Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Radar Conference (RadarConf)

When Should We Use Likelihood Ratio Target Detection with QTMS Radar and Noise Radar?

David Luong, Bhashyam Balaji, Sreeraman Rajan

Published May 7, 2021• 5 citations
Publisher

Abstract

We analyze the potential application of a generalized likelihood ratio (GLR)-based detector function to quantum two-mode squeezing (QTMS) radars and standard noise radars. We give an expression for the likelihood ratio (LR) in terms of the maximum-likelihood estimate of the correlation coefficient between the received and reference signals of the radar. Interestingly, we found that a previously-studied detector function outperforms the GLR detector, though not in all parameter regimes. This runs counter to the intuition, based on the Neyman-Pearson lemma, that the LR test is optimal. We discuss why the lemma does not hold in this particular case and why the search for detector functions for QTMS radars and noise radars remains open. However, the GLR detector is a good choice when the correlation coefficient is high, the number of integrated samples is low, and appropriate computational resources are available.

DOI
10.1109/radarconf2147009.2021.9455183

Related papers

A Likelihood Ratio Detector for QTMS Radar and Noise Radar

David Luong, Bhashyam Balaji, Sreeraman Rajan

We derive a detector function for quantum two-mode squeezing (QTMS) radar and noise radar that is based on the use of a generalized likelihood ratio (GLR) test for distinguishing between the presence and absence of a target. In addition to an explicit expression for the GLR detector, we derive a detector function which approximates the GLR detector in the limit where the target is small, far away, or otherwise difficult to detect. When the number of integrated samples is large, we derive a theoretical expression for the receiver operating characteristic (ROC) curve of the radar when the GLR detector is used. When the number of samples is small, we use simulations to understand the ROC curve behavior of the detector. One interesting finding is that there exists a parameter regime in which a previously-studied detector outperforms the GLR detector, contrary to the intuition that LR-based tests are optimal or nearly so. This is because neither the Neyman–Pearson lemma, nor the Karlin–Rubin theorem which generalizes the lemma to composite hypotheses, hold in this particular problem. However, the GLR detector remains a good choice for target detection in certain regimes.

arXiv:2011.09509•IEEE Transactions on Aerospace and Electronic Systems•Jan 25, 2022•9 citations

An Approximate Likelihood Ratio Detector for QTMS Radar and Noise Radar

David Luong, Bhashyam Balaji, Sreeraman Rajan

The most important task of any radar is to detect targets. From this perspective, they are machines for distinguishing between two hypotheses: target absent and target present. The test statistic—or detector function—used by the radar is clearly of primary importance. In this paper, we explore the properties of a detector function for quantum two-mode squeezing radar and noise radar. This detector is derived from a second-order approximation of the likelihood ratio, and is attractive because it has a simple mathematical form. In order to analyze the performance of this detector function, we derive an expression for the receiver operating characteristic curve and verify it via simulations.

Sensor Signal Processing for Defence (SSPD)•Sep 1, 2021•3 citations

Quantum Two-Mode Squeezing Radar and Noise Radar: Correlation Coefficients for Target Detection

David Luong, Sreeraman Rajan, Bhashyam Balaji

Quantum two-mode squeezing (QTMS) radars and noise radars detect targets by correlating the received signal with an internally stored recording. A covariance matrix can be calculated between the two which, in theory, is a function of a single correlation coefficient. This coefficient can be used to decide whether a target is present or absent. We can estimate the correlation coefficient by minimizing the Frobenius norm between the sample covariance matrix and the theoretically expected form of the matrix. Using simulated data, we show that the estimates follow a Rice distribution whose parameters are simple functions of the underlying, “true” correlation coefficient as well as the number of integrated samples. We obtain an explicit expression for the receiver operating characteristic curve that results when the correlation coefficient is used for target detection. This is an important first step toward performance prediction for QTMS radars.

arXiv:1911.09062•IEEE Sensors Journal•Feb 5, 2020•34 citations

Simulation Study of a Detector Function for QTMS Radar and Noise Radar

David Luong, Bhashyam Balaji, Sreeraman Rajan

A detector function for a newly proposed quantum radar known as quantum two-mode squeezing (QTMS) radar is analyzed in this paper. The detector function proposed in this paper behaves like a normal distribution function when the number of radar samples integrated for the detection is over 500 samples. A closed form expression for the receiver operating characteristic (ROC) curve for QTMS radar is derived under the assumption that the radar integrates more than 500 samples to detect the presence or absence of a target. The detector function can also be applied to noise radar.

IEEE Radar Conference (RadarConf)•Sep 21, 2020•7 citations

A Family of Neyman-Pearson-Based Detectors for Noise-Type Radars

David Luong, Bhashyam Balaji, Sreeraman Rajan

We derive a detector that optimizes the target detection performance of any single-input single-output noise radar satisfying the following properties: it transmits Gaussian noise, it retains an internal reference signal for matched filtering, all external noise is additive white Gaussian noise, and all signals are measured using heterodyne receivers. This class of radars, which we call noise-type radars, includes not only many types of standard noise radars, but also a type of quantum radar known as quantum two-mode squeezing radar. The detector, which we derive using the Neyman-Pearson lemma, is not practical because it requires foreknowledge of a target-dependent correlation coefficient that cannot be known beforehand. (It is, however, a natural standard of comparison for other detectors.) This motivates us to study the family of Neyman-Pearson-based detectors that result when the correlation coefficient is treated as a parameter. We derive the probability distribution of the Neyman-Pearson-based detectors when there is a mismatch between the pre-chosen parameter value and the true correlation coefficient. We then use this result to generate receiver operating characteristic curves. Finally, we apply our results to the case where the correlation coefficient is small. It turns out that the resulting detector is not only a good one, but that it has appeared previously in the quantum radar literature.

arXiv:2204.07881•Apr 16, 2022•3 citations

Quantum Two-Mode Squeezing Radar and Noise Radar: Correlation Coefficient and Integration Time

David Luong, Bhashyam Balaji, Sreeraman Rajan

Quantum two-mode squeezing (QTMS) radars and noise radars perform matched filtering of the received signal using a reference signal stored within the radar. Their target detection performance depends on the correlation between the received and reference signals, and the improved detection performance of QTMS radars over noise radars is due to the fact that it has an increased correlation. In this paper, we present a novel way of understanding how detection performance depends on the correlation by relating the correlation to the integration time. Concretely, we prove that increasing the correlation by a given factor is equivalent to increasing the integration time by the square of that factor. We apply this result to a recent QTMS radar experiment where the increase in correlation was approximately a factor of 3. This was found to be equivalent to increasing the integration time by a factor of 9, thus confirming the validity of our result and approximation.

IEEE Access•Jan 1, 2020•8 citations
We analyze the potential application of a generalized likelihood ratio (GLR)-based detector function to quantum two-mode squeezing (QTMS) radars and standard noise radars. We give an expression for the likelihood ratio (LR) in terms of the maximum-likelihood estimate of the correlation coefficient between the received and reference signals of the radar. Interestingly, we found that a previously-studied detector function outperforms the GLR detector, though not in all parameter regimes. This runs counter to the intuition, based on the Neyman-Pearson lemma, that the LR test is optimal. We discuss why the lemma does not hold in this particular case and why the search for detector functions for QTMS radars and noise radars remains open. However, the GLR detector is a good choice when the correlation coefficient is high, the number of integrated samples is low, and appropriate computational resources are available.
We derive a detector function for quantum two-mode squeezing (QTMS) radar and noise radar that is based on the use of a generalized likelihood ratio (GLR) test for distinguishing between the presence and absence of a target. In addition to an explicit expression for the GLR detector, we derive a detector function which approximates the GLR detector in the limit where the target is small, far away, or otherwise difficult to detect. When the number of integrated samples is large, we derive a theoretical expression for the receiver operating characteristic (ROC) curve of the radar when the GLR detector is used. When the number of samples is small, we use simulations to understand the ROC curve behavior of the detector. One interesting finding is that there exists a parameter regime in which a previously-studied detector outperforms the GLR detector, contrary to the intuition that LR-based tests are optimal or nearly so. This is because neither the Neyman–Pearson lemma, nor the Karlin–Rubin theorem which generalizes the lemma to composite hypotheses, hold in this particular problem. However, the GLR detector remains a good choice for target detection in certain regimes.
The most important task of any radar is to detect targets. From this perspective, they are machines for distinguishing between two hypotheses: target absent and target present. The test statistic—or detector function—used by the radar is clearly of primary importance. In this paper, we explore the properties of a detector function for quantum two-mode squeezing radar and noise radar. This detector is derived from a second-order approximation of the likelihood ratio, and is attractive because it has a simple mathematical form. In order to analyze the performance of this detector function, we derive an expression for the receiver operating characteristic curve and verify it via simulations.
Quantum two-mode squeezing (QTMS) radars and noise radars detect targets by correlating the received signal with an internally stored recording. A covariance matrix can be calculated between the two which, in theory, is a function of a single correlation coefficient. This coefficient can be used to decide whether a target is present or absent. We can estimate the correlation coefficient by minimizing the Frobenius norm between the sample covariance matrix and the theoretically expected form of the matrix. Using simulated data, we show that the estimates follow a Rice distribution whose parameters are simple functions of the underlying, “true” correlation coefficient as well as the number of integrated samples. We obtain an explicit expression for the receiver operating characteristic curve that results when the correlation coefficient is used for target detection. This is an important first step toward performance prediction for QTMS radars.
A detector function for a newly proposed quantum radar known as quantum two-mode squeezing (QTMS) radar is analyzed in this paper. The detector function proposed in this paper behaves like a normal distribution function when the number of radar samples integrated for the detection is over 500 samples. A closed form expression for the receiver operating characteristic (ROC) curve for QTMS radar is derived under the assumption that the radar integrates more than 500 samples to detect the presence or absence of a target. The detector function can also be applied to noise radar.
We derive a detector that optimizes the target detection performance of any single-input single-output noise radar satisfying the following properties: it transmits Gaussian noise, it retains an internal reference signal for matched filtering, all external noise is additive white Gaussian noise, and all signals are measured using heterodyne receivers. This class of radars, which we call noise-type radars, includes not only many types of standard noise radars, but also a type of quantum radar known as quantum two-mode squeezing radar. The detector, which we derive using the Neyman-Pearson lemma, is not practical because it requires foreknowledge of a target-dependent correlation coefficient that cannot be known beforehand. (It is, however, a natural standard of comparison for other detectors.) This motivates us to study the family of Neyman-Pearson-based detectors that result when the correlation coefficient is treated as a parameter. We derive the probability distribution of the Neyman-Pearson-based detectors when there is a mismatch between the pre-chosen parameter value and the true correlation coefficient. We then use this result to generate receiver operating characteristic curves. Finally, we apply our results to the case where the correlation coefficient is small. It turns out that the resulting detector is not only a good one, but that it has appeared previously in the quantum radar literature.
Quantum two-mode squeezing (QTMS) radars and noise radars perform matched filtering of the received signal using a reference signal stored within the radar. Their target detection performance depends on the correlation between the received and reference signals, and the improved detection performance of QTMS radars over noise radars is due to the fact that it has an increased correlation. In this paper, we present a novel way of understanding how detection performance depends on the correlation by relating the correlation to the integration time. Concretely, we prove that increasing the correlation by a given factor is equivalent to increasing the integration time by the square of that factor. We apply this result to a recent QTMS radar experiment where the increase in correlation was approximately a factor of 3. This was found to be equivalent to increasing the integration time by a factor of 9, thus confirming the validity of our result and approximation.