We investigated microwave characteristics of microwave kinetic inductance detectors (MKIDs) using rewound spiral resonators called as spiral-MKIDs. To realize 25-array spiral-MKIDs, frequency characteristics of 25 resonators with different resonant frequencies should be equal. We proposed spiral-MKIDs with expanded and contracted symmetric spiral resonator. We conducted simulations for 25 arrays and obtained maximum return losses of over 12 dB and unloaded quality factors of over 230,000 for frequencies between 3.2 and 3.4 GHz. This symmetric resonator may be useful for realization of large array MKIDs.
The superconducting materials that make up an MKID have a significant effect on its performance. The
Tc and normal state resistivity
ρN of the film determine the penetration depth
λ and therefore how much kinetic inductance it has. The ratio of kinetic inductance to total inductance (
α), the volume of the inductor, and
Qm determines the magnitude of the response to incoming energy. The quasiparticle lifetime
τqp is the characteristic time during which the MKID's surface impedance is modified by the incoming energy. Many materials have been explored for use in superconducting resonators and MKIDs, but that information is often not published or scattered around the literature. This chapter contains information and references on the work that has been done with thin film lithographed circuits for MKIDs over the last two decades. Note that measured material properties such as the internal loss quality factor
Qi and quasiparticle lifetime
τqp vary significantly depending on how the MKID superconducting thin film is made and the system they are measured in, so it is best to interpret all stated values as typical but not definitive. Values are omitted in cases when there aren't enough measurements or there is too much disagreement in the literature to estimate a typical value. In order to be as complete as possible some unpublished results from the author's lab are included and can be identified by the lack of a reference. Unless noted all films are polycrystalline or amorphous.
We design and fabricate a 350GHz 8×8 Al Microwave Kinetic Inductance Detector (MKIDs) array for the demonstration of its characteristics, mainly focus on the quasiparticle lifetime of the resonators. The quasiparticle lifetime data is collected by measuring a resonator’s phase response to a LED pulse at resonant frequency in a dilution refrigerator cooled to mK stage. We also measure and discuss the influence of various parameters on the change of quasiparticle lifetime, including different LED voltage supply, bath temperature of the MKIDs, and superconducting film thickness.