Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics B

Two-frequency amplification in a semiconductor tapered amplifier for cold atom experiments

Zhixin Meng, Yuhang Li, Yanying Feng

Published Sep 1, 2018• 5 citations
Publisher

Abstract

Simultaneous two-frequency amplification is highly desirable in cold atom experiments. The nonlinear response would appear in the two-frequency amplification with a semiconductor tapered amplifier (TA) and has a direct influence on the experimental result. We investigated in detail the effects of frequency difference, total power, and power ratio of two seeding lasers on the output components based on a simplified theoretical model. The simulation results showed that the multiple sideband generation in the amplifier due to self-phase and amplitude modulation could be suppressed and the TA tended to linearly amplify the power ratio between two-frequency components, when the two seeding lasers had a large frequency difference. This was verified experimentally in the output power ratio measurement via a calibrated Fabry–Perot interferometer method with a good linearity and an uncertainty of 1%. We also discussed the consequences of power ratio responses in the amplification in light of cold atom experiments, especially in the ac Stark shift related phase error of Raman-type atom interferometers (AIs). It was shown that the fluctuation of intensity ratio of Raman beams may induce significant systematic errors for an AI gyroscope.

DOI
10.1088/1674-1056/27/9/094201

Related papers

Investigating the frequency-dependent amplification of a tapered amplifier in atom interferometers

Su Zhan, Xiao‐Chun Duan, Min-Kang Zhou +3 more

We present the investigation on the frequency-dependent amplification (FDA) of a tapered amplifier (TA) and the corresponding influence on Raman-type atom interferometers. In our interferometer, the output of two phase-locked diode lasers is injected into a TA to generate Raman beams. The frequency of one laser is chirped during the interfering process, which induces a variance of the Raman lasers power as a result of the FDA of the TA. The corresponding power ratio variation of the Raman lasers is measured by beat note method, which shows a linear dependence with a slope of -0.087(4)/GHz when the laser frequency changes over 2 GHz at 780 nm. The corresponding error related to AC Stark effect due to this frequency-dependent variation is estimated for our atom interferometer. The investigation presented here may provide hints for other experiments involving TAs.

Optics Letters•Dec 15, 2014•16 citations

Impact of additional sidebands generated by a tapered amplifier on an atom interferometer

Hang Zhou, Qin Luo, Xiao-Bing Deng +4 more

Stimulated Raman transitions are often used in an atom interferometer (AI) for wave packet manipulation. Normally, two lasers with different frequencies contained in a Raman beam are combined first and then amplified by a single tapered amplifier (TA). This configuration can simplify the laser system of the AI, however, additional sidebands will be generated by the TA because of the nonlinear effect in the TA. In this work, the impact of additional sidebands generated with a single TA on the AI is studied. We first observe the additional sidebands in a Raman laser by a Fabry-Pérot interferometer (FPI), and the additional sidebands will be greatly suppressed by reducing the injection laser power of the TA. This is also confirmed by observing the position-dependent Raman transitions induced by additional sidebands at different injection power in an AI. However, the phase shifts induced by additional sidebands are not reduced obviously when the injection power of the TA is reduced. Therefore, it is necessary to separately amplify two lasers contained in the Raman laser by two TAs for a high precision AI. The spectroscopy of Raman laser generated by two TAs is also measured by the FPI, and the impact of additional sidebands on the AI is eliminated. This work has guiding significance for the design of the laser system in a high-precision AI.

Optics Letters•Aug 29, 2022•1 citation

Multiple side-band generation for two-frequency components injected into a tapered amplifier

Hua Luo, Kai Li, Dongfang Zhang +2 more

We have experimentally studied multiple side-band generation for two-frequency components injected into a tapered amplifier (TA) and demonstrated its effects on atomic laser cooling. A heterodyne frequency-beat measurement and a Fabry-Perot interferometer have been applied to analyze the side-band generation with different experimental parameters, such as frequency difference, injection laser power, and TA current. In laser-cooling potassium40 and potassium41 with hyperfine splitting of 1.3 GHz and 254 MHz, respectively, the side-band generation with a small frequency difference has a significant effect on the number of trapped atoms.

arXiv:1303.7277•Optics Letters•Mar 28, 2013•11 citations

Design and construction of cost-effective tapered amplifier systems for laser cooling and trapping experiments

Jayampathi Kangara, Andrew J. Hachtel, Matthew Gillette +9 more

We present plans for the construction and operation of a tapered optical amplifier (TA) system seeded by a single-mode, frequency-tunable, near-IR external-cavity diode laser. Our plans include machine drawings for the parts, electronic circuit diagrams, and information on prices and vendors. Instructions are provided on how to safely couple light into and out of the TA chip. Practical aspects of handling the chip are discussed as well. Because many cold atom experiments require light beams with Gaussian spatial profiles, measurements of the tapered amplifier light output through a single-mode optical fiber are presented as a function of seed intensity, polarization, and driving current.

American Journal of Physics•Jul 23, 2014•17 citations

A new method for high-bandwidth servo control of the power ratio between two Raman beams for cold atom interferometer

Yaning Wang, Huankai Zhang, Dongyang Xu +8 more

Light shift produced by the AC Stark effect is one of the major factors limiting the accuracy and long-term stability of a cold atom interferometer. The first order light shift can be canceled by fixing the power ratio of the Raman beams at a specified value. We report here a new method to stabilize the power ratio of the two Raman lasers with ∼100 kHz locking bandwidth, suppressing the effect of the first order light shift. We first mixed the two Raman lasers (at different optical frequencies) with a reference beam and then used two Schottky diode detectors to extract the corresponding beat note signals for each beam, which are much easier to be manipulated and processed as they are in the microwave band. The stability of the power ratio is improved by three orders of magnitude from 5.84 × 10−3 to 3.51 × 10−6 at 1 s averaging time and reaches 1.59 × 10−7 at 10 000 s integrating time when the servo loop is engaged. This method can be used in other precise quantum measurement based on the stimulated Raman transition and can be applied to compact inertial sensors.

Review of Scientific Instruments•Oct 1, 2020•5 citations

Construction and Optimization of a Tapered Amplifier System for Applications in Ultra-Cold Plasma Research

R. A. Cole

The number density of cold atoms confined in a magneto-optical trap (MOT) is critically dependent on the intensity of the lasers used to cool the sample. To generate large optical powers while retaining the practicality of homemade external cavity diode lasers (ECDLs), a tapered amplifier (TA) system was designed and constructed to amplify the output of an existing 780 nm, continuous-wave ECDL. The amplifier’s performance is discussed in terms of its gain and power output. Under standard operating conditions, optical amplification of 12 dB is achieved, with a maximum power output of 0.75 W. The completed amplifier is installed into an existing MOT at Colby College, and its effect is analyzed in terms of the number density of trapped samples of rubidium-85. MOT measurements are given demonstrating an increase in these number densities by a factor of ten. We conclude with initial results to quantify the amplifier’s effect on the dynamics of ultra-cold plasmas created from the trapped atom samples.

•Jan 1, 2015•0 citations
Simultaneous two-frequency amplification is highly desirable in cold atom experiments. The nonlinear response would appear in the two-frequency amplification with a semiconductor tapered amplifier (TA) and has a direct influence on the experimental result. We investigated in detail the effects of frequency difference, total power, and power ratio of two seeding lasers on the output components based on a simplified theoretical model. The simulation results showed that the multiple sideband generation in the amplifier due to self-phase and amplitude modulation could be suppressed and the TA tended to linearly amplify the power ratio between two-frequency components, when the two seeding lasers had a large frequency difference. This was verified experimentally in the output power ratio measurement via a calibrated Fabry–Perot interferometer method with a good linearity and an uncertainty of 1%. We also discussed the consequences of power ratio responses in the amplification in light of cold atom experiments, especially in the ac Stark shift related phase error of Raman-type atom interferometers (AIs). It was shown that the fluctuation of intensity ratio of Raman beams may induce significant systematic errors for an AI gyroscope.
We present the investigation on the frequency-dependent amplification (FDA) of a tapered amplifier (TA) and the corresponding influence on Raman-type atom interferometers. In our interferometer, the output of two phase-locked diode lasers is injected into a TA to generate Raman beams. The frequency of one laser is chirped during the interfering process, which induces a variance of the Raman lasers power as a result of the FDA of the TA. The corresponding power ratio variation of the Raman lasers is measured by beat note method, which shows a linear dependence with a slope of -0.087(4)/GHz when the laser frequency changes over 2 GHz at 780 nm. The corresponding error related to AC Stark effect due to this frequency-dependent variation is estimated for our atom interferometer. The investigation presented here may provide hints for other experiments involving TAs.
Stimulated Raman transitions are often used in an atom interferometer (AI) for wave packet manipulation. Normally, two lasers with different frequencies contained in a Raman beam are combined first and then amplified by a single tapered amplifier (TA). This configuration can simplify the laser system of the AI, however, additional sidebands will be generated by the TA because of the nonlinear effect in the TA. In this work, the impact of additional sidebands generated with a single TA on the AI is studied. We first observe the additional sidebands in a Raman laser by a Fabry-Pérot interferometer (FPI), and the additional sidebands will be greatly suppressed by reducing the injection laser power of the TA. This is also confirmed by observing the position-dependent Raman transitions induced by additional sidebands at different injection power in an AI. However, the phase shifts induced by additional sidebands are not reduced obviously when the injection power of the TA is reduced. Therefore, it is necessary to separately amplify two lasers contained in the Raman laser by two TAs for a high precision AI. The spectroscopy of Raman laser generated by two TAs is also measured by the FPI, and the impact of additional sidebands on the AI is eliminated. This work has guiding significance for the design of the laser system in a high-precision AI.
We have experimentally studied multiple side-band generation for two-frequency components injected into a tapered amplifier (TA) and demonstrated its effects on atomic laser cooling. A heterodyne frequency-beat measurement and a Fabry-Perot interferometer have been applied to analyze the side-band generation with different experimental parameters, such as frequency difference, injection laser power, and TA current. In laser-cooling potassium40 and potassium41 with hyperfine splitting of 1.3 GHz and 254 MHz, respectively, the side-band generation with a small frequency difference has a significant effect on the number of trapped atoms.
We present plans for the construction and operation of a tapered optical amplifier (TA) system seeded by a single-mode, frequency-tunable, near-IR external-cavity diode laser. Our plans include machine drawings for the parts, electronic circuit diagrams, and information on prices and vendors. Instructions are provided on how to safely couple light into and out of the TA chip. Practical aspects of handling the chip are discussed as well. Because many cold atom experiments require light beams with Gaussian spatial profiles, measurements of the tapered amplifier light output through a single-mode optical fiber are presented as a function of seed intensity, polarization, and driving current.
Light shift produced by the AC Stark effect is one of the major factors limiting the accuracy and long-term stability of a cold atom interferometer. The first order light shift can be canceled by fixing the power ratio of the Raman beams at a specified value. We report here a new method to stabilize the power ratio of the two Raman lasers with ∼100 kHz locking bandwidth, suppressing the effect of the first order light shift. We first mixed the two Raman lasers (at different optical frequencies) with a reference beam and then used two Schottky diode detectors to extract the corresponding beat note signals for each beam, which are much easier to be manipulated and processed as they are in the microwave band. The stability of the power ratio is improved by three orders of magnitude from 5.84 × 10−3 to 3.51 × 10−6 at 1 s averaging time and reaches 1.59 × 10−7 at 10 000 s integrating time when the servo loop is engaged. This method can be used in other precise quantum measurement based on the stimulated Raman transition and can be applied to compact inertial sensors.
The number density of cold atoms confined in a magneto-optical trap (MOT) is critically dependent on the intensity of the lasers used to cool the sample. To generate large optical powers while retaining the practicality of homemade external cavity diode lasers (ECDLs), a tapered amplifier (TA) system was designed and constructed to amplify the output of an existing 780 nm, continuous-wave ECDL. The amplifier’s performance is discussed in terms of its gain and power output. Under standard operating conditions, optical amplification of 12 dB is achieved, with a maximum power output of 0.75 W. The completed amplifier is installed into an existing MOT at Colby College, and its effect is analyzed in terms of the number density of trapped samples of rubidium-85. MOT measurements are given demonstrating an increase in these number densities by a factor of ten. We conclude with initial results to quantify the amplifier’s effect on the dynamics of ultra-cold plasmas created from the trapped atom samples.