Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

External serrodyne modulation for the suppression of low-frequency noise in quadrature interferometry

Vincent Michaud-Belleau, Mark Charlet, Alex Tourigny-Plante, Jean-Daniel Deschênes, Jérôme Genest

Published Dec 9, 2019• 3 citations
Publisher

Abstract

In interferometry, reaching a high signal-to-noise ratio at low frequencies can be challenging when the additive noise is nonstationary. Although this problem is typically solved by inserting a frequency shifter into one of the arms, in some cases, the interferometer cannot or should not be modified in this way. This Letter presents an alternative solution, based on external serrodyne frequency modulation, which is comparable to the typical approach in terms of complexity and performance yet does not require the modification of a passive interferometer. We demonstrate a prototype that achieves frequency shifting at 500 kHz with 89% power efficiency, leading to the wideband suppression of low-frequency additive noise by more than 19 dB. This enables a fully passive measurement of the thermoconductive noise of a 100 m single-mode fiber.

DOI
10.1364/ol.376542

Related papers

Composite Raman-Nath heterodyne interferometry with relevance for precise spectroscopy

Matteo Barbiero, Juan Pablo Salvatierra, Davide Calonico +2 more

Atomic state manipulation by laser radiation requires a stringent control of the light phase noise for precise spectroscopy and quantum computation . In this work we describe a novel interferometer recently employed to estimate the phase noise induced by an optical frequency shifter based on serrodyne modulation for optical frequency standards (Barbiero et al., 2023). The interferometer is generated by an acousto-optic actuator working in the Raman-Nath regime. Using the heterodyne detection between the unshifted optical mode with the first higher order optical components , we are able to detect the differential phase between the two optical path arms with a reduction of the phase noise induced by the actuator. We provide a theoretical treatment for the actuator phase suppression and we estimate the detectable phase noise limit of this interferometer. Finally, we discuss the possible applications in the field of precision measurements.

Optics & Laser Technology•Aug 29, 2024•1 citation

Broadband phase-noise suppression in fiber interferometers using specialty hollow-core photonic bandgap fibers

Yibin Liang, Kun-Hua Wen, Shun Wang +4 more

Fiber interferometers are widely used in precision measurements, yet phase-noise suppression over the mHz-kHz band remains a key bottleneck. Here, a specialty hollow-core photonic bandgap fiber (HC-PBGF) is introduced as the sensing arm to reduce temperature-induced phase noise. Comparative measurements show that, relative to a solid-core polarization-maintaining fiber (PMF) interferometer, the HC-PBGF interferometer achieves an ∼18 dB reduction in phase-noise power spectral density (PSD) in the mHz-Hz band while maintaining an ∼7 dB advantage in the Hz-k Hz band, which is qualitatively consistent with the simplified theoretical prediction. These results support the development of HC-PBGF-based broadband low-noise fiber interferometry.

Optics Express•Apr 10, 2026•0 citations

Subhertz interferometry at the quantum noise limit

Peng Yang, Boya Xie, Sheng Feng

Quantum noise limited interferometry for subhertz phase measurement is of essence in precision metrology applications, such as gravitational wave detection. However, suppression of subhertz classical noises below the shot-noise level is very challenging in practice. Two-frequency interferometry has been previously proposed to avoid low-frequency noises and may be useful for squeezing-enhanced high-precision phase measurement. Here we experimentally demonstrate a subhertz interferometer at the standard quantum noise (shot-noise) limit, by use of dual-frequency coherent probe light at the input and phase-sensitive heterodyne detection to measure the output interfered light. When the interferometer is locked at a dark fringe, the noise floor of the phase variance in the interferometer reaches the shot-noise level down to Fourier frequencies below 1 Hz. This work should pave a way for a realization of subhertz interferometry beyond the shot-noise limit.

Optics Letters•Apr 29, 2019•12 citations

Noise mitigation for high-sensitivity phase estimation based on weak measurements

Xiaorui Tan, Hongjing Li, Qi Song +6 more

Phase estimation has attracted much attention in the field of sensing, where weak measurement has become an effective solution for the study of small physical quantities because of its anomalous amplification property. However, it is difficult for weak measurement to cope with large low-frequency noise signals in the environment due to its extremely narrow linear range, which makes the extension of weak measurement to practical applications a challenging task. In order to solve this issue, we propose and experimentally verify a phase demodulation scheme based on weak measurement, which solves the problem of working point offset caused by the noise through artificially introducing a high-frequency carrier and performing demodulation operations on the output light. The experimental results show that the scheme can improve the signal-to-noise ratio by 17 dB compared to standard weak measurement and ensures low distortion in phase demodulation. Moreover, the scheme is not limited to a specific modulation depth, which greatly improves the robustness of the scheme.

Physical Review A•May 8, 2024•3 citations

Squeezing-enhanced fiber Mach-Zehnder interferometer for low-frequency phase measurement

Fang Liu, Yaoyao Zhou, Juan Yu +7 more

We propose and experimentally demonstrate a quantum-enhanced fiber Mach-Zehnder interferometer for low-frequency phase measurement beyond the shot-noise limit using a high-frequency squeezing technique. The local oscillator field is amplitude-modulated in the MHz range and is then demodulated to avoid the technical noise that occurs at low frequencies. After measurement of the phase noise at a frequency of tens of kHz, an improvement of ∼2 dB relative to the shot-noise level is achieved. Additionally, the amplitude modulation depth has no significant effect on the phase noise improvement of the interferometer when deployed in our experimental configuration. The current scheme introduces a quantum technique into the fiber-based measurements, particularly for the low frequency range, and this scheme has potential applications in the high-precision fiber sensing of temperature, strain, and various other parameters.

Applied Physics Letters•Jan 9, 2017•36 citations

Single-photon frequency shifting with a quadrature phase-shift keying modulator

Changchen Chen, Jane E. Heyes, Jeffrey H. Shapiro +1 more

Deterministic frequency manipulation of single photons is an essential tool for quantum communications and quantum networks. We demonstrate a 15.65 GHz frequency shift for classical and nonclassical light using a commercially available quadrature phase-shift keying modulator. The measured spectrum of frequency-shifted single photons indicates a high carrier-to-sideband ratio of 30 dB. We illustrate our frequency shifter's utility in quantum photonics by performing Hong-Ou-Mandel quantum interference between two photons whose initial frequency spectra overlap only partially, and showing visibility improvement from 62.7 to 89.1% after one of the photons undergoes a corrective frequency shift.

Scientific Reports•Jan 11, 2021•15 citations
In interferometry, reaching a high signal-to-noise ratio at low frequencies can be challenging when the additive noise is nonstationary. Although this problem is typically solved by inserting a frequency shifter into one of the arms, in some cases, the interferometer cannot or should not be modified in this way. This Letter presents an alternative solution, based on external serrodyne frequency modulation, which is comparable to the typical approach in terms of complexity and performance yet does not require the modification of a passive interferometer. We demonstrate a prototype that achieves frequency shifting at 500 kHz with 89% power efficiency, leading to the wideband suppression of low-frequency additive noise by more than 19 dB. This enables a fully passive measurement of the thermoconductive noise of a 100 m single-mode fiber.
Atomic state manipulation by laser radiation requires a stringent control of the light phase noise for precise spectroscopy and quantum computation . In this work we describe a novel interferometer recently employed to estimate the phase noise induced by an optical frequency shifter based on serrodyne modulation for optical frequency standards (Barbiero et al., 2023). The interferometer is generated by an acousto-optic actuator working in the Raman-Nath regime. Using the heterodyne detection between the unshifted optical mode with the first higher order optical components , we are able to detect the differential phase between the two optical path arms with a reduction of the phase noise induced by the actuator. We provide a theoretical treatment for the actuator phase suppression and we estimate the detectable phase noise limit of this interferometer. Finally, we discuss the possible applications in the field of precision measurements.
Fiber interferometers are widely used in precision measurements, yet phase-noise suppression over the mHz-kHz band remains a key bottleneck. Here, a specialty hollow-core photonic bandgap fiber (HC-PBGF) is introduced as the sensing arm to reduce temperature-induced phase noise. Comparative measurements show that, relative to a solid-core polarization-maintaining fiber (PMF) interferometer, the HC-PBGF interferometer achieves an ∼18 dB reduction in phase-noise power spectral density (PSD) in the mHz-Hz band while maintaining an ∼7 dB advantage in the Hz-k Hz band, which is qualitatively consistent with the simplified theoretical prediction. These results support the development of HC-PBGF-based broadband low-noise fiber interferometry.
Quantum noise limited interferometry for subhertz phase measurement is of essence in precision metrology applications, such as gravitational wave detection. However, suppression of subhertz classical noises below the shot-noise level is very challenging in practice. Two-frequency interferometry has been previously proposed to avoid low-frequency noises and may be useful for squeezing-enhanced high-precision phase measurement. Here we experimentally demonstrate a subhertz interferometer at the standard quantum noise (shot-noise) limit, by use of dual-frequency coherent probe light at the input and phase-sensitive heterodyne detection to measure the output interfered light. When the interferometer is locked at a dark fringe, the noise floor of the phase variance in the interferometer reaches the shot-noise level down to Fourier frequencies below 1 Hz. This work should pave a way for a realization of subhertz interferometry beyond the shot-noise limit.
Phase estimation has attracted much attention in the field of sensing, where weak measurement has become an effective solution for the study of small physical quantities because of its anomalous amplification property. However, it is difficult for weak measurement to cope with large low-frequency noise signals in the environment due to its extremely narrow linear range, which makes the extension of weak measurement to practical applications a challenging task. In order to solve this issue, we propose and experimentally verify a phase demodulation scheme based on weak measurement, which solves the problem of working point offset caused by the noise through artificially introducing a high-frequency carrier and performing demodulation operations on the output light. The experimental results show that the scheme can improve the signal-to-noise ratio by 17 dB compared to standard weak measurement and ensures low distortion in phase demodulation. Moreover, the scheme is not limited to a specific modulation depth, which greatly improves the robustness of the scheme.
We propose and experimentally demonstrate a quantum-enhanced fiber Mach-Zehnder interferometer for low-frequency phase measurement beyond the shot-noise limit using a high-frequency squeezing technique. The local oscillator field is amplitude-modulated in the MHz range and is then demodulated to avoid the technical noise that occurs at low frequencies. After measurement of the phase noise at a frequency of tens of kHz, an improvement of ∼2 dB relative to the shot-noise level is achieved. Additionally, the amplitude modulation depth has no significant effect on the phase noise improvement of the interferometer when deployed in our experimental configuration. The current scheme introduces a quantum technique into the fiber-based measurements, particularly for the low frequency range, and this scheme has potential applications in the high-precision fiber sensing of temperature, strain, and various other parameters.
Deterministic frequency manipulation of single photons is an essential tool for quantum communications and quantum networks. We demonstrate a 15.65 GHz frequency shift for classical and nonclassical light using a commercially available quadrature phase-shift keying modulator. The measured spectrum of frequency-shifted single photons indicates a high carrier-to-sideband ratio of 30 dB. We illustrate our frequency shifter's utility in quantum photonics by performing Hong-Ou-Mandel quantum interference between two photons whose initial frequency spectra overlap only partially, and showing visibility improvement from 62.7 to 89.1% after one of the photons undergoes a corrective frequency shift.