Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE International Superconductive Electronics Conference (ISEC)

Integration of Molybdenum Silicide Superconducting Nanowires with Quantum Photonic Circuits for On-Chip Single Photon Detection

Kleanthis Erotokritou, Robert M. Heath, Archan Banerjee, Marc Sorel, Robert H. Hadfield

Published Jun 1, 2017• 0 citations
Publisher

Abstract

Superconducting single-photon detectors (SNSPDs or SSPDs) based on superconducting nanowires offer single photon sensitivity at telecom wavelengths coupled with free running operation, high timing resolution and low dark counts. Amorphous superconducting materials open the pathway to improved yield and integration in advanced photonic applications. We report simulation, fabrication and experimental validation of waveguide integrated molybdenum silicide (MoSi) SNSPDs for scalable integration in quantum photonic circuits.

DOI
10.1109/isec.2017.8314227

Related papers

Amorphous superconducting nanowire single-photon detectors integrated with nanophotonic waveguides

M. Häußler, M. Yu. Mikhaĭlov, Martin A. Wolff +1 more

Future applications in integrated quantum photonics will require large numbers of efficient, fast, and low-noise single-photon counters. Superconducting nanowire single-photon detectors made from amorphous material systems are best suited to meet these demands, but the integration with nanophotonic circuits has remained a challenge. Here, we show how amorphous molybdenum silicide (MoSi) nanowires are integrated with nanophotonic silicon nitride waveguides in traveling wave geometry. We found a saturated on-chip detection efficiency of (73 ± 10) % for telecom wavelength photons and the sub-10 Hz dark count rate at a temperature of 2.1 K, which allows for operation in robust, compact, and economic cryogenic systems. Applications requiring fast counting will benefit from the sub-5 ns recovery times of our devices that we combine with 135 ps timing accuracy. Achieving this performance with waveguide-integrated amorphous superconductors is an important step toward enabling high yield fabrication of competitive single-photon detectors on a large variety of nanophotonic material systems.

APL Photonics•Jul 1, 2020•25 citations

Waveguide integrated superconducting single-photon detectors with high internal quantum efficiency at telecom wavelengths

Oliver Kahl, Simone Ferrari, Vadim V. Kovalyuk +3 more

Superconducting nanowire single-photon detectors (SNSPDs) provide high efficiency for detecting individual photons while keeping dark counts and timing jitter minimal. Besides superior detection performance over a broad optical bandwidth, compatibility with an integrated optical platform is a crucial requirement for applications in emerging quantum photonic technologies. Here we present SNSPDs embedded in nanophotonic integrated circuits which achieve internal quantum efficiencies close to unity at 1550 nm wavelength. This allows for the SNSPDs to be operated at bias currents far below the critical current where unwanted dark count events reach milli-Hz levels while on-chip detection efficiencies above 70% are maintained. The measured dark count rates correspond to noise-equivalent powers in the 10(-19) W/Hz(-1/2) range and the timing jitter is as low as 35 ps. Our detectors are fully scalable and interface directly with waveguide-based optical platforms.

Scientific Reports•Jun 10, 2015•112 citations

Molybdenum Silicide Superconducting Nanowire Single-Photon Detectors on Lithium Niobate Waveguides

Marco Colangelo, Di Zhu, Linbo Shao +7 more

We demonstrate a molybdenum silicide superconducting nanowire single-photon detector heterogeneously integrated onto a thin-film lithium niobate waveguide. The detector achieves approximately 50% on-chip detection efficiency at 1550 nm with a jitter of 82 ps when measured at 0.78 K. This demonstration showcases the integration of an amorphous superconductor utilizing conventional fabrication processes without strict cooling and substrate requirements. This paves the way for the integration of additional superconducting electronic components, potentially realizing the full promise of integrated quantum photonic circuits.

ACS Photonics•Jan 16, 2024•21 citations

Demonstration of Single Photon Detection in Amorphous Molybdenum Silicide / Aluminium Superconducting Nanostrip

Daniela Salvoni, L. Parlato, Mikkel Ejrnaes +11 more

Single photon detectors (SPD) are largely used when the signal to be measured is particularly low or if high accuracy, timing resolution and low noise are required. About twenty years ago, a new type of SPD based on superconducting materials appeared, and today these devices present the best performances in terms of efficiency, noise, counting rate, detectable wavelength, dead time, and timing jitter. In this work, we first describe the working principle of Superconducting Nanostrips Single Photon Detectors (SNSPDs) and provide a brief overview of the main properties and applications. Then, we present the results of the fabrication and characterization of Molybdenum Silicide SNSPDs with a cover layer of a thin Aluminium film (MoSi/Al). MoSi has already been adopted to fabricate SNSPDs, and in this work, we prove that the additional Al layer enhances the operating conditions without compromising the detection likelihood and leaving unaltered the properties of the device, even over a temporal window of two years and after several thermal cycles.

IEEE Instrumentation & Measurement Magazine•Jul 20, 2021•10 citations

Superconducting single photon detectors for quantum information processing

Robert A. Kirkwood

Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.

•Jan 1, 2017•1 citation

Superconducting Nanowire Single Photon Detectors with High System Detection Efficiency at Telecom Wavelengths

Francesco Marsili, Varun Boehm Verma, Jeff A. Stern +9 more

We report on a fiber-coupled eight-channel single-photon-detection system employing superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten silicide (WSi) with system detection efficiency ranging from 81 to 89 % at 1550 nm wavelength.

Conference on Lasers and Electro-Optics•Jan 1, 2013•1 citation
Superconducting single-photon detectors (SNSPDs or SSPDs) based on superconducting nanowires offer single photon sensitivity at telecom wavelengths coupled with free running operation, high timing resolution and low dark counts. Amorphous superconducting materials open the pathway to improved yield and integration in advanced photonic applications. We report simulation, fabrication and experimental validation of waveguide integrated molybdenum silicide (MoSi) SNSPDs for scalable integration in quantum photonic circuits.
Future applications in integrated quantum photonics will require large numbers of efficient, fast, and low-noise single-photon counters. Superconducting nanowire single-photon detectors made from amorphous material systems are best suited to meet these demands, but the integration with nanophotonic circuits has remained a challenge. Here, we show how amorphous molybdenum silicide (MoSi) nanowires are integrated with nanophotonic silicon nitride waveguides in traveling wave geometry. We found a saturated on-chip detection efficiency of (73 ± 10) % for telecom wavelength photons and the sub-10 Hz dark count rate at a temperature of 2.1 K, which allows for operation in robust, compact, and economic cryogenic systems. Applications requiring fast counting will benefit from the sub-5 ns recovery times of our devices that we combine with 135 ps timing accuracy. Achieving this performance with waveguide-integrated amorphous superconductors is an important step toward enabling high yield fabrication of competitive single-photon detectors on a large variety of nanophotonic material systems.
Superconducting nanowire single-photon detectors (SNSPDs) provide high efficiency for detecting individual photons while keeping dark counts and timing jitter minimal. Besides superior detection performance over a broad optical bandwidth, compatibility with an integrated optical platform is a crucial requirement for applications in emerging quantum photonic technologies. Here we present SNSPDs embedded in nanophotonic integrated circuits which achieve internal quantum efficiencies close to unity at 1550 nm wavelength. This allows for the SNSPDs to be operated at bias currents far below the critical current where unwanted dark count events reach milli-Hz levels while on-chip detection efficiencies above 70% are maintained. The measured dark count rates correspond to noise-equivalent powers in the 10(-19) W/Hz(-1/2) range and the timing jitter is as low as 35 ps. Our detectors are fully scalable and interface directly with waveguide-based optical platforms.
We demonstrate a molybdenum silicide superconducting nanowire single-photon detector heterogeneously integrated onto a thin-film lithium niobate waveguide. The detector achieves approximately 50% on-chip detection efficiency at 1550 nm with a jitter of 82 ps when measured at 0.78 K. This demonstration showcases the integration of an amorphous superconductor utilizing conventional fabrication processes without strict cooling and substrate requirements. This paves the way for the integration of additional superconducting electronic components, potentially realizing the full promise of integrated quantum photonic circuits.
Single photon detectors (SPD) are largely used when the signal to be measured is particularly low or if high accuracy, timing resolution and low noise are required. About twenty years ago, a new type of SPD based on superconducting materials appeared, and today these devices present the best performances in terms of efficiency, noise, counting rate, detectable wavelength, dead time, and timing jitter. In this work, we first describe the working principle of Superconducting Nanostrips Single Photon Detectors (SNSPDs) and provide a brief overview of the main properties and applications. Then, we present the results of the fabrication and characterization of Molybdenum Silicide SNSPDs with a cover layer of a thin Aluminium film (MoSi/Al). MoSi has already been adopted to fabricate SNSPDs, and in this work, we prove that the additional Al layer enhances the operating conditions without compromising the detection likelihood and leaving unaltered the properties of the device, even over a temporal window of two years and after several thermal cycles.
Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.