Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics Conference Series

Design and operation of distributed double-SQUID amplifier for RSFQ circuits

Komei Higuchi, Hiroshi Shimada, Yoshinao Mizugaki

Published Sep 1, 2019• 3 citations
Publisher

Abstract

Recently, many groups have been developing on-chip Rapid Single-Flux-Quantum (RSFQ) output amplifiers which are designed to connect RSFQ circuitry to room temperature electronics. One of such amplifiers is a distributed SQUID amplifier comprising SQUIDs embedded in cascaded RSFQ RS flip-flops. In this paper, we propose a distributed double-SQUID amplifier, where a SQUID is replaced with a double-SQUID. Test circuit was fabricated using a niobium integration technology. Measurements were performed in a liquid helium bath. We confirmed that the maximum output voltage swing of a 4-stage distributed double- SQUID amplifier was 2.93 mV, which was comparable with the corresponding numerical value of 3.54 mV.

DOI
10.1088/1742-6596/1293/1/012060

Related papers

Enhanced voltage swing of rapid-single-flux-quantum distributed output amplifier equipped with double-stack superconducting quantum interference devices

Yoshinao Mizugaki, Komei Higuchi, Hiroshi Shimada

We report the enhanced voltage swing of a rapid-single-flux-quantum (RSFQ) distributed amplifier by replacing a single superconducting quantum interference device (SQUID) with a double-stack-SQUID (DSS). A DSS is composed of two stacked 2-junction SQUIDs sharing one sensing inductor. Thanks to its stack structure, a DSS is expected to generate twofold output voltage. We have designed a 12-stage RSFQ distributed amplifier equipped with DSSs. The maximum output voltage swing reached 10.2 mV in simulation. Test chips were fabricated using a 25-µA/µm2 Nb integration process. In measurements, a test chip was cooled in a liquid helium bath. The experimental output voltage swing was up to 8.34 mV.

IEICE Electronics Express•Jan 1, 2019•1 citation

Single flux quantum quasi-digital voltage amplifier

V. K. Kaplunenko, V. P. Koshelets, M. Khabipov +2 more

The novel element of the rapid single flux quantum (RSFQ) logic family-the quasi digital voltage amplifier (QDVA)-which was recently proposed theoretically, has now been designed and experimentally investigated. The QDVA can be employed both as a logic element in digital circuits and as analogue voltage amplifier. The correct operation of the SFQ doubler has been demonstrated up to the output voltage 0.5 mV and with very large margins (up to 60%). The proposed QDVA can be integrated on the same chip with a SQUID sensor; it significantly simplifies the matching circuits and seems to be very attractive for the multichannel and digital SQUID systems.

Superconductor Science and Technology•Nov 1, 1991•10 citations

Rapid single-flux quantum control of the energy potential in a double SQUID qubit circuit

Maria Gabriella Castellano, F. Chiarello, Roberto Leoni +6 more

We report on the development and test of an integrated system composed of a flux qubit and a rapid single-flux quantum (RSFQ) circuit that allows qubit manipulation. The goal is to demonstrate the feasibility of control electronics integrated on the same chip as the qubit, in view of the application in quantum computation with superconducting devices. RSFQ logic relies on the storage and transmission of magnetic flux quanta and can be profitably used with superconducting qubits because of the speed, scalability, compatibility with the qubit fabrication process and low temperature environment. While standard RSFQ circuitry is well assessed, the application to quantum computing requires a complete rescaling of parameter values, in order to preserve the qubit coherence and reduce the power dissipation. In the system presented in this paper, the qubit role is played by a superconducting loop interrupted by a small dc SQUID, usually called a double SQUID, which behaves as a tunable rf-SQUID. Its energy potential has the shape of a double well, with the barrier between the wells controlled by magnetic flux applied to the inner dc SQUID. Here for the first time we report measurements at a base temperature of 370 mK in which flux control pulses with desired characteristics were supplied by a RSFQ circuit fabricated using non-standard parameters in the same chip as the qubit.

Superconductor Science and Technology•May 3, 2007•15 citations

Design and Operation of a Double-Flux-Quantum Amplifier Excluding Flux Bias Lines

Yoshinao Mizugaki, Tomoki Watanabe

In addition to their fast switching with low power dissipation, precise voltage generation is a unique feature of single-flux-quantum (SFQ) circuits. This feature is attractive for realizing ac voltage standards consisting of SFQ-based digital-to-analog converters (DACs). Among several key components in SFQ-based DACs, a double-flux-quantum amplifier (DFQA) is a potential candidate to amplify the output voltage. In this paper, we present a redesigned DFQA without flux bias lines. We found a parameter set that provided wide bias margins and zero-flux-bias operation. Improved bias regions were numerically demonstrated, whereas a ±20-fold DFQA excluding flux biases was fabricated using Nb integration technology and tested in a liquid helium bath.

IEEE Transactions on Applied Superconductivity•May 10, 2016•2 citations

Experimental analysis of a digital SQUID device at 4.2 K

Torsten Reich, Thomas Ortlepp, Friedrich Uhlmann +1 more

The application of superconducting rapid single-flux quantum (RSFQ) digital electronics for highly sensitive measurement of magnetic fields can provide significant advantages in the use of conventional analogue SQUIDs, especially in terms of operation speed and dynamic range. Furthermore, utilizing an unconventional generalized single-flux-quantum (SFQ) logic with a bidirectional operation principle allows an additional decrease in effort in superconducting electronics. Our novel fully digital SQUID based on the SFQ technique can be assumed to be operating at frequencies in the gigahertz range corresponding to slew rates of several 10^9 Φ0/s. We present first experimental results for the proper digital function as a preliminary stage for a digital SQUID magnetometer device. The measurements presented are performed for a reliable low temperature superconductor technology at liquid helium temperature; nevertheless the very low complexity of the superconducting digital circuitry holds promise as regards prospects for a working digital SQUID based on high temperature superconductor technology.

Superconductor Science and Technology•Jun 20, 2005•18 citations

Two-stage amplifier based on a double relaxation oscillation superconducting quantum interference device

M. Podt, Michiel J. van Duuren, A.W. Hamster +2 more

A low-noise single-chip two-stage superconducting quantum interference device (SQUID) system with a double relaxation oscillation SQUID as the second stage has been realized. The system was operated in a direct voltage readout mode, with a closed loop bandwidth up to 1 MHz. Operated at 4.2 K, the white flux noise measured in flux locked loop was 1.3 μΦ0/√Hz, corresponding to an energy sensitivity of ε≈27h. Owing to the large flux-to-voltage transfer of up to 3.6 mV/Φ0, the room-temperature preamplifier noise did not dominate the overall flux noise.

Applied Physics Letters•Oct 11, 1999•25 citations
Recently, many groups have been developing on-chip Rapid Single-Flux-Quantum (RSFQ) output amplifiers which are designed to connect RSFQ circuitry to room temperature electronics. One of such amplifiers is a distributed SQUID amplifier comprising SQUIDs embedded in cascaded RSFQ RS flip-flops. In this paper, we propose a distributed double-SQUID amplifier, where a SQUID is replaced with a double-SQUID. Test circuit was fabricated using a niobium integration technology. Measurements were performed in a liquid helium bath. We confirmed that the maximum output voltage swing of a 4-stage distributed double- SQUID amplifier was 2.93 mV, which was comparable with the corresponding numerical value of 3.54 mV.
We report the enhanced voltage swing of a rapid-single-flux-quantum (RSFQ) distributed amplifier by replacing a single superconducting quantum interference device (SQUID) with a double-stack-SQUID (DSS). A DSS is composed of two stacked 2-junction SQUIDs sharing one sensing inductor. Thanks to its stack structure, a DSS is expected to generate twofold output voltage. We have designed a 12-stage RSFQ distributed amplifier equipped with DSSs. The maximum output voltage swing reached 10.2 mV in simulation. Test chips were fabricated using a 25-µA/µm2 Nb integration process. In measurements, a test chip was cooled in a liquid helium bath. The experimental output voltage swing was up to 8.34 mV.
The novel element of the rapid single flux quantum (RSFQ) logic family-the quasi digital voltage amplifier (QDVA)-which was recently proposed theoretically, has now been designed and experimentally investigated. The QDVA can be employed both as a logic element in digital circuits and as analogue voltage amplifier. The correct operation of the SFQ doubler has been demonstrated up to the output voltage 0.5 mV and with very large margins (up to 60%). The proposed QDVA can be integrated on the same chip with a SQUID sensor; it significantly simplifies the matching circuits and seems to be very attractive for the multichannel and digital SQUID systems.
We report on the development and test of an integrated system composed of a flux qubit and a rapid single-flux quantum (RSFQ) circuit that allows qubit manipulation. The goal is to demonstrate the feasibility of control electronics integrated on the same chip as the qubit, in view of the application in quantum computation with superconducting devices. RSFQ logic relies on the storage and transmission of magnetic flux quanta and can be profitably used with superconducting qubits because of the speed, scalability, compatibility with the qubit fabrication process and low temperature environment. While standard RSFQ circuitry is well assessed, the application to quantum computing requires a complete rescaling of parameter values, in order to preserve the qubit coherence and reduce the power dissipation. In the system presented in this paper, the qubit role is played by a superconducting loop interrupted by a small dc SQUID, usually called a double SQUID, which behaves as a tunable rf-SQUID. Its energy potential has the shape of a double well, with the barrier between the wells controlled by magnetic flux applied to the inner dc SQUID. Here for the first time we report measurements at a base temperature of 370 mK in which flux control pulses with desired characteristics were supplied by a RSFQ circuit fabricated using non-standard parameters in the same chip as the qubit.
In addition to their fast switching with low power dissipation, precise voltage generation is a unique feature of single-flux-quantum (SFQ) circuits. This feature is attractive for realizing ac voltage standards consisting of SFQ-based digital-to-analog converters (DACs). Among several key components in SFQ-based DACs, a double-flux-quantum amplifier (DFQA) is a potential candidate to amplify the output voltage. In this paper, we present a redesigned DFQA without flux bias lines. We found a parameter set that provided wide bias margins and zero-flux-bias operation. Improved bias regions were numerically demonstrated, whereas a ±20-fold DFQA excluding flux biases was fabricated using Nb integration technology and tested in a liquid helium bath.
The application of superconducting rapid single-flux quantum (RSFQ) digital electronics for highly sensitive measurement of magnetic fields can provide significant advantages in the use of conventional analogue SQUIDs, especially in terms of operation speed and dynamic range. Furthermore, utilizing an unconventional generalized single-flux-quantum (SFQ) logic with a bidirectional operation principle allows an additional decrease in effort in superconducting electronics. Our novel fully digital SQUID based on the SFQ technique can be assumed to be operating at frequencies in the gigahertz range corresponding to slew rates of several 10^9 Φ0/s. We present first experimental results for the proper digital function as a preliminary stage for a digital SQUID magnetometer device. The measurements presented are performed for a reliable low temperature superconductor technology at liquid helium temperature; nevertheless the very low complexity of the superconducting digital circuitry holds promise as regards prospects for a working digital SQUID based on high temperature superconductor technology.
A low-noise single-chip two-stage superconducting quantum interference device (SQUID) system with a double relaxation oscillation SQUID as the second stage has been realized. The system was operated in a direct voltage readout mode, with a closed loop bandwidth up to 1 MHz. Operated at 4.2 K, the white flux noise measured in flux locked loop was 1.3 μΦ0/√Hz, corresponding to an energy sensitivity of ε≈27h. Owing to the large flux-to-voltage transfer of up to 3.6 mV/Φ0, the room-temperature preamplifier noise did not dominate the overall flux noise.