Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Springer series in optical sciences/SPringer series in optical sciences

Squeezing Intensity Noise on Laser-like Beams

E. Giacobino, Claude Fabre, H. Heidmann, R. J. Horowicz, Serge Reynaud, G. Camy

Published Jan 1, 1987• 0 citations
Publisher
DOI
10.1007/978-3-540-47973-4_40

Related papers

Laser Intensity Noise Suppression for Preparing Audio-Frequency Squeezed Vacuum State of Light

Lele Bai, Xin Wen, Yulin Yang +2 more

Laser intensity noise suppression has essential effects on preparation and characterization of the audio-frequency squeezed vacuum state of light based on a sub-threshold optical parametric oscillator (OPO). We have implemented two feedback loops by using relevant acousto-optical modulators (AOM) to stabilize the intensity of 795-nm near infrared (NIR) fundamental laser and 397.5-nm ultraviolet (UV) laser generated by cavity-enhanced frequency doubling. Typical peak-to-peak laser intensity fluctuation with a bandwidth of ~10 kHz in a half hour has been improved from ±7.45% to ±0.06% for 795-nm NIR laser beam, and from ±9.04% to ±0.05% for 397.5-nm UV laser beam, respectively. The squeezing level of the squeezed vacuum state at 795 nm prepared by the sub-threshold OPO with a PPKTP crystal has been improved from −3.3 to −4.0 dB around 3~9 kHz of analysis frequency range.

arXiv:2003.05090•Applied Sciences•Feb 20, 2020•5 citations

INTENSITY SQUEEZING WITH TWIN LASER BEAMS

Claude Fabre, E. Giacobino, Serge Reynaud +3 more

•Jul 18, 1988•0 citations

Twin-beam intensity-difference squeezing below 10 Hz

Meng-Chang Wu, Bonnie L. Schmittberger, Nicholas R. Brewer +3 more

We report the generation of strong, bright-beam intensity-difference squeezing down to measurement frequencies below 10 Hz. We generate two-mode squeezing in a four-wave mixing (4WM) process in Rb vapor, where the single-pass-gain nonlinear process does not require cavity locking and only relies on passive stability. We use diode laser technology and several techniques, including dual seeding, to remove the noise introduced by seeding the 4WM process as well as the background noise. Twin-beam intensity-difference squeezing down to frequencies limited only by the mechanical and atmospheric stability of the lab is achieved. These results should enable important low-frequency applications such as direct intensity-difference imaging with bright beams on integrating detectors.

arXiv:1810.09589•Optics Express•Feb 8, 2019•23 citations

Classical theory of laser noise

Jacques Arnaud

Optical and Quantum Electronics•Feb 1, 1995•22 citations

Squeezing more out of a laser

Carlton M. Caves

Machida and Yamamoto used negative feedback from a conventional photodetector to stabilize a laser's intensity and thus to obtain sub-shot-noise photon statistics within the feedback loop. Out-of-Ioop light extracted at a beam splitter, however, displayed super-shot-noise statistics. This behavior can be understood both quantum mechanically and semiclassically. Quantum mechanically the culprit is the vacuum field that enters the beam splitter’s second input port. I describe a technique for extracting sub-shot-noise light by replacing the culprit vacuum field with squeezed light generated by a nonlinear device—a squeezer—that is pumped by a portion of the laser light. Moreover, even if the unstabilized laser is shot-noise-limited, the extracted light can have a better intensity SNR; this signal-to-noise improvement requires both feedback and squeezing.

Annual Meeting Optical Society of America•Jan 1, 1987•0 citations

Intensity noise reduction in light by photon control

A. Heidmann, Jerome C. Mertz, Claude Fabre +2 more

Quantum Electronics and Laser Science Conference•May 10, 1992•0 citations
Laser intensity noise suppression has essential effects on preparation and characterization of the audio-frequency squeezed vacuum state of light based on a sub-threshold optical parametric oscillator (OPO). We have implemented two feedback loops by using relevant acousto-optical modulators (AOM) to stabilize the intensity of 795-nm near infrared (NIR) fundamental laser and 397.5-nm ultraviolet (UV) laser generated by cavity-enhanced frequency doubling. Typical peak-to-peak laser intensity fluctuation with a bandwidth of ~10 kHz in a half hour has been improved from ±7.45% to ±0.06% for 795-nm NIR laser beam, and from ±9.04% to ±0.05% for 397.5-nm UV laser beam, respectively. The squeezing level of the squeezed vacuum state at 795 nm prepared by the sub-threshold OPO with a PPKTP crystal has been improved from −3.3 to −4.0 dB around 3~9 kHz of analysis frequency range.
We report the generation of strong, bright-beam intensity-difference squeezing down to measurement frequencies below 10 Hz. We generate two-mode squeezing in a four-wave mixing (4WM) process in Rb vapor, where the single-pass-gain nonlinear process does not require cavity locking and only relies on passive stability. We use diode laser technology and several techniques, including dual seeding, to remove the noise introduced by seeding the 4WM process as well as the background noise. Twin-beam intensity-difference squeezing down to frequencies limited only by the mechanical and atmospheric stability of the lab is achieved. These results should enable important low-frequency applications such as direct intensity-difference imaging with bright beams on integrating detectors.
Machida and Yamamoto used negative feedback from a conventional photodetector to stabilize a laser's intensity and thus to obtain sub-shot-noise photon statistics within the feedback loop. Out-of-Ioop light extracted at a beam splitter, however, displayed super-shot-noise statistics. This behavior can be understood both quantum mechanically and semiclassically. Quantum mechanically the culprit is the vacuum field that enters the beam splitter’s second input port. I describe a technique for extracting sub-shot-noise light by replacing the culprit vacuum field with squeezed light generated by a nonlinear device—a squeezer—that is pumped by a portion of the laser light. Moreover, even if the unstabilized laser is shot-noise-limited, the extracted light can have a better intensity SNR; this signal-to-noise improvement requires both feedback and squeezing.