Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

A Flexible Control System for Quantum Dot Qubits

Nizar Messaoudi, Azfar Badaroudine, Larissa Njejimana, Gidget Heintz, Marc-Antoine Genest, Michel Pioro-Ladrière

Published Mar 8, 2019• 0 citations
OpenAlex

Related papers

Demonstrating RFSoC-based Control of a Fully Connected Exchange-Only Qubit

Abigail L. Wessels, M. Garrett Bimstefer, Joseph D. Broz +2 more

Semiconductor triple-quantum dots (TQDs) are a promising platform for scalable quantum information processing, but the community has so far lacked access to affordable and flexible high-speed control electronics. SpinQICK, an open-source spin qubit-control package built on the Xilinx Radio Frequency System-on-Chip (RFSoC), directly addresses this gap by leveraging the high sampling-rate signal generation and advanced digital signal processing (DSP) capabilities of the Quantum Instrumentation Control Kit (QICK) to enable precise time-domain voltage control and readout of semiconductor spin qubits. In this paper, we use spinQICK to demonstrate coherent control, state preparation, and readout of a fully connected triangular exchange-only device. We also introduce and experimentally verify a novel dynamical decoupling (DD) sequence enabled by the triangular TQD and leverage its unique decoupling properties to characterize electrical noise. These results establish spinQICK as a low-cost, flexible platform for semiconductor spin qubit control and provide a pathway for hardware optimization through qubit-level noise diagnostics.

quant-pharXiv:2610.31998•Oct 26, 2026•0 citations

Even-Handed Control of Quantum Dot Qubits

Anonymous

Physics•Mar 16, 2016•0 citations

Control strategies for semiconductor-quantum-dot-based single and double qubits

Robert Roloff, Markus Wenin, W. Pötz

Journal of Computational Electronics•Mar 1, 2009•7 citations

Development of Control Circuits for Silicon MOS Quantum Dot Qubit Network

Rubaya Absar

Future quantum processors intend to operate on millions of qubits and Silicon Metal Oxide Semiconductor (MOS) Quantum Dot qubits are a good fit for such a large-scale system due to their compactness in size and large coherence time. To control the operations of the qubits in such a large-scale system, efficient and careful design of the control circuits is very challenging. Here, in this thesis a control circuit is designed for silicon MOS quantum dot qubits operating on a node/ network architecture. Rather than using a 2D array of quantum dots, a node/ network architecture provides enough space for the wiring of integrated control circuits. The control circuit designed here is expected to work on millikelvin (mK) temperature and number of control lines from the mK temperature to 1-4 K temperature, where the digital control systems are operated, is reduced significantly compared to the number of qubits. The reduction in number of control lines from mK temperature is one of the basic requirements while scaling up. All these control circuits operate on the quantum dots based on the assumption that, all the dots are at same potential throughout the network. In practice due to fabrication variations and connection differences the potential of quantum dots varies from qubit to qubit. To solve this problem and pre-tune all the quantum dots to same potential prior to the operation of control circuit, a device level error correcting scheme is introduced and verified by simulation in this thesis.

•Apr 23, 2021•0 citations

Coherence and Manipulation of Quantum Dot Hybrid Qubits

Brandur Thorgrimsson

•Jan 1, 2019•0 citations

Conveyor-mode electron shuttling through a T-junction in Si/SiGe

Max Beer, Ran Xue, Lennart Deda +6 more

Conveyor-mode shuttling in gated Si/SiGe devices enables adiabatic transfer of single electrons, electron patterns and spin qubits confined in quantum dots across several microns with a scalable number of signal lines. To realize their full potential, linear shuttle lanes must connect into a two-dimensional grid with controllable routing. We introduce a T-junction device linking two independently driven shuttle lanes. Electron routing across the junction requires no extra control lines beyond the four channels per conveyor belt. We measure an inter-lane charge transfer fidelity of $F = 100.0000000^{+0}_{-9\times 10^{-7}}\,\%$ at an instantaneous electron velocity of $270\,\mathrm{mm}\,\mathrm{s}^{-1}$. The filling of 54 quantum dots is controlled by simple atomic pulses, allowing us to swap electron patterns, laying the groundwork for a native spin-qubit SWAP gate. This T-junction establishes a path towards scalable, two-dimensional quantum computing architectures with flexible spin qubit routing for quantum error correction.

cond-mat.mes-hallCross-listedarXiv:2601.03942•Jan 8, 2026
Semiconductor triple-quantum dots (TQDs) are a promising platform for scalable quantum information processing, but the community has so far lacked access to affordable and flexible high-speed control electronics. SpinQICK, an open-source spin qubit-control package built on the Xilinx Radio Frequency System-on-Chip (RFSoC), directly addresses this gap by leveraging the high sampling-rate signal generation and advanced digital signal processing (DSP) capabilities of the Quantum Instrumentation Control Kit (QICK) to enable precise time-domain voltage control and readout of semiconductor spin qubits. In this paper, we use spinQICK to demonstrate coherent control, state preparation, and readout of a fully connected triangular exchange-only device. We also introduce and experimentally verify a novel dynamical decoupling (DD) sequence enabled by the triangular TQD and leverage its unique decoupling properties to characterize electrical noise. These results establish spinQICK as a low-cost, flexible platform for semiconductor spin qubit control and provide a pathway for hardware optimization through qubit-level noise diagnostics.
Future quantum processors intend to operate on millions of qubits and Silicon Metal Oxide Semiconductor (MOS) Quantum Dot qubits are a good fit for such a large-scale system due to their compactness in size and large coherence time. To control the operations of the qubits in such a large-scale system, efficient and careful design of the control circuits is very challenging. Here, in this thesis a control circuit is designed for silicon MOS quantum dot qubits operating on a node/ network architecture. Rather than using a 2D array of quantum dots, a node/ network architecture provides enough space for the wiring of integrated control circuits. The control circuit designed here is expected to work on millikelvin (mK) temperature and number of control lines from the mK temperature to 1-4 K temperature, where the digital control systems are operated, is reduced significantly compared to the number of qubits. The reduction in number of control lines from mK temperature is one of the basic requirements while scaling up. All these control circuits operate on the quantum dots based on the assumption that, all the dots are at same potential throughout the network. In practice due to fabrication variations and connection differences the potential of quantum dots varies from qubit to qubit. To solve this problem and pre-tune all the quantum dots to same potential prior to the operation of control circuit, a device level error correcting scheme is introduced and verified by simulation in this thesis.
Conveyor-mode shuttling in gated Si/SiGe devices enables adiabatic transfer of single electrons, electron patterns and spin qubits confined in quantum dots across several microns with a scalable number of signal lines. To realize their full potential, linear shuttle lanes must connect into a two-dimensional grid with controllable routing. We introduce a T-junction device linking two independently driven shuttle lanes. Electron routing across the junction requires no extra control lines beyond the four channels per conveyor belt. We measure an inter-lane charge transfer fidelity of F=100.0000000−9×10−7+0 %F = 100.0000000^{+0}_{-9\times 10^{-7}}\,\%F=100.0000000−9×10−7+0​% at an instantaneous electron velocity of 270 mm s−1270\,\mathrm{mm}\,\mathrm{s}^{-1}270mms−1. The filling of 54 quantum dots is controlled by simple atomic pulses, allowing us to swap electron patterns, laying the groundwork for a native spin-qubit SWAP gate. This T-junction establishes a path towards scalable, two-dimensional quantum computing architectures with flexible spin qubit routing for quantum error correction.