Superconducting nanowire single-photon detectors (SNSPDs) are attractive because of their wide response band, low noise, and high repetition rate in practical applications. Owing to these advantage, SNSPDs are particularly useful for high efficiency (>80%) in laser-ranging systems operating at 1064 nm. However, the superconducting nanowire may latch in a permanent resistive state because of the backscattering problem, which may prevent it from detecting targeted reflection photons. This paper proposes an SNSPD that operates in a quasi-gated mode with the help of a programmed source and improved feeding circuit. The programmed source switches the SNSPD off at a low level, and switches it on at a high level. Such an on-off switching process enables the SNSPD to recover automatically from latching through compulsory initialization in each period, therefore, resolving the problem caused by strong backscatterings in laser ranging systems. The quasi-gated SNSPD can also be used in other applications operating in a nonstop mode, even with occasional latchings.
Superconducting nanowire single-photon detectors (SNSPDs) are attractive because of their wide response band, low noise, and high repetition rate in practical applications. Owing to these advantage, SNSPDs are particularly useful for high efficiency (>80%) in laser-ranging systems operating at 1064 nm. However, the superconducting nanowire may latch in a permanent resistive state because of the backscattering problem, which may prevent it from detecting targeted reflection photons. This paper proposes an SNSPD that operates in a quasi-gated mode with the help of a programmed source and improved feeding circuit. The programmed source switches the SNSPD off at a low level, and switches it on at a high level. Such an on-off switching process enables the SNSPD to recover automatically from latching through compulsory initialization in each period, therefore, resolving the problem caused by strong backscatterings in laser ranging systems. The quasi-gated SNSPD can also be used in other applications operating in a nonstop mode, even with occasional latchings.
Superconducting nanowire single photon detectors (SNSPDs) have been realized using an innovative parallel wire configuration. This configuration allows, at the same time, a large detection area and a fast response, with the additional advantage of large signal amplitudes. The detectors have been thoroughly characterized in terms of signal properties (amplitude, risetime and falltime), detector operation (latching and not latching) and quantum efficiency (at 850 nm). It has been shown that the parallel SNSPD is able to provide significantly higher maximum count rates for large area SNSPDs than meandered SNSPDs. Through a proper parallel wire configuration the increase in maximum count rate can be obtained without latching problems.
Superconducting Nanowire Single-Photon Detectors (SNSPDs) are well known for their single-photon sensitivity, low jitter, and high efficiency. Their dynamic range is generally limited either to zero or one (no photon, or a photon absorbed), and if single-photon sensitivity is needed in the vicinity of a strong light pulse, a counteraction like gating needs to be deployed. In such a scheme, we aim at the fastest possible transition time which is helpful to increase sensitivity, to temporally filter any strong laser excitation, and further suppress dark counts. Here, we present our work of time-gated SNSPDs where the detection current can be switched on- and off to allow the detector not to be saturated. We start our discussion by introducing the simplest gating scheme based on a square wave resulting in switch-off-switching transition times of ≈50ns. Then we present a new method to improve this relatively slow transition time to the sub-nanosecond range. Latest measurements of efficiency recovery and jitter are presented, and we show that a 1550nm light pulse with 100’000 photons within 500ns, applied right before the on-transition of the SNSPD, does not yet affect the performance in the on-state.
Superconducting nanowire single photon detector (SNSPD) has been widely used in many fields such as quantum computing, quantum key distribution and laser radar, due to its high detection efficiency, low dark count rate, high counting rate, and low timing jitter. In most cases, the SNSPD works under the DC-bias mode that can detect single photons arrived at any time. In some cases such as satellite laser ranging and single-photon laser radar where the light pulses arrive regularly, the AC-bias mode enables the SNSPD to work with higher counting rates and lower background dark counts, which however requires complicated readout due to the low signal-to-noise ratio of the photon response. In this work, we report on an AC-biased SNSPD system with a self-differential readout circuit. The system includes a 2-pixel SNSPD consisting of two parallel nanowires, which are biased with 100 MHz sinusoidal current. The output signals of these two nanowires are amplified and combined for the differential readout of the photon response. The resulting response pulse possesses a signal-to-noise ratio ten times higher than that extracted before self-differential readout. In addition, the dark counts are reduced by a factor of 4, and the count rates are increased by a factor of 1.5, in comparison with those under the DC-bias mode. This work provides a specific method to read out the AC-biased SNSPD.
High detection efficiency and low intrinsic dark count rate are two advantages of superconducting nanowire single photon detectors (SNSPDs). However, the stray photons penetrated into the fiber would cause the extrinsic dark count rate, owing to the free running mode of SNSPDs. In order to improve the performance of SNSPDs in realistic scenarios, stray photons should be investigated and suppression methods should be adopted. In this study, we demonstrate the pulse-gated mode, with 500 kHz gating frequency, of a commercial SNSPD system for suppressing the response of stray photons about three orders of magnitude than its free-running counterpart on the extreme test conditions. When we push the gating frequency to 8 MHz, the dark count rate still keeps under 4% of free-running mode. In experiments, the intrinsic dark count rate is also suppressed to 4.56 × 10−2 counts per second with system detection efficiency of 76.4372%. Furthermore, the time-correlated single-photon counting analysis also approves the validity of our mode in suppressing the responses of stray photons.
Superconducting nanowire single-photon detectors (SNSPDs) have shown to be promising in applications such as quantum communication and computation, quantum optics, imaging, metrology and sensing. They offer the advantages of a low dark count rate, high efficiency, a broadband response, a short time jitter, a high repetition rate, and no need for gated-mode operation. Several SNSPD designs have been proposed in literature. Here, we discuss the so-called parallel nanowires configurations. They were introduced with the aim of improving some SNSPD property like detection efficiency, speed, signal-to-noise ratio, or photon number resolution. Although apparently similar, the various parallel designs are not the same. There is no one design that can improve the mentioned properties all together. In fact, each design presents its own characteristics with specific advantages and drawbacks. In this work, we will discuss the various designs outlining peculiarities and possible improvements.
Superconducting nanowire single-photon detectors (SNSPDs) show near unity efficiency, low dark count rate, and short recovery time. Combining these characteristics with temporal control of SNSPDs broadens their applications as in active de-latching for higher dynamic range counting or temporal filtering for pump-probe spectroscopy or LiDAR. To that end, we demonstrate active gating of an SNSPD with a minimum off-to-on rise time of 2.4 ns and a total gate length of 5.0 ns. We show how the rise time depends on the inductance of the detector in combination with the control electronics. The gate window is demonstrated to be fully and freely, electrically tunable up to 500 ns at a repetition rate of 1.0 MHz, as well as ungated, free-running operation. Control electronics to generate the gating are mounted on the 2.3 K stage of a closed-cycle sorption cryostat, while the detector is operated on the cold stage at 0.8 K. We show that the efficiency and timing jitter of the detector is not altered during the on-time of the gating window. We exploit gated operation to demonstrate a method to increase in the photon counting dynamic range by a factor 11.2, as well as temporal filtering of a strong pump in an emulated pump-probe experiment.