Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

European Conference on Optical Communication

Quantum theory of noise in stokes vector receivers and application to bit error rate analysis

Kazuro Kikuchi

Published Jan 1, 2019• 2 citations
Publisher

Abstract

Polarization-modulated optical signals can be demodulated via direct detection of Stokes vectors. In this article, we develop a quantum theory of noise in the Stokes vector receiver. Examining the conditions that enable simultaneous measurement of three elements of the Stokes vector, we demonstrate that an optical pre-amplifier in front of the Stokes vector receiver can reduce the power penalty associated with simultaneous measurements, down to the quantum limit of 3 dB. Then, the 3-D Gaussian noise model for the shot noise and optical pre-amplifier noise is discussed. Subsequently, based on the noise analyses, we derive bit error rate formulae for the cubic-lattice polarization modulation format and evaluate the sensitivity of the Stokes vector receiver.

DOI
10.1049/cp.2019.1042

Related papers

Homodyne optical coherent systems based on polarization modulation

S. Betti, Giancarlo De Marchis, Eugenio Iannone +1 more

The first homodyne receiver for polarization modulated optical signals is proposed and analyzed. It is based on the detection at the receiver of the four quadratures that completely characterize the received optical field and on the estimation of the Stokes parameters starting from them. This allows homodyne detection to be carried out without phase locking the local oscillator to the received signal. An accurate performance evaluation is carried out both at the quantum limit and in the presence of phase noise for a binary system based on an antipodal decision in the Stokes space. The system structure is described. The quantum limit performance is evaluated, and the phase-noise induced penalty is evaluated using an accurate analytical model.>

Journal of Lightwave Technology•Jan 1, 1991•19 citations

A unified theory of quantum limits for optically pre-amplified and coherent detection

Moshe Nazarathy

We develop a unified theory of ideal error rate performance and quantum limit sensitivities for a large variety of optical modulation formats under four detection schemes: optically pre-amplified direct detection, and coherent homodyne / (a)synchronous heterodyne.

Optical Amplifiers and Their Applications•Jan 1, 2006•0 citations

Fundamental Limits to the Measurement of the Polarization of Classical Light

Antonio Mecozzi, Cristian Antonelli, Mark Shtaif

We study the limits that quantum mechanics imposes on the accuracy of the measurement of the Stokes polarization-vector in the case of classical states. Using the apparatus of the conventional Stokes receiver, we propose an estimation method that allows not only to exceed the signal-to-noise limit that is achieved by a heterodyne measurement or after ideal phase-insensitive amplification, but also to achieve the quantum SNR limit for the measurement of classical light. We refer to this receiver scheme as the enhanced Stokes receiver.

Journal of Lightwave Technology•Jan 14, 2021•2 citations

Stokes‐parameter detection experimental results for polarization modulation coherent systems with low bit‐rate‐to‐linewidth ratio

S. Betti, F. Curti, Giancarlo De Marchis +2 more

Abstract A BER measurement has been performed relative to each Stokes parameter in an ASPSK system using laser sources such that the beating signal linewidth exceeds the bit rate (about 200%). Under such severe conditions a sensitivity of about 155 photons/bit has been achieved at a BER of 10−9, with a penalty of about 6 dB with respect to the quantum limit of an ASPSK system. © 1993 John Wiley & Sons, Inc.

Microwave and Optical Technology Letters•Jul 1, 1993•0 citations

Quantum-noise-limited interferometric phase measurements

Andrew J. Stevenson, Malcolm B. Gray, Hans‐A. Bachor +1 more

Two schemes for interferometric optical phase measurement, with sensitivity limited only by quantum noise in the light, are analyzed. Direct detection is applicable to signals at modulation frequencies away from the technical noise of the light, so that quantum noise dominates the measurement. Alternatively signals otherwise obscured by classical optical noise may be recovered with a phase-modulation technique that shifts the signals to a quantum-noise-limited region of the photocurrent spectrum. The analysis is tested experimentally by using a polarimetric electric-field sensor. In the direct-detection scheme quantum-noise-limited performance produced a phase sensitivity of 0.25 µrad. The indirect scheme allowed subkilohertz signals to be extracted from classical noise 67 dB greater with sensitivity approaching the quantum noise limit.

Applied Optics•Jul 1, 1993•45 citations

Minimum energy per bit in high bit rate optical communications and quantum communications

Philippe B. Gallion, Francisco Javier Mendieta

Optical direct detection usually operates far above the quantum limit, due to the high thermal noise level of PIN photodiodes. For signal energy at the quantum level, the thermal effects in photon counters are also a strong limitation. The optical amplification or the heterodyne detection of the 2 quadratures of the field, widely used in high bit rate and long haul optical systems, overcome this limitation at the expense of a minimum 3db noise figure. By allowing a noise free mixing gain, as well as single quadrature measurements, the balanced homodyne receiver is allowed to reach quantum noise limited operation. The aim of this paper is to review the different quantum receiver implementations and to compare the minimum signal energy required to achieve a given bit error rate, or a given bit erasure rate, in high bit rate communications and quantum communications. Application to quantum cryptography will be also addressed.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 13, 2011•1 citation
Polarization-modulated optical signals can be demodulated via direct detection of Stokes vectors. In this article, we develop a quantum theory of noise in the Stokes vector receiver. Examining the conditions that enable simultaneous measurement of three elements of the Stokes vector, we demonstrate that an optical pre-amplifier in front of the Stokes vector receiver can reduce the power penalty associated with simultaneous measurements, down to the quantum limit of 3 dB. Then, the 3-D Gaussian noise model for the shot noise and optical pre-amplifier noise is discussed. Subsequently, based on the noise analyses, we derive bit error rate formulae for the cubic-lattice polarization modulation format and evaluate the sensitivity of the Stokes vector receiver.
The first homodyne receiver for polarization modulated optical signals is proposed and analyzed. It is based on the detection at the receiver of the four quadratures that completely characterize the received optical field and on the estimation of the Stokes parameters starting from them. This allows homodyne detection to be carried out without phase locking the local oscillator to the received signal. An accurate performance evaluation is carried out both at the quantum limit and in the presence of phase noise for a binary system based on an antipodal decision in the Stokes space. The system structure is described. The quantum limit performance is evaluated, and the phase-noise induced penalty is evaluated using an accurate analytical model.>
We study the limits that quantum mechanics imposes on the accuracy of the measurement of the Stokes polarization-vector in the case of classical states. Using the apparatus of the conventional Stokes receiver, we propose an estimation method that allows not only to exceed the signal-to-noise limit that is achieved by a heterodyne measurement or after ideal phase-insensitive amplification, but also to achieve the quantum SNR limit for the measurement of classical light. We refer to this receiver scheme as the enhanced Stokes receiver.
Two schemes for interferometric optical phase measurement, with sensitivity limited only by quantum noise in the light, are analyzed. Direct detection is applicable to signals at modulation frequencies away from the technical noise of the light, so that quantum noise dominates the measurement. Alternatively signals otherwise obscured by classical optical noise may be recovered with a phase-modulation technique that shifts the signals to a quantum-noise-limited region of the photocurrent spectrum. The analysis is tested experimentally by using a polarimetric electric-field sensor. In the direct-detection scheme quantum-noise-limited performance produced a phase sensitivity of 0.25 µrad. The indirect scheme allowed subkilohertz signals to be extracted from classical noise 67 dB greater with sensitivity approaching the quantum noise limit.
Optical direct detection usually operates far above the quantum limit, due to the high thermal noise level of PIN photodiodes. For signal energy at the quantum level, the thermal effects in photon counters are also a strong limitation. The optical amplification or the heterodyne detection of the 2 quadratures of the field, widely used in high bit rate and long haul optical systems, overcome this limitation at the expense of a minimum 3db noise figure. By allowing a noise free mixing gain, as well as single quadrature measurements, the balanced homodyne receiver is allowed to reach quantum noise limited operation. The aim of this paper is to review the different quantum receiver implementations and to compare the minimum signal energy required to achieve a given bit error rate, or a given bit erasure rate, in high bit rate communications and quantum communications. Application to quantum cryptography will be also addressed.