Control and utilization of coherent states of microwave photons is a ubiquitous requirement for the present and near-future implementations of solid-state quantum computers. The rate at which the photon state responds to external driving is limited by the relaxation rate of the storage resonator, which poses a trade-off between fast control and long storage time. Here, we present a control scheme that is designed to drive an unknown photon state to a desired coherent state much faster than the resonator decay rate. Our method utilizes a tunable environment which acts on an ancillary qubit coupled to the resonator. By periodically resetting the qubit and tuning it into resonance with the resonator, possible photon loss and dephasing of the resonator mode are corrected without measurements or active feedback. In general, our method is suitable for accelerating the control of coherent states in high-fidelity resonators.
Control and utilization of coherent states of microwave photons is a ubiquitous requirement for the present and near-future implementations of solid-state quantum computers. The rate at which the photon state responds to external driving is limited by the relaxation rate of the storage resonator, which poses a trade-off between fast control and long storage time. Here, we present a control scheme that is designed to drive an unknown photon state to a desired coherent state much faster than the resonator decay rate. Our method utilizes a tunable environment which acts on an ancillary qubit coupled to the resonator. By periodically resetting the qubit and tuning it into resonance with the resonator, possible photon loss and dephasing of the resonator mode are corrected without measurements or active feedback. In general, our method is suitable for accelerating the control of coherent states in high-fidelity resonators.
In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.
Abstract We propose a method for fast, deterministic resonator reset based on tunable dissipative modes. The dissipator is based on a Josephson junction with relatively low quality factor. When the dissipator is tuned into resonance with a high quality microwave resonator, resonator photons are absorbed by the dissipator at a rate orders of magnitude faster than the resonator relaxation rate. We determine the optimal parameters for realization of the tunable dissipator, and examine application of the dissipator to removing spurious photon population in the qubit readout resonator in circuit quantum electrodynamics. We show that even in the nonlinear large photon occupation regime, this enhanced resonator decay rate can be attained by appropriate modulation of the dissipator frequency.
We have studied theoretically the basic operation of a quantum feedback loop designed to maintain a desired phase of quantum coherent oscillations in a single solid-state qubit. The degree of oscillations synchronization with external harmonic signal is calculated as a function of feedback strength, taking into account available bandwidth and coupling to environment. The feedback can efficiently suppress the dephasing of oscillations if the qubit coupling to the detector is stronger than the coupling to the environment.
Superconducting quantum circuits have emerged as a leading platform for building large-scale quantum computers, owing to their ability to engineer strong, highly tunable interactions. However, achieving high-fidelity quantum operations requires overcoming the fundamental isolation-andcontrol challenge: qubits must be well-isolated from their electromagnetic environment to maintain long coherence times, yet they require strong external coupling for fast control, readout, and initialization. In current architectures, this trade-off often demands complex auxiliary circuitry that can introduce additional noise and thermal loads. This thesis presents novel circuit designs and control techniques to address the isolation-and-control challenge in superconducting transmon qubits. First, we introduce integrated on-chip filters, in particular, 𝜆/4 and 𝜆/2 transmission line filters that exhibit a stopband at the qubit frequency. This design protects the qubit from Purcell decay, yielding up to a 200-fold improvement in the energy relaxation time 𝑇1 at the stopband. To achieve fast single-qubit gates despite this isolation, we employ subharmonic driving, demonstrating sub-ten-nanosecond control and Rabi oscillations with a 12-ns pulse duration while significantly reducing the cryogenic thermal load. Building upon these static filters, we propose and experimentally demonstrate the quantum dial, a dynamically tunable band-stop filter consisting of a series array of direct-current superconducting quantum interference devices. The quantum dial enables on-demand tuning of the qubit–environment coupling, including a reduction of 𝑇1 from over 150 μs to roughly 200 ns, while introducing minimal ac Stark shifts. We demonstrate its versatility by dialing between three operational regimes: an idle state with 99.99% fidelity, a control state enabling 99.9% fidelity for 40-ns single-qubit gates at −110 dBm, and a strongly coupled state for unconditional, state-independent qubit reset. Furthermore, the quantum dial enables qubit thermometry close to the quantum-Fisherinformation bound, with a noise-equivalent temperature down to 0.6 mK/√Hz at 60 mK. Alongside the development of these dedicated control architectures, this thesis contributes to the broader framework of circuit quantum electrodynamics by advancing specific microwave engineering and characterization techniques. In particular, we explore the miniaturization of circuit footprints through the realization of compact sub-gigahertz inductor-capacitor resonators. Additionally, we contribute to the optimization of unconditional qubit reset using a single-junction quantum-circuit refrigerator, and to the advanced characterization of microwave fields via computed tomography of propagating microwave photons. In summary, these results demonstrate fixed and tunable drive-line filters that suppress idle-state radiative decay while preserving selected control, reset, and thermometry operations. By replacing static coupling compromises with temporally programmable environments, these architectures offer a promising route to reducing noise, mitigating crosstalk, and accelerating error-correction cycles in future superconducting quantum processors.
Resonant driving enables coherent control of quantum systems, including single and coupled qubits. From a complementary perspective, transitions of a quantum system can be exploited for the detection of microwave photons. In this work, we theoretically investigate resonant multiphoton excitations in a system of qubits. When the energy of K photons matches the energy splitting of the qubit system, the absorption of these photons leads to collective excitation of the qubits. We focus on the case of two coupled qubits and analyze the quantum dynamics of both excitation and relacation processes. In the particular case where only a single qubit is relevant and the remaining qubits can be neglected, the dynamics admits an analytical treatment. We examine multiphoton resonances, the Bloch-Siegert shift, and population inversion, phenomena that are central to both coherent quantum control and microwave photon detection.
We present a broad summary of research involving the application of quantum feedback control techniques to optical setups, from the early enhancement of optical amplitude squeezing to the recent stabilisation of photon number states in a microwave cavity, dwelling mostly on the latest experimental advances. Feedback control of quantum optical continuous variables, quantum nondemolition memories, feedback cooling, quantum state control, adaptive quantum measurements, and coherent feedback strategies will all be touched upon in our discussion.