Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Fiber Lasers: Technology and Systems

Generation of large optical bistability in a single-frequency Tm-doped fiber laser using saturable absorber

Junxiang Zhang, Quan Sheng, Lu Zhang, Shuai Sun, Chaodu Shi, Shijie Fu, Wei Shi, Jianquan Yao

Published Mar 4, 2021• 4 citations
Publisher

Abstract

We observed a large optical bistability in a single-frequency thulium fiber laser with ring cavity configuration. A piece of unpumped Tm-doped fiber served as nonlinear saturable absorber (SA), which also acted as a narrow-bandpass filter by forming self-induced gratings with counter-propagate lasers and enabled single-frequency laser operation at 1720 nm. Due to the large absorption cross section of thulium ions at 1720 nm, the unpumped Tm-doped fiber has large variable losses, hence resulting in strong optical bistability. With 0.75-m SA fiber, a 4.8-W wide bistable region was achieved. The evolution of bistable region with different lengths of SA fibers was investigated. The bistable region became narrower with decreasing SA fiber length, and totally disappeared at a SA fiber length of 0.15 m. To the best of our knowledge, this is the first observation of optical bistability in thulium fiber lasers.

DOI
10.1117/12.2578912

Related papers

Strong Optical Bistability in a Simple LLL -Band Tunable Erbium-Doped Fiber Ring Laser

Jung Mi Oh, Dong-Han Lee

We demonstrate strong optical bistability in a widely tunable L-band erbium-doped fiber ring laser pumped by a 980-nm laser diode. The bistable region is as much as 150-mW wide and can be controlled by the lasing wavelength or the length of erbium-doped fiber. The mechanism for the bistability is not typical cross gain saturation in a two-mode operation, but rather saturable absorption strongly enhanced in the proposed scheme.

IEEE Journal of Quantum Electronics•Mar 30, 2004•40 citations

Saturable Absorption in Erbium-doped Fiber and Optical Bistability in Erbium-doped Fiber Ring Laser

Deeksha Jachpure, R. Vijaya

Saturable absorption in erbium-doped fiber is presented through absorption measurements using a tunable laser and variable power. Its consequent optical bistability is also observed in erbium-doped fiber ring laser with long lengths of the fiber. Higher absorption at shorter wavelengths enables a wider bistable range.

Photonics North (PN)•May 31, 2021•2 citations

End-pumped optical bistability Tm,Ho:YLF laser

Xiaolin Zhang, Y. Wang, Li Li +3 more

We experimentally demonstrate strong optical bistability in a 2 μm continuous wave Tm,Ho:YLF laser with a bulk crystal. The laser is end-pumped by a 792 nm fiber-coupled laser diode. The bistable region is as wide as 1.6 W and the jump power at the turning point is as high as 82.5 mW when the temperature of the laser crystal is kept at 253 K. The influences of the cavity length and the transmission of the output coupler on the characteristics of optical bistability are obtained. The theoretical analysis shows that the bistable output in the Tm,Ho:YLF lasers comes from the combined effects of the nonlinear saturation of ground state reabsorption, the energy transfer upconversion, and the excited state absorption.

Laser Physics•Mar 1, 2009•11 citations

Optical-fiber ring cavity with saturable rare-earth-doped fiber

E. Aguilar, S. Srepanov, E. Hernandez

Resonance properties of the all-fiber ring cavity filled with nonlinear material - saturable rare-earth-doped fiber are analyzed and experimentally investigated. Unlike the earlier investigated erbium-doped fiber at 1550nm where the optical absorption photo-induced change (saturation) is observed only, the ytterbium-doped fiber at 1064nm demonstrates the saturation of the refractive index mainly. For this configuration we report experimental observation of the optical bistability and hysteresis in the transmitted output light at the 10mW-scale incident light power. The experimental results are in qualitative agreement with the theoretical analysis that takes into account the saturation of both parameters: the optical absorption and the refractive index of the doped fiber. The reported results seem promising for applications in high-sensitivity interferometric configurations at 1064nm operation wavelength.

Suplemento de la Revista Mexicana de Física•Mar 31, 2021•1 citation

Optical Bistability of the Negative Nonlinear Absorption Effect in Erbium-Doped Fibers Using a 1.5 µm Laser Diode

Yoshinobu Maeda

Optical bistability derived from the negative nonlinear absorption effect was investigated in 470 ppm erbium-doped fibers using a 1.5 µm laser diode. Optical bistability was observed in a laser intensity range of 0.3 W/cm2 to 2.5 kW/cm2 at a fiber length of 6 m. The transmitted laser intensity (I out), propagating through the fiber, decreased exponentially in accordance with the well-known exponential law. However, the amplitude of the optical bistability (ΔI out) increased logarithmically as the fiber length was increased. It was clarified that ΔI out was proportional to the product of exp (-L) and log (L) as a function of the fiber length (L). The optical bistability can be explained by considering an enhanced absorption model for a four-level system of the Er3+ ion.

Japanese Journal of Applied Physics•Jun 1, 2000•0 citations

Experiment and theoretical explanation of optical bistability in a single erbium-doped fiber ring laser

Jiafeng Shao, Shule Li, Qishun Shen +3 more

Optical bistability phenomenon in a single fiber ring laser employing erbium-doped fiber (EDF) as gain medium is observed in our experiment. In the EDF amplifiers, the photons of pump light cannot completely transfer into that of signal light because of various attenuation factors. This part of loss (useless pump loss) and active spontaneous emission (ASE) can both lower the small-signal gain of the EDF, and can eventually result in the bistability phenomenon. The range of this bistability has a complicated relationship with the length of the EDF, the erbium-ion doping concentration, the cavity loss and the useless loss coefficient of the pump light.

Optics Express•Jan 1, 2007•18 citations
We observed a large optical bistability in a single-frequency thulium fiber laser with ring cavity configuration. A piece of unpumped Tm-doped fiber served as nonlinear saturable absorber (SA), which also acted as a narrow-bandpass filter by forming self-induced gratings with counter-propagate lasers and enabled single-frequency laser operation at 1720 nm. Due to the large absorption cross section of thulium ions at 1720 nm, the unpumped Tm-doped fiber has large variable losses, hence resulting in strong optical bistability. With 0.75-m SA fiber, a 4.8-W wide bistable region was achieved. The evolution of bistable region with different lengths of SA fibers was investigated. The bistable region became narrower with decreasing SA fiber length, and totally disappeared at a SA fiber length of 0.15 m. To the best of our knowledge, this is the first observation of optical bistability in thulium fiber lasers.
We experimentally demonstrate strong optical bistability in a 2 μm continuous wave Tm,Ho:YLF laser with a bulk crystal. The laser is end-pumped by a 792 nm fiber-coupled laser diode. The bistable region is as wide as 1.6 W and the jump power at the turning point is as high as 82.5 mW when the temperature of the laser crystal is kept at 253 K. The influences of the cavity length and the transmission of the output coupler on the characteristics of optical bistability are obtained. The theoretical analysis shows that the bistable output in the Tm,Ho:YLF lasers comes from the combined effects of the nonlinear saturation of ground state reabsorption, the energy transfer upconversion, and the excited state absorption.
Resonance properties of the all-fiber ring cavity filled with nonlinear material - saturable rare-earth-doped fiber are analyzed and experimentally investigated. Unlike the earlier investigated erbium-doped fiber at 1550nm where the optical absorption photo-induced change (saturation) is observed only, the ytterbium-doped fiber at 1064nm demonstrates the saturation of the refractive index mainly. For this configuration we report experimental observation of the optical bistability and hysteresis in the transmitted output light at the 10mW-scale incident light power. The experimental results are in qualitative agreement with the theoretical analysis that takes into account the saturation of both parameters: the optical absorption and the refractive index of the doped fiber. The reported results seem promising for applications in high-sensitivity interferometric configurations at 1064nm operation wavelength.
Optical bistability derived from the negative nonlinear absorption effect was investigated in 470 ppm erbium-doped fibers using a 1.5 µm laser diode. Optical bistability was observed in a laser intensity range of 0.3 W/cm2 to 2.5 kW/cm2 at a fiber length of 6 m. The transmitted laser intensity (I out), propagating through the fiber, decreased exponentially in accordance with the well-known exponential law. However, the amplitude of the optical bistability (ΔI out) increased logarithmically as the fiber length was increased. It was clarified that ΔI out was proportional to the product of exp (-L) and log (L) as a function of the fiber length (L). The optical bistability can be explained by considering an enhanced absorption model for a four-level system of the Er3+ ion.
Optical bistability phenomenon in a single fiber ring laser employing erbium-doped fiber (EDF) as gain medium is observed in our experiment. In the EDF amplifiers, the photons of pump light cannot completely transfer into that of signal light because of various attenuation factors. This part of loss (useless pump loss) and active spontaneous emission (ASE) can both lower the small-signal gain of the EDF, and can eventually result in the bistability phenomenon. The range of this bistability has a complicated relationship with the length of the EDF, the erbium-ion doping concentration, the cavity loss and the useless loss coefficient of the pump light.