The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting. 1 ar
The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting. 1 ar
The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting.
Gravitational waves are a predication of Einstein's theory of general relativity. After nearly 50 years of effort by the scientific community to construct a detector capable of directly measuring gravitational waves, we expect a breakthrough, the first ever direct measurement of a gravitational wave within the next 5 years. The Advanced LIGO detectors currently under construction are predicted to achieve not only the first detection but to open the field of gravitational-wave astronomy: as an observational window on astrophysics and with an impart on other areas such as cosmology, strong-field gravity, general relativity, and nuclear physics. \n \nThe Advanced LIGO detectors are large-scale laser interferometers that have been designed for very low technical noise so that quantum noise will be limiting their sensitivity over a wide range of their spectrum. Planning for future gravitational wave observatories is already underway and reducing the fundamental quantum noise is considered to be one of the main experimental challenges. My work over the last 4 years has focused on possible new techniques to reduce or circumvent the quantum noise in laser interferometers. \n
Quantum fluctuation of light limits the sensitivity of advanced laser interferometric gravitational-wave detectors. It is one of the principal obstacles on the way towards the next-generation gravitational-wave observatories. The envisioned significant improvement of the detector sensitivity requires using quantum non-demolition measurement and back-action evasion techniques, which allow us to circumvent the sensitivity limit imposed by the Heisenberg uncertainty principle. In our previous review article (Danilishin and Khalili in Living Rev Relativ 15:5, 2012 ), we laid down the basic principles of quantum measurement theory and provided the framework for analysing the quantum noise of interferometers. The scope of this paper is to review novel techniques for quantum noise suppression proposed in the recent years and put them in the same framework. Our delineation of interferometry schemes and topologies is intended as an aid in the process of selecting the design for the next-generation gravitational-wave observatories.
Interferometric gravitational wave detectors (such as advanced LIGO) employ high-power solid-state lasers to maximize their detection sensitivity and hence their reach into the universe. These sophisticated light sources are ultra-stabilized with regard to output power, emission frequency and beam geometry; this is crucial to obtain low detector noise. However, even when all laser noise is reduced as far as technically possible, unavoidable quantum noise of the laser still remains. This is a consequence of the Heisenberg Uncertainty Principle, the basis of quantum mechanics: in this case, it is fundamentally impossible to simultaneously reduce both the phase noise and the amplitude noise of a laser to arbitrarily low levels. This fact manifests in the detector noise budget as two distinct noise sources—photon shot noise and quantum radiation pressure noise—which together form a lower boundary for current-day gravitational wave detector sensitivities, the standard quantum limit of interferometry. To overcome this limit, various techniques are being proposed, among them different uses of non-classical light and alternative interferometer topologies. This article explains how quantum noise enters and manifests in an interferometric gravitational wave detector, and gives an overview of some of the schemes proposed to overcome this seemingly fundamental limitation, all aimed at the goal of higher gravitational wave event detection rates. This article is part of a discussion meeting issue ‘The promises of gravitational-wave astronomy’.
Laser interferometers are quantum instruments. This chapter presents the quantum theory of laser interferometer gravitational wave detectors. We show the basics for analysing the quantum noise in the detector, and for deriving the associated standard quantum limit (SQL) for the sensitivity. By providing different perspectives on the origin of the SQL, we illustrate the motivations behind different approaches for surpassing the SQL. Introduction The most difficult challenge in building a laser interferometer gravitational wave (GW) detector is isolating the test masses from the rest of the world (e.g. random kicks from residual gas molecules, seismic activities, acoustic noises, thermal fluctuations, etc.) whilst keeping the device locked around the correct point of operation (e.g. pitch and yaw angles of the mirrors, locations of the beam spots, resonance condition of the cavities, and darkport condition for the Michelson). Once all these issues have been solved, we arrive at the issue that we are going to analyse in this chapter: the fundamental noise that arises from quantum fluctuations in the system. A simple estimate (following the steps of Braginsky, 1968) will already lead us into the quantum world – as it will turn out, the superb sensitivity of gravitational wave detectors will be constrained by the standard quantum limit (SQL), which relates to the fundamental heisenberg uncertainty principle . Further improvements of detector sensitivity beyond this require us to manipulate the quantum coherence of light to our advantage. In this chapter, we will introduce how to analyse GW detectors quantum mechanically, and will describe several advanced configurations to surpass the SQL.
Among the revolutionary predictions of Einstein’s theory of general relativity is the existence of gravitational waves, which are perturbations in the fabric of spacetime that travel at the speed of light. The first indirect evidence pointing to their existence came from the observation of the Hulse-Taylor pulsar in 1974[4]. More recently, gravitational wave observatories like the Laser Interferometer Gravitational-wave Observatory (LIGO) and Virgo have been built with the purpose of detecting gravitational waves (GW) directly, providing not only further evidence in support of general relativity, but also a whole new way of viewing the cosmos. The strain produced by a passing gravitational wave (namely, the relative change in the length of the matter a gravitational wave passes through) is so small that the best sensitivity achieved by the detectors has not produced a positive detection as of today. With a clear understanding that there should be gravitational waves, scientists are working on improving the sensitivity of the detectors to increase the likelihood of a detection. One of the main sources of noise for the next generation gravitational wave detectors, such as advanced LIGO, is shot noise. Shot noise dominates the noise spectrum above a few hundred Hz. This noise is due to uncertainties in quantum statistics, according to the generalized uncertainty principle. There are two ways to reduce the shot noise. The first way is to increase the intensity of the