In this thesis work, the quantum behavior of a superconducting circuit implementing a quantum bit or qubit is studied. With the use of resonant microwave pulses the full manipulation of the quantum state of this system is demonstrated: any rotation of the state vector around the Bloch sphere can be achieved and by using particular NMR inspired sequences of microwave pulses, the robustness of an operation against particular types of errors, like slow fluctuations of the transition frequency of the qubit, can be improved. The phenomenon of decoherence which drives the system from a quantum behavior to a classical one, has been characterized in the free evolution regime. By properly tuning the working point in the external parameter space, the qubit can be decoupled to first order from the fluctuations of its environment, thus enhancing coherence. In these optimal conditions, low frequency charge noise probably of microscopic origin appears to be the limiting source of decoherence for our system. The study of decoherence during driven evolution demonstrated that by suppressing the effect of those fluctuations of the environment slower than that of the driving field, the coherence of the qubit can be improved. Finally a new non-dissipative readout method based on microwave reflectometry has been set up, which improves the sensitivity and could in principle lead to a non-demolition measurement of the qubit state.
In this thesis work, the quantum behavior of a superconducting circuit implementing a quantum bit or qubit is studied. With the use of resonant microwave pulses the full manipulation of the quantum state of this system is demonstrated: any rotation of the state vector around the Bloch sphere can be achieved and by using particular NMR inspired sequences of microwave pulses, the robustness of an operation against particular types of errors, like slow fluctuations of the transition frequency of the qubit, can be improved. The phenomenon of decoherence which drives the system from a quantum behavior to a classical one, has been characterized in the free evolution regime. By properly tuning the working point in the external parameter space, the qubit can be decoupled to first order from the fluctuations of its environment, thus enhancing coherence. In these optimal conditions, low frequency charge noise probably of microscopic origin appears to be the limiting source of decoherence for our system. The study of decoherence during driven evolution demonstrated that by suppressing the effect of those fluctuations of the environment slower than that of the driving field, the coherence of the qubit can be improved. Finally a new non-dissipative readout method based on microwave reflectometry has been set up, which improves the sensitivity and could in principle lead to a non-demolition measurement of the qubit state.
This article reviews recent progress in superconducting quantum bits, including major improvements in design and coherence times. It first provides an overview of the basics of modern superconducting qubit devices and their architectures before turning to single-qubit Hamiltonians and reference frames. It then examines how decoherence originates with noise and shows how to characterize and mitigate this noise using magnetic-resonance-type pulse sequences. It also describes the first-generation superconducting qubits and the now-dominant circuit-quantum electrodynamics architecture in which qubits are coupled to microwave resonators. Finally, it considers several improved designs of superconducting qubits in which coherence times have been significantly improved by minimizing the sensitivity to fluctuating impurities and the coupling to external modes.
Quantum information processing holds the promise of a paradigm shift in computational power for specific problem classes. While contemporary quantum processors operate in the Noisy Intermediate-Scale Quantum (NISQ) regime and remain highly susceptible to errors, ongoing experimental efforts on these near-term devices are crucial for advancing the underlying technology. Among the various hardware implementations, superconducting quantum circuits stand out as one of the most robust architectures for scalable quantum technologies. Nevertheless, the primary bottleneck in these systems is the fragility of quantum information: interactions with the environment inevitably perturb the quantum states, a phenomenon known as decoherence. This rapid loss of stored information imposes a fundamental limit on the time available to reliably execute computations on these devices. Within this context, this thesis focuses on the comprehensive experimental characterization of a planar chip featuring isolated, fixed-frequency superconducting transmon qubits. The measurements were conducted in a cryogenic environment, relying on a dilution refrigerator to maintain the device at millikelvin temperatures. To probe the quantum system under these conditions, custom measurement scripts were developed to operate state-of-the-art microwave control electronics (Keysight Quantum Control System), establishing full control over pulse generation, signal acquisition, and digital demodulation. The experimental workflow systematically mapped the physical properties of the device through a progressive series of characterization steps. Initial spectroscopic techniques probed the coupled resonator-qubit system, identifying its fundamental transition frequencies and relevant energy scales. Building upon these frequency-domain measurements, coherent control was achieved by calibrating resonant microwave pulses to drive single-qubit rotations, enabling the reliable preparation of the qubit in excited or coherent superposition states. Finally, specific time-domain protocols were implemented to evaluate the operational limits of the device. By executing standard pulse sequences, the characteristic decoherence metrics of the system, namely the longitudinal energy relaxation time (T1) and the inhomogeneous dephasing time (T2*), were successfully extracted, providing a quantitative assessment of the qubit's overall performance and establishing a baseline for future implementations of more advanced quantum control protocols.
This thesis discusses a series of experimental and theoretical studies on fast control and decoherence in superconducting quantum circuits. These two subjects are complementary aspects of the problem of improving the gate fidelities in quantum information processing devices based on superconducting circuits. \n \nIn the first part of this thesis, we present experiments on fast control of a superconducting flux qubit using strong driving. We explore driving with short pulses and a driving strength significantly exceeding the transition frequency. The observed dynamics is described in terms of quasienergies and quasienergy states, in agreement with Floquet theory. We observe the role of pulse shaping in the dynamics, as determined by non-adiabatic transitions between Floquet states. In addition, based on adiabatic perturbation theory in the Floquet picture, we propose a control scheme for fast and high-fidelity single-qubit operations with strong driving. These results pave the way to quantum control with a fidelity beyond the threshold of fault-tolerant quantum computation. \n \nIn the second part of this thesis, we discuss experimental methods and present the characterization of decoherence in superconducting resonators and superconducting qubits. Firstly, we present an analysis method on the measurements of photon loss in superconducting resonators. We use this method to characterize the microwave loss of aluminum oxide, an important material in superconducting circuits. The power and temperature dependence of the measured loss is consistent with loss due to two-level defects in amorphous materials. Secondly, we present experimental results on decoherence and noise spectroscopy of a superconducting flux qubit. Using the qubit as a noise spectrometer, we perform detailed measurements on the power spectral density of the flux noise in superconducting circuits over a wide range of frequencies, from 10^-3 to 10^8 Hz, and over a temperature range from 35 to 130 mK. We also present measurements of frequency and temperature dependence of the qubit energy relaxation.
Real-time monitoring of a quantum state provides powerful tools for studying the backaction of quantum measurement and performing quantum feedback. Historically, this monitoring capability has been the exclusive province of atomic and optical physics. This thesis describes the implementation of the first such high-fidelity readout scheme in a solid state circuit, a superconducting quantum bit (qubit) coupled to a microwave cavity in the circuit quantum electrodynamics (circuit QED) architecture. The qubit-state-dependent resonance frequency of the cavity is probed with a microwave drive tone, and the resulting signal amplified using a fast, ultralow-noise superconducting parametric amplifier. This arrangement enables the observation of quantum jumps between the qubit states in real time. The ability to monitor the qubit continuously with high fidelity and resolve quantum jumps can be used to investigate the backaction of the measurement process on the qubit. This thesis examines the quantum Zeno effect--where strong measurement inhibits the evolution of a quantum system-- as well as the transition to non-ideal measurement with increasing measurement strength in the circuit QED architecture, a phenomenon shown to be due to the upconversion of low-frequency dephasing noise. These data allow probes of ``universal'' flux noise in previously inaccessible frequency ranges. The work presented here opens the door for quantum feedback and error correction in solid-state quantum systems using continuous weak measurement.
In a quantum computer, the information carriers, which are bits in ordinary computers, are implemented as devices that exhibit coherent superpositions of physical states and entanglement. Such components, known as quantum bits or qubits, can be realized with various different types of two-state quantum systems. Quantum computers will be built for computational speed, with hoped for applications especially in cryptography and in other tasks where classical computers remain inefficient. Circuit quantum electrodynamics (cQED) is a quantum-computer architecture which employs superconducting electronic components and microwave photon fields as building blocks. Compared to cavity quantum electrodynamics (CQED), where atoms are trapped in physical cavities, cQED is more attractive in that its qubits are tunable and conveniently integrable with the electronics already in use. This architecture has shown some of the most promising qubit designs, despite their coherence times reaching tens of microseconds, are still below the state of the art with spin qubits, which reach milliseconds. Coherence times are historically the most relevant parameters describing the fitness of a qubit, although these days not necessarily the limiting factor. This thesis presents a comprehensive set of theoretical and experimental methods for measuring the characteristic parameters of superconducting qubits. We especially study transmission-line-shunted plasma oscillation qubits, or transmons, and presents experimental results for a single sample. Transmon capacitively couples a superconducting quantum interference device (SQUID) with a coplanar waveguide (CPW) resonator, often with added frequency tunability utilizing an external magnet. The number of superconducting charge carriers tunnelled through a junction in the SQUID are used as qubit degrees of freedom. Readout of the qubit state is carried out by measuring transmission through the CPW. A cryogenic setup is employed with measurement and driving pulses delivered from microwave sources. Steady-state spectroscopy is employed to determine the resonance frequencies of the qubit and the resonator, qubit-resonator coupling constants, and the energy parameters of the qubit. Pulse-modulated measurements are employed to determine the coherence times of the qubit. The related analysis- and simulation programs and scripts are collected togithub.com/patomaki.
Circuit quantum electrodynamics (cQED), exemplified by a coupled system of a superconducting qubit and a microwave cavity, is a powerful framework for the quantum control and measurement of macroscopic quantum states in solid-state circuits. Quantum circuits based on superconducting qubits have emerged as one of the leading platforms in the pursuit of fault-tolerant quantum computing. Despite significant progress in extending qubit lifetimes, refining experimental protocols, and scaling up quantum processors, errors arising from the control and measurement of superconducting qubits continue to hinder the realization of a universal quantum computer. To investigate the error mechanisms for state-of-the-art qubits, we realize long-lived superconducting transmon qubits that exhibit fluctuating lifetimes, with an average of 0.2 ms and a maximum exceeding 0.4 ms. We then investigate their dominant error mechanism. By introducing novel time-resolved error measurements that are synchronized with the operation of the pulse tube cooler in a dilution refrigerator, we find that mechanical vibrations from the pulse tube induce nonequilibrium dynamics in highly coherent qubits, leading to their correlated bit-flip errors. Our findings not only deepen our understanding of qubit error mechanisms but also provide valuable insights into potential error-mitigation strategies for achieving fault tolerance by decoupling superconducting qubits from their mechanical environments. We also present a novel scheme for operating a cQED system in a regime where the cavity is largely displaced. We find that a qubit drive at the bare cavity frequency can effectively displace the cavity field while minimizing the cavity-drive-induced dephasing and the ac Stark shift. Furthermore, we demonstrate that standard cQED protocols, such as qubit control, readout, and cavity single-photon generation, remain compatible with largely displaced cavity fields, even beyond the critical photon number. These findings open new pathways for exploring cQED dynamics in large-photon-number regimes, including the study of nonlinear phenomena in microwave cavities, the saturation of two-level system baths for extending the coherence of microwave quantum states, and the acceleration of the dispersive readout. Finally, mechanical resonators have emerged as integral components in quantum computing for storing and transducing quantum information. Low-frequency mechanical resonators, with extremely low energy dissipation rates, are particularly interesting for extending the lifetimes of stored quantum information. However, integrating low-frequency mechanical resonators with qubits is challenging because their small energy gaps make coherent energy exchange and ground-state preparation difficult. In this thesis, we report the first steps towards the characterization of a hybrid quantum device, consisting of a Transmon qubit and a circuit optomechanical system, both coupled to a 3D microwave cavity.