Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)

Quantum nondemolition measurement of light intensity fluctuations in an optomechanical experiment

A. Pontin, M. Bonaldi, A. Borrielli, L. Marconi, Francesco Marino, G. Pandraud, Giovanni Andrea Prodi, Pasqualina Maria Sarro, Enrico Serra, Francesco Marin

Published Jun 1, 2017• 0 citations
Publisher

Abstract

According to quantum mechanics, there exists a class of observables for which is possible to confine the perturbation produced by a continuous measurement to the conjugate variable. Therefore, it is possible to devise experimental schemes that allow estimating the observed variable with arbitrary accuracy, or preparing it in a well-known state. Such schemes are referred to as quantum non-demolition measurements (QND). Among these observables there is the amplitude of the light field. Indeed, it is possible to exploit a movable mirror to implement a QND scheme [1]. Intensity fluctuations of an optical field impinging on it are not affected by the interaction. However, the movable mirror is excited by the associated radiation pressure. This, in turn, affects the phase of the field.

DOI
10.1109/cleoe-eqec.2017.8087321

Related papers

Quantum nondemolition measurement of optical field fluctuations by optomechanical interaction

A. Pontin, M. Bonaldi, A. Borrielli +7 more

According to quantum mechanics, if we keep observing a continuous variable we generally disturb its evolution. For a class of observables, however, it is possible to implement a so-called quantum nondemolition measurement: by confining the perturbation to the conjugate variable, the observable is estimated with arbitrary accuracy, or prepared in a well-known state. For instance, when the light bounces on a movable mirror, its intensity is not perturbed (the effect is just seen on the phase of the radiation), but the radiation pressure allows one to trace back its fluctuations by observing the mirror motion. In this work, we implement a cavity optomechanical experiment based on an oscillating micromirror, and we measure correlations between the output light intensity fluctuations and the mirror motion. We demonstrate that the uncertainty of the former is reduced below the shot-noise level determined by the corpuscular nature of light.

arXiv:1611.00917•Physical Review A•Mar 16, 2018•23 citations

Towards the ideal quantum measurement

Matthew Colleti

According to the Heisenberg uncertainty principle, if we measure one variable describing a physical system, we inevitably introduce noise into some other variable describing the same system. In practice, the situation is worse than that: measuring one variable usually introduces random noise into the very quantity we are measuring. It is possible in principle to make measurements, known as quantum non-demolition (or QND) measurements, which do not have this latter effect. A QND measurement may approach the ideal quantum measurement commonly encountered in quantum mechanics textbooks. Philippe Grangier and his co-workers at the Université Paris-Sud, at Orsay in France, have recently attempted to measure the intensity of a beam of light in this way (Phys. Rev. Len. (1991) 66 1418). Their experiment has shown that it is indeed possible to make a measurement which at least partially preserves the quantum mechanical state of the detected beam.

Physics World•Jun 1, 1991•1 citation

Quantum nondemolition detection of optical quadrature amplitudes

Robert M. Shelby

The concept of quantum nondemolition (QND) measurement is outlined in the context of quantum optics. As a prototypal QND measurement scheme, the interaction of a light beam with a classical mechanical oscillator via radiation pressure is outlined. Results of QND experiments using cross‐phase modulation of two co‐propagating beams in single mode optical fibers are reviewed, and the prospects for improved schemes briefly discussed.

AIP conference proceedings•Jan 1, 1989•0 citations

Quantum Nondemolition Schemes using Second Order Nonlinearities

Robert M. Shelby, M. D. Levenson

Conventional devices for measuring the amplitude of a light wave absorb the light, thus destroying it. Recently, quantum nondemolition (QND) methods based on the optical Kerr effect have been shown capable of measuring optical amplitude fluctuations with near quantum-limited sensitivity.1 In these experiments, amplitude fluctuations of a signal beam are transferred to the phase fluctuation quadrature of a probe beam which co-propagates with the signal beam, by the intensity-dependent refractive index, without absorption of the signal beam. A pure Kerr nonlinearity can cause only phase modulation of the light wave, and the amplitude of the signal wave is preserved. Such methods should more properly be called back-action evading measurement schemes since the quantity being measured is not perturbed by the back-action that quantum mechanics requires for any measurement. The signal-to-noise ratio achieved in these experiments was limited by the small magnitude of the Kerr nonlinearity relative to the excess phase noise imposed on the probe beam by thermal light scattering processes in the glass fibers that were employed.

•Jul 18, 1988•0 citations

Towards observation of quantum optomechanical correlations

Daniel Garcia-Sanchez, Alexandros Tavernarakis, Aurélien G. Kuhn +8 more

In an interferometric measurement, the quantum radiation pressure noise, which is due to quantum intracavity intensity fluctuations, gives rise to mirror displacement fluctuations and sets a limit in the displacement sensitivity. We have designed a table-top experiment to demonstrate this effect and realize various quantum optics experiments with an optomechanical system.

Conference on Lasers and Electro-Optics•Jan 1, 2013•0 citations

Theory of quantum-optical measurements with a phase-conjugate mirror

Mary Yvonne Lanzerotti, Alexander L. Gaeta

We show theoretically that optical phase conjugation via four-wave mixing can satisfy the quantitative criteria [Holland et al., Phys. Rev. A 42, 2995 (1990)] for performing quantum nondemolition measurements of a signal field despite the fact that this measurement scheme introduces noise into the signal field and thus does not perform a true quantum nondemolition measurement. The criteria can be satisfied under conditions in which the vacuum field injected in the rear of the phase-conjugate mirror is quadrature squeezed. Using this measurement scheme, it is possible to obtain values of the total information transfer coefficient that are as large as those that can be achieved using quantum nondemolition measurements.

Physical Review A•May 1, 1995•9 citations
According to quantum mechanics, there exists a class of observables for which is possible to confine the perturbation produced by a continuous measurement to the conjugate variable. Therefore, it is possible to devise experimental schemes that allow estimating the observed variable with arbitrary accuracy, or preparing it in a well-known state. Such schemes are referred to as quantum non-demolition measurements (QND). Among these observables there is the amplitude of the light field. Indeed, it is possible to exploit a movable mirror to implement a QND scheme [1]. Intensity fluctuations of an optical field impinging on it are not affected by the interaction. However, the movable mirror is excited by the associated radiation pressure. This, in turn, affects the phase of the field.
According to quantum mechanics, if we keep observing a continuous variable we generally disturb its evolution. For a class of observables, however, it is possible to implement a so-called quantum nondemolition measurement: by confining the perturbation to the conjugate variable, the observable is estimated with arbitrary accuracy, or prepared in a well-known state. For instance, when the light bounces on a movable mirror, its intensity is not perturbed (the effect is just seen on the phase of the radiation), but the radiation pressure allows one to trace back its fluctuations by observing the mirror motion. In this work, we implement a cavity optomechanical experiment based on an oscillating micromirror, and we measure correlations between the output light intensity fluctuations and the mirror motion. We demonstrate that the uncertainty of the former is reduced below the shot-noise level determined by the corpuscular nature of light.
According to the Heisenberg uncertainty principle, if we measure one variable describing a physical system, we inevitably introduce noise into some other variable describing the same system. In practice, the situation is worse than that: measuring one variable usually introduces random noise into the very quantity we are measuring. It is possible in principle to make measurements, known as quantum non-demolition (or QND) measurements, which do not have this latter effect. A QND measurement may approach the ideal quantum measurement commonly encountered in quantum mechanics textbooks. Philippe Grangier and his co-workers at the Université Paris-Sud, at Orsay in France, have recently attempted to measure the intensity of a beam of light in this way (Phys. Rev. Len. (1991) 66 1418). Their experiment has shown that it is indeed possible to make a measurement which at least partially preserves the quantum mechanical state of the detected beam.
Conventional devices for measuring the amplitude of a light wave absorb the light, thus destroying it. Recently, quantum nondemolition (QND) methods based on the optical Kerr effect have been shown capable of measuring optical amplitude fluctuations with near quantum-limited sensitivity.1 In these experiments, amplitude fluctuations of a signal beam are transferred to the phase fluctuation quadrature of a probe beam which co-propagates with the signal beam, by the intensity-dependent refractive index, without absorption of the signal beam. A pure Kerr nonlinearity can cause only phase modulation of the light wave, and the amplitude of the signal wave is preserved. Such methods should more properly be called back-action evading measurement schemes since the quantity being measured is not perturbed by the back-action that quantum mechanics requires for any measurement. The signal-to-noise ratio achieved in these experiments was limited by the small magnitude of the Kerr nonlinearity relative to the excess phase noise imposed on the probe beam by thermal light scattering processes in the glass fibers that were employed.
We show theoretically that optical phase conjugation via four-wave mixing can satisfy the quantitative criteria [Holland et al., Phys. Rev. A 42, 2995 (1990)] for performing quantum nondemolition measurements of a signal field despite the fact that this measurement scheme introduces noise into the signal field and thus does not perform a true quantum nondemolition measurement. The criteria can be satisfied under conditions in which the vacuum field injected in the rear of the phase-conjugate mirror is quadrature squeezed. Using this measurement scheme, it is possible to obtain values of the total information transfer coefficient that are as large as those that can be achieved using quantum nondemolition measurements.