the inherent characteristics of wireless channels to generate symmetric secret keys without requiring third-party infrastructure. The PLS key generation process involves four main stages: channel sampling, quantization, reconciliation, and privacy amplification. This paper provides a comprehensive survey of existing quantization schemes, as this step plays a crucial role in determining the key generation rate (KGR) and key disagreement rate (KDR). Additionally, the paper classifies quantization methods as either lossless or lossy, providing insights into the trade-offs between security and efficiency.
Key generation is one of the basic techniques used to realize secure channels in this digital world. This article compares both Quantum Key Distribution (QKD) and Physical Layer Key Generation (PLKG). While QKD can give information-theoretic security by invoking principles of quantum mechanics, PLKG is based on exploiting inherent randomness and reciprocity in wireless channels to extract the key. This study, through simulations, provides a comparative analysis of the security and performance aspects of QKD and PLKG against key rate, error rate, bandwidth, channel loss, and Signal-to-Noise Ratio (SNR). The results demonstrate strong trade-offs between QKD and PLKG in terms of security, practicality, and efficiency, with QKD bringing better guarantees for security but both inherently limited in terms of distance and key rate. On the other hand, PLKG is more readily deployable with higher key rates, based on computational security assumptions. This work provides practical guidelines concerning the applicability of both approaches for specific communication applications based on system requirements for communication security.
Reliable communication over Wireless Body Area Networks (WBANs) is an essential aspect of Wireless Body Area Networks (WBANs) because the physiological data flows between wearable sensor nodes is sensitive data. The convectional cryptography methods usually apply a lot of computational complexity as well as energy overhead besides which they are not going to fit in the ultra-low-power WBANs. In the current paper a light-weight, energy-efficient Physical Layer Key Generation (PLKG) scheme the possibilities of which based on the native randomness and reciprocity of the wireless channel is used to generate secure symmetric keys is presented. With WBANs, there is a lot of temporal and spatial dynamics in the human body and its surrounding environment, which causes great variability in channel characteristics, in terms of Received Signal Strength Indicator (RSSI) and Channel State Information (CSI). Such physical layer parameters can be used as perfect entropy sources in generation of unique, unpredictable secret keys with whose knowledge, communication between nodes is possible and mutually exclusive only. The channel probing in the proposed framework is also robust, multi-bit quantization is performed adaptively, information reconciliation is performed through error correction codes, and privacy amplification is made through cryptographic hashing. We have developed a resilient system against bit mismatch and efficiently against passively eavesdropping, we guarantee the secrecy of the generated keys under adversary situation. With realistic WBAN models simulation and experiment validation shows that the proposed approach is capable of generating keystokes with very high key generation rate (50 bps) and a bit mismatch rate of lower than 3 percent as compared to existing schemes that solely relied on RSSI, making this protocol more secure and reliable to use. In addition, the framework meets the statistical randomness requirements specified by NIST and it does not leak mutual information to eavesdroppers. The scheme allows real-time use on resource-constrained devices, e.g., wearable medical devices and health-monitoring sensor, as it has low computational and memory overhead. The findings establish the feasibility of employing physical layer properties to achieve secure WBANs communication without any pre-shared keys or a centralized trust paradigm, thus, opening the way to scalable and privacy-preserving healthcare systems.
With the burgeoning internet of things (IoT), securing communication becomes paramount. Traditional cryptography does not meet computational needs and brute-force attacks. This review explores the state-of-the-art physical layer secret key generation (PLKG) that takes advantage of the inherent reciprocity and randomness of wireless channels. We investigate cutting-edge techniques such as feature extraction networks, domain adversarial training, and deep learning-based approaches, evaluating their effects on the security and efficiency of key generation. In addition to these methods, the review addresses real-world challenges such as multi-user scenarios, reconciliation overhead, and inconsistent channel measurement. We believe that improved key generation rates and security can be achieved through the use of millimeter wave technology and full-duplex communication. To strengthen the robustness of key generation, the paper concludes by suggesting future directions, such as incorporating more random sources, such as physiological signals and sensor data. This comprehensive overview offers deep insights into the state-of-the-art and paves the way for reliable communication in ever more complicated IoT settings.
Wireless networks are vulnerable to various attacks due to their open nature, making them susceptible to eavesdropping and other security threats. Eavesdropping attack takes place at the physical layer. Traditional wireless network security relies on cryptographic techniques to secure data transmissions. However, these techniques may not be suitable for all scenarios, especially in resource-constrained environments such as wireless sensor networks and adhoc networks. In these networks having limited power resources, generating cryptographic keys between mobile entities can be challenging. Also, the cryptographic keys are computationally complex and require key management infrastructure. Physical Layer Key Generation (PLKG) is an emerging solution to address these challenges. It establishes secure communication between two users by taking advantage of the wireless channel's inherent features. PLKG process involves channel probing, quantization, information reconciliation (IR) and privacy amplification to generate symmetric secret key. The researchers have used various PLKG techniques to get the secret key, sTop of Form till they face problems in the IR scheme to obtain symmetric keys between the users who share the same channel for communication. Both the code based and protocol based methods proposed in the literature have advantages and limitations related to their performance parameters such as information leakage, interaction delay and computation complexity. This research work proposes a novel IR mechanism that combines the protocol and code-based error correction methods to obtain reduced Bit Mismatch Rate (BMR), reduced information leakage, reduced interaction delay, and reduced computational time to enhance physical layer secret key's quality. In the proposed research work, the channel samples are generated using the Received Signal Strength (RSS) and Channel Impulse Response (CIR) parameters. These samples are quantized using Vector Quantization with Affinity Propagation Clustering (VQAPC) method to generate the preliminary key. The samples collected by the two users who wish to communicate, (for example Alice and Bob) will be different due to noise in the channel and hardware limitations. Hence their preliminary keys will be different. Removing this discrepancy between Bob's and Alice's initial keys, using novel Hybrid Protocol and Code related Information Reconciliation (HPC-IR) scheme to generate error corrected key, is the most important contribution of this research work. This key is further encoded by the MD5 hash function to generate a final secret key for exchanging information between two users over the wireless channel. It is observed that the proposed HPC-IR scheme achieves BMR of 19.4%, information leakage is 0.002, interaction delay is 0.001 seconds and computation time is 0.02 seconds.