Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Optimizing the stoichiometry of ultrathin NbTiN films for high-performance superconducting nanowire single-photon detectors

Julien Zichi, Jin Chang, Stephan Steinhauer, Kristina von Fieandt, Johannes W. N. Los, Gijs Visser, Nima Kalhor, Thomas Lettner, Ali W. Elshaari, Iman Esmaeil Zadeh, Val Zwiller

Published Sep 9, 2019• 59 citations
Publisher

Abstract

N superconducting films and show that a Nb fraction of x = 0.62 allows for the fabrication of detectors from films as thick as 9 nm and covering an active area of 20 µm, with a wide detection saturation plateau at telecom wavelengths and in particular at 1550 nm. This is a signature of an internal detection efficiency saturation, achieved while maintaining the high time resolution associated with NbTiN and operation at 2.5K. With our optimized recipe, we reliably fabricated detectors with high critical current densities reaching a saturation plateau at 1550 nm with 80% system detection efficiency and with a FWHM timing jitter as low as 19.5 ps.

DOI
10.1364/oe.27.026579

Related papers

Nb$_x$Ti$_{1-x}$N low timing jitter single-photon detectors with unity internal efficiency at 1550 nm and 2.5 K

Julien Zichi, Jin Chang, Stephan Steinhauer +8 more

The requirements in quantum optics experiments for high single photon detection efficiency, low timing jitter, low dark count rate and short dead time have been fulfilled with the development of superconducting nanowire single photon detectors. Although they offer a detection efficiency above 90%, achieving a high time resolution in devices made of amorphous materials is a challenge, particularly at temperatures above 0.8 K. Devices made from niobium nitride and niobium titanium nitride allow to reach the best timing jitter, but in turn have stronger requirements in terms of film quality to achieve a high efficiency. Here we take advantage of the flexibility of reactive co-sputter deposition to tailor the composition of NbxTi1-xN superconducting films, and show that a Nb fraction of x = 0.62 allows for the fabrication of detectors from films as thick as 9 nm and covering an active area of 20 μm, with a wide detection saturation plateau at telecom wavelengths and in particular at 1550 nm. This is a signature of an internal detection efficiency saturation, achieved while maintaining the high time resolution associated with NbTiN and operation at 2.5K. With our optimized recipe, we reliably fabricated detectors with high critical current densities reaching a saturation plateau at 1550 nm with 80% system detection efficiency, and with a FWHM timing jitter as low as 19.47 ps.

arXiv:1905.06091•May 15, 2019•1 citation

Enhanced Superconducting Nanowire Single Photon Detector Performances using Silicon Capping

C. Klein, S. Cohen, T. Descamps +6 more

Niobium Titanium nitride (NbTiN) based superconducting nanowire single photon detectors (SNSPDs) are known for their high performance across a wide spectral range, from the X-ray to the mid-infrared. Nonetheless, fabrication challenges and performance degradation attributable to surface oxidation and lack of uniformity in films thinner than 5 nm remain a significant barrier for achieving high-quality detectors. In this work, we study the influence of a Silicon capping layer on film properties and on the performance of SNSPDs. A Silicon capping layer effectively suppresses oxidation and increases the superconducting transition temperature. This enables superconductivity in films as thin as 3 nm at 3 K, increases critical current in patterned nanowires and significantly extends the saturation plateau from the visible to the near infrared (up to 2050 nm): These detectors maintain sub-50 ps timing jitter, even for nanowires as wide as 250 nm and with detection areas of 20x20μm2. Our results establish that thinner films protected by a capping layer allow for the fabrication of wider wires, decreasing nanofabrication challenges and extending the operating temperature range for efficient single photon detection.

quant-pharXiv:2602.15948•Applied Physics Letters•Feb 19, 2026•1 citation

Superconducting nanowire single photon detectors based on NbRe nitride ultrathin films

Francesco Avitabile, Francesco Colangelo, M. Yu. Mikhaĭlov +5 more

The influence of the reactive DC sputtering parameters on the superconducting properties of NbReN ultrathin films was investigated. A detailed study of the current–voltage characteristics of the plasma was performed to optimize the superconducting critical temperature, Tc. The thickness dependence of Tc for the films deposited under different conditions was analyzed down to the ultrathin limit. Optimized films were used to fabricate superconducting nanowire single photon detectors which, at T=3.5 K, show saturated internal detection efficiency (IDE) up to a wavelength of 1301 nm and 95% IDE at 1548 nm with recovery times and timing jitter of about 8 ns and 28 ps, respectively.

arXiv:2510.05910•Applied Physics Letters•Oct 23, 2025•5 citations

Disorder enhanced relative intrinsic detection efficiency in NbTiN superconducting nanowire single photon detectors at high temperature

Ruoyan Ma, Qingchang Huan, Jia Huang +9 more

The intrinsic detection performance of superconducting nanowire single photon detectors (SNSPDs) is highly dependent on the superconducting properties of underlying thin films. This report outlines the enhancement of detection performance for single telecom wavelength photons in disordered NbTiN SNSPD at 4.2 K. By increasing the nitrogen content and deposition pressure, the NbTiN films show suppression in critical temperature and an increase in sheet resistance. Notably, the resulting SNSPDs display a broader saturation plateau at 2.2 K, leading to superior detection performance at 4.2 K. With the disordered 7-nm-thick NbTiN films, we fabricated SNSPDs with system detection efficiency up to 83% for 1550 nm photons at 4.2 K. Moreover, these devices also show saturated intrinsic detection efficiency for 2000 nm photons. With the features outlined, the devices can be integrated into the idle 4.2 K stage of the dilution refrigerator for applications in optical quantum information processing or utilize for detecting laser radar signals in airborne platforms.

Applied Physics Letters•Feb 12, 2024•14 citations

Single photon detection performance of highly disordered NbTiN thin films

Ruoyan Ma, Rui Shu, Xingyu Zhang +9 more

Abstract We experimentally investigated the detection performance of highly disordered Nb x Ti 1 − x N based superconducting nanowire single photon detectors (SNSPDs). The dependence on the composition of the transition temperature T c for Nb x Ti 1 − x N films show a dome-like behavior on the Nb content, with a maximal T c at x Nb ∼ 0.65 , and the Nb 0.65 Ti 0.35 N films also combine relatively large sheet resistance and intermediate residual resistivity ratio. Moreover, 60-nm-wide and 7-nm-thick Nb 0.65 Ti 0.35 N nanowires show a switching current as high as 14.5 μ A, and saturated intrinsic detection efficiency with a plateau of more than 2 μ A at 2.4 K. Finally, the corresponding SNSPDs on an alternative SiO 2 /Ta 2 O 5 dielectric mirror showed a system detection efficiency of approximately 92% for 1550 nm photons, and the timing jitter is around 26 ps. Our results demonstrate that the highly disordered Nb x Ti 1 − x N

arXiv:2210.15215•Journal of Physics Communications•May 1, 2023•15 citations

Fabrication Process Yielding Saturated Nanowire Single-Photon Detectors With 24-ps Jitter

Faraz Najafi, Andrew E. Dane, Francesco Bellei +4 more

We present an optimized fabrication process for superconducting nanowire single-photon detectors that allowed us to obtain a yield of ~70% for detectors based on 80-nm-wide niobium nitride nanowires. We fabricated detectors that showed 24-ps timing jitter and saturated detection efficiency without the need for cryogenic amplifiers, allowing for operation in a low-bias low-dark-count-rate regime while operating at maximum detection efficiency.

IEEE Journal of Selected Topics in Quantum Electronics•Dec 12, 2014•39 citations
N superconducting films and show that a Nb fraction of x = 0.62 allows for the fabrication of detectors from films as thick as 9 nm and covering an active area of 20 µm, with a wide detection saturation plateau at telecom wavelengths and in particular at 1550 nm. This is a signature of an internal detection efficiency saturation, achieved while maintaining the high time resolution associated with NbTiN and operation at 2.5K. With our optimized recipe, we reliably fabricated detectors with high critical current densities reaching a saturation plateau at 1550 nm with 80% system detection efficiency and with a FWHM timing jitter as low as 19.5 ps.
Nbx_xx​Ti1−x_{1-x}1−x​N low timing jitter single-photon detectors with unity internal efficiency at 1550 nm and 2.5 K
The requirements in quantum optics experiments for high single photon detection efficiency, low timing jitter, low dark count rate and short dead time have been fulfilled with the development of superconducting nanowire single photon detectors. Although they offer a detection efficiency above 90%, achieving a high time resolution in devices made of amorphous materials is a challenge, particularly at temperatures above 0.8 K. Devices made from niobium nitride and niobium titanium nitride allow to reach the best timing jitter, but in turn have stronger requirements in terms of film quality to achieve a high efficiency. Here we take advantage of the flexibility of reactive co-sputter deposition to tailor the composition of NbxTi1-xN superconducting films, and show that a Nb fraction of x = 0.62 allows for the fabrication of detectors from films as thick as 9 nm and covering an active area of 20 μm, with a wide detection saturation plateau at telecom wavelengths and in particular at 1550 nm. This is a signature of an internal detection efficiency saturation, achieved while maintaining the high time resolution associated with NbTiN and operation at 2.5K. With our optimized recipe, we reliably fabricated detectors with high critical current densities reaching a saturation plateau at 1550 nm with 80% system detection efficiency, and with a FWHM timing jitter as low as 19.47 ps.
Niobium Titanium nitride (NbTiN) based superconducting nanowire single photon detectors (SNSPDs) are known for their high performance across a wide spectral range, from the X-ray to the mid-infrared. Nonetheless, fabrication challenges and performance degradation attributable to surface oxidation and lack of uniformity in films thinner than 5 nm remain a significant barrier for achieving high-quality detectors. In this work, we study the influence of a Silicon capping layer on film properties and on the performance of SNSPDs. A Silicon capping layer effectively suppresses oxidation and increases the superconducting transition temperature. This enables superconductivity in films as thin as 3 nm at 3 K, increases critical current in patterned nanowires and significantly extends the saturation plateau from the visible to the near infrared (up to 2050 nm): These detectors maintain sub-50 ps timing jitter, even for nanowires as wide as 250 nm and with detection areas of 20x20μm2. Our results establish that thinner films protected by a capping layer allow for the fabrication of wider wires, decreasing nanofabrication challenges and extending the operating temperature range for efficient single photon detection.
The influence of the reactive DC sputtering parameters on the superconducting properties of NbReN ultrathin films was investigated. A detailed study of the current–voltage characteristics of the plasma was performed to optimize the superconducting critical temperature, Tc. The thickness dependence of Tc for the films deposited under different conditions was analyzed down to the ultrathin limit. Optimized films were used to fabricate superconducting nanowire single photon detectors which, at T=3.5 K, show saturated internal detection efficiency (IDE) up to a wavelength of 1301 nm and 95% IDE at 1548 nm with recovery times and timing jitter of about 8 ns and 28 ps, respectively.
The intrinsic detection performance of superconducting nanowire single photon detectors (SNSPDs) is highly dependent on the superconducting properties of underlying thin films. This report outlines the enhancement of detection performance for single telecom wavelength photons in disordered NbTiN SNSPD at 4.2 K. By increasing the nitrogen content and deposition pressure, the NbTiN films show suppression in critical temperature and an increase in sheet resistance. Notably, the resulting SNSPDs display a broader saturation plateau at 2.2 K, leading to superior detection performance at 4.2 K. With the disordered 7-nm-thick NbTiN films, we fabricated SNSPDs with system detection efficiency up to 83% for 1550 nm photons at 4.2 K. Moreover, these devices also show saturated intrinsic detection efficiency for 2000 nm photons. With the features outlined, the devices can be integrated into the idle 4.2 K stage of the dilution refrigerator for applications in optical quantum information processing or utilize for detecting laser radar signals in airborne platforms.
Abstract We experimentally investigated the detection performance of highly disordered Nb x Ti 1 − x N based superconducting nanowire single photon detectors (SNSPDs). The dependence on the composition of the transition temperature T c for Nb x Ti 1 − x N films show a dome-like behavior on the Nb content, with a maximal T c at x Nb ∼ 0.65 , and the Nb 0.65 Ti 0.35 N films also combine relatively large sheet resistance and intermediate residual resistivity ratio. Moreover, 60-nm-wide and 7-nm-thick Nb 0.65 Ti 0.35 N nanowires show a switching current as high as 14.5 μ A, and saturated intrinsic detection efficiency with a plateau of more than 2 μ A at 2.4 K. Finally, the corresponding SNSPDs on an alternative SiO 2 /Ta 2 O 5 dielectric mirror showed a system detection efficiency of approximately 92% for 1550 nm photons, and the timing jitter is around 26 ps. Our results demonstrate that the highly disordered Nb x Ti 1 − x N