Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Electrical Engineering and Technology

Simplified 2-Dimensional Scaled Min-Sum Algorithm for LDPC Decoder

Keol Cho, Wangheon Lee, Ki‐Seok Chung

Published May 1, 2017• 6 citations
Publisher

Abstract

Among various decoding algorithms of low-density parity-check (LDPC) codes, the minsum (MS) algorithm and its modified algorithms are widely adopted because of their computational simplicity compared to the sum-product (SP) algorithm with slight loss of decoding performance.In the MS algorithm, the magnitude of the output message from a check node (CN) processing unit is decided by either the smallest or the next smallest input message which are denoted as min1 and min2, respectively.It has been shown that multiplying a scaling factor to the output of CN message will improve the decoding performance.Further, Zhong et al. have shown that multiplying different scaling factors (called a 2-dimensional scaling) to min1 and min2 much increases the performance of the LDPC decoder.In this paper, the simplified 2-dimensional scaled (S2DS) MS algorithm is proposed.In the proposed algorithm, we figure out a pair of the most efficient scaling factors which multiplications can be replaced with combinations of addition and shift operations.Furthermore, one scaling operation is approximated by the difference between min1 and min2.The simulation results show that S2DS achieves the error correcting performance which is close to or outperforms the SP algorithm regardless of coding rates, and its computational complexity is the lowest comparing to modified versions of MS algorithms.

DOI
10.5370/jeet.2017.12.3.1262

Related papers

Estimation of Two-Dimensional Correction Factors for Min-Sum Decoding of Regular LDPC Code

Ahmed A. Hamad

In this paper, two-dimensional (2-D) correction scheme is proposed to improve the performance of conventional Min-Sum (MS) decoding of regular low density parity check codes. The adopted algorithm to obtain the correction factors is simply based on estimating the mean square difference (MSD) between the transmitted codeword and the posteriori information of both bit and check node that produced at the MS decoder. Semi-practical tests using software-defined radio (SDR) and specific code simulations show that the proposed quasi-optimal algorithm provides a comparable error performance as Sum-Product (SP) decoding while requiring less complexity.

Wireless Engineering and Technology•Jan 1, 2013•3 citations

Optimized Min-Sum Decoding Algorithm for Low Density Parity Check Codes

Mohammad Rakibul, Dewan Siam Shafiullah, Muhammad Mostafa +1 more

Low Density Parity Check (LDPC) code approaches Shannon–limit performance for binary field and long code lengths. However, performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods, an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program, and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.

International Journal of Advanced Computer Science and Applications•Jan 1, 2011•22 citations

Optimized Min-Sum decoding algorithm for Low Density PC codes

Dewan Siam Shafiullah, Mohammad Rakibul Islam, Muhammad Mostafa Amir Faisal +1 more

Low Density Parity Check (LDPC) approaches Shannon -limit performance for binary field and long code lengths. However performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding, while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.

International Conference on Advanced Communication Technology•Jan 1, 2012•5 citations

Stability analysis of an improved min-sum decoder

Mahdi Ramezani, R. Yazdani, Masoud Ardakani

It has been shown that under min-sum (MS) decoding, scaling the messages at the output of check nodes can improve the performance of regular low-density parity-check (LDPC) codes. However, for irregular codes designed for the sum-product decoder, linear scaling can hinder the performance. The problem of code design for MS and linear scaling min-sum (LSMS) decoders have been recently investigated. It is shown that the gap to the capacity for LSMS codes is better than MS codes, but compared to sum-product codes the gap is still considerable. In this letter, a modified MS decoding is proposed and studied. We use the stability analysis of density evolution to show that the proposed method allows for a larger fraction of edges connected to degree-2 variable nodes than LSMS codes. Finally, by designing codes based on the modified method, we show that compared to MS and LSMS codes, a smaller gap to the capacity can indeed be achieved while the complexity of decoding remains essentially the same.

IEEE Communications Letters•Aug 1, 2008•0 citations

A modified Min-Sum algorithm for low-density parity-check codes

Wei Han, Jianguo Huang, WU Fang-fei

A modified Min-Sum algorithm for low-density parity check codes is proposed in this paper. The inaccurate check node messages of the Min-Sum algorithm compared to the belief propagation (BP) algorithm are compensated by modified variable node messages, which is different from the normalized Min-Sum algorithm. The modified factor is obtained before decoding program and only one extra multiplication is needed in one cycle. So the increased complexity is fairly low. The simulation results show that the bit error rate (BER) and average number of iteration of the modified Min-Sum algorithm are very close to the BP algorithm, the modified algorithm can improve the BER performance compared to the Min-Sum algorithm while added complexity slightly.

Wireless Communications, Networking and Information Security•Jun 1, 2010•9 citations

A Second Minimum Approximation Method for Layered Min-Sum Decoding of QC-LDPC Codes

Zijian Qin, Yangcan Zhou, Zhongfeng Wang

Low-density parity-check (LDPC) codes have attracted tremendous attention for their excellent error-correction performance and inherent fitness for high-parallelism implementation. With great complexity reduction and friendly for hardware implementation, the min-sum (MS) decoding algorithm for LDPC codes gains widespread applications in practical. In the MS decoding algorithm, finding the first two minima among input variable-to-check messages is the most complex part. To further reduce the complexity of the MS decoding algorithm, an efficient single-minimum (single-min) based layered MS decoding for quasi-cyclic LDPC (QC-LDPC) codes is proposed in this paper. It is found that statistically the difference between the first minimum and second minimum increases as the decoding becomes more convergent. Accordingly, in the proposed single-min scheme, the second minimum is approximately derived based on the first minimum and an index indicating the convergence degree. Besides, some other metrics that are easily obtained are used to refine the second minimum. Simulation results show that the proposed method can significantly improve the error-correction performance and lower the average number of iterations, compared with the state-of-the-art single-min based MS decoding algorithms.

Information Communication Technologies Conference (ICTC)•May 17, 2023•1 citation
Among various decoding algorithms of low-density parity-check (LDPC) codes, the minsum (MS) algorithm and its modified algorithms are widely adopted because of their computational simplicity compared to the sum-product (SP) algorithm with slight loss of decoding performance.In the MS algorithm, the magnitude of the output message from a check node (CN) processing unit is decided by either the smallest or the next smallest input message which are denoted as min1 and min2, respectively.It has been shown that multiplying a scaling factor to the output of CN message will improve the decoding performance.Further, Zhong et al. have shown that multiplying different scaling factors (called a 2-dimensional scaling) to min1 and min2 much increases the performance of the LDPC decoder.In this paper, the simplified 2-dimensional scaled (S2DS) MS algorithm is proposed.In the proposed algorithm, we figure out a pair of the most efficient scaling factors which multiplications can be replaced with combinations of addition and shift operations.Furthermore, one scaling operation is approximated by the difference between min1 and min2.The simulation results show that S2DS achieves the error correcting performance which is close to or outperforms the SP algorithm regardless of coding rates, and its computational complexity is the lowest comparing to modified versions of MS algorithms.
In this paper, two-dimensional (2-D) correction scheme is proposed to improve the performance of conventional Min-Sum (MS) decoding of regular low density parity check codes. The adopted algorithm to obtain the correction factors is simply based on estimating the mean square difference (MSD) between the transmitted codeword and the posteriori information of both bit and check node that produced at the MS decoder. Semi-practical tests using software-defined radio (SDR) and specific code simulations show that the proposed quasi-optimal algorithm provides a comparable error performance as Sum-Product (SP) decoding while requiring less complexity.
Low Density Parity Check (LDPC) code approaches Shannon–limit performance for binary field and long code lengths. However, performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods, an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program, and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.
Low Density Parity Check (LDPC) approaches Shannon -limit performance for binary field and long code lengths. However performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding, while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.
It has been shown that under min-sum (MS) decoding, scaling the messages at the output of check nodes can improve the performance of regular low-density parity-check (LDPC) codes. However, for irregular codes designed for the sum-product decoder, linear scaling can hinder the performance. The problem of code design for MS and linear scaling min-sum (LSMS) decoders have been recently investigated. It is shown that the gap to the capacity for LSMS codes is better than MS codes, but compared to sum-product codes the gap is still considerable. In this letter, a modified MS decoding is proposed and studied. We use the stability analysis of density evolution to show that the proposed method allows for a larger fraction of edges connected to degree-2 variable nodes than LSMS codes. Finally, by designing codes based on the modified method, we show that compared to MS and LSMS codes, a smaller gap to the capacity can indeed be achieved while the complexity of decoding remains essentially the same.
A modified Min-Sum algorithm for low-density parity check codes is proposed in this paper. The inaccurate check node messages of the Min-Sum algorithm compared to the belief propagation (BP) algorithm are compensated by modified variable node messages, which is different from the normalized Min-Sum algorithm. The modified factor is obtained before decoding program and only one extra multiplication is needed in one cycle. So the increased complexity is fairly low. The simulation results show that the bit error rate (BER) and average number of iteration of the modified Min-Sum algorithm are very close to the BP algorithm, the modified algorithm can improve the BER performance compared to the Min-Sum algorithm while added complexity slightly.
Low-density parity-check (LDPC) codes have attracted tremendous attention for their excellent error-correction performance and inherent fitness for high-parallelism implementation. With great complexity reduction and friendly for hardware implementation, the min-sum (MS) decoding algorithm for LDPC codes gains widespread applications in practical. In the MS decoding algorithm, finding the first two minima among input variable-to-check messages is the most complex part. To further reduce the complexity of the MS decoding algorithm, an efficient single-minimum (single-min) based layered MS decoding for quasi-cyclic LDPC (QC-LDPC) codes is proposed in this paper. It is found that statistically the difference between the first minimum and second minimum increases as the decoding becomes more convergent. Accordingly, in the proposed single-min scheme, the second minimum is approximately derived based on the first minimum and an index indicating the convergence degree. Besides, some other metrics that are easily obtained are used to refine the second minimum. Simulation results show that the proposed method can significantly improve the error-correction performance and lower the average number of iterations, compared with the state-of-the-art single-min based MS decoding algorithms.