Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

InTech eBooks

Quantum Noise in Optical Amplifiers

Kyo Inoue

Published Jul 25, 2018• 5 citations
Publisher

Abstract

Noise is one of the basic characteristics of optical amplifiers. Whereas there are various noise sources, the intrinsic one is quantum noise that originates from Heisenberg’s uncertainty principle. This chapter describes quantum noise in optical amplifiers, including population-inversion–based amplifiers such as an Erbium-doped fiber amplifier and a semiconductor optical amplifier, and optical parametric amplifiers. A full quantum mechanical treatment is developed based on Heisenberg equation of motion for quantum mechanical operators. The results provide the quantum mechanical basis for a classical picture of amplifier noise widely used in the optical communication field.

DOI
10.5772/intechopen.72992

Related papers

Optimum noise performance of optical amplifiers

H. A. Haus

The concept of noise figure F and noise measure M applicable to radio frequency and microwave amplifiers is reviewed and extended to cover optical amplifiers. Two noise figures are defined in the optical regime: one gives the ASE output, while the other gives the ratio of signal-to-noise ratios at the input and output. In the quantum regime, the lower limit on these optimum values is set by a generalization of Heisenberg's uncertainty relation. A Raman back-pumped fiber link with post-amplification with an erbium-doped fiber amplifier is used to illustrate the use of noise measure.

IEEE Journal of Quantum Electronics•Jun 1, 2001•16 citations

Quantum noise figure of fiber OPAs

M.E. Marhic

Introduction In previous chapters we studied wave propagation in fiber OPAs from a classical standpoint, i.e. starting from Maxwell's equations. That approach provides only a partial view of the rich nature of the electromagnetic field, namely its wave nature. However, a complete description of the electromagnetic field requires quantum mechanics. This quantum description of the electromagnetic field (called quantum electrodynamics, or QED) predicts fluctuations in measurable quantities due to the Heisenberg uncertainty principle and sets ultimate limits on the performance of devices such as optical amplifiers. A remarkable result of this theory is that the statistics and thus the noise performance of a system are affected by the quantum statistics of the source and by the physical measurement that is made. Thus a different analysis is needed depending on whether homodyne, heterodyne, or direct detection (where the field simply impinges on a photodiode) is used. Direct detection reveals the particle nature of the electromagnetic field. More specifically, energy arrives in discrete units, called photons, each of which may create an electron–hole pair in a semiconductor photodetector. In particular, the number of photons in an optical pulse can be thought of as a random variable having a mean and a variance. By deriving the mean and variance of the photocurrent that would be present if one performed direct detection of ideal laser light at the input of an optical amplifier and then a similar measurement at its exit, one can quantify the degradation of the signal-to-noise ratio (SNR) caused by the amplifier.

Cambridge University Press eBooks•Nov 15, 2007•0 citations

Quantum Mechanical Treatment of Optical Amplifiers Based on Population Inversion

Kyo Inoue

Optical amplification in a population-inverted medium is quantum-mechanically described, using the Heisenberg picture. Unlike conventional approaches that use a photon rate equation or a phenomenological field equation, the time evolution of the field operator, the photon number operator, and their squares are directly derived from first principles. The results give a logical theoretical base for the traditional phenomenological expressions describing quantum-mechanical characteristics of optical amplifiers.

IEEE Journal of Quantum Electronics•May 22, 2014•8 citations

Quantum noise in optical parametric amplifier based on a lossy nonlinear interferometer

Pape Maguette Sylla

Optical Parametric Amplifiers (OPA) have been of wide interest for the past decades due to their potential for low noise amplification and generation of squeezed light. However, the existing OPAs for fiber applications are based on Kerr effect and require from few centimeters to kilometers of fiber for significant gain. In this thesis, I review the principles of phase sensitive amplification and derive the expression for gain of a lossless Kerr medium based Nonlinear Mach-Zehnder Interferometer (NMZI OPA) using a classical physics model . Using quantum optics, I calculate the noise of a lossless Kerr medium based OPA and show that the noise figure can be close to zero. Since in real life a Kerr medium is lossy, using quantum electrodynamics, I derive equations for the evolution of a wave propagating in a lossy Kerr medium such as an optical fiber. I integrate these equations in order to obtain the parametric gain, the noise and the noise figure. I demonstrate that the noise figure has a simple expression as a function of loss coefficient and length of the Kerr medium and that the previously published results by a another research group are incorrect. I also develop a simple expression for the noise figure for high gain parametric amplifiers with distributed loss or gain. In order to enable construction of compact parametric amplifiers I consider using different nonlinear media, in particular a Saturable Absorber (SA) and a Semiconductor Optical Amplifier (SOA). Using published results on the noise from SOA I conclude that that such device would be prohibitively noisy. Therefore, I perform a detailed analysis of noise properties of a SA based parametric amplifier. Using a quantum mechanical model of an atomic 3 level system and the Heisenberg's equations, I analyze the evolution in time of a single mode coherent optical wave interacting with a saturable absorber. I solve the simultaneous differential equations and find the expression for the noise figure of the SA based NMZI OPA. The results show that noise figure is still undesirably high. The source of the noise is identified. A new approach for low noise parametric amplifier operating with short pulses is proposed.

•Jan 1, 2009•0 citations

Optical Amplifiers

Shiva Kumar, M. Jamal Deen

This chapter focuses mainly on three types of optical amplifiers: (1) the semiconductor optical amplifier (SOA), (2) the erbium-doped fibers amplifier, and (3) the Raman amplifier. In each case, the physical principles, governing equations, noise amplifications, and practical applications are discussed. The chapter considers a simple amplifier model in which the amplifier magnifies the input power by a factor of G and adds white noise. Impact of amplified spontaneous emission (ASE) noise in two-level systems is also discussed.

Wiley eBooks•Apr 11, 2014•0 citations

Phase noise in traveling-wave inverted-population-type optical amplifiers

Lars Thylen, Anders Karlsson, T. Kenneth Gustafson +1 more

The Heisenberg equations of motion are used to calculate the phase noise of inverted-population-type traveling-wave laser amplifiers generally and semiconductor amplifiers specifically. Agreement with previously reported results in the limit of perfect inversion is demonstrated.

Journal of the Optical Society of America B•Mar 1, 1992•4 citations
Noise is one of the basic characteristics of optical amplifiers. Whereas there are various noise sources, the intrinsic one is quantum noise that originates from Heisenberg’s uncertainty principle. This chapter describes quantum noise in optical amplifiers, including population-inversion–based amplifiers such as an Erbium-doped fiber amplifier and a semiconductor optical amplifier, and optical parametric amplifiers. A full quantum mechanical treatment is developed based on Heisenberg equation of motion for quantum mechanical operators. The results provide the quantum mechanical basis for a classical picture of amplifier noise widely used in the optical communication field.
The concept of noise figure F and noise measure M applicable to radio frequency and microwave amplifiers is reviewed and extended to cover optical amplifiers. Two noise figures are defined in the optical regime: one gives the ASE output, while the other gives the ratio of signal-to-noise ratios at the input and output. In the quantum regime, the lower limit on these optimum values is set by a generalization of Heisenberg's uncertainty relation. A Raman back-pumped fiber link with post-amplification with an erbium-doped fiber amplifier is used to illustrate the use of noise measure.
Introduction In previous chapters we studied wave propagation in fiber OPAs from a classical standpoint, i.e. starting from Maxwell's equations. That approach provides only a partial view of the rich nature of the electromagnetic field, namely its wave nature. However, a complete description of the electromagnetic field requires quantum mechanics. This quantum description of the electromagnetic field (called quantum electrodynamics, or QED) predicts fluctuations in measurable quantities due to the Heisenberg uncertainty principle and sets ultimate limits on the performance of devices such as optical amplifiers. A remarkable result of this theory is that the statistics and thus the noise performance of a system are affected by the quantum statistics of the source and by the physical measurement that is made. Thus a different analysis is needed depending on whether homodyne, heterodyne, or direct detection (where the field simply impinges on a photodiode) is used. Direct detection reveals the particle nature of the electromagnetic field. More specifically, energy arrives in discrete units, called photons, each of which may create an electron–hole pair in a semiconductor photodetector. In particular, the number of photons in an optical pulse can be thought of as a random variable having a mean and a variance. By deriving the mean and variance of the photocurrent that would be present if one performed direct detection of ideal laser light at the input of an optical amplifier and then a similar measurement at its exit, one can quantify the degradation of the signal-to-noise ratio (SNR) caused by the amplifier.
Optical amplification in a population-inverted medium is quantum-mechanically described, using the Heisenberg picture. Unlike conventional approaches that use a photon rate equation or a phenomenological field equation, the time evolution of the field operator, the photon number operator, and their squares are directly derived from first principles. The results give a logical theoretical base for the traditional phenomenological expressions describing quantum-mechanical characteristics of optical amplifiers.
Optical Parametric Amplifiers (OPA) have been of wide interest for the past decades due to their potential for low noise amplification and generation of squeezed light. However, the existing OPAs for fiber applications are based on Kerr effect and require from few centimeters to kilometers of fiber for significant gain. In this thesis, I review the principles of phase sensitive amplification and derive the expression for gain of a lossless Kerr medium based Nonlinear Mach-Zehnder Interferometer (NMZI OPA) using a classical physics model . Using quantum optics, I calculate the noise of a lossless Kerr medium based OPA and show that the noise figure can be close to zero. Since in real life a Kerr medium is lossy, using quantum electrodynamics, I derive equations for the evolution of a wave propagating in a lossy Kerr medium such as an optical fiber. I integrate these equations in order to obtain the parametric gain, the noise and the noise figure. I demonstrate that the noise figure has a simple expression as a function of loss coefficient and length of the Kerr medium and that the previously published results by a another research group are incorrect. I also develop a simple expression for the noise figure for high gain parametric amplifiers with distributed loss or gain. In order to enable construction of compact parametric amplifiers I consider using different nonlinear media, in particular a Saturable Absorber (SA) and a Semiconductor Optical Amplifier (SOA). Using published results on the noise from SOA I conclude that that such device would be prohibitively noisy. Therefore, I perform a detailed analysis of noise properties of a SA based parametric amplifier. Using a quantum mechanical model of an atomic 3 level system and the Heisenberg's equations, I analyze the evolution in time of a single mode coherent optical wave interacting with a saturable absorber. I solve the simultaneous differential equations and find the expression for the noise figure of the SA based NMZI OPA. The results show that noise figure is still undesirably high. The source of the noise is identified. A new approach for low noise parametric amplifier operating with short pulses is proposed.
This chapter focuses mainly on three types of optical amplifiers: (1) the semiconductor optical amplifier (SOA), (2) the erbium-doped fibers amplifier, and (3) the Raman amplifier. In each case, the physical principles, governing equations, noise amplifications, and practical applications are discussed. The chapter considers a simple amplifier model in which the amplifier magnifies the input power by a factor of G and adds white noise. Impact of amplified spontaneous emission (ASE) noise in two-level systems is also discussed.