Introduction In this chapter, we discuss some of the differences between apparatus and systems under observation (SUOs). The discussion is phrased in terms of self–intervening networks , wherein partial quantum outcomes in an early stage of an apparatus can alter future configurations of that apparatus. To explain what we mean, we introduce the following classification of experiments. Note that reference to apparatus here includes real and virtual detectors, and real and virtual modules. Virtual detectors and modules are mathematical fictions that are introduced into the formalism for convenience. Type-Zero Experiments Many important experiments involve signal propagation through “empty space.” We classify these as type zero (T0). The feature of T0 experiments qualifying for this classification is that the observer has no control of the modules in the information void. Examples are experiments in astrophysics, where the observer can choose which source to observe and how they observe it, but has no influence on the physical properties of whatever lies between source and detector. If there are gas clouds between source and detector, the observer can only recognize that fact after the experimental data are analyzed. An important modern variant of T0 experiments involves map location via the Global Positioning System (GPS): signals sent from Earth to geostationary satellites and received by mobile devices back on Earth have traveled through Earth's atmosphere and through empty space, where special relativistic and general relativistic effects have to be taken into account (Ashby, 2002). Before the rise of experimental science, most “experiments” were based on visual observations, which are principally of T0 classification. The advent of the telescope and the microscope did not change things in this respect. Indeed, it has been suggested that science did not progress in antiquity precisely because of the philosophical principle that the only valid experiments could be of T0, as these do not introduce the artificiality of constructed modules into observation, which (it was argued) would give a false perspective on “reality.” The logic of that argument is superb, but it is a dead-end principle in science. Several sciences such as geology, archaeology, and, indeed, cosmology started off with periods of basic observation rather than experimentation. During such initial stages of these sciences, the observations could be classified as T0 experiments.
Introduction In this chapter, we discuss some of the differences between apparatus and systems under observation (SUOs). The discussion is phrased in terms of self–intervening networks , wherein partial quantum outcomes in an early stage of an apparatus can alter future configurations of that apparatus. To explain what we mean, we introduce the following classification of experiments. Note that reference to apparatus here includes real and virtual detectors, and real and virtual modules. Virtual detectors and modules are mathematical fictions that are introduced into the formalism for convenience. Type-Zero Experiments Many important experiments involve signal propagation through “empty space.” We classify these as type zero (T0). The feature of T0 experiments qualifying for this classification is that the observer has no control of the modules in the information void. Examples are experiments in astrophysics, where the observer can choose which source to observe and how they observe it, but has no influence on the physical properties of whatever lies between source and detector. If there are gas clouds between source and detector, the observer can only recognize that fact after the experimental data are analyzed. An important modern variant of T0 experiments involves map location via the Global Positioning System (GPS): signals sent from Earth to geostationary satellites and received by mobile devices back on Earth have traveled through Earth's atmosphere and through empty space, where special relativistic and general relativistic effects have to be taken into account (Ashby, 2002). Before the rise of experimental science, most “experiments” were based on visual observations, which are principally of T0 classification. The advent of the telescope and the microscope did not change things in this respect. Indeed, it has been suggested that science did not progress in antiquity precisely because of the philosophical principle that the only valid experiments could be of T0, as these do not introduce the artificiality of constructed modules into observation, which (it was argued) would give a false perspective on “reality.” The logic of that argument is superb, but it is a dead-end principle in science. Several sciences such as geology, archaeology, and, indeed, cosmology started off with periods of basic observation rather than experimentation. During such initial stages of these sciences, the observations could be classified as T0 experiments.
Introduction In this chapter we discuss how quantized detector network (QDN) theory can be extended to cover the creation and decommissioning of apparatus, from the perspective of observers and their laboratories. This extension will be referred to as extended QDN. It allows us to discuss bit power sets, laboratories, the universal register, contextual vacua, and the creation of quantized detector apparatus. This extended formalism is used to describe the Elitzur–Vaidman bomb-tester experiment and the Hardy paradox experiment. A central concept running through this book is that of the observer , the enigmatic “ I ” of I think therefore I am . The problem is that, despite the many triumphs of quantum mechanics (QM), the physics of the observer and observation is still not well understood. Regardless of how observers are defined and whether classical or quantum principles are involved, physicists generally believe that classical information in some form is extracted from systems under observation (SUOs) in actual physics experiments. In all branches of science, their language reflects this belief: experimentalists talk of measuring an electron's spin or the mass of a new particle, and so on. The conceptual issues in quantum mechanics such as wave–particle duality, quantum interference, and nonlocality gave the first indication that all might not be well with this perspective. We need only to look at the photon concept to appreciate some of the problems with the idea that photons are particles (Paul, 2004). There are experiments where a photon (that is, a signal) is detected from a crystal, but the atom “from whence it came” cannot be identified, suggesting that a cooperative process is involved, rather like the phonon concept in the physics of crystals. The problem we have with the photon-as-particle concept is the gap in logic. If the particle interpretation is taken literally, then obvious questions about the physical structure or its equivalent of such particles spring up. Does such a particle have a “surface”? If it has a surface, what is that surface made of? These and other simple (minded) questions quickly lead to the conclusion that the particle concept is a convenient and economical objectification of context. In other words, a useful illusion.
Modules ModulesIn this chapter, we discuss important modules such as Wollaston prisms, Newtonian prisms, beam splitters, phase shifters, mirrors, and null modules.Modules are pieces of apparatus placed at various strategic positions in the information void and are designed to influence labstate amplitudes at signal detectors.Modules are therefore a critical component in the quantized detector network (QDN) approach to quantum mechanics (QM).Modules are not classified as either real or virtual detectors, because no information is extracted from them.Their function is solely to influence quantum amplitude propagation between stages in specific ways.Even empty space (the vacuum) can be regarded as a module, for the propagation of signals through nominally "empty" space is a fundamental subject in its own right.A particularly important example illustrating how nontrivial that can be is the Hubble-Doppler red shift of light from distant galaxies.In the QDN description of the double-slit (DS) experiment, shown in Figure 10.2, the stage Σ 1 detectors labeled 1 1 and 2 1 may be considered as on the V 2 side of the wall W , where V 2 is the information void between stages Σ 1 and Σ 2 .Viewed in this way, the wall may be interpreted as a part of the apparatus that is positioned in the information void region V 1 so as to influence the signals obtained at detectors 1 1 and 2 1 .Virtually all experiments have similar components of apparatus in the information void.We shall call any such piece of apparatus a module.Modules are necessary to the architecture of the experiment, are situated in the information void, and therefore are not detectors.Examples of modules are Stern-Gerlach (SG) inhomogeneous field magnets, Wollaston prisms, mirrors, phase changers, and so on.Even empty space, otherwise known as the vacuum, should be regarded as a module.Each module has its own physical properties.These include the number of detectors feeding amplitudes into that module and the number of detectors that
Introduction In this chapter we discuss experiments where the run architecture is significantly different from that of standard in-out experiments such as particle scattering. We apply the quantized detector network (QDN) formalism to particle decays, the ammonium molecular system, Kaon-type regeneration decay experiments, and quantum Zeno experiments. In all of these experiments, the problem is the modeling of time, which conventionally is taken to be continuous. In QDN, time is treated in terms of stages, which are discrete.We show how the QDN formalism deals with such experiments. In standard quantum mechanics (QM), time is assumed to be continuous. That is a legacy from classical mechanics (CM), which does not concern itself in general with the processes of observation. CMassumes systems under observation (SUOs) “have” physical properties that are independent of how they are observed. In contrast, QM cannot be considered without a discussion of the processes of observation. On close inspection of any process of observation, as it is actually carried out in the laboratory and not how it is modeled theoretically , the continuity of time does not look quite so obvious. The problem is that there are two mutually exclusive views about the nature of observation in physics. These were discussed in detail by Misra and Sudarshan (MS) in an influential paper on the quantum Zeno effect (Misra and Sudarshan, 1977). On the one hand, no known principle forbids the continuity of time, so the axioms of QM are stated implicitly in terms of continuous time. When the Schrödinger equation is postulated to be one of them (Peres, 1995), temporal continuity is assumed explicitly. On the other hand, it is an empirical fact that no experiment can actually monitor any SUO in a truly continuous way. All references to continuous time measurements are invariably based on statistical modeling of complex processes, with the continuity of time having much the same status as that of temperature. Such effective parameters are extremely useful in physics, but their status as model-dependent, emergent attributes of SUOs, and the apparatus used to observe them, should always be kept in mind. The best that could be done toward simulating temporal continuity in physics would be to perform a sequence of experiments with a carefully prescribed decreasing measurement time scale, such as occurs in experiments investigating the phenomenon known as the quantum Zeno effect (Itano et al., 1990).
Motivation The aim of this book is to introduce, develop, and apply quantized detector networks (QDN), an information-based, observer-centric approach to quantum mechanics (QM). Six reasons motivating our development of QDN are the following. Avoidance of Metaphysical Speculation There is such a variety of unproven (and unprovable) speculation concerning the interpretation of QM that the subject of this book, QDN, may appear at first sight to be yet another in this growing branch of metaphysics. In fact, our motivation is precisely the opposite. QDN was intended from the outset to reduce the level of metaphysics in the application of QM. To achieve this, our strategy is to move the traditional focus of attention away from systems under observation (SUOs) and toward the observers of those SUOs. In QDN, wave functions represent not states of SUOs but states of apparatus. We shall call such states labstates , to distinguish them from states of SUOs (which do have a place in QDN). It is only labstates that observers can ever deal with directly. In this respect, QDN is an attempt at a more laboratory-based description of quantum physics than standard QM, focusing as much on how an experiment is done as on the results of that experiment. For example, instead of talking about the wave function of an electron, QDN talks about the labstate of the signal detectors that allow us to say anything about that electron in the first place. That is all, there is nothing deeper. Whether or not electrons actually “exist” is thereby relegated to an inessential metaphysical issue that we can choose to ignore. It is important to understand what QDN does not say as much as what it does say. QDN does not say that electrons do not “exist”. QDN merely asks for an empirical definition of “existence”. QM Is Much More Than a Calculational Device Many physicists hold the utilitarian view that the success of quantum theory in predicting experimental data is sufficient for their purposes, and that further inquiry is really the business of metaphysics and therefore outside the scope of science proper. We cannot say that this is entirely unreasonable. However, we take the view that QM represents such a radical departure from the principles of classical mechanics (CM) that this pragmatical view cannot be all there is to the subject.
Introduction In this chapter we show how the quantized detector network (QDN) formalism describes the double-slit (DS) experiment. This is arguably the simplest experiment that demonstrates quantum affects such as wave–particle duality and quantum interference. It continues to be the focus of much debate and experiment (Mardari, 2005), because theoretical modeling of what is going on reflects current understanding of quantum physics and hence physical reality.We will apply QDN to two variants: the original DS experiment and the monitored DS experiment, where an attempt is made to determine the imagined path of the particle. The DS experiment is widely acknowledged by physicists to be of importance to the understanding of quantum mechanics (QM). So much so that in 2002, the single electron version, first performed by Merli, Missiroli, and Pozzi (Merli et al., 1976), was voted by readers of Physics World to be “the most beautiful experiment in physics” (Rosa, 2012). The DS experiment can be discussed in terms of three stages, shown in Figure 10.1. By the end of the preparation stage, Σ 0 , a monochromatic beam of light or particles has been prepared by a source P , such as a laser. The beam emerges from point O and then passes through an information void V 1 to the first stage, Σ 1 , which consists of a wall or barrier W . This wall has two openings denoted A and B that allow parts of the beam to pass through into another information void V 2 and onto the second and final stage Σ 2 , which consists of a detecting screen S . The screen S is in general some material that can absorb and record particle impacts. In reality, any screen will consist of a finite number of signal detectors, such as photosensitive molecules, but the typical QM modeling is done as if there were a continuum of sites on the screen, such as C , that could register particles.