Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Turn-On Delays in Single Josephson Junction Devices | NIST

Rick Peterson

Published Jan 1, 1980• 0 citations
OpenAlex

Related papers

Stacked SNS Josephson Junctions for Quantum Voltage Applications | NIST

Paul D. Dresselhaus, Yonuk Chong, Samuel P. Benz

•Jul 11, 2003•2 citations

Turn-on delay of Josephson interferometer logic devices

E. P. Harris

It has generally been assumed that the switching dynamics of Josephson logic devices can be well approximated by treating the Josephson device as a capacitatively-shunted switch which opens instantaneously when a control current crosses threshold. In this approximation, the switching delay is proportional to RC, where R = load resistance and C = device capacitance. However, we show here that the above approximation is quite incorrect in the technologically important case of logic interferometers in which resonances are suppressed by internal damping. We treat in detail the case of damped two-junction interferometers with step-function control current. Analysis of the equations of motion shows that in addition to the RC delay there is an initial turn-on delay during which the output voltage is very small, and which is most pronounced for heavy internal damping. It consists of the time required for the difference in phase between the two junctions to increase to a critical value, followed by approximately the first half-cycle of growth of the average of the junction phases. The turn-on delay is a strong function of overdrive, (i.e., the factor by which the control current amplitude exceeds threshold), being smallest at large overdrives, and scales as (C/i0)1/2, where i0= junction critical current. Hence it can be reduced by miniaturization and/or increased junction current density. For parameter values typical of 5μm Josephson circuit technology, the turn-on delay is on the order of 10pS at large overdrives (≃2).

IEEE Transactions on Magnetics•Jan 1, 1979•48 citations

Superconducting Devices | NIST

James Edward Zimmerman, Donald B. Sullivan

•Dec 31, 1979•0 citations

RF Applications of the Josephson Effect | NIST

R.A. Kamper

Microwave journal•Apr 1, 1976•0 citations

Experimental investigation of a high frequency sampling system based on shunted Josephson junctions

V. K. Kaplunenko, M. Khabipov, E. Goldobin

The authors propose a new type of sampler design based on shunted junctions ( beta c =1). The sampler is to be used for the investigation of single flux quantum devices (RSFQ) employing similar junctions (Kaplunenko et al. 1989, Filippenko et al. 1991). They measure the time resolution of the sampler and delay time of the shunted Josephson junction array. The circuit was manufactured on a single chip and was DC powered. They employed Nb-AlO x -Nb tunnel junctions of 300 A m -2 critical current density and observed Josephson oscillations of the output junction at frequencies from 6 to 50 GHz. Despite a long plasma period of 20 ps the time resolution was 5 ps. The transmission line of 27 Josephson junctions (critical current 165 mu A each) demonstrated time delay of 0.5 ps mu A -1 .

Superconductor Science and Technology•Nov 1, 1991•15 citations

High-Speed Superconducting Electronics | NIST

Clark A. Hamilton, R. Harris, Donald B. Sullivan

•Dec 31, 1978•0 citations
It has generally been assumed that the switching dynamics of Josephson logic devices can be well approximated by treating the Josephson device as a capacitatively-shunted switch which opens instantaneously when a control current crosses threshold. In this approximation, the switching delay is proportional to RC, where R = load resistance and C = device capacitance. However, we show here that the above approximation is quite incorrect in the technologically important case of logic interferometers in which resonances are suppressed by internal damping. We treat in detail the case of damped two-junction interferometers with step-function control current. Analysis of the equations of motion shows that in addition to the RC delay there is an initial turn-on delay during which the output voltage is very small, and which is most pronounced for heavy internal damping. It consists of the time required for the difference in phase between the two junctions to increase to a critical value, followed by approximately the first half-cycle of growth of the average of the junction phases. The turn-on delay is a strong function of overdrive, (i.e., the factor by which the control current amplitude exceeds threshold), being smallest at large overdrives, and scales as (C/i0)1/2, where i0= junction critical current. Hence it can be reduced by miniaturization and/or increased junction current density. For parameter values typical of 5μm Josephson circuit technology, the turn-on delay is on the order of 10pS at large overdrives (≃2).
The authors propose a new type of sampler design based on shunted junctions ( beta c =1). The sampler is to be used for the investigation of single flux quantum devices (RSFQ) employing similar junctions (Kaplunenko et al. 1989, Filippenko et al. 1991). They measure the time resolution of the sampler and delay time of the shunted Josephson junction array. The circuit was manufactured on a single chip and was DC powered. They employed Nb-AlO x -Nb tunnel junctions of 300 A m -2 critical current density and observed Josephson oscillations of the output junction at frequencies from 6 to 50 GHz. Despite a long plasma period of 20 ps the time resolution was 5 ps. The transmission line of 27 Josephson junctions (critical current 165 mu A each) demonstrated time delay of 0.5 ps mu A -1 .