Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Acta Physica Sinica

A NEW SENSITIVE METHOD FOR DETECTING R. F. RESONANCE IN OPTICAL PUMPING EXPERIMENT

Shuqin Liu, DONG TAI-QIAN, 北京大学

Published Jan 1, 1986• 0 citations
Publisher

Abstract

By making use the influence of microwave-r.f. multi-quantum transition on the spectral line intensity of single quantum microwave transition, a new sensitive method for detecting r.f. resonance in optical pumping experiment is found.
DOI
10.7498/aps.35.944

Related papers

THE MICROWAVE-RADIO FREQUENCY WAVE MULTI-QUANTUM TRANSITION IN OPTICAL PUMPING EXPERIMENT

Shuqin Liu, DONG TAI-QIAN, 北京大学

In the optical pumping experiment for 87Rb gas cell, when the microwave and radio frequency wave are applied simultaneously, the optically detected resonance signals of microwave-radio frequency wave multi-quantum transition are observed.

Acta Physica Sinica•Jan 1, 1984•0 citations

THE MICROWAVE-RADIO FREQUENCY MULTI-QUANTUM TRANSITION IN OPTICAL PUMPING EXPERIMENT (CONTINUED)

Shuqin Liu, DONG TAI-QIAN, 北京大学

The microwave-radio frequency multi-quantum transition in optical pumping experiment is studied for different r.f. power. The microwave-r.f. subharmonic multi-quantum trasition has also been observed.

Acta Physica Sinica•Jan 1, 1985•0 citations

BEAT IN OPTICAL PUMPING EXPERIMENT

Shuqin Liu, DONG TAI-QIAN, 北京大学

When two microwaves with frequencies close to each other are applied simultaneously to a 87Rb gas cell, which is optically pumped by 85Rb lamp, the beat in the resonance signal of 0-0 transition of 87Rb gro und state is observed. Theoretical explanation is presented.

Acta Physica Sinica•Jan 1, 1984•0 citations

Theory of Optical-Microwave Double Resonance I. Fundamentals and Double Resonance of Microwave Detection

Michio Takami

The effect of optical pumping on the lineshapes and the peak values of microwave absorption line is calculated by a density matrix method in the Doppler limit approximation. The calculated double resonance signal consists of two terms. One is proportional to the unperturbed population difference of the optical transition and has a Lorentzian lineshape at weak microwave saturation. In this term the two-photon processes cause broadening of the line. The other is proportional to the population difference of the microwave transition and gives the higher-order dynamic Stark effect. At moderate optical saturation the former term is much greater than the latter. At strong optical saturation the latter term becomes noticeable and lineshape anomaly occurs. The peak values of the double resonance signals are also calculated and compared with an experimental result.

Japanese Journal of Applied Physics•Jun 1, 1976•40 citations

A New Pumping Source for Optical Pumping Resonance Experiments

Fan Sun

Introduce a new pumping source for optical pumping magnetic resonance experiment.The pumping source is with the characteristic of high stable?adjustable easy modulated and multi wavelength.An application for the source to be used in observation of atom transition is also introduced.

Journal of Huizhou University•Jan 1, 2002•0 citations

Research of Magnetic Resonances Optical Detection Method in Optically Pumped Magnetometer

Zhang Zhen-yua

In the optically pumped magnetometer,the signal to noise ratio is very low when use the method of detecting Zeeman energy level transition directly.However,the detected signal to noise ratio can be greatly improved by using the technique of magnetic resonances optical detection which can transform the microwave quantum detection to the photon detection,because the energy of photon is much greater than that of microwave quantum.The method of magnetic resonances optical detection in the OPM(Optically Pumped Magnetometer) has been studied,the principles and experimental devices are discussed which includes the method of detection of cells transparency,detection of orthogonal beams,spin exchange collision and the method of pump beam modulation.The characteristics of these methods are analyzed and compared,the application and complexity are considered,and all these will provide the basis for the design of the optically pumped magnetometer.

Journal of Jilin University•Jan 1, 2011•0 citations
The effect of optical pumping on the lineshapes and the peak values of microwave absorption line is calculated by a density matrix method in the Doppler limit approximation. The calculated double resonance signal consists of two terms. One is proportional to the unperturbed population difference of the optical transition and has a Lorentzian lineshape at weak microwave saturation. In this term the two-photon processes cause broadening of the line. The other is proportional to the population difference of the microwave transition and gives the higher-order dynamic Stark effect. At moderate optical saturation the former term is much greater than the latter. At strong optical saturation the latter term becomes noticeable and lineshape anomaly occurs. The peak values of the double resonance signals are also calculated and compared with an experimental result.
In the optically pumped magnetometer,the signal to noise ratio is very low when use the method of detecting Zeeman energy level transition directly.However,the detected signal to noise ratio can be greatly improved by using the technique of magnetic resonances optical detection which can transform the microwave quantum detection to the photon detection,because the energy of photon is much greater than that of microwave quantum.The method of magnetic resonances optical detection in the OPM(Optically Pumped Magnetometer) has been studied,the principles and experimental devices are discussed which includes the method of detection of cells transparency,detection of orthogonal beams,spin exchange collision and the method of pump beam modulation.The characteristics of these methods are analyzed and compared,the application and complexity are considered,and all these will provide the basis for the design of the optically pumped magnetometer.