Systems of coupled mechanical resonators are useful for quantum information processing and fundamental tests of physics. Direct coupling is only possible with resonators of very similar frequency, but by using an intermediary optical mode, non-degenerate modes can interact and be independently controlled in a single optical cavity. Here we demonstrate coherent optomechanical state swapping between two spatially and frequency separated resonators with a mass ratio of 4. We find that, by using two laser beams far detuned from an optical cavity resonance, efficient state transfer is possible. Although the demonstration is classical, the same technique can be used to generate entanglement between oscillators in the quantum regime.Coupled mechanical resonators where each mode can be separately controlled are a promising system for quantum information processing. Here, Weaver et al. demonstrate coherent swapping of optomechanical states between two separate resonators.
In the late 1960s and early 1970s, the development of mechanical resonators was pushed forward in efforts to record gravitational waves. In order to push down the limit of the smallest detectable force, the radiation circulating in a Fabry-Perot cavity was demonstrated to modify the damping of the cavity end-mirror suspended to act as a mechanical resonator. A few years later, motivated by the study of the internal properties of atoms and ions, the radiation pressure of light was realized as a means to cool atomic motion. In the following years, the ground-state cooling of ion motion was achieved in landmark studies. For mechanical resonators parametrically coupled to Fabry-Perot cavities, it took much longer to reach quantum ground-state cooling, both in the microwave domain, where the original experiments took place, and in the optical domain. Ground-state cooling in both regimes was reached by three groups during the preparation of this thesis and was largely due to advancements in the fabrication methods. \n \nGround-state cooling allows, in principle, the quantum nature of mechanical resonators to be probed and harnessed. Microwave domain devices, which are focused on in this thesis, have the advantage that nonlinear elements (superconducting quantum bits, qubits) are readily available. These elements enable nonclassical state preparation of the qubit and the subsequent transfer to the microwave cavity. The goal is to transfer these quantum states to mechanical resonators. This would allow mechanics to be used as a quantum mechanical memory in quantum information processing thanks to their long lifetimes. \n \nIn this thesis, various aspects of microwave domain circuit optomechanics are studied. The main goal of this thesis is to study how to enhance the coupling between a quantum regime microwave device and a mechanical resonator by using Josephson junction –based qubits. Coherent interaction between a superconducting qubit and a classical driven mechanical field is demonstrated. The analysis presented in this thesis predicts that ground-state cooling and coherent state transfer is possible in the single-phonon regime with transmon-regime qubits. Also, traditional linear optomechanical systems are considered in which the mechanical resonator is coupled to an electrical resonator. Such systems exhibit a rich spectrum of phenomena from which the quantum-limited amplification and multimode effects are considered in this thesis. It is shown that the system operates near quantum-limited amplification, which could be reached if the mechanical resonator was in the ground state.
State transfer between light and microwaves is a key challenge in quantum networks. Promising transducers use a mechanical intermediary that couples to both fields via radiation pressure. Such electro-optomechanical devices have achieved high efficiencies, yet require resolved-sideband cavities, and generally compromise in scalability and noise performance. Here, we relax this constraint by extending the protocol of Navarathna et al. that transfers optical quantum information onto a mechanical resonator using a broadband, sideband-unresolved cavity and feedback. Combining this with parametric mechanical-to-microwave conversion, we show that continuous optical-to-microwave quantum state transfer is possible using measurement-based feedback, while all-optical coherent feedback enables bidirectional transfer. To assess the transfer, we introduce the quantum transfer witness WT, which -- though similar to the input-referred added noise -- also identifies whether a channel is capable of both preserving Gaussian entanglement and outperforming classical transduction schemes. Finally, we show that quantum-compatible noise performance is within reach of current experimental capabilities. Our results unlock a new design space for electro-optomechanical transducers and strengthens their candidacy as scalable quantum links between distant nodes.
Quantum optomechanics uses optical means to generate and manipulate quantum states of motion of mechanical resonators. This provides an intriguing platform for the study of fundamental physics and the development of novel quantum devices. Yet, the challenge of reconstructing and verifying the quantum state of mechanical systems has remained a major roadblock in the field. Here, we present a novel approach that allows for tomographic reconstruction of the quantum state of a mechanical system without the need for extremely high quality optical cavities. We show that, without relying on the usual state transfer presumption between light an mechanics, the full optomechanical Hamiltonian can be exploited to imprint mechanical tomograms on a strong optical coherent pulse, which can then be read out using well-established techniques. Furthermore, with only a small number of measurements, our method can be used to witness nonclassical features of mechanical systems without requiring full tomography. By relaxing the experimental requirements, our technique thus opens a feasible route towards verifying the quantum state of mechanical resonators and their nonclassical behaviour in a wide range of optomechanical systems.