We study the ground state of spin-2 dipolar rotating Bose–Einstein condensates in a harmonic potential. As the strength of dipolar interaction enhances, our results show that the vortex number becomes smaller and smaller at a fixed component. In addition, the vortex stripe occurs and its number increases. The components m[Formula: see text]1 or ±2 display the same density and the total density shows layered distribution. Increasing the rotational frequency to a higher value, the vortex number and vortex row number increase. We also plot the dependence of angular momentum Lz as a function of dipole strength c[Formula: see text], showing that Lz decreases with increasing c[Formula: see text].
We study the ground state of spin-2 dipolar rotating Bose–Einstein condensates in a harmonic potential. As the strength of dipolar interaction enhances, our results show that the vortex number becomes smaller and smaller at a fixed component. In addition, the vortex stripe occurs and its number increases. The components m[Formula: see text]1 or ±2 display the same density and the total density shows layered distribution. Increasing the rotational frequency to a higher value, the vortex number and vortex row number increase. We also plot the dependence of angular momentum Lz as a function of dipole strength c[Formula: see text], showing that Lz decreases with increasing c[Formula: see text].
We investigate the impact of interplay between the contact interaction and the dipole-dipole interaction on the rotational properties of dipolar Bose-Einstein condensate, rotating in an axially confined double-well potential. The dynamics is governed by a quasi-two-dimensional Gross-Pitaevskii equation with phenomenological dissipation and non-local dipole-dipole interaction integral. In the present study, we consider using three different dipolar atoms namely 52Cr, 168Er and 164Dy with increasing order of dipole-dipole interaction strength respectively. From our numerical simulation, we see, at the critical frequency, the vortex core starts to emerge from the peripheries of the BEC. Further, we observe that the critical frequency of vortex nucleation decreases with an increase of dipole-dipole interaction strength and contact interaction strength and these interactions also enhance the number of vortices. We also find that the increase in average angular momentum per atom with rotational frequency suddenly shifts from linear to non-linear progression after attaining the critical rotational frequency. From the results obtained in the present study, it is quite clear that dipole-dipole interaction and contact interaction compliments with each other, has a considerable influence on the rotational properties of dipolar BECs.
We study the ground-state phases of two-dimensional spin-orbit coupled spin-1 Bose-Einstein condensate loaded in a plane quadrupole field. In the absence of rotation, for the fixed spin-orbit coupling strength, the ordinary stripe phase is found when the strength of the magnetic field gradient is small. As the strength of magnetic field gradient enhances, the system realizes the phases with three layer vortices along the radial direction. The number of vortices in the second layer is successively increased and the vortices in the outermost layer disappear when the strength of magnetic field gradient surpass the critical value. For the large strength of magnetic field gradient, the system only has the inner layer vortices. The magnetic field inhibits the region of vortices. For the fixed magnetic field gradient strength, the vortices of the system elongate along the radial direction and form a series of vortex lines, the number of the vortex line increases as the strength of spin-orbit coupling enhances. By adding the rotation, for the fixed strengths of spin-orbit coupling and magnetic field gradient, the number of second layer vortices also successively increases as the rotational frequency increases. The number of vortices in the certain layer of the ground-state density can be regularly changed under the effects of the magnetic field and spin-orbit coupling.
In the last decade, considerable advances have been made in the investigation of dipolar quantum gases. Previous theoretical investigations of a rotating binary dipolar Bose-Einstein condensate, where only one component possesses dipole moment, were mainly focused on two special orientations of the dipoles: perpendicular or parallel to the plane of motion. Here we study the ground-state and rotational properties of such a system for an arbitrary orientation of the dipoles. We demonstrate the ground-state vortex structures depend strongly on the relative strength between dipolar and contact interactions and the rotation frequency, as well as on the orientation of the dipoles. In the absence of rotation, the tunable dipolar interaction can be used to induce the squeezing or expansion of the cloud, and to derive the phase transition between phase coexistence and separation. Under finite rotation, the system is found to exhibit exotic ground-state vortex configurations, such as kernel-shell, vortex necklace, and compensating stripe vortex structures. We also check the validity of the Feynman relation, and find no significant deviations from it. The obtained results open up alternate ways for the quantum control of dipolar quantum gases.
We investigate the ground-state phases and spin textures of spin–orbit-coupled dipolar pseudo-spin-1/2 Bose–Einstein condensates in a rotating two-dimensional toroidal potential. The combined effects of dipole–dipole interaction (DDI), spin–orbit coupling (SOC), rotation, and interatomic interactions on the ground-state structures and topological defects of the system are analyzed systematically. For fixed SOC strength and rotation frequency, we provide a set of phase diagrams as a function of the DDI strength and the ratio between inter- and intra-species interactions. The system can show rich quantum phases including a half-quantum vortex, symmetrical (asymmetrical) phase with quantum droplets (QDs), asymmetrical segregated phase with hidden vortices (ASH phase), annular condensates with giant vortices, triangular (square) vortex lattice with QDs, and criss-cross vortex string lattice, depending on the competition between DDI and contact interaction. For given DDI strength and rotation frequency, the increase of the SOC strength leads to a structural phase transition from an ASH phase to a tetragonal vortex lattice then to a pentagonal vortex lattice and finally to a vortex necklace, which is also demonstrated by the momentum distributions. Without rotation, the interplay of DDI and SOC may result in the formation of a unique trumpet-shaped Bloch domain wall. In addition, the rotation effect is discussed. Furthermore, the system supports exotic topological excitations, such as a half-skyrmion (meron) string, triangular skyrmion lattice, skyrmion–half-skyrmion lattice, skyrmion–meron cluster, skyrmion–meron layered necklace, skyrmion–giant-skyrmion necklace lattice, and half-skyrmion–half-antiskyrmion necklace.
We investigate the ground state of rotating two-component Bose-Einstein condensates in the combined potential well of one-dimensional spin-dependent optical lattice potential and harmonic potential. The density distribution of the condensate is striped. By defining the generalized momentum operator, we derive the velocity distribution of the condensate. The velocity contours are concentric circles for each stripe, with different centers for different stripes. This velocity distribution corresponds to a specific spin texture structure. In this texture, the azimuthal angle of the magnetic moments varies along the y-direction, while the z-component of the magnetic moments varies along the x-direction. When the lattice period [Formula: see text], the texture is divided into two regions. The magnetic moments reverse in a counterclockwise direction and in a clockwise direction as y increases in regions I and II, respectively. Furthermore, when the lattice period [Formula: see text], the texture is divided into three regions. The magnetic moments reverse in a counterclockwise direction, do not reverse, and reverse in a clockwise direction as y increases in regions I, II, and III, respectively. Accurate manipulation of the texture can be achieved by adjusting the optical lattice periods [Formula: see text] and [Formula: see text], the relative phase φ, and the rotational angular frequency Ω.