Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

String of data comparison through Laguerre-Gaussian modes

Mateusz Szatkowski, Julian Koechlin, Dorilian Lopez-Mago

Published Aug 20, 2020• 0 citations
Publisher

Abstract

This work, based on classical light, was in uenced by quantum applications, where comparison of quantum states is an important issue. Laguerre-Gaussian modes were used to encode and compare two independent signals. Polarization controlled SWAP gate exchanges information between two strings of data, therefore preventing them from the leakage. Comparison is done with kHz frequency, achieved by the Digital Micromirror Device. Detected power, being a single value, represents an overlap of both signals. Presented system is capable to perform direct error analysis together with a normalization procedure, which overcomes the necessity of data post-processing and largely reduces time required for such comparison. We present a calibration procedure, which uses the glass sample to determine the performance of the experimental setup.

DOI
10.1117/12.2568486

Related papers

Efficient analysis of entangled photons and single photons

Shigeki Takeuchi

Efficient analysis of the quantum states of photons are essential for photonic quantum technologies. In the first part, we report the experimental demonstration of direct and efficient verification of entanglement between two multimode-multiphoton systems (one photon in three modes and two photons in three modes) using just two sets of classical correlation tables with and without a discrete Fourier transformation of the optical modes, clearly demonstrating a dramatic reduction in the resources required for entanglement verification. In the second part, we report our experimental demonstration of adaptive quantum state estimation for quantum states of photons changing in time.

Quantum Communications and Quantum Imaging•Jul 30, 2021•0 citations

Parallel string comparison using spatially separated controlled-SWAP gates based on Laguerre–Gaussian modes of light

Jakub Wroński, Przemysław Litwin, Mateusz Szatkowski

We demonstrate a parallel optical processing protocol that utilizes spatially separated controlled-SWAP gates based on Laguerre–Gaussian modes. Information is encoded in the relative phase between superposed LG modes within each channel, while the aggregated detection provides channel-independent similarity measurement. We experimentally validate this approach for N =2 and N =3 parallel channels, demonstrating protocol performance across a broad data overlap range (10% to 100%), and verifying channel symmetry. The obtained results show good agreement with theoretical values. This hybrid approach combines spatial multiplexing with phase encoding to enable a computational framework for multiple data streams requiring real-time similarity verification, with scalability constraints related to interferometric complexity and digital micromirror device dimensions.

Journal of the Optical Society of America A•Mar 17, 2026•1 citation

Encoding, manipulating and measuring quantum information in optics

Nathan K. Langford

In this thesis, I present experimental and theoretical work which assesses and develops a range of tools that are required for performing quantum information processing, particularly in photonic systems. I investigate the three degrees of freedom of a single photon—its polarisation, spatialmomentum and time-frequency distributions. For polarisation, I show that using wave plates to implement arbitrary, single-qubit rotations is more complicated than is commonly appreciated. In the spatial-momentum and time-frequency domains, I develop ways to perform tomographic analysis of quantum states, and I report the first demonstrations of these techniques. In the time-frequency domain, the tomography technique utilises entanglement in the photon polarisation as a resource to store and provide access to the time-frequency information. In my first two experiments, I use spontaneous parametric down-conversion to produce entanglement between pairs of single photons in all three degrees of freedom. I demonstrate the first characterisation of entanglement in spatial modes and the time-frequency domain, the first quantitative measurement of entangled qutrit states, and the highest quality entangled states yet measured in both polarisation and spatial modes. I also report the first realisation of complete hyperentanglement, and a full, black-box tomography of a 36-dimensional two-photon state—the largest system to be characterised in this way to date. In my final experiment, I model and implement a new architecture for a controlled-Z gate which is much simpler to align than previous implementations. This gate requires only one non-classical interference condition, the visibility of which is the main limitation to its performance. I show that the gate operates effectively as a means of both creating entanglement and discriminating between the four elements in a basis of maximally entangled, Bell-type states. Indeed, its observed performance as a Bell analyser would be sufficient to build a quantum state teleporter which would guarantee that the recipient would be left with a better copy of an unknown input state than any eavesdropper. In a series of numerical simulations, I investigate some of the practicalities that arise when using tomographic reconstruction techniques, including how to estimate errors, which measurements to make and what is actually the optimal reconstruction. In particular, I show that tomographies perform better when based on the results from over-complete sets of measurements. Finally, I discuss the important issue of how to compare two processes, particularly when trying to assess the quality of a measured process by comparing it to some expected ideal. Judging possible candidate measures against a set of experimentally and theoretically motivated

•Jan 1, 2007•17 citations

Ternary logic in the optical controlled-SWAP gate based on Laguerre-Gaussian modes of light

Przemysław Litwin, Jakub Wroński, Konrad Markowski +3 more

The need set by a computational industry to increase processing power, while simultaneously reducing the energy consumption of data centers, became a challenge for modern computational systems. In this work, we propose an optical communication solution, that could serve as a building block for future computing systems, due to its versatility. The solution arises from Landauer's principle and utilizes reversible logic, manifested as an optical logical gate with structured light, here represented as Laguerre-Gaussian modes. We introduced a phase-shift-based encoding technique and incorporated multi-valued logic in the form of a ternary numeral system to determine the similarity between two images through the free space communication protocol.

arXiv:2401.03521•Optics Express•Mar 21, 2024•4 citations

Optical quantum bit string comparator

C. P. de Sousa, João Batista Rosa Silva, Rubens Viana Ramos

Optical and Quantum Electronics•Jan 1, 2019•4 citations

Measurement and analysis of high-frequency voltage errors in the Josephson arbitrary waveform synthesizer

Marco Kraus, D. Drung, Ralf Behr +4 more

Abstract This paper reports on the comparison of two Josephson arbitrary waveform synthesizers for frequencies up to 500 kHz. Both independent pulse-driven Josephson arrays produce a 10 mV RMS sinusoidal voltage. They are alternately connected to an analog-to-digital converter which serves as a transfer standard. The setup is capable to of synthesizing quantum-based waveforms using two different pulse-bias techniques. We use the Zero-Compensation method and a two-pole high-pass filter structure in the pulse-bias configuration of one system (the reference) to minimize the amplitude error for signal frequencies up to 500 kHz. Consequently, we are able to directly detect the high-frequency voltage errors in the other system (the device under test). The setup is used to measure differences between both systems, and the influence of parameter variation on the results with Type A uncertainties of 0.4 µV/V ( k = 1) in measurement times of 60 s. We find that the dominant sources of deviations above 10 kHz can be traced to the influence of the output cabling and the pulse bias on the synthesized voltage signal. Our analysis explains the origin and the reduction of these high-frequency voltage errors.

Measurement Science and Technology•Jul 9, 2020•13 citations
This work, based on classical light, was in uenced by quantum applications, where comparison of quantum states is an important issue. Laguerre-Gaussian modes were used to encode and compare two independent signals. Polarization controlled SWAP gate exchanges information between two strings of data, therefore preventing them from the leakage. Comparison is done with kHz frequency, achieved by the Digital Micromirror Device. Detected power, being a single value, represents an overlap of both signals. Presented system is capable to perform direct error analysis together with a normalization procedure, which overcomes the necessity of data post-processing and largely reduces time required for such comparison. We present a calibration procedure, which uses the glass sample to determine the performance of the experimental setup.
Efficient analysis of the quantum states of photons are essential for photonic quantum technologies. In the first part, we report the experimental demonstration of direct and efficient verification of entanglement between two multimode-multiphoton systems (one photon in three modes and two photons in three modes) using just two sets of classical correlation tables with and without a discrete Fourier transformation of the optical modes, clearly demonstrating a dramatic reduction in the resources required for entanglement verification. In the second part, we report our experimental demonstration of adaptive quantum state estimation for quantum states of photons changing in time.
We demonstrate a parallel optical processing protocol that utilizes spatially separated controlled-SWAP gates based on Laguerre–Gaussian modes. Information is encoded in the relative phase between superposed LG modes within each channel, while the aggregated detection provides channel-independent similarity measurement. We experimentally validate this approach for N =2 and N =3 parallel channels, demonstrating protocol performance across a broad data overlap range (10% to 100%), and verifying channel symmetry. The obtained results show good agreement with theoretical values. This hybrid approach combines spatial multiplexing with phase encoding to enable a computational framework for multiple data streams requiring real-time similarity verification, with scalability constraints related to interferometric complexity and digital micromirror device dimensions.
In this thesis, I present experimental and theoretical work which assesses and develops a range of tools that are required for performing quantum information processing, particularly in photonic systems. I investigate the three degrees of freedom of a single photon—its polarisation, spatialmomentum and time-frequency distributions. For polarisation, I show that using wave plates to implement arbitrary, single-qubit rotations is more complicated than is commonly appreciated. In the spatial-momentum and time-frequency domains, I develop ways to perform tomographic analysis of quantum states, and I report the first demonstrations of these techniques. In the time-frequency domain, the tomography technique utilises entanglement in the photon polarisation as a resource to store and provide access to the time-frequency information. In my first two experiments, I use spontaneous parametric down-conversion to produce entanglement between pairs of single photons in all three degrees of freedom. I demonstrate the first characterisation of entanglement in spatial modes and the time-frequency domain, the first quantitative measurement of entangled qutrit states, and the highest quality entangled states yet measured in both polarisation and spatial modes. I also report the first realisation of complete hyperentanglement, and a full, black-box tomography of a 36-dimensional two-photon state—the largest system to be characterised in this way to date. In my final experiment, I model and implement a new architecture for a controlled-Z gate which is much simpler to align than previous implementations. This gate requires only one non-classical interference condition, the visibility of which is the main limitation to its performance. I show that the gate operates effectively as a means of both creating entanglement and discriminating between the four elements in a basis of maximally entangled, Bell-type states. Indeed, its observed performance as a Bell analyser would be sufficient to build a quantum state teleporter which would guarantee that the recipient would be left with a better copy of an unknown input state than any eavesdropper. In a series of numerical simulations, I investigate some of the practicalities that arise when using tomographic reconstruction techniques, including how to estimate errors, which measurements to make and what is actually the optimal reconstruction. In particular, I show that tomographies perform better when based on the results from over-complete sets of measurements. Finally, I discuss the important issue of how to compare two processes, particularly when trying to assess the quality of a measured process by comparing it to some expected ideal. Judging possible candidate measures against a set of experimentally and theoretically motivated
The need set by a computational industry to increase processing power, while simultaneously reducing the energy consumption of data centers, became a challenge for modern computational systems. In this work, we propose an optical communication solution, that could serve as a building block for future computing systems, due to its versatility. The solution arises from Landauer's principle and utilizes reversible logic, manifested as an optical logical gate with structured light, here represented as Laguerre-Gaussian modes. We introduced a phase-shift-based encoding technique and incorporated multi-valued logic in the form of a ternary numeral system to determine the similarity between two images through the free space communication protocol.
Abstract This paper reports on the comparison of two Josephson arbitrary waveform synthesizers for frequencies up to 500 kHz. Both independent pulse-driven Josephson arrays produce a 10 mV RMS sinusoidal voltage. They are alternately connected to an analog-to-digital converter which serves as a transfer standard. The setup is capable to of synthesizing quantum-based waveforms using two different pulse-bias techniques. We use the Zero-Compensation method and a two-pole high-pass filter structure in the pulse-bias configuration of one system (the reference) to minimize the amplitude error for signal frequencies up to 500 kHz. Consequently, we are able to directly detect the high-frequency voltage errors in the other system (the device under test). The setup is used to measure differences between both systems, and the influence of parameter variation on the results with Type A uncertainties of 0.4 µV/V ( k = 1) in measurement times of 60 s. We find that the dominant sources of deviations above 10 kHz can be traced to the influence of the output cabling and the pulse bias on the synthesized voltage signal. Our analysis explains the origin and the reduction of these high-frequency voltage errors.