Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Optics Letters

Detection of 13.8 dB squeezed vacuum states by optimizing the interference efficiency and gain of balanced homodyne detection

Xiaocong Sun, Yajun Wang, Long Tian, Yaohui Zheng, Kunchi Peng

Published Jan 1, 2019• 26 citations
Publisher

Abstract

Squeezed states belong to the most prominent non-classical resources. They have compelling applications in precise measurement, quantum computation, and detection. Here, we report on the direct measurement of 13.8 dB squeezed vacuum states by improving the interference efficiency and gain of balanced homodyne detection. By employing an auxiliary laser beam, the homodyne visibility is increased to 99.8%. The equivalent loss of the electronic noise is reduced to 0.05% by integrating a junction field-effect transistor (JFET) buffering input and another JFET bootstrap structure in the balanced homodyne detector.

DOI
10.3788/col201917.072701

Related papers

Balanced Homodyne Detector With Independent Phase Control and Noise Detection Branches

JinRong Wang, Wenhui Zhang, Long Tian +4 more

Squeezed state light is a fundamental resource for many quantum optics experiments. Important applications like quantum-enhanced magnetometer and quantum key distribution, require the squeezing level as high as possible. In balanced homodyne detection, the detector output is directly proportional to the noise of the squeezed beam. The detected quadrature is dependent on the relative phase between the squeezed beam and local oscillator. Here, we present a balanced homodyne detector (BHD) with independent phase control and noise detection branches. The independence between the phase control and noise detection branches is experimentally verified, the two branches are independently optimized according to the practical requirements. With the BHD, a bright squeezed light at 1550 nm with quantum noise reduction of 10.3 dB is directly detected. After stabilizing the relative phase between the squeezed states and local oscillator by the phase locking branch of the BHD, the fluctuation of the noise suppression is ±0.2 dB by 1-h testing time.

IEEE Access•Jan 1, 2019•9 citations

Balanced homodyne detection of optical quantum states at audio-band frequencies and below

M S Stefszky, C M Mow-Lowry, S. Chua +7 more

The advent of stable, highly squeezed states of light has generated great interest in the gravitational wave community as a means for improving the quantumnoise- limited performance of advanced interferometric detectors. To confidently measure these squeezed states, it is first necessary to measure the shot-noise across the frequency band of interest. Technical noise, such as non-stationary events, beam pointing, and parasitic interference, can corrupt shot-noise measurements at low Fourier frequencies, below tens of kilo-Hertz. In this paper we present a qualitative investigation into all of the relevant noise sources and the methods by which they can be identified and mitigated in order to achieve quantum noise limited balanced homodyne detection. Using these techniques, flat shot-noise down to Fourier frequencies below 0.5 Hz is produced. This enables the direct observation of large magnitudes of squeezing across the entire audio-band, of particular interest for ground-based interferometric gravitational wave detectors. 11.6 dB of shot-noise suppression is directly observed, with more than 10 dB down to 10 Hz.

arXiv:1205.3229•Classical and Quantum Gravity•Jun 25, 2012•135 citations

Detection of 10 dB vacuum noise squeezing at 1064 nm by balanced homodyne detectors with a common mode rejection ratio more than 80 dB

Chien-Ming Wu, Shu-Rong Wu, Yi‐Ru Chen +2 more

We report our implementation of a squeezer, by generating squeezed vacuum state at 1064 nm through a bow-tie optical parametric oscillator cavity operated below the threshold. With the help of our home-made balanced homodyne detector (BHD), characterized with a Common Mode Rejection Ratio (CMRR) more than 80 dB, a noise reduction up to 10 dB is observed.

Conference on Lasers and Electro-Optics•Jan 1, 2019•1 citation

A low-noise, high-SNR and large-dynamic-range balanced homodyne detector for broadband squeezed light measurement

Jinrong Wang, Shuange Wu, Liying Hou +3 more

Squeezing-based quantum metrology has been extensively applied in the field of precision measurement. Performance characteristics of squeezed light are obtained by a balanced homodyne detector. Here, we report a large dynamic range balanced homodyne detector with low-noise and high-signal-to-noise-ratio (SNR) for broadband squeezed light measurement. We perform a comprehensive theoretical analysis of the SNR in a wide bandwidth and experimentally analyze the important printed circuit board (PCB) layout and electronic components. Consequently, in the 100 MHz frequency band, the SNR and common mode rejection ratio (CMRR) rise over 12.6 dB and 55 dB, respectively, and the electronic noise is suppressed below −90 dB. The directly observed squeezing level at 1550 nm with the specified detector is 11.8 dB at 2 MHz and 3.1 dB at 100 MHz.

Results in Physics•Jan 18, 2024•5 citations

Cavity enhanced parametric homodyne detection of a squeezed quantum comb

Yuhang Tian, Xiaocong Sun, Yajun Wang +3 more

A squeezed state with higher-order sidebands is a valuable quantum resource for channel multiplexing quantum communication. However, balanced homodyne detection used in nonclassical light detection has a trade-off performance between the detection bandwidth and clearance, in which the verification of a highly squeezing factor faces a challenge. Here, we construct two optical parametric amplifiers with cavity enhancement; one is for the generation of a -10.5 dB squeezed vacuum state, and the other is for all-optical phase-sensitive parametric homodyne detection. Finally, -6.5 dB squeezing at the carrier with 17 pairs of squeezing sidebands (bandwidth of 156 GHz) is directly and simultaneously observed. In particular, for the cavity-enhanced parametric oscillation and detection processes, we analyze the limiting factors of the detectable bandwidth and measurement deviation from the generated value, which indicates that the length difference and propagation loss between two optical parametric amplifiers should be as small as possible to improve the detection performance. The experimental results confirm our theoretical analysis.

Optics Letters•Dec 20, 2021•8 citations

Balanced homodyne detection circuit design analysis for high gain and low noise performance

Akanksha Angural, Joyee Ghosh

The study, generation, and application of squeezed states of light has been a widely researched area in quantum optics. Vacuum fluctuations or photon shot noise quantified in terms of quadrature operators, impose a quantum limit on the sensitivity of quantum sensing and quantum communication systems. Thus, squeezing the quadratures reduces the quantum uncertainty in a particular quadrature. The amount of squeezing is, however, highly limited by the optics in the experiments and the performance of the balanced homodyne detection (BHD) systems employed for the detection of the squeezed states of light. In this paper, we have analytically studied the steady state, transient and noise responses of the balanced homodyne detection (BHD) circuitry by comparing two configurations i.e., a variable gain circuit with a differential amplifier and a current subtracting circuit with differential fine-tuning circuit (DFTC) and an adjustable bias (ABV). The current subtracting circuit design with DFTC and ABV has been adopted from Xiaoli et al. [1] in order to compensate for any differences in the photodiode performance characteristics in the two arms. A variable gain configuration is used to compensate for the unequal beam splitter ratio and uneven optical powers in the two arms. In order to further improve the noise performance of the system, a differential amplifier is used in the output of the variable gain configuration. A high transimpedance gain (~>70 dB) and a low noise (~<500nV/ √ Hz) performance can be achieved using these circuits as per our analysis.

IEEE International Conference on Emerging Electronics (ICEE)•Dec 11, 2022•0 citations
Squeezed states belong to the most prominent non-classical resources. They have compelling applications in precise measurement, quantum computation, and detection. Here, we report on the direct measurement of 13.8 dB squeezed vacuum states by improving the interference efficiency and gain of balanced homodyne detection. By employing an auxiliary laser beam, the homodyne visibility is increased to 99.8%. The equivalent loss of the electronic noise is reduced to 0.05% by integrating a junction field-effect transistor (JFET) buffering input and another JFET bootstrap structure in the balanced homodyne detector.
Squeezed state light is a fundamental resource for many quantum optics experiments. Important applications like quantum-enhanced magnetometer and quantum key distribution, require the squeezing level as high as possible. In balanced homodyne detection, the detector output is directly proportional to the noise of the squeezed beam. The detected quadrature is dependent on the relative phase between the squeezed beam and local oscillator. Here, we present a balanced homodyne detector (BHD) with independent phase control and noise detection branches. The independence between the phase control and noise detection branches is experimentally verified, the two branches are independently optimized according to the practical requirements. With the BHD, a bright squeezed light at 1550 nm with quantum noise reduction of 10.3 dB is directly detected. After stabilizing the relative phase between the squeezed states and local oscillator by the phase locking branch of the BHD, the fluctuation of the noise suppression is ±0.2 dB by 1-h testing time.
The advent of stable, highly squeezed states of light has generated great interest in the gravitational wave community as a means for improving the quantumnoise- limited performance of advanced interferometric detectors. To confidently measure these squeezed states, it is first necessary to measure the shot-noise across the frequency band of interest. Technical noise, such as non-stationary events, beam pointing, and parasitic interference, can corrupt shot-noise measurements at low Fourier frequencies, below tens of kilo-Hertz. In this paper we present a qualitative investigation into all of the relevant noise sources and the methods by which they can be identified and mitigated in order to achieve quantum noise limited balanced homodyne detection. Using these techniques, flat shot-noise down to Fourier frequencies below 0.5 Hz is produced. This enables the direct observation of large magnitudes of squeezing across the entire audio-band, of particular interest for ground-based interferometric gravitational wave detectors. 11.6 dB of shot-noise suppression is directly observed, with more than 10 dB down to 10 Hz.
Squeezing-based quantum metrology has been extensively applied in the field of precision measurement. Performance characteristics of squeezed light are obtained by a balanced homodyne detector. Here, we report a large dynamic range balanced homodyne detector with low-noise and high-signal-to-noise-ratio (SNR) for broadband squeezed light measurement. We perform a comprehensive theoretical analysis of the SNR in a wide bandwidth and experimentally analyze the important printed circuit board (PCB) layout and electronic components. Consequently, in the 100 MHz frequency band, the SNR and common mode rejection ratio (CMRR) rise over 12.6 dB and 55 dB, respectively, and the electronic noise is suppressed below −90 dB. The directly observed squeezing level at 1550 nm with the specified detector is 11.8 dB at 2 MHz and 3.1 dB at 100 MHz.
A squeezed state with higher-order sidebands is a valuable quantum resource for channel multiplexing quantum communication. However, balanced homodyne detection used in nonclassical light detection has a trade-off performance between the detection bandwidth and clearance, in which the verification of a highly squeezing factor faces a challenge. Here, we construct two optical parametric amplifiers with cavity enhancement; one is for the generation of a -10.5 dB squeezed vacuum state, and the other is for all-optical phase-sensitive parametric homodyne detection. Finally, -6.5 dB squeezing at the carrier with 17 pairs of squeezing sidebands (bandwidth of 156 GHz) is directly and simultaneously observed. In particular, for the cavity-enhanced parametric oscillation and detection processes, we analyze the limiting factors of the detectable bandwidth and measurement deviation from the generated value, which indicates that the length difference and propagation loss between two optical parametric amplifiers should be as small as possible to improve the detection performance. The experimental results confirm our theoretical analysis.
The study, generation, and application of squeezed states of light has been a widely researched area in quantum optics. Vacuum fluctuations or photon shot noise quantified in terms of quadrature operators, impose a quantum limit on the sensitivity of quantum sensing and quantum communication systems. Thus, squeezing the quadratures reduces the quantum uncertainty in a particular quadrature. The amount of squeezing is, however, highly limited by the optics in the experiments and the performance of the balanced homodyne detection (BHD) systems employed for the detection of the squeezed states of light. In this paper, we have analytically studied the steady state, transient and noise responses of the balanced homodyne detection (BHD) circuitry by comparing two configurations i.e., a variable gain circuit with a differential amplifier and a current subtracting circuit with differential fine-tuning circuit (DFTC) and an adjustable bias (ABV). The current subtracting circuit design with DFTC and ABV has been adopted from Xiaoli et al. [1] in order to compensate for any differences in the photodiode performance characteristics in the two arms. A variable gain configuration is used to compensate for the unequal beam splitter ratio and uneven optical powers in the two arms. In order to further improve the noise performance of the system, a differential amplifier is used in the output of the variable gain configuration. A high transimpedance gain (~>70 dB) and a low noise (~<500nV/ √ Hz) performance can be achieved using these circuits as per our analysis.