Macroscopic quantum tunneling is a process by which a macroscopic object, rather than a single electron, tunnels between two macroscopically distinct quantum states. In this dissertation, we will present the study of macroscopic quantum tunneling of phase-slips in superconducting devices, including one-dimensional nanowires, quasi-two-dimensional superconducting strips and doubly connected superconducting devices composed of two nanowires connected in parallel. We observe macroscopic quantum tunneling in these devices by measuring switching current distributions. It is known that the standard deviation of switching current distributions can be measured on a single nanowire to reveal temperatures at which macroscopic quantum tunneling is responsible for phase-slips. Therefore we begin by studying higher moments of the switching current distributions, namely the skewness S (a measure of the asymmetry of a distribution) and kurtosis K (a measure of its peakedness). We find that the skewness and kurtosis of the switching current distributions obtained via the Kurkijarvi process on devices composed of single nanowires do not depend on whether the switching events are initiated by quantum or thermal phase-slips. Skewness and kurtosis deviate considerably from the values associated with a Gaussian distribution (S=0 and K=3). If, in an experiment these higher moments approach Gaussian values they indicate the existence of noise. Next we study macroscopic quantum tunneling of phase-slips in quasi-two-dimensional superconducting strips, which are commercially available devices used as single-photon detectors. These devices are composed of (250 um) long, (120 nm) wide, meandering superconducting strips. Each time a photon with sufficient energy strikes the strip a voltage pulse is produced and counted. However, the accuracy of these detectors is limited by a rate of dark counts (false events). We find that at sufficiently low temperatures, the macroscopic quantum tunneling of a vortex through an edge barrier on the wire (which results in a phase-slip as the vortex crosses the wide wire) contributes a base-level dark count rate in these detectors which must be considered during operation at low enough temperatures. After studying tunneling in single one-dimensional nanowires and wide, quasi-two-dimensional strips, we move our focus to doubly connected superconducting samples composed of two nanowires connected in parallel. We characterize and model these devices, and show their applicability as nanometer-scale superconducting memory cells. We develop precise algorithms allowing us to write and read the information onto such memory cells. We also observe signatures of macroscopic quantum tunneling in these doubly connected devices by observing a saturation in the standard deviation of switching current distributions at low temperatures. We then discuss how macroscopic quantum tunneling of the memory state can lead to a dissipationless operation of the superconducting memory cell. In each of these devices, whether single one-dimensional nanowires, wide quasi-two-dimensional superconducting strips, or two nanowires in parallel, we find, quite surprisingly, that the same equations can be used to model macroscopic quantum tunneling at the high currents we apply. Therefore we argue that the physics of macroscopic quantum tunneling in wide quasi-two-dimensional strips and doubly connected nanowire devices can be well understood in the context of tunneling in a single, one-dimensional nanowire.
Macroscopic quantum tunneling is a process by which a macroscopic object, rather than a single electron, tunnels between two macroscopically distinct quantum states. In this dissertation, we will present the study of macroscopic quantum tunneling of phase-slips in superconducting devices, including one-dimensional nanowires, quasi-two-dimensional superconducting strips and doubly connected superconducting devices composed of two nanowires connected in parallel. We observe macroscopic quantum tunneling in these devices by measuring switching current distributions. It is known that the standard deviation of switching current distributions can be measured on a single nanowire to reveal temperatures at which macroscopic quantum tunneling is responsible for phase-slips. Therefore we begin by studying higher moments of the switching current distributions, namely the skewness S (a measure of the asymmetry of a distribution) and kurtosis K (a measure of its peakedness). We find that the skewness and kurtosis of the switching current distributions obtained via the Kurkijarvi process on devices composed of single nanowires do not depend on whether the switching events are initiated by quantum or thermal phase-slips. Skewness and kurtosis deviate considerably from the values associated with a Gaussian distribution (S=0 and K=3). If, in an experiment these higher moments approach Gaussian values they indicate the existence of noise. Next we study macroscopic quantum tunneling of phase-slips in quasi-two-dimensional superconducting strips, which are commercially available devices used as single-photon detectors. These devices are composed of (250 um) long, (120 nm) wide, meandering superconducting strips. Each time a photon with sufficient energy strikes the strip a voltage pulse is produced and counted. However, the accuracy of these detectors is limited by a rate of dark counts (false events). We find that at sufficiently low temperatures, the macroscopic quantum tunneling of a vortex through an edge barrier on the wire (which results in a phase-slip as the vortex crosses the wide wire) contributes a base-level dark count rate in these detectors which must be considered during operation at low enough temperatures. After studying tunneling in single one-dimensional nanowires and wide, quasi-two-dimensional strips, we move our focus to doubly connected superconducting samples composed of two nanowires connected in parallel. We characterize and model these devices, and show their applicability as nanometer-scale superconducting memory cells. We develop precise algorithms allowing us to write and read the information onto such memory cells. We also observe signatures of macroscopic quantum tunneling in these doubly connected devices by observing a saturation in the standard deviation of switching current distributions at low temperatures. We then discuss how macroscopic quantum tunneling of the memory state can lead to a dissipationless operation of the superconducting memory cell. In each of these devices, whether single one-dimensional nanowires, wide quasi-two-dimensional superconducting strips, or two nanowires in parallel, we find, quite surprisingly, that the same equations can be used to model macroscopic quantum tunneling at the high currents we apply. Therefore we argue that the physics of macroscopic quantum tunneling in wide quasi-two-dimensional strips and doubly connected nanowire devices can be well understood in the context of tunneling in a single, one-dimensional nanowire.
In quasi-one-dimensional nanowires, superconductivity is destroyed by phase slip events. Phase slips can be caused by thermal activation over a free energy barrier (TAPS) or quantum tunneling through the barrier (QPS). Quantum phase slip is an example of macroscopic quantum tunneling. Here, we report the observation of QPS experimentally separated from interference of TAPS in aluminum nanowires. This separation between the low-temperature QPS and the high-temperature TAPS regions is made possible by a phase slip free superconducting region stabilized by the dissipative environment viz. the normal electrodes. Individual QPSs are detected by means of a single-shot voltage measurement protocol, in which they appear as stochastic switching events from the superconducting to the normal state.
We perform measurements of the switching current distributions of three w ≈ 120 nm wide, 4 nm thick NbN superconducting strips which are used for single-photon detectors. These strips are much wider than the diameter of the vortex cores, so they are classified as quasi-two-dimensional (quasi-2D). We discover evidence of macroscopic quantum tunneling by observing the saturation of the standard deviation of the switching distributions at temperatures around 2 K. We analyze our results using the Kurkijärvi-Garg model and find that the escape temperature also saturates at low temperatures, confirming that at sufficiently low temperatures, macroscopic quantum tunneling is possible in quasi-2D strips and can contribute to dark counts observed in single photon detectors. At the highest temperatures the system enters a multiple phase-slip regime. In this range single phase-slips are unable to produce dark counts and the fluctuations in the switching current are reduced.
Abstract Quantum phase slip (QPS) is the fundamental manifestation of macroscopic quantum tunneling (MQT). We measure the distribution of the switching current I sw in quasi-one-dimensional superconducting NbN nanowires in the temperature range of 0.2–5.1 K. The escape temperature T esc extracted from the I sw distributions exhibits saturation at temperatures below 1.2 K, indicating a transition into the MQT state. We investigate the single-photon response of the nanowire and find that the QPS rate increases with incident light power in the MQT state. We propose the photon-enhanced quantum phase-slip model, which establishes a quantitative relationship between the quantum phase-slip rate and the incident photon energy, generalizing the phase-slip dynamics into the photon-induced non-equilibrium MQT regime.
Quantum phase slips (QPS) or the macroscopic quantum tunneling (MQT) of a nanowire’s order parameter through an activation energy barrier have remained the subject of intense debate for many years. They are expected to occur at low enough temperature where thermally activated phase slips (TAPS) have been frozen out in analogy with Josephson junctions where the macroscopic tunneling of phase at low temperatures has been conclusively experimentally demonstrated. We address this question by following a similar experimental strategy to that employed for establishing MQT in JJs. By measuring switching current distributions, we can probe the phase slip rate and determine if it corresponds to thermal activation or quantum tunneling. Having established that the behavior we see is consistent with being in the quantum regime, we can alter properties of the nanowires and see if the response is consistent with the expectations of the quantum model. To do this we employ an in-situ modification technique using high bias voltage pulses. Using these pulses, we can change resistance, critical temperature, critical current and morphology of the nanowire. We can also change the shunting capacitance of the nanowire by altering the photolithography step used to create the nanowires electrodes. The resulting response of the nanowires agrees well with being in the quantum tunneling dominated regime. An interesting side benefit of the pulsing technique is that we can exactly set the nanowires switching current to a desired value. This may be instrumental in the development of superconducting nanowire qubits.
The topic of superconducting nanowires has recently been an interesting field of research which has included the study of the superconductor to insulator transition (SIT), the observation of macroscopic quantum behavior such as quantum phase slips (QPS), and the potential use of nanowires as qubits. Superconducting coplanar microwave waveguide resonators have also become a popular way of studying superconducting junctions and qubits, as they provide an extremely low noise environment. For example, superconducting two-dimensional Fabry-Perot resonators have been used by other groups to make non-demolition measurements of a qubit. The motivation of this thesis will be the merging of the fields of superconducting nanowires and the technique of using superconducting microwave resonators to study junctions by incorporating a nanowire into the resonator itself at a current anti-node. By doing this, the nonlinear effects of the nanowire can be studied which may find application in single photon detectors, mixers, and the readout of qubits. We also employ the technique of molecular templating to fabricate some of the thinnest superconducting nanowires ever studied (down to ~ 5 nm in diameter in some cases). In this thesis, we extend the understanding of the nonlinear properties of a nanowire- resonator system and investigate a new type of nonlinearity that involves a pulsing regime between the superconducting and normal phases of the nanowire. We develop a model, which describes the results quantitatively and by modeling the system, we are able to extract information regarding the relaxation time of the nanowire back into the superconducting state. We also study double nanowire-resonator systems where two closely spaced parallel nanowires interrupt the resonator center conductor and form a loop where vortex tunneling processes can occur. Using a double nanowire-resonator we are able to observe the Little-Parks effect at low temperatures (where the resistance of the wires is immeasurably low) and are able to confirm the multivalued nature of the current phase relationship (CPR) in nanowires. Additionally, we observe an anomalous transmission regime where the periodic pulsing is replaced by stochastic amplitude fluctuations. In addition to microwave measurements on nanowires, we also study the normal state in resistively shunted nanowires with dc measurements where the inclusion of a shunt resistor is observed to change the nature of the normal state from the Joule heated state to a state that preserves phase coherence. Finally, the statistics on switching current events in graphene proximity junctions are analyzed and compared to the well known results for Josephson junctions. Only thermal activation (and no macroscopic quantum tunneling) is observed in graphene proximity superconducting junctions down to temperatures of ~ 300 mK.
Superconducting circuits combine zero electrical resistance with macroscopic quantum coherence, making them a versatile platform for both fundamental studies and technological applications. Modern thin-film deposition and lithography allow precise control over geometry, material composition, and dimensional scales, enabling the fabrication of complex superconducting structures with tailored properties. These capabilities give access to phenomena not achievable with conventional electronic components, establishing superconducting circuits as a unique tool for exploring quantum physics and developing devices with unique functionalities. In superconducting rings, macroscopic quantum coherence manifests as discrete circulating currents. Fluxoid quantization restricts these currents to discrete winding states. Transitions between winding states occur via phase-slip events. A phase slip event requires overcoming an energy barrier, which can be crossed either through thermal activation, resulting in thermally activated phase slips (TAPS), or via quantum tunneling, resulting in quantum phase slips (QPS) that have no classical analogue. Both processes depend sensitively on temperature, loop geometry, material properties, and the intrinsic properties of the superconductor. Embedding weak links or nanowires in a superconducting ring provides localized regions where phase slips preferentially occur, enabling controlled TAPS and QPS dynamics. When the QPS rate becomes sufficiently high, coherent tunneling between neighboring winding states generates an energy splitting, forming the basis of qubit states. The discrete winding states can thus be exploited for device applications: serving as robust memory elements when the energy barrier is high and phase slips are rare and well controlled, and as qubits when coherent quantum phase slips allow the system to occupy superpositions of distinct winding states, marking the transition from a classical bit to a quantum bit. Phase-slip dynamics in superconducting rings have traditionally been studied using switching-current measurements, in which the bias current is ramped until the ring or nanowire becomes resistive. While this approach provides statistical information about phase-slip rates, it is inherently dissipative and cannot detect events that do not drive the system in the normal state, leaving many phase slips hidden and preventing their unambiguous classification by origin or rate.This thesis develops a non-invasive, radio-frequency resonator-based platform for studying phase-slip dynamics in superconducting rings. Building on magnetooptical imaging of flux penetration in superconducting resonators, we first established methods to apply a local magnetic field to a loop without perturbing the resonator and couple it to the resonator, linking changes in circulating currents to shifts in the resonance frequency. This enabled continuous, timeresolved detection of individual phase-slip events on microsecond-to-nanosecond timescales. Using this platform, we systematically investigated how loop geometry, weak-link properties, kinetic inductance, and temperature govern phase-slip rates and dynamics. Deterministic control of discrete winding states in high-kinetic-inductance aluminum loops, our chosen material platform, was demonstrated, realizing a superconducting memory based on fluxoid quantization. By progressively reducing loop dimensions and introducing weak links, we observed quantum phase-slip events at millikelvin temperatures, providing the first experimental signatures of coherent tunneling between winding states, a first step toward realizing phase-slip-based qubits. Collectively, these results establish a robust experimental pathway from conventional DC measurements to non-invasive RF probing, provide a framework for controlled studies of superconducting phase-slip dynamics, and open the door to exploring and utilizing coherent phase slips in circuit-QED-compatible architectures with device geometries that are simple and easy to fabricate.