Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Microwave Theory and Techniques

An Atomic Sensor for Direct Detection of Weak Microwave Signals

Vladislav P. Gerginov, Fabio C. S. da Silva, Archita Hati, Craig W. Nelson

Published Jul 7, 2019• 21 citations
Publisher

Abstract

This paper demonstrates direct detection of weak signals at microwave frequencies based on parametric frequency conversion. The atomic medium is optically pumped by a resonant light field and prepared in a coherent atomic superposition by a weak microwave field. The coherent atomic superposition causes a parametric modulation of the polarization of a probe light field at the microwave field frequency. An upper limit magnetic field component sensitivity of 1.2(1.0) pT/Hz1/2, corresponding to 3.7(3.1)-μV/cm/Hz1/2electric field component sensitivity, is achieved at ~6.835 GHz with a 33-mm3vapor cell.

DOI
10.1109/tmtt.2019.2921351

Related papers

Gradient Field Detection Using Interference of Stimulated Microwave Optical Sidebands

Kaleb Campbell, Ying-Ju Wang, Igor Savukov +3 more

We demonstrate that stimulated microwave optical sideband generation using parametric frequency conversion can be utilized as a powerful technique for coherent state detection in atomic physics experiments. The technique has advantages over traditional absorption or polarization rotation-based measurements and enables the isolation of signal photons from probe photons. We outline a theoretical framework that accurately models sideband generation using a density matrix formalism. Using this technique, we demonstrate a novel intrinsic magnetic gradiometer that detects magnetic gradient fields between two spatially separated vapor cells by measuring the frequency of the beat note between sidebands generated within each cell. The sidebands are produced with high efficiency using parametric frequency conversion of a probe beam interacting with ^{87}Rb atoms in a coherent superposition of magnetically sensitive hyperfine ground states. Interference between the sidebands generates a low-frequency beat note whose frequency is determined by the magnetic field gradient between the two vapor cells. In contrast to traditional gradiometers the intermediate step of measuring the magnetic field experienced by the two vapor cells is unnecessary. We show that this technique can be readily implemented in a practical device by demonstrating a compact magnetic gradiometer sensor head with a sensitivity of 25 fT/cm/sqrt[Hz] with a 4.4 cm baseline, while operating in a noisy laboratory environment unshielded from Earth's field.

Physical Review Letters•Apr 21, 2022•4 citations

Microwave electric field measurement using frequency modulation spectroscopy in Rydberg atoms vapor cells

Santosh Kumar, Haoquan Fan, Akbar Jahangiri Jozani +2 more

We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.

International conference on fiber optics and photonics•Jan 1, 2016•0 citations

Microwave electric field sensing with Rydberg atoms

Daniel T. Stack, Paul D. Kunz, David H. Meyer +1 more

Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 19, 2016•3 citations

Coherent Atomic Microwave Sensor

Vladislav P. Gerginov, F. C. S. da Silva, Craig W. Nelson +1 more

We developed a room-temperature atomic microwave sensor that converts coherently a low-power microwave signal to polarization modulation of a probe light field. The sensitivity rivals that of microwave field probes based on Rydberg atoms.

Conference on Lasers and Electro-Optics•May 5, 2019•0 citations

Coherent atomic microwave sensor

Vladislav P. Gerginov, F. C. S. da Silva, Craig W. Nelson +1 more

We developed a room-temperature atomic microwave sensor that converts coherently a low-power microwave signal to polarization modulation of a probe light field. The sensitivity rivals that of microwave field probes based on Rydberg atoms.

Conference on Lasers and Electro-Optics•Jan 1, 2019•0 citations

Sensitivity of a Rydberg-atom receiver to frequency and amplitude modulation of microwaves

Sebastian Borówka, Uliana Pylypenko, Mateusz Mazelanik +1 more

Electromagnetically induced transparency in atomic systems involving Rydberg states is known to be a sensitive probe of incident microwave (MW) fields, in particular those resonant with Rydberg-to-Rydberg transitions. Here we propose an intelligible analytical model of a Rydberg atomic receiver's response to amplitude- (AM) and frequency-modulated (FM) signals and compare it with experimental results, presenting a setup that allows sending signals with either AM or FM and evaluating their efficiency with demodulation. Additionally, the setup reveals a detection configuration using all circular polarizations for optical fields and allowing detection of a circularly polarized MW field, propagating colinearly with optical beams. In our measurements, we systematically show that several parameters exhibit local optimum characteristics and then estimate these optimal parameters and working ranges, addressing the need to devise a robust Rydberg MW sensor and its operational protocol.

arXiv:2206.11829•Applied Optics•Sep 15, 2022•29 citations
This paper demonstrates direct detection of weak signals at microwave frequencies based on parametric frequency conversion. The atomic medium is optically pumped by a resonant light field and prepared in a coherent atomic superposition by a weak microwave field. The coherent atomic superposition causes a parametric modulation of the polarization of a probe light field at the microwave field frequency. An upper limit magnetic field component sensitivity of 1.2(1.0) pT/Hz1/2, corresponding to 3.7(3.1)-μV/cm/Hz1/2electric field component sensitivity, is achieved at ~6.835 GHz with a 33-mm3vapor cell.
We demonstrate that stimulated microwave optical sideband generation using parametric frequency conversion can be utilized as a powerful technique for coherent state detection in atomic physics experiments. The technique has advantages over traditional absorption or polarization rotation-based measurements and enables the isolation of signal photons from probe photons. We outline a theoretical framework that accurately models sideband generation using a density matrix formalism. Using this technique, we demonstrate a novel intrinsic magnetic gradiometer that detects magnetic gradient fields between two spatially separated vapor cells by measuring the frequency of the beat note between sidebands generated within each cell. The sidebands are produced with high efficiency using parametric frequency conversion of a probe beam interacting with ^{87}Rb atoms in a coherent superposition of magnetically sensitive hyperfine ground states. Interference between the sidebands generates a low-frequency beat note whose frequency is determined by the magnetic field gradient between the two vapor cells. In contrast to traditional gradiometers the intermediate step of measuring the magnetic field experienced by the two vapor cells is unnecessary. We show that this technique can be readily implemented in a practical device by demonstrating a compact magnetic gradiometer sensor head with a sensitivity of 25 fT/cm/sqrt[Hz] with a 4.4 cm baseline, while operating in a noisy laboratory environment unshielded from Earth's field.
We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.
Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.
Electromagnetically induced transparency in atomic systems involving Rydberg states is known to be a sensitive probe of incident microwave (MW) fields, in particular those resonant with Rydberg-to-Rydberg transitions. Here we propose an intelligible analytical model of a Rydberg atomic receiver's response to amplitude- (AM) and frequency-modulated (FM) signals and compare it with experimental results, presenting a setup that allows sending signals with either AM or FM and evaluating their efficiency with demodulation. Additionally, the setup reveals a detection configuration using all circular polarizations for optical fields and allowing detection of a circularly polarized MW field, propagating colinearly with optical beams. In our measurements, we systematically show that several parameters exhibit local optimum characteristics and then estimate these optimal parameters and working ranges, addressing the need to devise a robust Rydberg MW sensor and its operational protocol.