A century after Einstein's formulation of general relativity, the detectors of the Laser Interferometer Gravitational-wave Observatory (LIGO) made the first direct detection of gravitational waves. This historic achievement was the culmination of a world-wide effort and decades of instrument research. While sufficient for this monumental discovery, the current generation of gravitational-wave detectors represent the least sensitive devices necessary for the task; improved detectors will be required to fully exploit this new window on the Universe. In this paper, we review the application of squeezed vacuum states of light to gravitational-wave detectors as a way to reduce quantum noise, which currently limits their performance in much of the detection band.
A century after Einstein's formulation of general relativity, the detectors of the Laser Interferometer Gravitational-wave Observatory (LIGO) made the first direct detection of gravitational waves. This historic achievement was the culmination of a world-wide effort and decades of instrument research. While sufficient for this monumental discovery, the current generation of gravitational-wave detectors represent the least sensitive devices necessary for the task; improved detectors will be required to fully exploit this new window on the Universe. In this paper, we review the application of squeezed vacuum states of light to gravitational-wave detectors as a way to reduce quantum noise, which currently limits their performance in much of the detection band.
The Laser Interferometer Gravitational Wave Observatory (LIGO) has been directly detecting gravitational waves from compact binary mergers since 2015. We report on the first use of squeezed vacuum states in the direct measurement of gravitational waves with the Advanced LIGO H1 and L1 detectors. This achievement is the culmination of decades of research to implement squeezed states in gravitational-wave detectors. During the ongoing O3 observation run, squeezed states are improving the sensitivity of the LIGO interferometers to signals above 50 Hz by up to 3 dB, thereby increasing the expected detection rate by 40% (H1) and 50% (L1).
Among the revolutionary predictions of Einstein’s theory of general relativity is the existence of gravitational waves, which are perturbations in the fabric of spacetime that travel at the speed of light. The first indirect evidence pointing to their existence came from the observation of the Hulse-Taylor pulsar in 1974[4]. More recently, gravitational wave observatories like the Laser Interferometer Gravitational-wave Observatory (LIGO) and Virgo have been built with the purpose of detecting gravitational waves (GW) directly, providing not only further evidence in support of general relativity, but also a whole new way of viewing the cosmos. The strain produced by a passing gravitational wave (namely, the relative change in the length of the matter a gravitational wave passes through) is so small that the best sensitivity achieved by the detectors has not produced a positive detection as of today. With a clear understanding that there should be gravitational waves, scientists are working on improving the sensitivity of the detectors to increase the likelihood of a detection. One of the main sources of noise for the next generation gravitational wave detectors, such as advanced LIGO, is shot noise. Shot noise dominates the noise spectrum above a few hundred Hz. This noise is due to uncertainties in quantum statistics, according to the generalized uncertainty principle. There are two ways to reduce the shot noise. The first way is to increase the intensity of the
Recent experiments have demonstrated that squeezed vacuum states can be injected into gravitational wave detectors to improve their sensitivity at detection frequencies where they are quantum noise limited. Squeezed states could be employed in the next generation of more sensitive advanced detectors currently under construction, such as Advanced LIGO, to further push the limits of the observable gravitational wave Universe. To maximize the benefit from squeezing, environmentally induced disturbances such as back scattering and angular jitter need to be mitigated. We discuss the limitations of current squeezed vacuum sources in relation to the requirements imposed by future gravitational wave detectors, and show a design for squeezed light injection which overcomes these limitations.
Gravitational waves are a predication of Einstein's theory of general relativity. After nearly 50 years of effort by the scientific community to construct a detector capable of directly measuring gravitational waves, we expect a breakthrough, the first ever direct measurement of a gravitational wave within the next 5 years. The Advanced LIGO detectors currently under construction are predicted to achieve not only the first detection but to open the field of gravitational-wave astronomy: as an observational window on astrophysics and with an impart on other areas such as cosmology, strong-field gravity, general relativity, and nuclear physics. \n \nThe Advanced LIGO detectors are large-scale laser interferometers that have been designed for very low technical noise so that quantum noise will be limiting their sensitivity over a wide range of their spectrum. Planning for future gravitational wave observatories is already underway and reducing the fundamental quantum noise is considered to be one of the main experimental challenges. My work over the last 4 years has focused on possible new techniques to reduce or circumvent the quantum noise in laser interferometers. \n
The ability to directly detect gravitational waves will open a completely new branch of astronomy to view the Universe, one that is inaccessible to electromagnetic-based astronomy. First generation ground-based interferometric gravitational-wave detectors have achieved strain sensitivities of order one part in ten to the twenty-one, at 100 Hz detection frequency. A new generation of detectors are under construction, designed to improve on the sensitivity of the first-generation detectors by a factor of 10. The quantum nature of light will broadly limit the sensitivity of these new instruments. This quantum noise will originate from the quantum vacuum fluctuations that enter the unused port of the interferometer. One of the most promising options for reducing the quantum noise impact and further increasing the sensitivity is applying quantum squeezed vacuum states. These squeezed states have lower noise in one quadrature than the vacuum state. By replacing the quantum vacuum fluctuations entering the interferometer with squeezed vacuum states, the quantum noise impact is reduced. This thesis firstly details the development of a squeezed light source that produces squeezed states applicable for enhancing interferometric gravitational-wave detectors. A doubly-resonant, travelling-wave bow-tie cavity squeezed light source is presented. For the first time, greater than 10 dB of quantum noise suppression across the gravitational-wave detection band is directly observed, and 11.6 dB of quantum noise suppression is observed above 200 Hz. This squeezing cavity design also has benefits with intrinsic isolation to backscattered light. Experiments that quantify this isolation are reported. The properties affecting squeezing magnitude and low-frequency squeezing measurement are discussed. In addition, a modified squeezing-ellipse-phase control technique for squeezed vacuum states is presented. This thesis secondly presents results from the LIGO Squeezed Light Injection Experiment, undertaken to test squeezed light injection into a 4 km interferometric gravitational-wave detector. The results of the experiment show the first measurement of squeezing-enhancement in a 4 km gravitational-wave detector, with 2.15 dB measured above 250 Hz. This represents the best sensitivity to gravitational waves yet achieved at these frequencies by any single gravitational-wave detector to date. An unknown area was whether the addition of a squeezer would introduce noise couplings that degrade the crucial low frequency sensitivity. The results demonstrate that injected squeezed states are compatible with low frequency gravitational-wave measurement. The characterisation of squeezing-injection optical losses and fluctuations of the squeezing angle are also reported. The knowledge and processes gained, from both the squeezed light source development work and the LIGO Squeezed Light Injection Experiment, will inform the design, planning and implementation of squeezed states in future gravitational-wave detectors.
Gravitational-wave astronomy promises a radically new method of investigating the universe, one that does not detect elementary particles, but rather ripples in space-time itself. One might expect that with this radically new method, our understanding of the universe will make an equally giant leap. One of the most promising methods for the eventual detection of gravitational-waves is that of interferometric gravitational-wave detection. The sensitivity of these devices is nothing short of amazing, and their sensitivity continues to improve. The next generation of detectors are expected reach a point where increasing the laser power, previously used to increase the sensitivity, is no longer expected to provide any benefit. One of the most promising options for further increasing the sensitivity, through reduction of the quantum noise, is via the application of "squeezed states of light". Squeezed states of light are light fields for which the noise of some observable has been reduced below the quantum noise limit. These states have been shown for many years to offer increased sensitivity in interferometers and recently in interferometric gravitational-wave detectors. One of the most challenging tasks to make suitable squeezed light sources for these detectors is to produce low-frequency squeezing, corresponding to the detection band of these interferometers. This thesis details the doubly resonant travelling wave bow-tie squeezer as a source of squeezing for interferometric gravitational-wave detection. This squeezer achieves record results of squeezing in the gravitational-wave detection band. For the first time, 10 dB of shot noise suppression at 10Hz is directly observed and above 200Hz, 11.6 dB is observed. The work presented in this thesis provides evidence that further substantiates previous progress indicating that squeezed states of light are now ready for full-time integration into interferometric gravitational-wave detectors. The new cavity design, described in detail throughout this thesis, is shown to outperform previous designs and provide benefits when integrating squeezing into these detectors, in particular, isolation to backscattered light from the interferometer. The noise sources that typically lead to degradation in squeezing measurements are investigated and discussed. Additionally, a modification to the standard locking technique used to control these vacuum squeezed states, coherent locking, is presented and discussed. The modified technique reduces the required number of locking loops and provides a larger beat note from which to derive an error signal for one of the remaining loops. A squeezer using these design philosophies is then constructed and used to inject squeezing into the LIGO gravitational-wave detector. Injection of the squeezed state provides enhancement of the sensitivity of the detector at frequencies around 200Hz and above. The sensitivity seen was equivalent to approximately 2 dB of shot noise reduction. The enhancement is limited by the loss within the interferometer. Injection of the squeezed state did not show any degradation in the sensitivity of the device below 200Hz, indicating for the first time that noise couplings between the interferometer and the squeezer could be sufficiently suppressed at these frequencies even for the most sensitive detectors.