Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Digital Instrumentation for Phase-Coherent Frequency Transfer over 300 km Fiber Link

Andrea Cardenas-Olaya, Anna Tampellini, Elio K. Bertacco, Cecilia Clivati, Alberto Mura, Davide Calonico, Salvatore Micalizio, Claudio Eligio Calosso

Published Apr 1, 2019• 7 citations
Publisher

Abstract

This paper presents a digital instrumentation for coherent frequency transfer over fiber links. It detects the phase and the amplitude of the beat notes at the two ends and uses them for compensating the fiber phase noise and the polarization rotation. The system is implemented on the commercial platform Red-Pitaya, which integrates the Zynq System-on-Chip with fast Analog to Digital and Digital to Analog Converters, and provides great flexibility for on-site reconfiguration and remote operation. The system we propose can be used for Doppler and two-way compensations, both in open and closed loop. Additionally, it features a detection bandwidth of 10 MHz which is of particular importance for minimizing cycle slips in thousand kilometer links. The electronics exhibits residual frequency stability of the order of 10-18at 1 s exceeding 10-21at 10000 s. We verified the system performance on a 300 km loop link for the two-way scheme.

DOI
10.1109/fcs.2019.8856059

Related papers

Performance of digital servos in an optical frequency transfer network

Liang Hu, Ruimin Xue, Guiling Wu +1 more

We demonstrate the use of three kinds of flexible digital servos for the stabilization of the optical fiber link, the interferometer temperature, and the polarization of the transmitted light at the remote site, respectively. The main fiber noise cancellation digital servo provides a large phase detection range (∼210π radians), automatic relock function, and low cycle-slip rate over a 62 km field-deployed fiber link achieved by utilizing a feedback optical actuator of an acousto-optic modulator fed by a voltage-controlled oscillator. The temperature control and polarization control digital servos enable that the temperature of the interferometer can be stabilized at a stability of 0.01 K and the data uptime is enhanced from 85.5% to 99.9% by implementing the polarization controller. The results demonstrate that the performance of the three digital servos is sufficient for high-precision optical frequency transfer applications and indicates comparable performance to existing analog optical frequency control systems. The full digital controlled optical frequency transfer method demonstrated here provides guidance for the development of a low-cost, low-complexity, and high-reliability optical frequency transfer system.

Review of Scientific Instruments•May 1, 2021•10 citations

Coherent optical frequency transfer via 972-km fiber link

Xue 雪 Deng 邓, Xiang 翔 Zhang 张, Qi 琦 Zang 臧 +8 more

We demonstrate coherent optical frequency dissemination over a distance of 972 km by cascading two spans where the phase noise is passively compensated for. Instead of employing a phase discriminator and a phase locking loop in the conventional active phase control scheme, the passive phase noise cancellation is realized by feeding double-trip beat-note frequency to the driver of the acoustic optical modulator at the local site. This passive scheme exhibits fine robustness and reliability, making it suitable for long-distance and noisy fiber links. An optical regeneration station is used in the link for signal amplification and cascaded transmission. The phase noise cancellation and transfer instability of the 972-km link is investigated, and transfer instability of 1.1 × 10−19 at 104 s is achieved. This work provides a promising method for realizing optical frequency distribution over thousands of kilometers by using fiber links.

Chinese Physics B•Oct 24, 2023•8 citations

Coherent Optical Frequency Transfer via a 490 km Noisy Fiber Link

Xiang Zhang, Xue Deng, Qi Zang +9 more

We demonstrate the coherent transfer of an ultrastable optical frequency reference over a 490 km noisy field fiber link. The fiber-induced phase noise power spectrum density per-unit-length at 1 Hz offset frequency can reach up to 510 rad2⋅Hz−1⋅km−1, which is much higher than the fiber noise observed in previous reports. This extreme level of phase noise is mainly due to the fiber link laying underground along the highway. Appropriate phase-locked loop parameters are chosen to complete the active compensation of fiber noise by measuring the intensity fluctuation of additional phase noise and designing a homemade digital frequency division phase discriminator with a large phase detection range of 212 π rad. Finally, a noise suppression intensity of approximately 40 dB at 1 Hz is obtained, with fractional frequency instability of 1.1 × 10−14 at 1 s averaging time, and 3.7 × 10−19 at 10000 s. The transfer system will be used for remote atomic clock comparisons and optical frequency distribution over a long-distance communication network established in China.

Chinese Physics Letters•Mar 25, 2022•14 citations

Coherent Optical Frequency Transfer over 100 km Fiber Link Using Bidirectional Active Optics

Hanxu Wu, Xiaoming Zhang, Weinan Zhao +7 more

SummaryPrecise and stable coherent optical frequency transfer over long-haul fiber link is required by diverse scientific applications, such as large-scale optical clock networks, global positioning and timing, very-long baseline interferometry, and high-sensitivity tests of fundamental physics. To meet the needs of the above applications, active compensation schemes for cancelling fiber-induced phase noise has developed considerably over the past ten years. However, optical signal severely reduces across distant fiber-optic networks, which degrades optical beat signal and feedback control.Here, we adopt active phase compensation and bidirectional optical frequency locking to achieve ultra-stable optical carrier transfer. The phase noise of the fiber link is effectively suppressed, meanwhile, the ultra-stable optical frequency signal is regenerated accurately at the remote site.Preliminary experiment over 100 km fiber link indicates that the additional frequency stability exhibits 1.9×10-16and 2.5×10-17at an averaging time of 1 s and 100 s, respectively. This approach has a capacity of extending to the parallel transfer of microwave and optical frequency, and free-space optical frequency transfer.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 15, 2023•0 citations

Optical frequency transfer link with remote site compensation

Qi Zang, Xiang Zhang, Xue Deng +9 more

In this paper, we present a remote time-base-free technique for a coherent optical frequency transfer system via fiber.At the remote site, the thermal noise of the optical components is corrected along with the link phase noise caused by environmental effects.In this system, a 1 × 2 acousto-optic modulator (AOM) is applied at the remote site, with the first light being used to eliminate the noise of the remote time base and interface with remote users while the zeroth light is used to establish an active noise canceling loop.With this technique, a 10 MHz commercial oscillator, used as a time base at the remote site, does not contribute to the noise of the transferred signal.An experimental system is constructed using a 150 km fiber spool to validate the proposed technique.After compensation, the overlapping Allan deviation of the transfer link is 7.42 × 10 -15 at 1 s integration time and scales down to 1.07 × 10 -18 at 10,000 s integration time.The uncertainty of the transmitted optical frequency is on the order of a few 10 -19 .This significantly reduces the time-base requirements and costs for multi-user applications without compromising transfer accuracy.Meanwhile, these results show great potential for transferring ultra-stable optical frequency signals to remote sites, especially for point-to-multi-users.

Chinese Optics Letters•Jan 1, 2024•2 citations

Digital implementation of a two-way coherent phase transfer over optical fiber for remote clocks comparisons

Claudio Eligio Calosso, Elio K. Bertacco, Davide Calonico +7 more

We performed a two-way remote optical phase comparison on optical fiber. Two optical frequency signals were launched in opposite directions in an optical fiber and their phases were simultaneously measured at the other end. In this technique, the fiber noise is passively cancelled, and we compared two optical frequencies at the ultimate 10−21 stability level. The experiment was performed on a 47km fiber that is part of the metropolitan network for Internet traffic. The technique relies on the synchronous measurement of the optical phases at the two ends of the link, that is here performed by digital electronics. This scheme offers some advantages with respect to active noise cancellation schemes, as the light travels only once in the fiber.

European Frequency and Time Forum•Jun 1, 2014•0 citations
This paper presents a digital instrumentation for coherent frequency transfer over fiber links. It detects the phase and the amplitude of the beat notes at the two ends and uses them for compensating the fiber phase noise and the polarization rotation. The system is implemented on the commercial platform Red-Pitaya, which integrates the Zynq System-on-Chip with fast Analog to Digital and Digital to Analog Converters, and provides great flexibility for on-site reconfiguration and remote operation. The system we propose can be used for Doppler and two-way compensations, both in open and closed loop. Additionally, it features a detection bandwidth of 10 MHz which is of particular importance for minimizing cycle slips in thousand kilometer links. The electronics exhibits residual frequency stability of the order of 10-18at 1 s exceeding 10-21at 10000 s. We verified the system performance on a 300 km loop link for the two-way scheme.
We demonstrate the use of three kinds of flexible digital servos for the stabilization of the optical fiber link, the interferometer temperature, and the polarization of the transmitted light at the remote site, respectively. The main fiber noise cancellation digital servo provides a large phase detection range (∼210π radians), automatic relock function, and low cycle-slip rate over a 62 km field-deployed fiber link achieved by utilizing a feedback optical actuator of an acousto-optic modulator fed by a voltage-controlled oscillator. The temperature control and polarization control digital servos enable that the temperature of the interferometer can be stabilized at a stability of 0.01 K and the data uptime is enhanced from 85.5% to 99.9% by implementing the polarization controller. The results demonstrate that the performance of the three digital servos is sufficient for high-precision optical frequency transfer applications and indicates comparable performance to existing analog optical frequency control systems. The full digital controlled optical frequency transfer method demonstrated here provides guidance for the development of a low-cost, low-complexity, and high-reliability optical frequency transfer system.
We demonstrate coherent optical frequency dissemination over a distance of 972 km by cascading two spans where the phase noise is passively compensated for. Instead of employing a phase discriminator and a phase locking loop in the conventional active phase control scheme, the passive phase noise cancellation is realized by feeding double-trip beat-note frequency to the driver of the acoustic optical modulator at the local site. This passive scheme exhibits fine robustness and reliability, making it suitable for long-distance and noisy fiber links. An optical regeneration station is used in the link for signal amplification and cascaded transmission. The phase noise cancellation and transfer instability of the 972-km link is investigated, and transfer instability of 1.1 × 10−19 at 104 s is achieved. This work provides a promising method for realizing optical frequency distribution over thousands of kilometers by using fiber links.
We demonstrate the coherent transfer of an ultrastable optical frequency reference over a 490 km noisy field fiber link. The fiber-induced phase noise power spectrum density per-unit-length at 1 Hz offset frequency can reach up to 510 rad2⋅Hz−1⋅km−1, which is much higher than the fiber noise observed in previous reports. This extreme level of phase noise is mainly due to the fiber link laying underground along the highway. Appropriate phase-locked loop parameters are chosen to complete the active compensation of fiber noise by measuring the intensity fluctuation of additional phase noise and designing a homemade digital frequency division phase discriminator with a large phase detection range of 212 π rad. Finally, a noise suppression intensity of approximately 40 dB at 1 Hz is obtained, with fractional frequency instability of 1.1 × 10−14 at 1 s averaging time, and 3.7 × 10−19 at 10000 s. The transfer system will be used for remote atomic clock comparisons and optical frequency distribution over a long-distance communication network established in China.
SummaryPrecise and stable coherent optical frequency transfer over long-haul fiber link is required by diverse scientific applications, such as large-scale optical clock networks, global positioning and timing, very-long baseline interferometry, and high-sensitivity tests of fundamental physics. To meet the needs of the above applications, active compensation schemes for cancelling fiber-induced phase noise has developed considerably over the past ten years. However, optical signal severely reduces across distant fiber-optic networks, which degrades optical beat signal and feedback control.Here, we adopt active phase compensation and bidirectional optical frequency locking to achieve ultra-stable optical carrier transfer. The phase noise of the fiber link is effectively suppressed, meanwhile, the ultra-stable optical frequency signal is regenerated accurately at the remote site.Preliminary experiment over 100 km fiber link indicates that the additional frequency stability exhibits 1.9×10-16and 2.5×10-17at an averaging time of 1 s and 100 s, respectively. This approach has a capacity of extending to the parallel transfer of microwave and optical frequency, and free-space optical frequency transfer.
In this paper, we present a remote time-base-free technique for a coherent optical frequency transfer system via fiber.At the remote site, the thermal noise of the optical components is corrected along with the link phase noise caused by environmental effects.In this system, a 1 × 2 acousto-optic modulator (AOM) is applied at the remote site, with the first light being used to eliminate the noise of the remote time base and interface with remote users while the zeroth light is used to establish an active noise canceling loop.With this technique, a 10 MHz commercial oscillator, used as a time base at the remote site, does not contribute to the noise of the transferred signal.An experimental system is constructed using a 150 km fiber spool to validate the proposed technique.After compensation, the overlapping Allan deviation of the transfer link is 7.42 × 10 -15 at 1 s integration time and scales down to 1.07 × 10 -18 at 10,000 s integration time.The uncertainty of the transmitted optical frequency is on the order of a few 10 -19 .This significantly reduces the time-base requirements and costs for multi-user applications without compromising transfer accuracy.Meanwhile, these results show great potential for transferring ultra-stable optical frequency signals to remote sites, especially for point-to-multi-users.
We performed a two-way remote optical phase comparison on optical fiber. Two optical frequency signals were launched in opposite directions in an optical fiber and their phases were simultaneously measured at the other end. In this technique, the fiber noise is passively cancelled, and we compared two optical frequencies at the ultimate 10−21 stability level. The experiment was performed on a 47km fiber that is part of the metropolitan network for Internet traffic. The technique relies on the synchronous measurement of the optical phases at the two ends of the link, that is here performed by digital electronics. This scheme offers some advantages with respect to active noise cancellation schemes, as the light travels only once in the fiber.