Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Terahertz Science and Technology

Simulating the Behavior of a 230-GHz SIS Mixer Using Multitone Spectral Domain Analysis

John Garrett, Boon-Kok Tan, Faouzi M. Boussaha, Christine Chaumont, G. Yassin

Published Sep 2, 2019• 2 citations
Publisher

Abstract

We present a new software package, called QMix, for simulating the behavior of superconductor/insulator/ superconductor (SIS) mixers. The software uses a harmonic balance procedure to calculate the ac voltage across the SIS junction and multitone spectral domain analysis to calculate the quasiparticle tunneling currents. This approach has two major advantages over other simulation techniques: 1) it can include an arbitrary number of higher order harmonics, and 2) it can simulate the effect of multiple strong nonharmonic frequencies. This allows the QMix software to simulate a wide range of SIS mixer operation, including the effects of harmonics in the local-oscillator (LO) signal and gain saturation with respect to the RF signal power. In this article, we compare the simulated results from QMix to the measured performance of a 230-GHz SIS device, both to validate the software and to investigate the experimental data. To begin, we simulated the conversion gain of the mixer and we found excellent agreement with the experimental results. We were also able to recreate the broken photon step effect by adding higher and lower order harmonics to the LO signal. We then simulated a range of incident RF signal powers in order to calculate the gain saturation point. This is an important metric for SIS mixers because we require linear gain for reliable measurements and calibration. In the simulated results, we found both gain compression and gain expansion, which is consistent with other studies. Overall, these examples demonstrate that QMix is a powerful software package that will allow researchers to simulate the performance of SIS mixers, investigate experimental results, and optimize mixer operation. We have made all of the QMix software open-source and we invite others to contribute to the project.

DOI
10.1109/tthz.2019.2938993

Related papers

Simulation of the superconducting quasiparticle mixer using a five-port model

Edward Tong, R. Blundell

A harmonic Newton technique has successfully been used in the simulation of superconducting quasiparticle mixers in a five-port model. The steady-state large-signal waveform impressed across the tunnel junction by the incident local oscillator (LO) power is computed in the frequency domain. The three-frequency approximation provides the initial trial solution, which, together with the superlinear convergence property of Newton's method, ensures rapid convergence. A wide range of simulations based on the response function of a real superconductor-insulator-superconductor (SIS) junction is presented. The case of an SIS harmonic mixer (n=2) is also studied. Using a five-port model, the simulation explicitly takes the effect of the first harmonic into account. The algorithm and the principal results obtained for a hypothetical mixer incorporating the measured current-voltage characteristics of a real (SIS) junction are presented. The first results indicate that harmonic quasiparticle mixing may be very attractive in the submillimeter-wave band.>

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1990•15 citations

Theoretical and numerical analysis of very high harmonic superconducting tunnel junction mixers

Phichet Kittara, S. Withington, G. Yassin

We describe a procedure for modeling the nonlinear, quantum-mechanical behavior of very high harmonic superconductor-insulator-superconductor (SIS) mixers. A typical mixer is pumped by a strong microwave source at 10–15GHz, which causes high-harmonic (20–40) currents to flow, any one of which can be used as a local oscillator to downconvert a submillimeter-wave signal to a low microwave frequency, 1–8GHz. This mode of operation is attractive for measuring the beam patterns of conventional SIS mixers, because only a single submillimeter-wave source is needed. We conducted simulations using the 20th harmonic of a 13.5GHz microwave source, downconverting a 271.4GHz signal to a 1.4GHz intermediate frequency. These simulations clearly show that linear downconversion can be achieved even for relatively high levels of rf signal power; although, care is needed when choosing the operating point. The patterns of behavior seen in the simulations are in remarkable agreement with recently published experimental results.

Journal of Applied Physics•Jan 15, 2007•14 citations

Spectral-domain analysis of harmonic effects in superconducting quasiparticle mixers

S. Withington, E. Kollberg

An algorithm was developed for calculating the harmonic performance of superconducting quasiparticle millimeter-wave mixers. The scheme uses harmonic balance to determine the steady-state waveform of the large-amplitude voltage which is induced across the tunnel junction by the local oscillator source. A key feature of the algorithm is that the large-signal tunneling-current calculations are done in the frequency domain rather than in the time domain, and this approach leads to numerically efficient computer simulations. The superiority of the spectral-domain method is particularly pronounced when modeling mixers that incorporate high-quality tunnel junctions with very sharp DC nonlinearities. A simplified mixer simulation was performed to determine the range of omega CR products for which harmonic effects are likely to be important.>

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1989•33 citations

Multitone quantum simulations of saturating tunnel junction mixers

S. Withington, Phichet Kittara, G. Yassin

When designing instruments for submillimeter-wave astronomy it is important to understand precisely how saturating superconducting tunnel-junction mixers behave. In this article, a procedure is described for calculating the behavior of tunnel-junction circuits when multitone high-level signals are applied. The procedure is based on a full quantum-mechanical description of photon-assisted tunneling, and uses Harmonic Newton to search for a set of voltages and currents that satisfy the circuit equations at every frequency present. A number of illustrative simulations are presented, and it is shown that Harmonic Newton can be used to model saturating superconductor–insulator–superconductor mixers in a robust and numerically efficient manner.

Journal of Applied Physics•Jun 6, 2003•15 citations

Non-linear two-frequency analysis of SIS mixers through harmonic balance

S. Withington, Phichet Kittara, G. Yassin

\nWe present a numerical procedure for simulating the non-linear behaviour of Superconductor-InsulatorSuperconductor (SIS) tunnel junction mixers. Mixers of this kind are used extensively in high-performance submillimetre-wave astronomical receivers. The procedure is complete in that both the signal and local-oscillator voltages can be at high levels, with significant amounts of harmonic content; also, the full quantum mechanical behaviour of the tunnel junction is taken into account. The initial simulations show that multi-tone analysis can be carried out in a numerically efficient manner, and that saturation, and the attendant generation of IF harmonics, can be modelled rigorously. This work constitutes the first full non-linear model of an SIS mixer, and the theoretical and numerical procedures described, will be of great importance when designing the next generation of heterodyne astronomical receivers.\n

Journal de Physique IV (Proceedings)•May 1, 2002•1 citation

SIS Mixer Research

A. W. Lichtenberger, M.J. Feldman

Theoretica and experimental research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of an SIS mixer using a slightly nonideal junction, with finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing. The resulting equations have a particularly simple form. The minimum noise temperature is controlled by the leakage current of the junction. Even the most nearly ideal junctions made today require a considerable LO for best sensitivity; nevertheless, even a comparatively large leakage current allows mixer noise to be only a small factor above the quantum limit. The saturation properties of SIS mixers subjected to broad-band thermal noise obey the equations derived for monochromatic saturating signals. The Josephson junction tuning inductor was analyzed with the conclusion that such a device is not feasible with present fabrication techniques. Computer calculations using synthetic SIS junction I-V characteristics predicted the performance of an optimized receiver over its entire operating frequency range. Many aspects of the operation of SIS mixers were clarified and unexpected new phenomena were predicted. A 'photon picture' interpretation of the quantum theory of mixing is in the early stages ofmore » development. Niobium nitride edge junctions with excellent current-voltage characteristics were fabricated using novel barrier formation processes. The role of surface damage in the quality of NbN edge junction electrical characteristics was investigated and unexpected results were obtained.« less

Final Technical Report•Nov 1, 1990•0 citations
We present a new software package, called QMix, for simulating the behavior of superconductor/insulator/ superconductor (SIS) mixers. The software uses a harmonic balance procedure to calculate the ac voltage across the SIS junction and multitone spectral domain analysis to calculate the quasiparticle tunneling currents. This approach has two major advantages over other simulation techniques: 1) it can include an arbitrary number of higher order harmonics, and 2) it can simulate the effect of multiple strong nonharmonic frequencies. This allows the QMix software to simulate a wide range of SIS mixer operation, including the effects of harmonics in the local-oscillator (LO) signal and gain saturation with respect to the RF signal power. In this article, we compare the simulated results from QMix to the measured performance of a 230-GHz SIS device, both to validate the software and to investigate the experimental data. To begin, we simulated the conversion gain of the mixer and we found excellent agreement with the experimental results. We were also able to recreate the broken photon step effect by adding higher and lower order harmonics to the LO signal. We then simulated a range of incident RF signal powers in order to calculate the gain saturation point. This is an important metric for SIS mixers because we require linear gain for reliable measurements and calibration. In the simulated results, we found both gain compression and gain expansion, which is consistent with other studies. Overall, these examples demonstrate that QMix is a powerful software package that will allow researchers to simulate the performance of SIS mixers, investigate experimental results, and optimize mixer operation. We have made all of the QMix software open-source and we invite others to contribute to the project.
A harmonic Newton technique has successfully been used in the simulation of superconducting quasiparticle mixers in a five-port model. The steady-state large-signal waveform impressed across the tunnel junction by the incident local oscillator (LO) power is computed in the frequency domain. The three-frequency approximation provides the initial trial solution, which, together with the superlinear convergence property of Newton's method, ensures rapid convergence. A wide range of simulations based on the response function of a real superconductor-insulator-superconductor (SIS) junction is presented. The case of an SIS harmonic mixer (n=2) is also studied. Using a five-port model, the simulation explicitly takes the effect of the first harmonic into account. The algorithm and the principal results obtained for a hypothetical mixer incorporating the measured current-voltage characteristics of a real (SIS) junction are presented. The first results indicate that harmonic quasiparticle mixing may be very attractive in the submillimeter-wave band.>
We describe a procedure for modeling the nonlinear, quantum-mechanical behavior of very high harmonic superconductor-insulator-superconductor (SIS) mixers. A typical mixer is pumped by a strong microwave source at 10–15GHz, which causes high-harmonic (20–40) currents to flow, any one of which can be used as a local oscillator to downconvert a submillimeter-wave signal to a low microwave frequency, 1–8GHz. This mode of operation is attractive for measuring the beam patterns of conventional SIS mixers, because only a single submillimeter-wave source is needed. We conducted simulations using the 20th harmonic of a 13.5GHz microwave source, downconverting a 271.4GHz signal to a 1.4GHz intermediate frequency. These simulations clearly show that linear downconversion can be achieved even for relatively high levels of rf signal power; although, care is needed when choosing the operating point. The patterns of behavior seen in the simulations are in remarkable agreement with recently published experimental results.
An algorithm was developed for calculating the harmonic performance of superconducting quasiparticle millimeter-wave mixers. The scheme uses harmonic balance to determine the steady-state waveform of the large-amplitude voltage which is induced across the tunnel junction by the local oscillator source. A key feature of the algorithm is that the large-signal tunneling-current calculations are done in the frequency domain rather than in the time domain, and this approach leads to numerically efficient computer simulations. The superiority of the spectral-domain method is particularly pronounced when modeling mixers that incorporate high-quality tunnel junctions with very sharp DC nonlinearities. A simplified mixer simulation was performed to determine the range of omega CR products for which harmonic effects are likely to be important.>
When designing instruments for submillimeter-wave astronomy it is important to understand precisely how saturating superconducting tunnel-junction mixers behave. In this article, a procedure is described for calculating the behavior of tunnel-junction circuits when multitone high-level signals are applied. The procedure is based on a full quantum-mechanical description of photon-assisted tunneling, and uses Harmonic Newton to search for a set of voltages and currents that satisfy the circuit equations at every frequency present. A number of illustrative simulations are presented, and it is shown that Harmonic Newton can be used to model saturating superconductor–insulator–superconductor mixers in a robust and numerically efficient manner.
\nWe present a numerical procedure for simulating the non-linear behaviour of Superconductor-InsulatorSuperconductor (SIS) tunnel junction mixers. Mixers of this kind are used extensively in high-performance submillimetre-wave astronomical receivers. The procedure is complete in that both the signal and local-oscillator voltages can be at high levels, with significant amounts of harmonic content; also, the full quantum mechanical behaviour of the tunnel junction is taken into account. The initial simulations show that multi-tone analysis can be carried out in a numerically efficient manner, and that saturation, and the attendant generation of IF harmonics, can be modelled rigorously. This work constitutes the first full non-linear model of an SIS mixer, and the theoretical and numerical procedures described, will be of great importance when designing the next generation of heterodyne astronomical receivers.\n
Theoretica and experimental research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of an SIS mixer using a slightly nonideal junction, with finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing. The resulting equations have a particularly simple form. The minimum noise temperature is controlled by the leakage current of the junction. Even the most nearly ideal junctions made today require a considerable LO for best sensitivity; nevertheless, even a comparatively large leakage current allows mixer noise to be only a small factor above the quantum limit. The saturation properties of SIS mixers subjected to broad-band thermal noise obey the equations derived for monochromatic saturating signals. The Josephson junction tuning inductor was analyzed with the conclusion that such a device is not feasible with present fabrication techniques. Computer calculations using synthetic SIS junction I-V characteristics predicted the performance of an optimized receiver over its entire operating frequency range. Many aspects of the operation of SIS mixers were clarified and unexpected new phenomena were predicted. A 'photon picture' interpretation of the quantum theory of mixing is in the early stages ofmore » development. Niobium nitride edge junctions with excellent current-voltage characteristics were fabricated using novel barrier formation processes. The role of surface damage in the quality of NbN edge junction electrical characteristics was investigated and unexpected results were obtained.« less