Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Subwavelength optical lithography via classical light: A possible implementation

Jieyu You, Zeyang Liao, Philip Hemmer, Muhammad Suhail Zubairy

Published Apr 6, 2018• 5 citations
Publisher

Abstract

The resolution of an interferometric optical lithography system is about the half wavelength of the illumination light. We proposed a method based on Doppleron resonance to achieve a resolution beyond half wavelength [Phys. Rev. Lett. 96, 163603 (2006)]. Here, we analyze a possible experimental demonstration of this method in the negatively charged silicon-vacancy (${\mathrm{SiV}}^{\ensuremath{-}}$) system by considering realistic experimental parameters. Our results show that quarter wavelength resolution and beyond can be achieved in this system even in room temperature without using perturbation theory.

DOI
10.1103/physreva.97.043807

Related papers

Quantum lithography with classical light

Wenchao Ge, Philip Hemmer, Muhammad Suhail Zubairy

The concept of performing quantum lithography with classical, instead of entangled, light is of great interest for practical implementation. One recent proposal [Hemmer, Muthukrishnan, Scully, and Zubairy, Phys. Rev. Lett. 96, 163603 (2006)] to accomplish this was based on the use of frequency selective multiphoton transitions in a two-level atom. To analyze this possibility we investigate a four-level system theoretically and show that a high-resolution lithography is possible. We quantitatively identify conditions under which high-contrast lithography can be performed without sacrificing high resolution. The approach is a perturbative density matrix method. This model identifies the tradeoff between resolution and contrast as being due to higher-order terms from intermediate-level Rabi oscillations. We propose using positive and negative one-photon detunings to suppress this effect. Allowing higher Rabi frequencies means that shorter interaction time can be used, and this overcomes the degradation in contrast due to population decay. Finally, we generalize our scheme to $\mathbit{N}$-photon lithography.

Physical Review A•Feb 19, 2013•20 citations

Theoretical consideration on quantum lithography with conventional projection

Tôru Fujii, Naoki Fukutake, Hisao Osawa +1 more

At the end of last century, the name of “quantum lithography” has been emerged. This exciting approach was proposed for making a resolution two times higher than that of the conventional optics without changing a wavelength and a numerical aperture. For those who want optical lithography to last long, this has been thought to be a great technology. However, an applicability of the proposed method to the current exposure system i.e., reduced projection exposure system has not yet been examined clearly. We have investigated the proposed quantum lithography to apply into the current exposure system using reticle. For simplicity, coherent illumination i.e. sigma is zero condition is used for calculation. Our quantum lithography compatible to mask exposure system explains probability of one and two photon absorption on the image plane i.e. on wafer. We have shown that the half-wavelength quantum lithography using conventional mask exposure system is impossible because diffraction at the mask makes biphoton into two photon. We have found that there is still super-resolution quantum lithography using mask exposure, however, there is little possibility of quantum lithography practically today because biphoton light source is as dark as stars. To realize quantum lithography practically, further development of not only biphoton light source but also two-photon absorption resist is indispensable.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jun 25, 2003•3 citations

Quantum lithography with classical light: Generation of arbitrary patterns

Qingqing Sun, Philip Hemmer, Muhammad Suhail Zubairy

Based on our previous scheme [Hemmer et al., Phys. Rev. Lett. 96, 163603 (2006)] we show the procedures to obtain any one- or two-dimensional pattern by multiple exposures. A key modification to the resonance condition is made to achieve subwavelength pattern resolution. The level separation of the substrate does not pose an upper limit to the frequency summation. So the fundamental frequency can be high and the number of Fourier terms can be large, making our scheme very suitable for subwavelength arbitrary patterns.

Physical Review A•Jun 27, 2007•32 citations

Subwavelength interference with classical light

Peilong Hong, Guoquan Zhang

The resolution of optical interference is ultimately limited by the wavelength of light, which is known as Rayleigh criterion. Interestingly, this limitation could be surpassed by considering photonic de Broglie wave, and the resulting subwavelength interference is useful for lithography and super-resolving phase measurementsuper-resolving phase measurement. Usually, quantum entangled state is necessary to realize photonic de Broglie wave. Recent advances show that subwavelength interference could also be realized with a classical light through post-selected operation or by considering light-matter interaction. In this work, a new classical source is designed to achieve subwavelength interference without any post-selected operation in a linear scheme.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2013•0 citations

Atom lithography with subwavelength resolution

Muhammad Suhail Zubairy, Zeyang Liao, M. Al-Amri

The resolutions of the optical lithography is limited by the well-known Rayleigh limit. Although the atom lithography can generate features smaller than this limit, the spacing of the pattern is still limited by the optical wavelength. Here, we proposed two atom lithography methods, both of which used the coherent Rabi oscillation to break the diffraction limit. One is in the microwave regime where the Rydberg atom is used and micrometer resolution can be achieved. The other is in the optical regime where sub-10 nanometer resolution is possible.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 26, 2013•0 citations

Atom lithography with subwavelength resolution via Rabi oscillations

Zeyang Liao, M. Al-Amri, Thomas Becker +3 more

We propose two atom lithography techniques with subwavelength resolution based on position-dependent Rabi oscillations. Our method either uses neutral or ionized atoms to write subwavelength patterns. We illustrate our proposal by numerical simulations of an experimental setup using rubidium Rydberg atoms. We show that, for a microwave wavelength of 1.4 cm, a spacing of a few hundred nanometers is possible.

Physical Review A•Feb 13, 2013•18 citations
The resolution of an interferometric optical lithography system is about the half wavelength of the illumination light. We proposed a method based on Doppleron resonance to achieve a resolution beyond half wavelength [Phys. Rev. Lett. 96, 163603 (2006)]. Here, we analyze a possible experimental demonstration of this method in the negatively charged silicon-vacancy (SiV\ensuremath−{\mathrm{SiV}}^{\ensuremath{-}}SiV\ensuremath−) system by considering realistic experimental parameters. Our results show that quarter wavelength resolution and beyond can be achieved in this system even in room temperature without using perturbation theory.
The concept of performing quantum lithography with classical, instead of entangled, light is of great interest for practical implementation. One recent proposal [Hemmer, Muthukrishnan, Scully, and Zubairy, Phys. Rev. Lett. 96, 163603 (2006)] to accomplish this was based on the use of frequency selective multiphoton transitions in a two-level atom. To analyze this possibility we investigate a four-level system theoretically and show that a high-resolution lithography is possible. We quantitatively identify conditions under which high-contrast lithography can be performed without sacrificing high resolution. The approach is a perturbative density matrix method. This model identifies the tradeoff between resolution and contrast as being due to higher-order terms from intermediate-level Rabi oscillations. We propose using positive and negative one-photon detunings to suppress this effect. Allowing higher Rabi frequencies means that shorter interaction time can be used, and this overcomes the degradation in contrast due to population decay. Finally, we generalize our scheme to $\mathbit{N}$-photon lithography.
At the end of last century, the name of “quantum lithography” has been emerged. This exciting approach was proposed for making a resolution two times higher than that of the conventional optics without changing a wavelength and a numerical aperture. For those who want optical lithography to last long, this has been thought to be a great technology. However, an applicability of the proposed method to the current exposure system i.e., reduced projection exposure system has not yet been examined clearly. We have investigated the proposed quantum lithography to apply into the current exposure system using reticle. For simplicity, coherent illumination i.e. sigma is zero condition is used for calculation. Our quantum lithography compatible to mask exposure system explains probability of one and two photon absorption on the image plane i.e. on wafer. We have shown that the half-wavelength quantum lithography using conventional mask exposure system is impossible because diffraction at the mask makes biphoton into two photon. We have found that there is still super-resolution quantum lithography using mask exposure, however, there is little possibility of quantum lithography practically today because biphoton light source is as dark as stars. To realize quantum lithography practically, further development of not only biphoton light source but also two-photon absorption resist is indispensable.
Based on our previous scheme [Hemmer et al., Phys. Rev. Lett. 96, 163603 (2006)] we show the procedures to obtain any one- or two-dimensional pattern by multiple exposures. A key modification to the resonance condition is made to achieve subwavelength pattern resolution. The level separation of the substrate does not pose an upper limit to the frequency summation. So the fundamental frequency can be high and the number of Fourier terms can be large, making our scheme very suitable for subwavelength arbitrary patterns.
The resolution of optical interference is ultimately limited by the wavelength of light, which is known as Rayleigh criterion. Interestingly, this limitation could be surpassed by considering photonic de Broglie wave, and the resulting subwavelength interference is useful for lithography and super-resolving phase measurementsuper-resolving phase measurement. Usually, quantum entangled state is necessary to realize photonic de Broglie wave. Recent advances show that subwavelength interference could also be realized with a classical light through post-selected operation or by considering light-matter interaction. In this work, a new classical source is designed to achieve subwavelength interference without any post-selected operation in a linear scheme.
The resolutions of the optical lithography is limited by the well-known Rayleigh limit. Although the atom lithography can generate features smaller than this limit, the spacing of the pattern is still limited by the optical wavelength. Here, we proposed two atom lithography methods, both of which used the coherent Rabi oscillation to break the diffraction limit. One is in the microwave regime where the Rydberg atom is used and micrometer resolution can be achieved. The other is in the optical regime where sub-10 nanometer resolution is possible.