Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Theoretical Analysis of Noise in Erbium Doped Fiber Amplifier

Alexander William Setiawan Putra, Minoru Yamada, Hiroyuki Tsuda, Sumiaty Ambran

Published Jun 20, 2017• 18 citations
Publisher

Abstract

Characteristics of noise in erbium doped fiber amplifier (EDFA) are theoretically analyzed and experimentally verified. Four discreet energy models are used for erbium ion transition. Spatially varying photon number for traveling optical field was defined in a spatially divided segment with finite length, whose length is decided by property of the spontaneous emission. Quantitative evaluation of the Langevin noise sources becomes possible by this model. The amplified spontaneous emission was included in terms of discrete longitudinal mode, which is defined for whole length of the EDFA. It was found that the relative intensity noise (RIN) in the EDFA hardly changes with noise frequency in the region higher than several kHz. The phase noise in EDFA also hardly changes with the noise frequency. The frequency noise of the signal light in the EDFA increases proportional to squared value of the noise frequency. The amount of RIN and the phase noise decrease in higher input optical power. Good correspondence between theoretical and experimental results was obtained.

DOI
10.1109/jqe.2017.2717703

Related papers

Output Photon Number Distribution of Erbium-Doped Fiber Amplifiers

G. Saplakoglu, M. CELIK

Erbium-doped fiber amplifiers (EDFA) are gaining increasing importance in the lightwave communications arena due mainly to their low insertion loss and easy manufacturability. Consequently there is significant motivation in obtaining the photon number distribution at the output of an EDFA taking finite bandwith and line shape of the signal lasers into account. In this paper the photon number distribution at the output of an EDFA resulting from an input wave packet having an arbitrary photon number distribution is evaluated. Previously the output photon number distribution was derived [1] for input fields having Poisson photon number distributions, i.e. for coherent sate input fields. Our treatment is more general in the sense that the input field can be in an arbitrary quantum sate. This generality will enable researchers to evaluate EDFA photon number distributions resulting from non-monochromatic incident fields [for example laser sources with phase and/or intensity noise] simply by using the appropriate input photon number distributions in the equations that will be derived below [see for example [2] for several photon number distributions corresponding to various laser line shapes].

Optical Amplifiers and Their Applications•Jan 1, 1992•2 citations

"Analytical Model of Pulse Amplification in Erbium Doped Fiber Amplifier "

Nour. A. Naser, Muhammed. R. Harb, Hassan Abid Yasser

"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Oct 14, 2020•0 citations

The Gain Characteristics and the Optimum Fiber Length of Erbium-doped Fiber Amplifiers

Huang De, Li Zai

An apporoximative theoretical of an erbium-doped fiber amplifier (EDFA) has been proposed in this paper by the rate equation of three-level system. The optimum fiber length is obtained with different pump wavelength by considering the excited-stated-absorption(ESA) in EDFA. The relations between the gain and signal light intensity and pump light intensity are analyzed. It is found that the gain spectrum shape can be changed with the fiber length, which provides the evidence that EDFA is of great potential use in wavelength division multiplexed telecommunication systems.

Optical Communication Technology•Jan 1, 1994•0 citations

Analytical Model of Pulse Amplification inErbium Doped Fiber Amplifier

Muhammed. R. Harb

Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Dec 30, 2020•0 citations

The effect of upconversion on erbium-doped fiber amplifiers (EDFA)

Zhou Meng

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.

Optical Technique•Jan 1, 2006•0 citations

Intensity noise of erbium-doped fiber laser based on full quantum theory

Wenjun Yue, YunXiang Wang, Cai-Dong Xiong +2 more

Traditionally, by means of full quantum theory, we present the intensity noise transfer function of an Er-doped fiber laser, on the basis of which we analyze the spectrum of the intensity noise. Our theoretical results are in agreement with the existing experiment results. This model explains not only how the noise is produced, but also how the spontaneous emission and dipole fluctuations have an effect on the output noise, which cannot be explained via rate equation theory. We analyze the physical sources of various contributions to the noise spectrum as well. The simulation results show that the noise of the Er-doped fiber laser mainly consists of the vacuum noise resulting from the output coupling, dipole fluctuation noise, the pump source intensity noise, and the spontaneous emission from the upper level to the ground level, which provides the theoretical basis for noise suppression. Compared to the solid laser, the Er-doped fiber laser shows lower resonant relaxation oscillation frequency.

Journal of the Optical Society of America B•Jan 7, 2013•29 citations
Characteristics of noise in erbium doped fiber amplifier (EDFA) are theoretically analyzed and experimentally verified. Four discreet energy models are used for erbium ion transition. Spatially varying photon number for traveling optical field was defined in a spatially divided segment with finite length, whose length is decided by property of the spontaneous emission. Quantitative evaluation of the Langevin noise sources becomes possible by this model. The amplified spontaneous emission was included in terms of discrete longitudinal mode, which is defined for whole length of the EDFA. It was found that the relative intensity noise (RIN) in the EDFA hardly changes with noise frequency in the region higher than several kHz. The phase noise in EDFA also hardly changes with the noise frequency. The frequency noise of the signal light in the EDFA increases proportional to squared value of the noise frequency. The amount of RIN and the phase noise decrease in higher input optical power. Good correspondence between theoretical and experimental results was obtained.
Erbium-doped fiber amplifiers (EDFA) are gaining increasing importance in the lightwave communications arena due mainly to their low insertion loss and easy manufacturability. Consequently there is significant motivation in obtaining the photon number distribution at the output of an EDFA taking finite bandwith and line shape of the signal lasers into account. In this paper the photon number distribution at the output of an EDFA resulting from an input wave packet having an arbitrary photon number distribution is evaluated. Previously the output photon number distribution was derived [1] for input fields having Poisson photon number distributions, i.e. for coherent sate input fields. Our treatment is more general in the sense that the input field can be in an arbitrary quantum sate. This generality will enable researchers to evaluate EDFA photon number distributions resulting from non-monochromatic incident fields [for example laser sources with phase and/or intensity noise] simply by using the appropriate input photon number distributions in the equations that will be derived below [see for example [2] for several photon number distributions corresponding to various laser line shapes].
"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
An apporoximative theoretical of an erbium-doped fiber amplifier (EDFA) has been proposed in this paper by the rate equation of three-level system. The optimum fiber length is obtained with different pump wavelength by considering the excited-stated-absorption(ESA) in EDFA. The relations between the gain and signal light intensity and pump light intensity are analyzed. It is found that the gain spectrum shape can be changed with the fiber length, which provides the evidence that EDFA is of great potential use in wavelength division multiplexed telecommunication systems.
Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.
Traditionally, by means of full quantum theory, we present the intensity noise transfer function of an Er-doped fiber laser, on the basis of which we analyze the spectrum of the intensity noise. Our theoretical results are in agreement with the existing experiment results. This model explains not only how the noise is produced, but also how the spontaneous emission and dipole fluctuations have an effect on the output noise, which cannot be explained via rate equation theory. We analyze the physical sources of various contributions to the noise spectrum as well. The simulation results show that the noise of the Er-doped fiber laser mainly consists of the vacuum noise resulting from the output coupling, dipole fluctuation noise, the pump source intensity noise, and the spontaneous emission from the upper level to the ground level, which provides the theoretical basis for noise suppression. Compared to the solid laser, the Er-doped fiber laser shows lower resonant relaxation oscillation frequency.