This work presents a comprehensive investigation of the influence of geometry-dependent factors on performance metrics of superconducting single-photon detectors. With fundamental knowledge, main investigations are focused to extend the spectral bandwidth and to enhance the detection efficiency, especially in infrared range. The developed technology of single-spiral detectors and unconventional electron-beam lithography allows to improve the performance of superconducting detectors.
This work presents a comprehensive investigation of the influence of geometry-dependent factors on performance metrics of superconducting single-photon detectors. With fundamental knowledge, main investigations are focused to extend the spectral bandwidth and to enhance the detection efficiency, especially in infrared range. The developed technology of single-spiral detectors and unconventional electron-beam lithography allows to improve the performance of superconducting detectors.
The important development of quantum technologies during the past decade brought the need for efficient, fast and precise single-photon detection. Superconducting Nanowire Single-Photon Detectors (SNSPDs) are currently considered as the detection method of choice when extreme performances are required. This thesis aimed at investigating this technology, with the objective of improving existing detectors for high-rate applications in quantum communication. This document presents the work and result achieved over four years dedicated to the subject. During this thesis, single-photon detection based on superconducting nanowire has been investigated, with a particular focus on specific requirements for high speed quantum communication applications. The work achieved ranges from the design and nano-fabrication of the structures, to the characterization and the understanding of the physics, detection models and fundamental limits of the devices.
Superconducting Nanowire Single-Photon Detectors offer the capability to detect electromagnetic waves on a single photon level in a wavelength range that far exceeds that of alternative detector types. However, above a certain threshold wavelength, the efficiency of those detectors decreases stronlgy, leading to a poor performance in the far-infrared range. Influences on this threshold are studied and approaches for improvement are verified experimentally by measurement of the device performance.
Superconducting Nanowire Single-Photon Detectors (SNSPDs) are the premier single-photon counting technology in the near-infrared regime. Operating via a photon-induced phase transition from the superconducting to the normal state, SNSPDs act as highly sensitive digital detectors that now play a critical role in quantum communication, deep-space optical communications, and direct dark matter detection. As the demand for these detectors scales, there is a pressing need to extend their performance capabilities toward longer wavelengths, larger active areas, and higher operating temperatures. However, advancing these metrics requires navigating complex physical trade-offs inherent to the detection mechanism. This thesis explores the material optimizations, novel detector architectures, and fundamental device physics required to push SNSPD technology beyond its current limits. The first thrust of this work focuses on extending SNSPD sensitivity into the mid-infrared (MIR) and far-infrared regimes. By developing a low-Tc (sub-1 K) WSi film engineered to reduce the characteristic detection energy, the threshold for long-wavelength detection is significantly lowered. Coupled with a novel detector architecture utilizing impedance-matching tapers and superconducting nanowire avalanche photon detectors (SNAPs), sensitivity is initially demonstrated at wavelengths up to 29um using a blackbody thermal source. Expanding beyond this limit, the implementation of quantum cascade lasers enables the demonstration of single-photon counting at wavelengths up to 88um, marking a major improvement over the current state of the art. To address the practical MIR detection challenges of low signal-to-noise ratio and restricted fill factors, this work also demonstrates a 1 mm x 1mm array of superconducting microwire single-photon detectors (SMSPDs) sensitive out to 3.7um, establishing a pathway for future antenna-coupled detectors. The second thrust investigates the development of micrometer-scale wires to simultaneously increase active area and operating temperature. Moving to microwire geometries raises fundamental questions regarding intrinsic detection mechanisms. Using a scanning lens setup, this work demonstrates the first direct observation of transverse coordinate effects in microwires, where the precise location of photon incidence across the wire width significantly alters the detector's slew rate and timing performance. To counteract this, new rectification schemes are introduced to produce a more uniform detection landscape. Specifically, the integration of a superconducting rail alongside the main detector is shown to successfully mitigate the transverse coordinate effect, improve timing performance, and increase the viable operating temperature of the detector. The third thrust explores the use of unconventional superconductors, namely MgB2 to achieve an appreciably higher-temperature single-photon detection pathway. This section details the distinct challenges associated with the growth and fabrication of detectors using air-sensitive materials and evaluates their long-term viability for the SNSPD platform. Ultimately, this thesis highlights the critical material and architectural parameters required to advance the field of single-photon detection. By elucidating the metrics and mechanisms that govern ideal detector performance, this work aims to broaden the understanding and future application of SNSPDs across diverse scientific disciplines. All the data presented here is my own unless otherwise mentioned.
Superconducting nanowire single-photon detectors (SNSPDs) are important in quantum optics, secure communication, and even medical imaging. An SNSPD exhibits higher detection efficiency when a photon is absorbed near the edge of its wire, rather than in the middle. Combining insight from superconductor physics with nanophotonics, the authors show how to concentrate incident light on the edges of the nanowire, to enhance the efficiency and speed of next-generation detectors. This is expected to be particularly useful in the infrared range, for which there is presently no alternative SPD technology.
We investigate the detection efficiency of a spiral layout of a superconducting nanowire single-photon detector. The design is less susceptible to the critical current reduction in sharp turns of the nanowire than the conventional meander design. Detector samples with different nanowire widths from 100 to 300 nm are patterned from a 4-nm-thick NbN film deposited on sapphire substrates. The critical current ICat 4.2 K for spiral, meander, and single-bridge structures is measured and compared. On the 100-nm-wide samples, the detection efficiency is measured in the wavelength range 400-1700 nm and the spectral bandwidth of the intrinsic detection efficiency is determined. In the optical range, the spiral detector reaches a detection efficiency of 27.6%, which is ~ 1.5 times the value of the meander. In the infrared range the detection efficiency of the spiral superconducting nanowire single-photon detector is more than doubled.
We present an overview of recent results for new generation of infrared and optical superconducting nanowire single-photon detectors (SNSPDs) that has already demonstrated a performance that makes them devices-of-choice for many applications. SNSPDs provide high efficiency for detecting individual photons while keeping dark counts and timing jitter minimal. Besides superior detection performance over a broad optical bandwidth, SNSPDs are also compatible with an integrated optical platform as a crucial requirement for applications in emerging quantum photonic technologies. By embedding SNSPDs in nanophotonic circuits we realize waveguide integrated single photon detectors which unite all desirable detector properties in a single device.