An atom trapping technique for determining absolute, total ionization cross sections (TICS) out of an excited atom is presented. The unique feature of our method is in utilizing Doppler cooling of neutral atoms to determine ionization cross sections. This fluorescence-monitoring experiment, which is a variant of the ``trap loss'' technique, has enabled us to obtain the experimental electron impact ionization cross sections out of the Cs
62P3∕2 state between
7eV and
400eV. CCC, RMPS, and Born theoretical results are also presented for both the ground and excited states of cesium and rubidium. In the low energy region
(<11eV) where best agreement between these excited state measurements and theory might be expected, a discrepancy of approximately a factor of five is observed. Above this energy there are significant contributions to the TICS from both autoionization and multiple ionization.
The key features of the cross sections for electron-impact excitation out of the ground levels of the rare-gas atoms are summarized and application of these cross section data is shown. This is followed by discussions of recent experiments on determination of electron-impact cross sections for excitation out of the metastable levels of He and Ar. The metastiable atom targets are produced by two different methods, i.e., hollow-cathode discharges and charge-exchange collisions of rare-gas ions with Cs atoms. The former method is simple but is limited to low electron energies because of the very small metastable concentration, whereas the latter method yields a fast target beam with predominantly metastable atoms allowing measurements up to the keV range. The measured cross sections show features very different from those of excitation out of the ground levels. Another new development in electron-atom collision is the use of atom traps for measuring ionization cross sections. The experiment is conducted by passing an electron beam pulse through magneto-optically trapped Rb atoms while the trap is momentarily turned off. Turning the trap back on immediately after the electron beam pulse recaptures the unionized atoms allowing only the ions to escape. The ionization cross section is determined bymore » measuring the electron beam current density at the trapped atom region and the fractional loss of trapped atoms due to the electron beam. This method avoids measurements of the absolute number of the target atoms and the overlap between the atomic and electron beams and therefore eliminates the major sources of uncertainty associated with the crossed-beam method for measuring ionization cross section.« less