Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frontiers in Optics

Enhancing the Electrooptic Effect using Optical Sideband-only Amplification

Bahram Jalali, David Borlaug, Peter T. S. DeVore, Ozdal Boyraz, Ali Rostrami

Published Jan 1, 2014• 0 citations
Publisher

Abstract

The high-frequency increase in modulator half-wave voltage contradicts the reduction in voltage swing of electronics. We show a solution whereby modulation side-bands are amplified, at the expense of the carrier, using controlled modulation instability.
DOI
10.1364/fio.2014.ftu1d.1

Related papers

Photorefractive amplification at high frequencies

Russell M. Kurtz, Weixing Lu, Judy Piranian +1 more

Photorefractive optical amplification, while useful, is a slow process. Under some circumstances, however, it amplifies optical signals effectively even when one is modulated at a relatively high frequency. We determine the reasons for this capability (what we have called the "Fast Photorefractive Effect") and analyze its enhanced bandwidth, improvements over standard photorefractivity, and limitations.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 6, 2011•0 citations

Optical modulators for photonic sideband management

Tetsuya Kawanishi, Masayuki Izutsu

情報通信研究機構季報•Mar 1, 2004•0 citations

Enhancement of optical receiver sensitivities by amplification of the carrier

Jacques Arnaud

The amplification before detection of the carrier of a modulated optical signal by a narrow-band quantum amplifier enhances the signal-to-noise ratio, particularly when the signal wave-front is distorted. A further improvement is obtained by using a combination of wide-band and narrow-band quantum amplifiers. The practical application of these schemes requires a degenerate regenerative ring-type amplifier capable of amplifying arbitrary transverse field configurations. Experiments show that such an amplifier with a gain of 24 dB and a bandwidth of 1 MHz is feasible. The incident beam axis can be displaced by as much as ten times the beam-waist radius without losing more than 4 dB in gain. Frequency modulation may be converted into amplitude modulation by the phase shift introduced in the carrier.

IEEE Journal of Quantum Electronics•Nov 1, 1968•59 citations

Experimental study of balanced optical homodyne and heterodyne detection by controlling sideband modulation

Wei Li, Xudong Yu, Zengming Meng +2 more

arXiv:1508.04974•Science China Physics Mechanics and Astronomy•Sep 4, 2015•7 citations

Long distance QKD propagation using optical single sideband scheme

Bandana Mallick, Priyadarsan Parida, Chittaranjan Nayak +4 more

Implementation of the passive radio over-fiber technique permits modulating the low-frequency sub-carrier onto an optical channel for dissemination through a light-wave fiber network. Single-sideband modulation for optical signals allows the impressive utilization of channel capacity in optical fiber. Dispersion reduction techniques limit the pulse spreading of a propagated signal in any photonic scheme. To control pulse-spreading effects, the optical single-sideband modulation technique at different phase shifts is modeled, analyzed, and compared to examine the performance of a sub-carrier multiplexing system. Hence, in this paper, a quantum key distribution network using a single sideband modulation technique based on a Li-Nb Mach-Zehnder modulator has been proposed at different electrical phase shifts. In this suggested model, the Optisystem 14.2 simulator is used to analyze the nonlinear characteristics. We have designed a single-sideband contour reduction and amplification with each couplet of 120 km by increasing the distance up to 720 km, and the phase between quantum states is determined. The system performance of the suggested model is investigated and compared based on output power (dBm), quality factor, eye diagram, bit error rate (BER), extinction ratio (ER), and optical spectrum of the received signal by varying link distance (km), channel spacing (nm), input power (dBm), and fiber dispersion (ps/ns/km).

Optics Continuum•Feb 26, 2024•10 citations

Design of high-voltage electronic driver for polarization encoding quantum transmitters

Hugo Filipe Costa, João G. Prata, Armando N. Pinto +1 more

We present the design and experimental implementation of a compact high-voltage driver tailored for multi-wave-plate electro-optical polarization controllers (EPC) in polarization-based DV-QKD subsystems. The driver is capable of deriving a 140 Vppoutput swing per wave-plate, supports modulation bandwidths up to 7.5MHz, with 10mV resolution, and incorporates per-channel Analog-to-Digital Converter (ADC) monitoring for real-time feedback. A two-stage architecture, with a low-voltage pre-amplification stage followed by a high-voltage output stage, is used with the input being provided by a 16-channel FMC216 Digital-to-Analog Converter (DAC) board, connected to Xilinx Zynq FPGA. Electrical characterization shows that both rise times (∼30ns) and maximum stable square-wave frequency, up to 7.5 MHz, improve as the input Vppincreases, with output gain scaling linearly with input amplitude. Optical testing demonstrates reliable polarization state stability and speed. By enabling fast, precise State of Polarization (SOP) control without bulky stabilization hardware, our driver significantly simplifies the design of polarization-encoded QKD transmitters and receivers, paving the way toward cost-effective, high-rate quantum communications.

International Conference on Transparent Optical Networks•Jul 6, 2025•0 citations
The amplification before detection of the carrier of a modulated optical signal by a narrow-band quantum amplifier enhances the signal-to-noise ratio, particularly when the signal wave-front is distorted. A further improvement is obtained by using a combination of wide-band and narrow-band quantum amplifiers. The practical application of these schemes requires a degenerate regenerative ring-type amplifier capable of amplifying arbitrary transverse field configurations. Experiments show that such an amplifier with a gain of 24 dB and a bandwidth of 1 MHz is feasible. The incident beam axis can be displaced by as much as ten times the beam-waist radius without losing more than 4 dB in gain. Frequency modulation may be converted into amplitude modulation by the phase shift introduced in the carrier.
Implementation of the passive radio over-fiber technique permits modulating the low-frequency sub-carrier onto an optical channel for dissemination through a light-wave fiber network. Single-sideband modulation for optical signals allows the impressive utilization of channel capacity in optical fiber. Dispersion reduction techniques limit the pulse spreading of a propagated signal in any photonic scheme. To control pulse-spreading effects, the optical single-sideband modulation technique at different phase shifts is modeled, analyzed, and compared to examine the performance of a sub-carrier multiplexing system. Hence, in this paper, a quantum key distribution network using a single sideband modulation technique based on a Li-Nb Mach-Zehnder modulator has been proposed at different electrical phase shifts. In this suggested model, the Optisystem 14.2 simulator is used to analyze the nonlinear characteristics. We have designed a single-sideband contour reduction and amplification with each couplet of 120 km by increasing the distance up to 720 km, and the phase between quantum states is determined. The system performance of the suggested model is investigated and compared based on output power (dBm), quality factor, eye diagram, bit error rate (BER), extinction ratio (ER), and optical spectrum of the received signal by varying link distance (km), channel spacing (nm), input power (dBm), and fiber dispersion (ps/ns/km).
We present the design and experimental implementation of a compact high-voltage driver tailored for multi-wave-plate electro-optical polarization controllers (EPC) in polarization-based DV-QKD subsystems. The driver is capable of deriving a 140 Vppoutput swing per wave-plate, supports modulation bandwidths up to 7.5MHz, with 10mV resolution, and incorporates per-channel Analog-to-Digital Converter (ADC) monitoring for real-time feedback. A two-stage architecture, with a low-voltage pre-amplification stage followed by a high-voltage output stage, is used with the input being provided by a 16-channel FMC216 Digital-to-Analog Converter (DAC) board, connected to Xilinx Zynq FPGA. Electrical characterization shows that both rise times (∼30ns) and maximum stable square-wave frequency, up to 7.5 MHz, improve as the input Vppincreases, with output gain scaling linearly with input amplitude. Optical testing demonstrates reliable polarization state stability and speed. By enabling fast, precise State of Polarization (SOP) control without bulky stabilization hardware, our driver significantly simplifies the design of polarization-encoded QKD transmitters and receivers, paving the way toward cost-effective, high-rate quantum communications.